Eliciting and fostering learners' metacognitive knowledge about language learning in self-directed learning programs: a review of data collection methods and procedures

Són molts els estudis que avui en dia incideixen en la necessitat d’oferir un suport metodològic i psicològic als aprenents que treballen de manera autònoma. L’objectiu d’aquest suport és ajudar-los a desenvolupar les destreses que necessiten per dirigir el seu aprenentatge així com una actitud positiva i una major conscienciació envers aquest aprenentatge. En definitiva, aquests dos tipus de preparació es consideren essencials per ajudar els aprenents a esdevenir més autònoms i més eficients en el seu propi aprenentatge. Malgrat això, si bé és freqüent trobar estudis que exemplifiquen aplicacions del suport metodològic dins els seus programes, principalment en la formació d’estratègies o ajudant els aprenents a desenvolupar un pla de treball, aquest no és el cas quan es tracta de la seva preparació psicològica. Amb rares excepcions, trobem estudis que documentin com s’incideix en les actituds i en les creences dels aprenents, també coneguts com a coneixement metacognitiu (CM), en programes que fomenten l’autonomia en l’aprenentatge. Els objectius d’aquest treball son dos: a) oferir una revisió d’estudis que han utilitzat diferents mitjans per incidir en el CM dels aprenents i b) descriure les febleses i avantatges dels procediments i instruments que utilitzen, tal com han estat valorats en estudis de recerca, ja que ens permetrà establir criteris objectius sobre com i quan utilitzar-los en programes que fomentin l’aprenentatge autodirigit.

On the set of subrings wich are directed unions of Artinian subrings

The paper contributes to the investigation of zero-dimensional rings which can be written as a directed union of Artinian subrings. We give conditions on DU(R) in order to be nonempty.

North-South trade and directed technical change

In a world where poor countries provide weak protection for intellectual property rights (IPRs), market integration shifts technical change in favor of rich nations. Through this channel, free trade may amplify international income differences. At the same time, integration with countries where IPRs are weakly protected can slow down the world growth rate. An important implication of these results is that protection of intellectual property is most beneficial in open countries. This prediction, which is novel in the literature, is consistent with evidence from a panel of 53 countries observed in the years 1965-1990. The paper also provides empirical support for the mechanism linking North-South trade to the direction of technical change: an increase in import penetration from low-wage, low-IPRs, countries is followed by a sharp fall in R&D investment in a panel of US manufacturing sectors.

Cell size distribution in a random tessellation of space governed by the Kolmogorov-Johnson-Mehl-Avrami model: Grain size distribution in crystallization

The space subdivision in cells resulting from a process of random nucleation and growth is a subject of interest in many scientific fields. In this paper, we deduce the expected value and variance of these distributions while assuming that the space subdivision process is in accordance with the premises of the Kolmogorov-Johnson-Mehl-Avrami model. We have not imposed restrictions on the time dependency of nucleation and growth rates. We have also developed an approximate analytical cell size probability density function. Finally, we have applied our approach to the distributions resulting from solid phase crystallization under isochronal heating conditions

Offshoring and directed technical change

To study the short-run and long-run implications on wage inequality, we introducedirected technical change into a Ricardian model of offshoring. A unique final good isproduced by combining a skilled and an unskilled product, each produced from a continuumof intermediates (tasks). Some of these tasks can be transferred from a skill-abundant Westto a skill-scarce East. Profit maximization determines both the extent of offshoring andtechnological progress. Offshoring induces skill-biased technical change because it increasesthe relative price of skill-intensive products and induces technical change favoring unskilledworkers because it expands the market size for technologies complementing unskilled labor.In the empirically more relevant case, starting from low levels, an increase in offshoringopportunities triggers a transition with falling real wages for unskilled workers in the West,skill-biased technical change and rising skill premia worldwide. However, when the extentof offshoring becomes sufficiently large, further increases in offshoring induce technicalchange now biased in favor of unskilled labor because offshoring closes the gap betweenunskilled wages in the West and the East, thus limiting the power of the price effectfueling skill-biased technical change. The unequalizing impact of offshoring is thus greatestat the beginning. Transitional dynamics reveal that offshoring and technical change aresubstitutes in the short run but complements in the long run. Finally, though offshoringimproves the welfare of workers in the East, it may benefit or harm unskilled workers inthe West depending on elasticities and the equilibrium growth rate.

