Thin silicon films ranging from amorphous to nanocrystalline obtained by Hot-Wire CVD

In this paper, we have presented results on silicon thin films deposited by hot-wire CVD at low substrate temperatures (200 °C). Films ranging from amorphous to nanocrystalline were obtained by varying the filament temperature from 1500 to 1800 °C. A crystalline fraction of 50% was obtained for the sample deposited at 1700 °C. The results obtained seemed to indicate that atomic hydrogen plays a leading role in the obtaining of nanocrystalline silicon. The optoelectronic properties of the amorphous material obtained in these conditions are slightly poorer than the ones observed in device-grade films grown by plasma-enhanced CVD due to a higher hydrogen incorporation (13%).

Magnetic hardening mechanisms in Nd-Fe-B nanocrystalline material

Microstructural and magnetic measurements of the evolution by heat treatment of initially amorphous Nd16Fe76B8 alloys prepared by melt spinning are presented. Evidence of magnetic hardening above a threshold temperature induced by magnetic isolation of the Nd2Fe14B grains is provided. A thermodynamic and kinetic explanation of local melting of the intergranular nanostructured Nd¿rich eutectic phase at temperatures below 900 K based on capillary effects is presented. A subsequent Ostwald ripening process moves Nd to wet intimately the hard magnetic grains, becoming, on cooling, a real paramagnetic isolating thin film (~2.5 nm). By using a simple analogy, it is shown that the switching magnetization field in a single¿domain crystal can be drastically affected through the exchange coupling to neighboring grains with different orientation of the easy axis. This effect should be important enough to reinforce the coercive field of polycrystalline hard magnetic materials and explains the observed enhancement from 0.9 to 1.9 T.

Low temperature amorphous and nanocrystalline silicon thin film transistors deposited by Hot-Wire CVD on glass substrate

Amorphous and nanocrystalline silicon films obtained by Hot-Wire Chemical Vapor Deposition have been incorporated as active layers in n-type coplanar top gate thin film transistors deposited on glass substrates covered with SiO 2. Amorphous silicon devices exhibited mobility values of 1.3 cm 2 V - 1 s - 1, which are very high taking into account the amorphous nature of the material. Nanocrystalline transistors presented mobility values as high as 11.5 cm 2 V - 1 s - 1 and resulted in low threshold voltage shift (∼ 0.5 V).

Influence of pressure and radio frequency power on deposition rate and structural properties of hydrogenated amorphous silicon thin films prepared by plasma deposition

The influence of radio frequency (rf) power and pressure on deposition rate and structural properties of hydrogenated amorphous silicon (a-Si:H) thin films, prepared by rf glow discharge decomposition of silane, have been studied by phase modulated ellipsometry and Fourier transform infrared spectroscopy. It has been found two pressure regions separated by a threshold value around 20 Pa where the deposition rate increases suddenly. This behavior is more marked as rf power rises and reflects the transition between two rf discharges regimes. The best quality films have been obtained at low pressure and at low rf power but with deposition rates below 0.2 nm/s. In the high pressure region, the enhancement of deposition rate as rf power increases first gives rise to a reduction of film density and an increase of content of hydrogen bonded in polyhydride form because of plasma polymerization reactions. Further rise of rf power leads to a decrease of polyhydride bonding and the material density remains unchanged, thus allowing the growth of a-Si:H films at deposition rates above 1 nm/s without any important detriment of material quality. This overcoming of deposition rate limitation has been ascribed to the beneficial effects of ion bombardment on the a-Si:H growing surface by enhancing the surface mobility of adsorbed reactive species and by eliminating hydrogen bonded in polyhydride configurations.

Material flow accounting of Spain

Material throughput is a means of measuring the so-called social metabolism, or physical dimensions of a society’s consumption, and can be taken as an indirect and approximate indicator of sustainability. Material flow accounting can be used to test the dematerialisation hypothesis, the idea that technological progress causes a decrease in total material used (strong dematerialisation) or material used per monetary unit of output (weak dematerialisation). This paper sets out the results of a material flow analysis for Spain for the period from 1980 to 2000. The analysis reveals that neither strong nor weak dematerialisation took place during the period analysed. Although the population did not increase considerably, materials mobilised by the Spanish economy (DMI) increased by 85% in absolute terms, surpassing GDP growth. In addition, Spain became more dependent on external trade in physical terms. In fact, its imports are more than twice the amount of its exports in terms of weight.

