Agronomic and commercial performance of four Spanish carob cultivars

The carob tree (Ceratonia siliqua) shows interesting prospects for some coastal Mediterranean growing areas and is widely used for industrial, agricultural, and ornamental purposes. It can be an alternative crop adapted to part-time farming and can also be used to regenerate vegetation in areas with a mild climate and erosion problems. Four Spanish carob cultivars were examined (Banya de Cabra, Duraio, Matalafera, and Rojal) to determine the one that performed the best for planting new orchards in northeastern Spain (Catalonia). The trees in this rain-fed trial (average rainfall of 500 mm) were planted in 1986 using seedling rootstocks that were budded in 1987. The trees were trained using the free-vase system and were spaced 8 x 9 m (138 trees/ha including 12% pollinators). The results showed that ‘Rojal’ was the earliest bearing cultivar. However, no significant differences were observed for cumulative pod production 18 years after budding. With respect to cumulative seed yield, ‘Duraio’ had the highest production (95 kg/tree). The lowest tree vigor (trunk cross-section) was observed in ‘Matalafera’. ‘Rojal’ trees produced the largest pods (average fruit weight of 18.9 g) and lowest seed content (11.8%), while ‘Banya de Cabra’ and ‘Duraio’ produced the smallest fruit (weighing 15.3 and 16.2 g, respectively) with the highest seed content (15.2% and 17.3%, respectively). Gum content, expressed as a percentage of the dry weight, was highest in ‘Duraio’ (56.9%) and was lowest in ‘Rojal’ (54.1%). Thus, in terms of kernel and pod production, ‘Duraio’ appeared to be the best-performing female cultivar for planting new carob orchards

Disseny i caracterització d'estructures RF amb printed electronics per a RFID

En els últims anys printed electronics està aixecant un gran interès entre la indústria electrònica. Aquest tipus de procés consisteix en imprimir circuits amb tècniques d'impressió convencionals utilitzant tintes conductores, resistives, dielèctriques o semiconductores sobre substrats flexibles de baix cost com paper o plàstic. Fer servir aquestes tècniques s'espera que suposi una reducció dels costos de producció degut a que és un procés totalment additiu el que fa que sigui més senzill i es redueixi la quantitat de material emprat. El disseny de dispositius bàsics com resistències, condensadors i bobines per posteriorment veure la relació entre simulacions i valors obtinguts ha ocupat la primera part del projecte. La segona s’ha centrat en fer prototips d’antenes per a RFID (Radio Frequency IDentification) amb la tecnologia que es disposa a CEPHIS (Centre de Prototips i Solucions Hardwre-Software). Tot això ha servit per caracteritzar la tecnologia de la que es disposa i saber en quins apartats s’ha de seguir treballant per aconseguir millors prestacions.

On commercial media bias

Within the spokes model of Chen and Riordan (2007) that allowsfor non-localized competition among arbitrary numbers of media outlets, we quantify the effect of concentration of ownership on qualityand bias of media content. A main result shows that too few commercial outlets, or better, too few separate owners of commercial outlets can lead to substantial bias in equilibrium. Increasing the number of outlets (commercial and non-commercial) tends to bring down this bias; but the strongest effect occurs when the number of owners is increased. Allowing for free entry provides lower bounds on fixed costs above which substantial commercial bias occurs in equilibrium.

Concentration and self-censorship in commercial media

Within a simple model of non-localized, Hotelling-type competitionamong arbitrary numbers of media outlets we characterize qualityand content of media under different ownership structures. Assumingadvertising-sponsored, profit-maximizing outlets, we show that (i) topicssensitive to advertisers can be underreported (self-censored) by alloutlets in the market, (ii) self-censorship increases with the concentrationof ownership, (iii) adding outlets, while keeping the number ofowners fixed, may even increase self-censorship; the latter result relieson consumers' most preferred outlets being potentially owned by thesame media companies. We argue that externalities resulting fromself-censorship could be empirically large.

