Els sufixos apreciatius: una descripció del problema i una proposta d'anàlisi semàntica

L'objectiu d'aquest article és doble. D'una banda, s'exposen els problemes que planteja l’anàlisi que la morfologia generativa ha proposat per a la sufixació apreciativa, especialment per a noms i adjectius. D'altra banda, es defensa la unificació de dos tipus d'afixos apreciatius que les gramàtiques tradicionals han considerat diferents: els sufixos que s'adjunten a arrels nominals (diminutius, augmentatius i despectius) i els que s'adjunten a arrels adjectivals (anomenats intensius ). Aquest treball es centra, fonamentalment, en les dades del català i es demostra que hi ha raons per suposar que tots els sufixos apreciatius formen una única classe d'afixos. Si bé es discuteixen diversos aspectes problemàtics d'aquests derivats, només es presenta una proposta de solució al de la interpretació semàntica. Es defensa que les diferències en la interpretació semàntica dels derivats es poden deduir de l'estructura lexicoconceptual (ELC) de la base i de l'element d'aquesta ELC que sigui modificat per l'afix

CAC controlled services sharing a link with connectionless data services in an ATM network: a performance evaluation study

In the B-ISDN there is a provision for four classes of services, all of them supported by a single transport network (the ATM network). Three of these services, the connected oriented (CO) ones, permit connection access control (CAC) but the fourth, the connectionless oriented (CLO) one, does not. Therefore, when CLO service and CO services have to share the same ATM link, a conflict may arise. This is because a bandwidth allocation to obtain maximum statistical gain can damage the contracted ATM quality of service (QOS); and vice versa, in order to guarantee the contracted QOS, the statistical gain have to be sacrificed. The paper presents a performance evaluation study of the influence of the CLO service on a CO service (a circuit emulation service or a variable bit-rate service) when sharing the same link

Bandwidth allocation based on real time calculations using the convolution approach

This paper focuses on one of the methods for bandwidth allocation in an ATM network: the convolution approach. The convolution approach permits an accurate study of the system load in statistical terms by accumulated calculations, since probabilistic results of the bandwidth allocation can be obtained. Nevertheless, the convolution approach has a high cost in terms of calculation and storage requirements. This aspect makes real-time calculations difficult, so many authors do not consider this approach. With the aim of reducing the cost we propose to use the multinomial distribution function: the enhanced convolution approach (ECA). This permits direct computation of the associated probabilities of the instantaneous bandwidth requirements and makes a simple deconvolution process possible. The ECA is used in connection acceptance control, and some results are presented

Multicast algorithms evaluation using an adaptative routing in ATM networks

This paper proposes a multicast implementation based on adaptive routing with anticipated calculation. Three different cost measures for a point-to-multipoint connection: bandwidth cost, connection establishment cost and switching cost can be considered. The application of the method based on pre-evaluated routing tables makes possible the reduction of bandwidth cost and connection establishment cost individually

Fast calculation of the CAC convolution algorithm using the multinomial distribution function

The authors focus on one of the methods for connection acceptance control (CAC) in an ATM network: the convolution approach. With the aim of reducing the cost in terms of calculation and storage requirements, they propose the use of the multinomial distribution function. This permits direct computation of the associated probabilities of the instantaneous bandwidth requirements. This in turn makes possible a simple deconvolution process. Moreover, under certain conditions additional improvements may be achieved

Using petri nets to specify and execute missions for autonomous underwater vehicles

This paper presents the design and implementation of a mission control system (MCS) for an autonomous underwater vehicle (AUV) based on Petri nets. In the proposed approach the Petri nets are used to specify as well as to execute the desired autonomous vehicle mission. The mission is easily described using an imperative programming language called mission control language (MCL) that formally describes the mission execution thread. A mission control language compiler (MCL-C) able to automatically translate the MCL into a Petri net is described and a real-time Petri net player that allows to execute the resulting Petri net onboard an AUV are also presented

Enhanced Model Selection for motion segmentation

In this paper a novel rank estimation technique for trajectories motion segmentation within the Local Subspace Affinity (LSA) framework is presented. This technique, called Enhanced Model Selection (EMS), is based on the relationship between the estimated rank of the trajectory matrix and the affinity matrix built by LSA. The results on synthetic and real data show that without any a priori knowledge, EMS automatically provides an accurate and robust rank estimation, improving the accuracy of the final motion segmentation

La Participació dels estudiants en la universitat. Anàlisi de la situació a la Universitat de Girona

