Structural and gas-sensing properties of WO3 nanocrystalline powders obtained by a sol-gel method from tungstic acid

WO3 nanocrystalline powders were obtained from tungstic acid following a sol-gel process. Evolution of structural properties with annealing temperature was studied by X-ray diffraction and Raman spectroscopy. These structural properties were compared with those of WO3 nanopowders obtained by the most common process of pyrolysis of ammonium paratungstate, usually used in gas sensors applications. Sol-gel WO3 showed a high sensor response to NO2 and low response to CO and CH4. The response of these sensor devices was compared with that of WO3 obtained from pyrolysis, showing the latter a worse sensor response to NO2. Influence of operating temperature, humidity, and film thickness on NO2 detection was studied in order to improve the sensing conditions to this gas.

A time-domain method for the analysis of thermal impedance response preserving the convolution form

The study of the thermal behavior of complex packages as multichip modules (MCM¿s) is usually carried out by measuring the so-called thermal impedance response, that is: the transient temperature after a power step. From the analysis of this signal, the thermal frequency response can be estimated, and consequently, compact thermal models may be extracted. We present a method to obtain an estimate of the time constant distribution underlying the observed transient. The method is based on an iterative deconvolution that produces an approximation to the time constant spectrum while preserving a convenient convolution form. This method is applied to the obtained thermal response of a microstructure as analyzed by finite element method as well as to the measured thermal response of a transistor array integrated circuit (IC) in a SMD package.

Una comparación de la selección de los ratios contables en los modelos contable-financieros de predicción de la insolvencia empresarial : la literatura previa frente al analisis factorial

En los últimos 30 años la proliferación de modelos cuantitativos de predicción de la insolvencia empresarial en la literatura contable y financiera ha despertado un gran interés entre los especialistas e investigadores de lamateria. Lo que en un principio fueron unos modelos elaborados con un único objetivo, han derivado en una fuente de investigación constante.En este documento se formula un modelo de predicción de la insolvencia a través de la combinación de diferentes variables cuantitativas extraídas de los estados contables de una muestra de empresas para los años 1994-1997. A través de un procedimiento por etapas se selecciona e interpreta cuáles son las más relevantes en cuanto a aportación de información.Una vez formulado este primer tipo de modelos se busca una alternativa a las variables anteriores a través de la técnica factorial del análisis de componentes principales. Con ella se hace una selección de variables y se aplica, junto conlos ratios anteriores, el análisis univariante. Por último, se comparan los modelos obtenidos y se concluye que aunque la literatura previa ofrece mejores porcentajes de clasificación, los modelos obtenidos a través del análisis decomponentes principales no deben ser rechazados por la claridad en la explicación de las causas que conducen a una empresa a la insolvencia.

Anàlisi factorial confirmatòria per a variables categòriques: Aplicació al qüestionari de discapacitat WHODAS-II

Objective: To describe the methodology of Confirmatory Factor Analyis for categorical items and to apply this methodology to evaluate the factor structure and invariance of the WHO-Disability Assessment Schedule (WHODAS-II) questionnaire, developed by the World HealthOrganization.Methods: Data used for the analysis come from the European Study of Mental Disorders(ESEMeD), a cross-sectional interview to a representative sample of the general population of 6 european countries (n=8796). Respondents were administered a modified version of theWHODAS-II, that measures functional disability in the previous 30 days in 6 differentdimensions: Understanding and Communicating; Self-Care, Getting Around, Getting Along withOthers, Life Activities and Participation. The questionnaire includes two types of items: 22severity items (5 points likert) and 8 frequency items (continuous). An Exploratory factoranalysis (EFA) with promax rotation was conducted on a random 50% of the sample. Theremaining half of the sample was used to perform a Confirmatory Factor Analysis (CFA) inorder to compare three different models: (a) the model suggested by the results obtained in theEFA; (b) the theoretical model suggested by the WHO with 6 dimensions; (c) a reduced modelequivalent to model b where 4 of the frequency items are excluded. Moreover, a second orderfactor was also evaluated. Finally, a CFA with covariates was estimated in order to evaluatemeasurement invariance of the items between Mediterranean and non-mediterranean countries.Results: The solution that provided better results in the EFA was that containing 7 factors. Twoof the frequency items presented high factor loadings in the same factor, and one of thempresented factor loadings smaller than 0.3 with all the factors. With regard to the CFA, thereduced model (model c) presented the best goodness of fit results (CFI=0.992,TLI=0.996,RMSEA=0.024). The second order factor structure presented adequate goodness of fit (CFI=0.987,TLI=0.991, RMSEA=0.036). Measurement non-invariance was detected for one of the items of thequestionnaire (FD20 ¿ Embarrassment due to health problems).Conclusions: AFC confirmed the initial hypothesis about the factorial structure of the WHODAS-II in 6factors. The second order factor supports the existence of a global dimension of disability. The use of 4of the frequency items is not recommended in the scoring of the corresponding dimensions.

Bargmann-Wigner method and (6S + 1)-component wave equations

A modified Bargmann-Wigner method is used to derive (6s + 1)-component wave equations. The relation between different forms of these equations is shown.