Material flow accounting of Mexico (1970-2003)

This technical background paper describes the methods applied and data sources used in the compilation of the 1980-2003 data set for material flow accounts of the Mexican economy and presents the data set. It is organised in four parts: the first part gives an overview of the Material Flow Accounting (MFA) methodology. The second part presents the main material flows of the Mexican economy including biomass, fossil fuels, metal ores, industrial minerals and, construction minerals. The aim of this part is to explain the procedures and methods followed, the data sources used as well as providing a brief evaluation of the quality and reliability of the information used and the accounts established. Finally, some conclusions will be provided.

Material Flow Accounting in Chile, Ecuador, Mexico and Peru (1980-2000)

In this paper we compare the resource flows of Chile, Ecuador, Mexico and Peru between 1980 and 2000. In this time span, the domestic extraction of materials increased in the four countries, mainly due to the mining sector in Chile and Peru, biomass and oil in Ecuador and construction minerals in Mexico. Imports and exports increased too, due to the increasing integration in the international markets, prompted by the liberalization policies undertaken by the four countries between the late 1970s and the late 1990s. The four countries had a negative physical trade balance for most of the period analyzed, meaning that their exports exceeded their imports in terms of weight. However, the increase of imports reduced the physical deficit in Chile, Mexico and Peru. Ecuador’s physical deficit was the highest and did not decrease in the period analyzed. Also, a diversification of exports away from bulk commodities could be observed in Chile and Mexico, and to a lesser extent in Peru, whereas in Ecuador the export sector remained mainly based on oil and biomass. More research is needed to explore the environmental effects of this phenomenon. Also, the indirect flows associated to the direct physical flows deserve to be subject to further analysis.

Evaluación agronómica e industrial del material vegetal de avellano en Cataluña. Estudio de nuevas aplicaciones tecnológicas de la avellana

Los frutos secos representan un peso notable en la producción final agrícola española, siendo nuestro país el segundo productor mundial de almendra (55.000 tm grano) y el cuarto de avellana (9.000 tm grano). En el caso del avellano, la superficie de España es de unas 25.000 ha (MAPA, 2000), concentrándose el 95 % de la misma en Cataluña y, más concretamente en Tarragona (18.000 ha), donde el avellano es, en diversas comarcas, una importante fuente de ingresos. Durante las últimas décadas, el sector ha estado sometido a fuertes crisis debido al descenso de precios causado, entre otros motivos, por la existencia o no de acuerdos comerciales entre la UE y Turquía sobre este fruto seco, por las oscilaciones del dólar y la competencia creciente de Turquía, que produce casi el 75 % del total mundial y cuyos costes de producción son más reducidos, por disponer de mano de obra más barata y mejores condiciones edafoclimáticas para el cultivo. Un problema adicional de la avellana española en dicho periodo, fue la poca calidad del producto obtenido, motivada por la realización inadecuada de una serie de prácticas de recogida y de postcosecha. La variedad 'Negret' es la base de la producción de avellana española para industria y, junto con la ‘Pauetet’, constituyen el tipo comercial ‘negreta’ que es el que obtiene mejor precio en el mercado nacional. Ello es debido a sus buenas características organolépticas y elevada aptitud al tostado, que constituye el punto de partida de la mayoría de aplicaciones comerciales. Por otra parte, constituye, también, la base de la producción de la Denominación de Origen ‘Avellana de Reus’. Tradicionalmente esta variedad adolece de importantes problemas de tipo agronómico (poco vigor, rebrotante, sensible a clorosis férrica, asfixia del suelo, muy virosada, etc.) y comercial (facilidad de enranciamiento, calibres pequeños, etc.), situación que ha inducido, en la última década, a la introducción de variedades foráneas (‘Tonda Giffoni’ y ‘Tonda Romana’) que en principio no presentan estos problemas. Sin embargo, la sustitución de la variedad autóctona ‘Negret’ por otras nuevas supondría la pérdida de un carácter diferencial para la producción española, que debe evaluarse con sumo cuidado.

