Resonating-valence-bond theory for the square-planar lattice

The short-range resonating-valence-bond (RVB) wave function with nearest-neighbor (NN) spin pairings only is investigated as a possible description for the Heisenberg model on a square-planar lattice. A type of long-range order associated to this RVB Ansatz is identified along with some qualitative consequences involving lattice distortions, excitations, and their coupling.

Coherent tunnelling in Cu2+- and Ag2+-doped MgO and CaO: Cu2+ explored through ab initio calculations

The observation of coherent tunnelling in Cu2+ - and Ag2+ -doped MgO and CaO:Cu2+ was a crucial discovery in the realm of the Jahn-Teller (JT) effect. The main reasons favoring this dynamic behavior are now clarified through ab initio calculations on Cu2+ - and Ag2+ -doped cubic oxides. Small JT distortions and an unexpected low anharmonicity of the eg JT mode are behind energy barriers smaller than 25 cm-1 derived through CASPT2 calculations for Cu2+ - and Ag2+ -doped MgO and CaO:Cu2+ . The low anharmonicity is shown to come from a strong vibrational coupling of MO610- units (M=Cu,Ag) to the host lattice. The average distance between the d9 impurity and ligands is found to vary significantly on passing from MgO to SrO following to a good extent the lattice parameter.

Volcanic stratigraphy of Hannah Point, Livingston Island, South Shetland Islands, Antarctica

The Upper Cretaceous volcanic succession of Hannah Point is the best exposure of the Antarctic Peninsula Volcanic Group on L ivingston Island. The aim of the present paper is to contribute to the characterisation of the stratigr a p hy and petrogr a p hy of this little studied succession, and briefly discuss some aspects of the eru p t ive style of its volcanism. The succession is about 470 m thick and is here subdivided into five lithostratigraphic units (A to E from base to top). Unit A, approximately 120 m thick, is mainly composed of polymict clast-supported volcaniclastic breccias and also includes a dacitic lava laye r. Interstratified in the breccias of this unit, there is a thin laminated devitrified layer which shows some degree of welding. Unit B, approx imately 70 m thick, is almost entirely composed of volcaniclastic breccias, and includes a volcaniclastic conglomerate laye r. Breccias in this unit can be subdivided into two distinct types; polymict clast-supported breccias, and monomict matrix-supported breccias rich in juvenile components and displaying incipient welding. Unit C, about 65 m thick, is mainly composed of basaltic lavas, which are interlayered with minor vo lcaniclastic breccias. Unit D, approximately 65 m thick, is lithologically similar to unit B, composed of an alternation of polymict clasts upported breccias and matrix-supported breccias, and includes a volcaniclastic conglomerate laye r. Unit E, about 150 m thick, is mainly formed of thick andesitic lava layers. Minor basaltic dykes and a few normal faults cut the succession, and the contact betwe e n units A and B can be interpreted both as an unconformity or a fault. The matrix-supported breccias included in the succession of Hannah Point have high contents of juvenile components and incipient welding, which suggest that part of the succession is the result of pyroclastic fragmentation and emplacement from pyroclastic flows. In contrast, the polymict clast-supported breccias suggest reworking of previous deposits and deposition from cool mass flows. The lavas indicate eff u s ive volcanic eruptions, and the absence of features indicative of subaqueous volcanism suggests that at least these portions of the succession were emplaced in a subaerial environment .

Structural development accounting

We construct and estimate a unified model combining three of the main sources ofcross-country income disparities: differences in factor endowments, barriers to technologyadoption and the inappropriateness of frontier technologies to local conditions. The keycomponents are different types of workers, distortions to capital accumulation, directedtechnical change, costly adoption and spillovers from the world technology frontier. Despiteits parsimonious parametrization, our empirical model provides a good fit of GDP data forup to 86 countries in 1970 and 122 countries in 2000. Removing barriers to technologyadoption would increase the output per worker of the average non-OECD country relativeto the US from 0.19 to 0.61, while increasing skill premia in all countries. Removing barriersto trade in goods amplifies income disparities, induces skill-biased technology adoptionand increases skill premia in the majority of countries. These results are reverted if tradeliberalization is coupled with international IPR protection.