North-south trade and directed technical change

In a world where poor countries provide weak protection for intellectual propertyrights, market integration shifts technical change in favor of rich nations. Throughthis channel, free trade may amplify international income differences. At the sametime, integration with countries where intellectual property rights are weakly protectedcan slow down the world growth rate. A crucial implication of these results is thatprotection of intellectual property is most beneficial in open countries. This prediction,which is novel in the literature, finds support in the data on a panel of 53 countriesobserved in the years 1965-1990.

Crystallization behaviour of some melt spun Nd-Fe-B alloys

The kinetics of crystallization of four amorphous (or partially amorphous) melt spun Nd-Fe-B alloys induced by thermal treatment is studied by means of differential scanning calorimetry and scanning electron microscopy, In the range of temperatures explored experimentally, the crystallization process is thermally activated and generally proceeds in various stages. The Curie temperature and the crystallization behavior have been measured. The apparent activation energy of crystallization of most of the crystallization stages has been determined for each melt spun alloy. The explicit form of the kinetic equation that best describes the first stage of crystallization has been found. It follows in general the Johnson-Mehl-Avrami-Erofe'ev model, but clear deviations to that model occur for one alloy. Scanning electron microscopy demonstrates that preferentially hetereogeneous nucleation occurs at the ribbon surface which was in contact with the wheel. From crystallization kinetics results the lower part of the experimental time-temperature-transformation curves for all studied alloys are deduced and extrapolated to the high temperature limit of their range of validity, also deduced.

Accuracy in the experimental calorimetric study of the crystallization kinetics and predicitve transformation diagrams: Application to a Ga-Te amorphous alloy

The uncertainties inherent to experimental differential scanning calorimetric data are evaluated. A new procedure is developed to perform the kinetic analysis of continuous heating calorimetric data when the heat capacity of the sample changes during the crystallization. The accuracy of isothermal calorimetric data is analyzed in terms of the peak-to-peak noise of the calorimetric signal and base line drift typical of differential scanning calorimetry equipment. Their influence in the evaluation of the kinetic parameters is discussed. An empirical construction of the time-temperature and temperature heating rate transformation diagrams, grounded on the kinetic parameters, is presented. The method is applied to the kinetic study of the primary crystallization of Te in an amorphous alloy of nominal composition Ga20Te80, obtained by rapid solidification.

Effect of the nanoparticles on the structure and crystallization of amorphous silicon thin films produced by rf glow discharge

Thin films of nanostructured silicon (ns-Si:H) were deposited by plasma-enhanced chemical vapor deposition in the presence of silicon nanoparticles at 100 C substrate temperature using silane and hydrogen gas mixture under continuous wave (cw) plasma conditions. The nanostructure of the films has been demonstrated by diverse ways: transmission electron microscopy, Raman spectroscopy and x-ray diffraction, which have shown the presence of ordered silicon clusters (1!=2 nm) embedded in an amorphous silicon matrix. Due to the presence of these ordered domains, the films crystallize faster than standard hydrogenated amorphous silicon samples, as evidenced by electrical measurements during the thermal annealing.

Anomalous crystallization of hydrogenated amorphous silicon during fast heating ramps

Thermal crystallization experiments carried out using calorimetry on several a-Si:H materials with different microstructures are reported. The samples were crystallized during heating ramps at constant heating rates up to 100 K/min. Under these conditions, crystallization takes place above 700 C and progressively deviates from the standard kinetics. In particular, two crystallization processes were detected in conventional a-Si:H, which reveal an enhancement of the crystallization rate. At100 K/min, such enhancement is consistent with a diminution of the crystallization time by a factor of 7. In contrast, no systematic variation of the resulting grain size was observed. Similar behavior was also detected in polymorphous silicon and silicon nanoparticles, thus showing that it is characteristic of a variety of hydrogenated amorphous silicon materials.

Generalized percolation in random directed networks

We develop a general theory for percolation in directed random networks with arbitrary two-point correlations and bidirectional edgesthat is, edges pointing in both directions simultaneously. These two ingredients alter the previously known scenario and open new views and perspectives on percolation phenomena. Equations for the percolation threshold and the sizes of the giant components are derived in the most general case. We also present simulation results for a particular example of uncorrelated network with bidirectional edges confirming the theoretical predictions.

Finite-size scaling investigation of the liquid-liquid critical point in ST2 water and its stability with respect to crystallization.