Gated Geiger mode avalanche photodiode pixels with integrated readout electronics for low noise photon detection

Avalanche photodiodes operated in the Geiger mode offer a high intrinsic gain as well as an excellent timing accuracy. These qualities make the sensor specially suitable for those applications where detectors with high sensitivity and low timing uncertainty are required. Moreover, they are compatible with standard CMOS technologies, allowing sensor and front-end electronics integration within the pixel cell. However, the sensor suffers from high levels of intrinsic noise, which may lead to erroneous results and limit the range of detectable signals. They also increase the amount of data that has to be stored. In this work, we present a pixel based on a Geiger-mode avalanche photodiode operated in the gated mode to reduce the probability to detect noise counts interfering with photon arrival events. The readout circuit is based on a two grounds scheme to enable low reverse bias overvoltages and consequently lessen the dark count rate. Experimental characterization of the fabricated pixel with the HV-AMS 0.35µm standard technology is also presented in this article.

Silicon nanocrystals as an enabling material for silicon Ppotonics

Silicon nanocrystals (Si-nc) is an enabling material for silicon photonics, which is no longer an emerging field of research but an available technology with the first commercial products available on the market. In this paper, properties and applications of Si-nc in silicon photonics are reviewed. After a brief history of silicon photonics, the limitations of silicon as a light emitter are discussed and the strategies to overcome them are briefly treated, with particular attention to the recent achievements. Emphasis is given to the visible optical gain properties of Si-nc and to its sensitization effect on Er ions to achieve infrared light amplification. The state of the art of Si-nc applied in a few photonic components is reviewed and discussed. The possibility to exploit Si-nc for solar cells is also presented. in addition, nonlinear optical effects, which enable fast all-optical switches, are described.

Electroluminiscence and optical amplification in silicon nanostructures: towards the integration of electronics and photonics

This line of research of my group intends to establish a Silicon technological platform in the field of photonics allowing the development of a wide set of applications. Particularly, what is still lacking in Silicon Photonics is an efficient and integrable light source such an LED or laser. Nanocrystals in silicon oxide or nitride matrices have been recently demonstrated as competitive materials for both active components (electrically and optically driven light emitters and optical amplifiers) and passive ones (waveguides and modulators). The final goal is the achievement of a complete integration of electronic and optical functions in the same CMOS chip. The first part of this paper will introduce the structural and optical properties of LEDs fabricated from silicon nanostructures. The second will treat the interaction of such nanocrystals with rare-earth elements (Er), which lead to an efficient hybrid system emitting in the third window of optical fibers. I will present the fabrication and assessment of optical waveguide amplifiers at 1.54 ¿m for which we have been able to demonstrate recently optical gain in waveguides made from sputtered silicon suboxide materials.

Optical correlation by use of partial phase-only modulation with VGA liquid-crystal displays

The development of liquid-crystal panels for use in commercial equipment has been aimed at improving the pixel resolution and the display efficiency. These improvements have led to a reduction in the thickness of such devices, among other outcomes, that involves a loss in phase modulation. We propose a modification of the classical phase-only filter to permit displays in VGA liquid-crystal panels with a constant amplitude modulation and less than a 2¿(PI) phase modulation. The method was tested experimentally in an optical setup.

Warranties used as a mean to promote commercial FOSS

From a business standpoint, this paper describes the point of view on the question of warranties of a FOSS editor doing business in a risk-averse market segment. It is based on 15-years experience of AdaCore in the safety-critical embedded industry. However, it is not only the point of view of a provider, as it also aims at demonstrating that the interests of providers and users are aligned in this area. From a legal point of view, the enforceability of these warranties will be partly covered, as well as the articulation between the license and the warranties on one hand, and the articulation between the license and the other contracts that can be created in a business relationship on the other hand.

Improvement of the thermal performance of commercial freezers using phase change materials (PCM)

The aim of this work is to improve the thermal performance of commercial freezers using phase change materials (PCM) and the prove the importance of the correct PCM selection (melting temperature) for each application. To do this a vertical freezer with and without macro encapsulation PCM are used to assess the benefits of using PCM in minimizing temperature fluctuations and to maintain at the lowest possible temperature the freezer under heat of losses.