The Conservativeness of the Central Bank when Institutional Quality is Poor

We propose an extension of Alesina and Tabellini 's model (1987) to include corruption, which is understood as the presence of weak institutions collecting revenue through formal tax channels. This paper analyses how conservative should an independent central bank be when the institutional quality is poor. When there are no political distortions, we show that the central bank has to be more conservative than the government, except with complete corruption. In this particular case, the central bank should be as conservative as the government. Further, we obtain that the relationship between the optimal relative degree of conservativeness of the central bank and the degree of corruption is affected by supply shocks. Concretely, when these shocks are not important, the central bank should be less conservative if the degree of corruption increases. However, this result may not hold when the shocks are relevant. JEL classi fication: D6, D73, E52, E58, E62, E63. Keywords: Central Bank Conservativeness; Corruption; Fiscal Policy; Monetary Policy; Seigniorage.

Application of the Mutual Information Minimization to speaker recognition / identification improvement

In this paper we propose the inversion of nonlinear distortions in order to improve the recognition rates of a speaker recognizer system. We study the effect of saturations on the test signals, trying to take into account real situations where the training material has been recorded in a controlled situation but the testing signals present some mismatch with the input signal level (saturations). The experimental results for speaker recognition shows that a combination of several strategies can improve the recognition rates with saturated test sentences from 80% to 89.39%, while the results with clean speech (without saturation) is 87.76% for one microphone, and for speaker identification can reduce the minimum detection cost function with saturated test sentences from 6.42% to 4.15%, while the results with clean speech (without saturation) is 5.74% for one microphone and 7.02% for the other one.

Quasi-Nonparametric Blind Inversion of Wiener Systems

An e cient procedure for the blind inversion of a nonlinear Wiener system is proposed. We proved that the problem can be expressed as a problem of blind source separation in nonlinear mixtures, for which a solution has been recently proposed. Based on a quasi-nonparametric relative gradient descent, the proposed algorithm can perform e ciently even in the presence of hard distortions.

Standardized enforcement: Access to justice vs. contractual innovation

We model the effect of contract standardization on the development of markets andthe law. In a setting in which biased judges can distort contract enforcement, we findthat the introduction of a standard contract reduces enforcement distortions relative toreliance on precedents, exerting two effects: i) it statically expands the volume of trade,but ii) it crowds out the use of open-ended contracts, hindering legal evolution. We shedlight on the large-scale commercial codification undertaken in the nineteenth centuryin many countries (even common-law ones) during a period of booming commerce andlong-distance trade.

Microwave spectrometry for the Evaluation of the structural integrity of metallic stents

Purpose: To assess the feasibility of a method based on microwave spectrometry to detect structural distortions of metallic stents in open air conditions and envisage the prospects of this approach toward possible medical applicability for the evaluation of implanted stents. Methods: Microwave absorbance spectra between 2.0 and 18.0 GHz were acquired in open air for the characterization of a set of commercial stents using a specifically design setup. Rotating each sample over 360º, 2D absorbance diagrams were generated as a function of frequency and rotation angle. To check our approach for detecting changes in stent length (fracture) and diameter (recoil), two specific tests were performed in open air. Finally, with a few adjustments, this same system provides 2D absorbance diagrams of stents immersed in a water-based phantom, this time over a bandwidth ranging from 0.2 to 1.8 GHz. Results: The authors show that metallic stents exhibit characteristic resonant frequencies in their microwave absorbance spectra in open air which depend on their length and, as a result, may reflect the occurrence of structural distortions. These resonances can be understood considering that such devices behave like dipole antennas in terms of microwave scattering. From fracture tests, the authors infer that microwave spectrometry provides signs of presence of Type I to Type IV stent fractures and allows in particular a quantitative evaluation of Type III and Type IV fractures. Recoil tests show that microwave spectrometry seems able to provide some quantitative assessment of diametrical shrinkage, but only if it involves longitudinal shortening. Finally, the authors observe that the resonant frequencies of stents placed inside the phantom shift down with respect to the corresponding open air frequencies, as it should be expected considering the increase of dielectric permittivity from air to water. Conclusions: The evaluation of stent resonant frequencies provided by microwave spectrometry allows detection and some quantitative assessment of stent fracture and recoil in open air conditions. Resonances of stents immersed in water can be also detected and their characteristic frequencies are in good agreement with theoretical estimates. Although these are promising results, further verifica tion in a more relevant phantom is required in order to foresee the real potential of this approach.