A simple method for the simulation of multiple elastic scattering of electrons

A screened Rutherford cross section is modified by means of a correction factor to obtain the proper transport cross section computed by partial¿wave analysis. The correction factor is tabulated for electron energies in the range 0¿100 keV and for elements in the range from Z=4 to 82. The modified screened Rutherford cross section is shown to be useful as an approximation for the simulation of plural and multiple scattering. Its performance and limitations are exemplified for electrons scattered in Al and Au.

Simple method for the simulation of multiple elastic scattering of electrons

A screened Rutherford cross section is modified by means of a correction factor to obtain the proper transport cross section computed by partial¿wave analysis. The correction factor is tabulated for electron energies in the range 0¿100 keV and for elements in the range from Z=4 to 82. The modified screened Rutherford cross section is shown to be useful as an approximation for the simulation of plural and multiple scattering. Its performance and limitations are exemplified for electrons scattered in Al and Au.

Heat pulse line-source method to determine thermal conductivity of consolidated rocks

An instrument designed to measure thermal conductivity of consolidated rocks, dry or saturated, using a transient method is presented. The instrument measures relative values of the thermal conductivity, and it needs calibration to obtain absolute values. The device can be used as heat pulse line source and as continuous heat line source. Two parameters to determine thermal conductivity are proposed: TMAX, in heat pulse line source, and SLOPE, in continuous heat line source. Its performance is better, and the operation simpler, in heat pulse line-source mode with a measuring time of 170 s and a reproducibility better than 2.5%. The sample preparation is very simple on both modes. The performance has been tested with a set of ten rocks with thermal conductivity values between 1.4 and 5.2 W m¿1 K¿1 which covers the usual range for consolidated rocks.

Phase-only filters codified with Burckhardt's method

We show that Burckhardt's method is available to codify phase-only filters with amplitude-only variations. Correlation experimental results are given.

Correlation postprocessing-based method for the detection of de focused images

We present a method to detect patterns in defocused scenes by means of a joint transform correlator. We describe analytically the correlation plane, and we also introduce an original procedure to recognize the target by postprocessing the correlation plane. The performance of the methodology when the defocused images are corrupted by additive noise is also considered.

General method to determine replica symmetry breaking transitions

We introduce a new parameter to investigate replica symmetry breaking transitions using finite-size scaling methods. Based on exact equalities initially derived by F. Guerra this parameter is a direct check of the self-averaging character of the spin-glass order parameter. This new parameter can be used to study models with time reversal symmetry but its greatest interest lies in models where this symmetry is absent. We apply the method to long-range and short-range Ising spin-glasses with and without a magnetic field as well as short-range multispin interaction spin-glasses.

Discriminant ECOC: a heuristic method for application dependent design of error correcting output codes

We present a heuristic method for learning error correcting output codes matrices based on a hierarchical partition of the class space that maximizes a discriminative criterion. To achieve this goal, the optimal codeword separation is sacrificed in favor of a maximum class discrimination in the partitions. The creation of the hierarchical partition set is performed using a binary tree. As a result, a compact matrix with high discrimination power is obtained. Our method is validated using the UCI database and applied to a real problem, the classification of traffic sign images.

Extrapolation theory for the real interpolation method

We develop an abstract extrapolation theory for the real interpolation method that covers and improves the most recent versions of the celebrated theorems of Yano and Zygmund. As a consequence of our method, we give new endpoint estimates of the embedding Sobolev theorem for an arbitrary domain Omega

Fecal pellets collection as a method for assessing egesta of the marine cave-dwelling mysid Hemimysis speluncula

Egesta of a cave-dwelling mysid (Hemimysis speluncola Ledoyer, 1963) was studied in a submarine cave of Medes Islands, NW Mediterranean by in situ fecal pellet collecting. Fecal pellet production and gut fullness of mysids during incubation experiments are used to estimate mysid egestion rates. Intrinsic factors related with the natural history of this species such as population structure, density of mysids, daily rhythms and pellet decomposition rates are tested for their influence on the egestion rate. The effects of methodological artifacts, such as the stress induced by both incubation and preservation procedures, are also studied. An average mysid egests about 2.5 pellets per day into the cave. The time of day is the main factor affecting egestion. The highest deposition rate is between 2 to 4 hours after sunrise when about 38 % of the total daily pellet production becomes egested. Fecal pellet morphology changes with mysid demographic classes: immature mysids produce slender and thick pellets, whereas mature mysids produce only thick pellets. Immature classes show higher percentages of full guts than mature ones. Mysid density in the incubators does not affect the results on gut fullness, but it causes a decrease in the number of pellets collected after incubation. Coprorhexia seems to be the only plausible process to explain this paradox. The incubation procedure does not increase deposition rate significantly. Time of incubation is critical because the half-life of fecal pellets is about 2.5 hours. Fixation with liquid nitrogen decreases gut fullness and also deposition rates. Higher values are obtained with 70 % ethanol and 5 % formalin solutions which show very similar results for both gut fullness and pellet deposition rates. Nevertheless, ethanol is not suitable as fixative because it enhances the opacity of the body. Several suggestions are given in order to optimize the reliability of further in situ experiments for evaluation of egesta of Hemimysis speluncola in submarine caves.