Aquest estudi posa a debat tant els nivells com les formes de participació dels estudiants en el funcionament de la universitat amb la finalitat d’aprofundir en els models i les dinàmiques que afavoreixen la participació dels estudiants. Parteix de l’estudi del cas de la Universitat de Girona i recull, des de diferents punts de vista, quina és la situació actual pel que fa a la participació dels estudiants en aquesta universitat, i es proposen algunes línies d’actuació per promoure-la. A la base d’aquest estudi se situa el convenciment que la participació dels estudiants en el funcionament de la universitat és un objectiu desitjable per part de la comunitat universitària, i que, com a centre de formació que és la universitat, cal que es plantegi la participació com un objectiu d’aprenentatge propi ja que, a més de formar científi cs i professionals en diferents àmbits, la universitat també contribueix (o hauria de contribuir) a la formació de ciutadans. Es tracta d’un treball fi nançat per la convocatòria 20 de la UdG d’ajuts a projectes cooperatius d’R+D en els àmbits humanístic i de les ciències socials i que s’ha desenvolupat en la seva major part durant l’any 2008 i inicis del 2009. Les dades de participació que es presenten sobre la UdG són de l’any 2008

Multi-isotopic and compositional exploration of factors controlling nitrate pollution

In Catalonia, according to the nitrate directive (91/676/EU), nine areas have been declared as vulnerable to nitrate pollution from agricultural sources (Decret 283/1998 and Decret 479/2004). Five of these areas have been studied coupling hydro chemical data with a multi-isotopic approach (Vitòria et al. 2005, Otero et al. 2007, Puig et al. 2007), in an ongoing research project looking for an integrated application of classical hydrochemistry data, with a comprehensive isotopic characterisation (δ15N and δ18O of dissolved nitrate, δ34S and δ18O of dissolved sulphate, δ13C of dissolved inorganic carbon, and δD and δ18O of water). Within this general frame, the contribution presented explores compositional ways of: (i) distinguish agrochemicals and manure N pollution, (ii) quantify natural attenuation of nitrate (denitrification), and identify possible controlling factors.To achieve this two-fold goal, the following techniques have been used. Separate biplots of each suite of data show that each studied region has a distinct δ34S and pH signatures, but they are homogeneous with regard to NO3- related variables. Also, the geochemical variables were projected onto the compositional directions associated with the possible denitrification reactions in each region. The resulting balances can be plot together with some isotopes, to assess their likelihood of occurrence

Modelling scenarios of diffusion and control of pandemic influenza, italy

En aquest article es resumeixen els resultats publicats en un informe de l' ISS (Istituto Superiore di Sanità) del desembre de 2006, sobre un model matemàtic desenvolupat per un grup de treball que inclou a investigadors de les Universitats de Trento, Pisa i Roma, i els Instituts Nacionals de Salut (Istituto Superiore di Sanità, ISS), per avaluar i mesurar l'impacte de la transmissió i el control de la pandèmia de grip

Studies in stoichiometry with compositional data

Geochemical data that is derived from the whole or partial analysis of various geologic materialsrepresent a composition of mineralogies or solute species. Minerals are composed of structuredrelationships between cations and anions which, through atomic and molecular forces, keep the elementsbound in specific configurations. The chemical compositions of minerals have specific relationships thatare governed by these molecular controls. In the case of olivine, there is a well-defined relationshipbetween Mn-Fe-Mg with Si. Balances between the principal elements defining olivine composition andother significant constituents in the composition (Al, Ti) have been defined, resulting in a near-linearrelationship between the logarithmic relative proportion of Si versus (MgMnFe) and Mg versus (MnFe),which is typically described but poorly illustrated in the simplex.The present contribution corresponds to ongoing research, which attempts to relate stoichiometry andgeochemical data using compositional geometry. We describe here the approach by which stoichiometricrelationships based on mineralogical constraints can be accounted for in the space of simplicialcoordinates using olivines as an example. Further examples for other mineral types (plagioclases andmore complex minerals such as clays) are needed. Issues that remain to be dealt with include thereduction of a bulk chemical composition of a rock comprised of several minerals from which appropriatebalances can be used to describe the composition in a realistic mineralogical framework. The overallobjective of our research is to answer the question: In the cases where the mineralogy is unknown, arethere suitable proxies that can be substituted?Kew words: Aitchison geometry, balances, mineral composition, oxides