The univalent Bloch-Landau constant, harmonic symmetry and conformal glueing

By modifying a domain first suggested by Ruth Goodman in 1935 and by exploiting the explicit solution by Fedorov of the Polyá-Chebotarev problem in the case of four symmetrically placed points, an improved upper bound for the univalent Bloch-Landau constant is obtained. The domain that leads to this improved bound takes the form of a disk from which some arcs are removed in such a way that the resulting simply connected domain is harmonically symmetric in each arc with respect to the origin. The existence of domains of this type is established, using techniques from conformal welding, and some general properties of harmonically symmetric arcs in this setting are established.

On the origin of the selectivity of plasmidic H-NS towards horizontally acquired DNA: Linking H-NS oligomerization and cooperative DNA binding

The nucleoid-associated protein H-NS is a global modulator of the expression of genes associated with adaptation to environmental changes. A variant of H-NS expressed in the R27 plasmid was previously shown to selectively modulate the expression of horizontally acquired genes, with minimal effects on core genes that are repressed by the chromosomal form of H-NS. Both H-NS proteins are formed by an oligomerization domain and a DNA-binding domain, which are connected by a linker that is highly flexible in the absence of DNA. We studied DNA binding by means of oligomer-forming chimeric proteins in which domains of the chromosomal and plasmidic variants are exchanged, as well as in monomeric truncated forms containing the DNA-binding domain and variable portions of the linker. Point mutations in the linker were also examined in full-length and truncated H-NS constructs. These experiments show that the linker region contributes to DNA binding affinity and that it is a main component of the distinct DNA binding properties of chromosomal and plasmidic H-NS. We propose that interactions between the linker and DNA limit the flexibility of the connection between H- NS oligomerization and DNA binding and provide an allosteric indirect readout mechanism to detect long- range distortions of DNA, thus enabling discrimination between core and horizontally acquired DNA.

Microwave spectrometry for the Evaluation of the structural integrity of metallic stents

Purpose: To assess the feasibility of a method based on microwave spectrometry to detect structural distortions of metallic stents in open air conditions and envisage the prospects of this approach toward possible medical applicability for the evaluation of implanted stents. Methods: Microwave absorbance spectra between 2.0 and 18.0 GHz were acquired in open air for the characterization of a set of commercial stents using a specifically design setup. Rotating each sample over 360º, 2D absorbance diagrams were generated as a function of frequency and rotation angle. To check our approach for detecting changes in stent length (fracture) and diameter (recoil), two specific tests were performed in open air. Finally, with a few adjustments, this same system provides 2D absorbance diagrams of stents immersed in a water-based phantom, this time over a bandwidth ranging from 0.2 to 1.8 GHz. Results: The authors show that metallic stents exhibit characteristic resonant frequencies in their microwave absorbance spectra in open air which depend on their length and, as a result, may reflect the occurrence of structural distortions. These resonances can be understood considering that such devices behave like dipole antennas in terms of microwave scattering. From fracture tests, the authors infer that microwave spectrometry provides signs of presence of Type I to Type IV stent fractures and allows in particular a quantitative evaluation of Type III and Type IV fractures. Recoil tests show that microwave spectrometry seems able to provide some quantitative assessment of diametrical shrinkage, but only if it involves longitudinal shortening. Finally, the authors observe that the resonant frequencies of stents placed inside the phantom shift down with respect to the corresponding open air frequencies, as it should be expected considering the increase of dielectric permittivity from air to water. Conclusions: The evaluation of stent resonant frequencies provided by microwave spectrometry allows detection and some quantitative assessment of stent fracture and recoil in open air conditions. Resonances of stents immersed in water can be also detected and their characteristic frequencies are in good agreement with theoretical estimates. Although these are promising results, further verifica tion in a more relevant phantom is required in order to foresee the real potential of this approach.

Pose-based SLAM with probabilistic scan matching algorithm using a mechanical scanned imaging sonar

This paper proposes a pose-based algorithm to solve the full SLAM problem for an autonomous underwater vehicle (AUV), navigating in an unknown and possibly unstructured environment. The technique incorporate probabilistic scan matching with range scans gathered from a mechanical scanning imaging sonar (MSIS) and the robot dead-reckoning displacements estimated from a Doppler velocity log (DVL) and a motion reference unit (MRU). The proposed method utilizes two extended Kalman filters (EKF). The first, estimates the local path travelled by the robot while grabbing the scan as well as its uncertainty and provides position estimates for correcting the distortions that the vehicle motion produces in the acoustic images. The second is an augment state EKF that estimates and keeps the registered scans poses. The raw data from the sensors are processed and fused in-line. No priory structural information or initial pose are considered. The algorithm has been tested on an AUV guided along a 600 m path within a marina environment, showing the viability of the proposed approach