The liquid-liquid critical point scenario of water hypothesizes the existence of two metastable liq- uid phases low-density liquid (LDL) and high-density liquid (HDL) deep within the supercooled region. The hypothesis originates from computer simulations of the ST2 water model, but the stabil- ity of the LDL phase with respect to the crystal is still being debated. We simulate supercooled ST2 water at constant pressure, constant temperature, and constant number of molecules N for N ≤ 729 and times up to 1 μs. We observe clear differences between the two liquids, both structural and dynamical. Using several methods, including finite-size scaling, we confirm the presence of a liquid-liquid phase transition ending in a critical point. We find that the LDL is stable with respect to the crystal in 98% of our runs (we perform 372 runs for LDL or LDL-like states), and in 100% of our runs for the two largest system sizes (N = 512 and 729, for which we perform 136 runs for LDL or LDL-like states). In all these runs, tiny crystallites grow and then melt within 1 μs. Only for N ≤ 343 we observe six events (over 236 runs for LDL or LDL-like states) of spontaneous crystal- lization after crystallites reach an estimated critical size of about 70 ± 10 molecules.

Analcime crystallization and compositional profiles - Comparing approaches to detect post-depositional alterations in archaeological pottery

The approaches of comparative studies and profile measurements, often used in order to detect post-depositional alterations of ceramics, have been applied simultaneously to two sets of Roman pottery, both of which include altered individuals. As analytical techniques, Neutron Activation Analysis and X-Ray Diffraction have been used. Both approaches lead to substantially different results. This shows that they detect different levels of alteration and should complement each other rather than being used exclusively. For the special process of a glassy phase decomposition followed by a crystallization of the Na-zeolite analcime, the results suggest that it changes high-fired calcareous pottery rapidly, and so fundamentally that the results of various archaeometric techniques can be severely disturbed.

Crystallization and properties of poly(ethylene terephtalate) copolymers containing 5-tert-butyl isophtalic units

The influence of incorporating 5-tert-butyl isophthalic units (tBI) in the polymer chain of poly(ethylene terephthalate) (PET) on the crystallization behavior, crystal structure, and tensile and gas transport properties of this polyester was evaluated. Random poly(ethyleneterephthalate-co-5-tert-butyl isophthalate) copolyesters (PETtBI) containing between 5 and 40 mol% of tBI units were examined. Isothermal crystallization studies were performed on amorphous glassy films at 120 8C and on molten samples at 200 8C by means of differential scanning calorimetry. Furthermore, the non-isothermal crystallization behavior of the copolyesters was investigated. It was observed that both crystallinity and crystallization rate of the PETtBI copolyesters tend to decrease largely with the comonomeric content, except for the copolymer containing 5 mol% of tBI units, which crystallized faster than PET. Fiber X-ray diffraction patterns of the semicrystalline PETtBI copolyesters proved that they adopt the same triclinic crystal structure as PET with the comonomeric units being excluded from the crystalline phase. Although PETtBI copolyesters became brittle for higher contents in tBI, the tensile modulus and strength of PET were barely affected by copolymerization. The ncorporation of tBI units slightly increased the permeability of PET, but copolymers containing up to 20 mol% of the comonomeric units were still able to present barrier properties.

Crystallization and resolution of the lipoxygenase of Pseudomonas aeruginosa 42A2 and phylogenetic study of the subfamilies of the lipoxygenases

Lipoxygenases are non-heme iron enzymes essential in eukaryotes, where they catalyze the formation of the fatty acid hydroperoxides that are required by a large diversity of biological and pathological processes. In prokaryotes, most of them totally lacking in polyunsaturated fatty acids, the possible biological roles oflipoxygenases have remained obscure. In this study, it is reported the crystallization of a lipoxygenase of Pseudomonas aeruginosa (Pa_LOX), the first from a prokaryote. High resolution data has been acquired which is expected to yield structural clues to the questions adressed. Besides, a preliminar phylogenetic analysis using 14 sequences has confirmed the existence of this subfamily of bacterial lipoxygenases, on one side, and a greater diversity than in the corresponding eukaryotic ones, on the other. Finally, an evolutionary study of bacteriallipoxygenases on the same set of lipoxygenases, show a selection pressure of a basically purifying or neutral character except for a single aminoacid, which would have been selected after a positive selection event.