Mejora de la competitividad de las plantaciones frutales de nogal: selección de material vegetal, desarrollo de un modelo de predicción de la infección de Xanthomonas arboricola pv. juglandis y optimización de las podas de formación y producción

En las colecciones del IRTA-Mas Bové se han caracterizado más de 150 clones de nogal procedentes de prospección, material extranjero y de selecciones de distintos programas de mejora. El material se ha caracterizado agronómicamente siguiendo los descriptores del IPGRI (1994). Actualmente existen fichas descriptivas muy amplias de 43 accesiones. Toda esta información sobre el comportamiento del material vegetal en las condiciones climáticas de Tarragona, tiene interés a nivel científico y es muy válida para posibles plantaciones con nuevo material. El estudio de los caracteres de sensibilidad a Bacteriosis y afección de la caída prematura de flores (PFA), en dos decendencias de nogal de cruzamientos controlados, ha permitido obvervar que estos caracteres tienen una herencia compleja. Se ha establecido la virulencia de distintos aislados de Xanthomonas arboricola pv. juglandis, en nogal. Los aislados más virulentos se han utilizado para establecer un modelo de predicción, en condiciones de laboratorio, de esta bacteria en nogal. La temperatura a la que la severidad de la enfermedad es máxima es 26ºC. A esta temperatura un aumento en la duración del período de humedad relativa elevada de 0-24 horas, produce un aumento de la afección. En los próximos años, este modelo de predicción se validará en campo. Si los resultados son positivos, permitirán racionalizar los tratamientos para la Bacteriosis en las plantaciones de nogal. Los primeros resultados de un control de la iluminación en el interior de las copas de los árboles, realizado mediante medidas de iluminación interceptadas con un ceptómetro Delta T (SunScan), han puesto de manifiesto que la gran influencia de la luz en el crecimiento anual de las ramas. Así, en la formación y poda de los árbles hay que tener presente estos resultados, en especial en las formaciones en ejes libres, y favorecer la máxima entrada de luz en el interior de la copa de los árboles.

The biophysical perspective of a middle income economy: material flows in Mexico

We analyse natural resource use dynamics in the Mexican economy during the last three decades. Despite low and uneven economic growth, the extraction and use of materials in the Mexican economy has continuously increased during the last 30 years. In this period, population growth rather than economic growth was the main driving force for biophysical growth. In addition, fundamental changes have taken place in the primary sectors, in manufacturing, and in household consumption and these are reflected in an increasing emphasis on the use of fossil fuels and construction materials. Mexico’s economy has been strongly influenced by international trade since the country commenced competing in international markets. In the 1970s, Mexico mainly exported primary resources. This pattern has changed and manufactured goods now have a much greater importance due to a boom in assembling industries. In contrast with other Latin American countries, Mexico has achieved a diversification of production, moving towards technology-intensive products and a better mix in its export portfolio. However, crude oil exports still represent the single most important export good. Mexico’s material consumption is still well below the OECD average but is growing fast and the current resource use patterns may well present serious social and environmental problems to the medium and long term sustainability of Mexico’s economy and community. Information on natural resource use and resource productivity could provide valuable guidance for economic policy planning in Mexico.

Aplicatiu de gestió de material multimèdia produït amb Dalet Plus

A principis de 2002, a la facultat de Ciències de la Comunicació de la Universitat Autònoma de Barcelona es va implantar un sistema de digitalització d'àudio, per tal de modernitzar els laboratoris de ràdio i adaptar-los a la realitat actual dels massmedia. Aquest sistema, anomenat Dalet Plus, permet produir, editar i gestionar material multimèdia relacionat amb les assignatures de ràdio impartides a la facultat. Fins ara, no existia cap aplicació que gestionés el material de cursos anteriors produït amb el sistema Dalet. L'objectiu d'aquest projecte, és desenvolupar una aplicació en entorn web, accessible a tothom, per a que alumnes, professors i tècnics puguin consultar, reproduir i recuperar, el material produït amb el sistema Dalet Plus de cursos anteriors.