How hard is a commercial puzzle: the eternity II challenge

Recently, edge matching puzzles, an NP-complete problem, have received, thanks to money-prized contests, considerable attention from wide audiences. We consider these competitions not only a challenge for SAT/CSP solving techniques but also as an opportunity to showcase the advances in the SAT/CSP community to a general audience. This paper studies the NP-complete problem of edge matching puzzles focusing on providing generation models of problem instances of variable hardness and on its resolution through the application of SAT and CSP techniques. From the generation side, we also identify the phase transition phenomena for each model. As solving methods, we employ both; SAT solvers through the translation to a SAT formula, and two ad-hoc CSP solvers we have developed, with different levels of consistency, employing several generic and specialized heuristics. Finally, we conducted an extensive experimental investigation to identify the hardest generation models and the best performing solving techniques.

Broadband prices in the European Union : competition and commercial strategies

This paper analyses the determinants of broadband Internet access prices in a group of 15 EU countries between 2008 and 2011. Using a rich panel dataset of broadband plans, we show the positive effect of downstream speed on prices, and report that cable and fibre-to-the-home technologies are available at lower prices per Mbps than x DSL technology. Operators’marketing strategies are also analysed as we show how much prices rise when the broadband service is offered in a bundle with voice telephony and/or television, and how much they fall when download volume caps are included. The most insightful results of this study are provided by a group of metrics that represent the situation of competition and entry patterns in the broadband market. We show that consumer segmentation positively affects prices. On the other hand, broadband prices are higher in countries where entrants make greater use of bitstream access and lower when they use more intensively direct access -local loop unbundling-. However, we do not find a significant effect of inter-platform competition on prices.

Fast and economic immobilization methods described for non-commercial Pseudomonas lipases

There is an increasing interest to seek new enzyme preparations for the development of new products derived from bioprocesses to obtain alternative bio-based materials. In this context, four non-commercial lipases from Pseudomonas species were prepared, immobilized on different low-cost supports, and examined for potential biotechnological applications. Results: To reduce costs of eventual scaling-up, the new lipases were obtained directly from crude cell extracts or from growth culture supernatants, and immobilized by simple adsorption on Accurel EP100, Accurel MP1000 and Celite (R) 545. The enzymes evaluated were LipA and LipC from Pseudomonas sp. 42A2, a thermostable mutant of LipC, and LipI. 3 from Pseudomonas CR611, which were produced in either homologous or heterologous hosts. Best immobilization results were obtained on Accurel EP100 for LipA and on Accurel MP1000 for LipC and its thermostable variant. Lip I. 3, requiring a refolding step, was poorly immobilized on all supports tested ( best results for Accurel MP1000). To test the behavior of immobilized lipases, they were assayed in triolein transesterification, where the best results were observed for lipases immobilized on Accurel MP1000. Conclusions: The suggested protocol does not require protein purification and uses crude enzymes immobilized by a fast adsorption technique on low-cost supports, which makes the method suitable for an eventual scaling up aimed at biotechnological applications. Therefore, a fast, simple and economic method for lipase preparation and immobilization has been set up. The low price of the supports tested and the simplicity of the procedure, skipping the tedious and expensive purification steps, will contribute to cost reduction in biotechnological lipase-catalyzed processes.

Improving the efficiency of PV low-power processing circuits by selecting an optimal inductor current of the DC/DC converter

In the context of autonomous sensors powered by small-size photovoltaic (PV) panels, this work analyses how the efficiency of DC/DC-converter-based power processing circuits can be improved by an appropriate selection of the inductor current that transfers the energy from the PV panel to a storage unit. Each component of power losses (fixed, conduction and switching losses) involved in the DC/DC converter specifically depends on the average inductor current so that there is an optimal value of this current that causes minimal losses and, hence, maximum efficiency. Such an idea has been tested experimentally using two commercial DC/DC converters whose average inductor current is adjustable. Experimental results show that the efficiency can be improved up to 12% by selecting an optimal value of that current, which is around 300-350 mA for such DC/DC converters.