Comments on "On resistor-induced thermal noise in linear circuits"

Correspondència referida a l'article de R. Giannetti, publicat ibid. vol.49 p.87-88

On the thermal noise introduced by a resistor in a circuit

Comentari sobre l'article publicat anteriorment pels mateixos autors: Vargas, M; Pallás, R; The seemingly paradoxical noise behaviour some active circuits. IEEE Transactions on Instrumentation and Measurement. 1994, vol. 43, núm. 5, p. 764-767

Extensional flow of nematic liquid crystal under electric field gradient

Systematic asymptotic methods are used to formulate a model for the extensional flow of a thin sheet of nematic liquid crystal. With no external body forces applied, the model is found to be equivalent to the so-called Trouton model for Newtonian sheets (and fi bers), albeit with a modi fied "Trouton ratio". However, with a symmetry-breaking electric field gradient applied, behavior deviates from the Newtonian case, and the sheet can undergo fi nite-time breakup if a suitable destabilizing field is applied. Some simple exact solutions are presented to illustrate the results in certain idealized limits, as well as sample numerical results to the full model equations.

A physical frequency-dependent compact model for RF integrated inductors

A frequency-dependent compact model for inductors in high ohmic substrates, which is based on an energy point-of-view, is developed. This approach enables the description of the most important coupling phenomena that take place inside the device. Magnetically induced losses are quite accurately calculated and coupling between electric and magnetic fields is given by means of a delay constant. The later coupling phenomenon provides a modified procedure for the computation of the fringing capacitance value, when the self-resonance frequency of the inductor is used as a fitting parameter. The model takes into account the width of every metal strip and the pitch between strips. This enables the description of optimized layout inductors. Data from experiments and electromagnetic simulators are presented to test the accuracy of the model.

Desplegament dels circuits dedicats de 1 i 10 Gbps entre el PIC i el CERN

Aquest projecte consisteix a realitzar el disseny i desplegament d'una connexió entre el Port d'Informació Científica (PIC) i el Consell Europeu per a la Recerca Nuclear (CERN) sobre un circuit dedicat amb una velocitat de transferència de 10 Gbps. En una primera fase el desplegament de la connexió es realitza sobre un circuit dedicat de 1 Gbps. El projecte implica la certificació dels circuits dedicats de 1 i 10 Gbps i el disseny dels plans d'actuació que han de permetre la integració de les noves connexions dins la xarxa i els serveis del PIC.

Metodología de diseño de filtros CRF/SCF basada en modelos de resonadores BAW acoplados acústicamente

La creixent utilització de sistemes de comunicacions mòbils ha impulsat la demanda de filtres passabanda miniaturitzats d'elevades prestacions operant en el rang de freqüències de microones. Els Film Bulk Acoustic Resonators (FBAR) estan esdevenint la principal alternativa als filtres basats en ressonadors Surface Acoustic Wave (SAW) o als basats en ressonadors ceràmics. Els Stacked Crystal Filters (SCF) i els Coupled Resonator Filters (CRF) són configuracions FBAR que permeten assolir una excel·lent atenuació en la banda de refús. Aquest treball presenta un innovador circuit equivalent elèctric que modela el CRF. Llavors, es desenvolupa una metodologia de síntesi de filtres per al SCF i per al CRF utilitzant els seus circuits equivalents elèctrics. La metodologia de disseny presentada permet obtenir les dimensions de l'estructura del filtre acústic partint de les especificacions del filtre i de les restriccions pròpies de la tecnologia. S'han implementat diferents respostes de Chebyshev per a sistemes de comunicacions reals per tal de validar el procediment de disseny dels filtres obtenint els resultats esperats.

Origins and efficiency of the electric industry regulation in Spain, 1910-1936

The aim of this paper is to discover the origins of utility regulation in Spain, and to analyse, from a microeconomic perspective, its characteristics and the impact of regulation on consumers and utilities. Madrid and the Madrilenian utilities are taken as a case study. The electric industry in the period studied was a natural monopoly2. Each of the three phases of production, generation, transmission and distribution, had natural monopoly characteristics. Therefore, the most efficient form to generate, transmit and distribute electricity was the monopoly because one firm can produce a quantity at a lower cost than the sum of costs incurred by two or more firms. A problem arises because when a firm is the single provider it can charge prices above the marginal cost, at monopoly prices. When a monopolist reduces the quantity produced, price increases, causing the consumer to demand less than the economic efficiency level, incurring a loss of consumer surplus. The loss of the consumer surplus is not completely gained by the monopolist, causing a loss of social surplus, a deadweight loss. The main objective of regulation is going to be to reduce to a minimum the deadweight loss. Regulation is also needed because when the monopolist fixes prices at marginal cost equal marginal revenue there would be an incentive for firms to enter the market creating inefficiency. The Madrilenian industry has been chosen because of the availability of statistical information on costs and production. The complex industry structure and the atomised demand add interest to the analysis. This study will also provide some light on the tariff regulation of the period which has been poorly studied and will complement the literature on the US electric utilities regulation where a different type of regulation was implemented.