Clustering compositional data trajectories

Our essay aims at studying suitable statistical methods for the clustering ofcompositional data in situations where observations are constituted by trajectories ofcompositional data, that is, by sequences of composition measurements along a domain.Observed trajectories are known as “functional data” and several methods have beenproposed for their analysis.In particular, methods for clustering functional data, known as Functional ClusterAnalysis (FCA), have been applied by practitioners and scientists in many fields. To ourknowledge, FCA techniques have not been extended to cope with the problem ofclustering compositional data trajectories. In order to extend FCA techniques to theanalysis of compositional data, FCA clustering techniques have to be adapted by using asuitable compositional algebra.The present work centres on the following question: given a sample of compositionaldata trajectories, how can we formulate a segmentation procedure giving homogeneousclasses? To address this problem we follow the steps described below.First of all we adapt the well-known spline smoothing techniques in order to cope withthe smoothing of compositional data trajectories. In fact, an observed curve can bethought of as the sum of a smooth part plus some noise due to measurement errors.Spline smoothing techniques are used to isolate the smooth part of the trajectory:clustering algorithms are then applied to these smooth curves.The second step consists in building suitable metrics for measuring the dissimilaritybetween trajectories: we propose a metric that accounts for difference in both shape andlevel, and a metric accounting for differences in shape only.A simulation study is performed in order to evaluate the proposed methodologies, usingboth hierarchical and partitional clustering algorithm. The quality of the obtained resultsis assessed by means of several indices

Possible solution of some essential zero problems in compositional data analysis

One of the tantalising remaining problems in compositional data analysis lies in how to deal with data sets in which there are components which are essential zeros. By anessential zero we mean a component which is truly zero, not something recorded as zero simply because the experimental design or the measuring instrument has not been sufficiently sensitive to detect a trace of the part. Such essential zeros occur inmany compositional situations, such as household budget patterns, time budgets,palaeontological zonation studies, ecological abundance studies. Devices such as nonzero replacement and amalgamation are almost invariably ad hoc and unsuccessful insuch situations. From consideration of such examples it seems sensible to build up amodel in two stages, the first determining where the zeros will occur and the secondhow the unit available is distributed among the non-zero parts. In this paper we suggest two such models, an independent binomial conditional logistic normal model and a hierarchical dependent binomial conditional logistic normal model. The compositional data in such modelling consist of an incidence matrix and a conditional compositional matrix. Interesting statistical problems arise, such as the question of estimability of parameters, the nature of the computational process for the estimation of both the incidence and compositional parameters caused by the complexity of the subcompositional structure, the formation of meaningful hypotheses, and the devising of suitable testing methodology within a lattice of such essential zero-compositional hypotheses. The methodology is illustrated by application to both simulated and real compositional data

Intraovarian sperm storage in Helicolenus dactylopterus dactylopterus fertilitzation, crypt formation and maintenance of stored sperm

The females of the bluemouth rockfish, Helicolenus dactylopterus dactylopterus (DelaRoche, 1809), store sperm within their ovaries for periods of up to 10 months. Twenty six females with standard lengths between 152 and 257 mm and six males with standard lengths between 253 and 209 mm were caught storage crypts with stored spermatozoa and to describe their evolution over the year. After internal fertilization and once sperm reaches the ovary, a crypt forms probably by an epithelial inclusion at the base of the lamellae of one or several spermatozoa groups that are floating freely in the interlamellar space of the ovarian lumen. Stored spermatozoa have a large cytoplasm bag surrounding their heads. This bag could serve as a nutritive reservoir during the long storage period. Many desmosonal and tight junctions between the crypt cells ensure tha male sex cells are protected against the female immune system

A hybrid method for sag source location in power network

The work presented in this paper belongs to the power quality knowledge area and deals with the voltage sags in power transmission and distribution systems. Propagating throughout the power network, voltage sags can cause plenty of problems for domestic and industrial loads that can financially cost a lot. To impose penalties to responsible party and to improve monitoring and mitigation strategies, sags must be located in the power network. With such a worthwhile objective, this paper comes up with a new method for associating a sag waveform with its origin in transmission and distribution networks. It solves this problem through developing hybrid methods which hire multiway principal component analysis (MPCA) as a dimension reduction tool. MPCA reexpresses sag waveforms in a new subspace just in a few scores. We train some well-known classifiers with these scores and exploit them for classification of future sags. The capabilities of the proposed method for dimension reduction and classification are examined using the real data gathered from three substations in Catalonia, Spain. The obtained classification rates certify the goodness and powerfulness of the developed hybrid methods as brand-new tools for sag classification