Cortical mapping of the neuronal circuits modulating the muscle tone. Introduction to the electrophysiological treatment of the spastic hand.

L’objectiu d’aquest estudi es investigar l’organització cortical junt amb la connectivitat còrtico-subcortical en subjectes sans, com a estudi preliminar. Els mapes corticals s’han fet per TMS navegada, i els punts motors obtinguts s’han exportant per estudi tractogràfic i anàlisi de las seves connexions. El coneixement precís de la localització de l’àrea cortical motora primària i les seves connexions es la base per ser utilitzada en estudis posteriors de la reorganització cortical i sub-cortical en pacients amb infart cerebral. Aquesta reorganització es deguda a la neuroplasticitat i pot ser influenciada per els efectes neuromoduladors de la estimulació cerebral no invasiva.

Estimation of zero-sequence impedance of undergrounds cables for single-phase fault location in distribution systems with electric arc

This paper focus on the problem of locating single-phase faults in mixed distribution electric systems, with overhead lines and underground cables, using voltage and current measurements at the sending-end and sequence model of the network. Since calculating series impedance for underground cables is not as simple as in the case of overhead lines, the paper proposes a methodology to obtain an estimation of zero-sequence impedance of underground cables starting from previous single-faults occurred in the system, in which an electric arc occurred at the fault location. For this reason, the signal is previously pretreated to eliminate its peaks voltage and the analysis can be done working with a signal as close as a sinus wave as possible

Modelització i simulació del motor d'inducció en règim transitori amb PSIM

El present treball pretén modelitzar i simular el motor d’inducció trifàsic en règim transitori amb PSIM 6.0 Demo(la versió del programa que s’utilitza actualment a l’Escola Politècnica Superior de la UdG), però també s’estudia el model en règim permanent, per tal de comparar a nivell teòric els resultats dels dos règims. Primer cal entendre i implementar el model del motor d’inducció, i així obtenir l'esquema equivalent en règim transitori, per després poder-lo simular. Abans de dur a terme la simulació, cal obtenir els paràmetres del circuit equivalent del motor real per introduir-los al programa informàtic, amb la finalitat de tenir precisió en les respostes. Aquests valors s’obtindran mitjançant assajos necessaris al laboratori. Posteriorment, es fan simulacions i pràctiques reals amb el motor treballen en diferents condicions per veure el seu comportament, i així poder comparar els resultats de la simulació amb els valors reals. També s’implementa un estudi de la influencia dels paràmetres interns en el funcionament del motor. Així es podrà visualitzar i comparar les respostes de diferents variables en cadascunes de les simulacions que es duguin a terme. Finalment, seria interessant la introducció de la màquina d’inducció trifàsica actuant com a generador en la simulació.Aquest és un estudi en el qual se simula la màquina d'inducció trifàsic en règim transitori i en règim permanent mitjançant l'ús del PSIM, que és el programa informàtic de simulació

Modification of the Perrine-Baum diagram to improve the calculation of high voltage electric lines

Through the history of Electrical Engineering education, vectorial and phasorial diagrams have been used as a fundamental learning tool. At present, computational power has replaced them by long data lists, the result of solving equation systems by means of numerical methods. In this sense, diagrams have been shifted to an academic background and although theoretically explained, they are not used in a practical way within specific examples. This fact may be against the understanding of the complex behavior of the electrical power systems by students. This article proposes a modification of the classical Perrine-Baum diagram construction to allowing both a more practical representation and a better understanding of the behavior of a high-voltage electric line under different levels of load. This modification allows, at the same time, the forecast of the obsolescence of this behavior and line’s loading capacity. Complementary, we evaluate the impact of this tool in the learning process showing comparative undergraduate results during three academic years

A comparative analysis of two methods for the calculation of electric-field-induced perturbations to molecular vibration

Two common methods of accounting for electric-field-induced perturbations to molecular vibration are analyzed and compared. The first method is based on a perturbation-theoretic treatment and the second on a finite-field treatment. The relationship between the two, which is not immediately apparent, is made by developing an algebraic formalism for the latter. Some of the higher-order terms in this development are documented here for the first time. As well as considering vibrational dipole polarizabilities and hyperpolarizabilities, we also make mention of the vibrational Stark effec

A quantum molecular similarity analysis of changes in molecular electron density caused by basis set flotation and electric field application

Quantum molecular similarity (QMS) techniques are used to assess the response of the electron density of various small molecules to application of a static, uniform electric field. Likewise, QMS is used to analyze the changes in electron density generated by the process of floating a basis set. The results obtained show an interrelation between the floating process, the optimum geometry, and the presence of an external field. Cases involving the Le Chatelier principle are discussed, and an insight on the changes of bond critical point properties, self-similarity values and density differences is performed