Capacity-achieving input covariance for single-user multi-antenna channels

We characterize the capacity-achieving input covariance for multi-antenna channels known instantaneously at the receiver and in distribution at the transmitter. Our characterization, valid for arbitrary numbers of antennas, encompasses both the eigenvectors and the eigenvalues. The eigenvectors are found for zero-mean channels with arbitrary fading profiles and a wide range of correlation and keyhole structures. For the eigenvalues, in turn, we present necessary and sufficient conditions as well as an iterative algorithm that exhibits remarkable properties: universal applicability, robustness and rapid convergence. In addition, we identify channel structures for which an isotropic input achieves capacity.

Preisach modeling of hysteresis for a pseudoelastic Cu-Zn-Al single crystal

Stress-strain trajectories associated with pseudoelastic behavior of a Cu¿19.4 Zn¿13.1 Al (at.%) single crystal at room temperature have been determined experimentally. For a constant cross-head speed the trajectories and the associated hysteresis behavior are perfectly reproducible; the trajectories exhibit memory properties, dependent only on the values of return points, where transformation direction is reverted. An adapted version of the Preisach model for hysteresis has been implemented to predict the observed trajectories, using a set of experimental first¿order reversal curves as input data. Explicit formulas have been derived giving all trajectories in terms of this data set, with no adjustable parameters. Comparison between experimental and calculated trajectories shows a much better agreement for descending than for ascending paths, an indication of a dissymmetry between the dissipation mechanisms operative in forward and reverse directions of martensitic transformation.

Joint array combining and MLSE for single-user receivers in multipath Gaussian multiuser channels

The well-known structure of an array combiner along with a maximum likelihood sequence estimator (MLSE) receiveris the basis for the derivation of a space-time processor presentinggood properties in terms of co-channel and intersymbol interferencerejection. The use of spatial diversity at the receiver front-endtogether with a scalar MLSE implies a joint design of the spatialcombiner and the impulse response for the sequence detector. Thisis faced using the MMSE criterion under the constraint that thedesired user signal power is not cancelled, yielding an impulse responsefor the sequence detector that is matched to the channel andcombiner response. The procedure maximizes the signal-to-noiseratio at the input of the detector and exhibits excellent performancein realistic multipath channels.

Readout schemes for low noise single-photon avalanche diodes fabricated in conventional HV-CMOS technologies

Three different pixels based on single-photon avalanche diodes for triggered applications, such as fluorescence lifetime measurements and high energy physics experiments, are presented. Each pixel consists of a 20µm x 100µm (width x length) single photon avalanche diode and a monolithically integrated readout circuit. The sensors are operated in the gated mode of acquisition to reduce the probability to detect noise counts interferring with real radiation events. Each pixel includes a different readout circuit that allows to use low reverse bias overvoltages. Experimental results demonstrate that the three pixels present a similar behaviour. The pixels get rid of afterpulses and present a reduced dark count probability by applying the gated operation. Noise figures are further improved by using low reverse bias overvoltages. The detectors exhibit an input dynamic range of 13.35 bits with short gated"on" periods of 10ns and a reverse bias overvoltage of 0.5V. The three pixels have been fabricated in a standard HV-CMOS process.

Single period Markowitz portfolio selection, performance gauging and duality: a variation on Luenberger's shortage function

Markowitz portfolio theory (1952) has induced research into the efficiency of portfolio management. This paper studies existing nonparametric efficiency measurement approaches for single period portfolio selection from a theoretical perspective and generalises currently used efficiency measures into the full mean-variance space. Therefore, we introduce the efficiency improvement possibility function (a variation on the shortage function), study its axiomatic properties in the context of Markowitz efficient frontier, and establish a link to the indirect mean-variance utility function. This framework allows distinguishing between portfolio efficiency and allocative efficiency. Furthermore, it permits retrieving information about the revealed risk aversion of investors. The efficiency improvement possibility function thus provides a more general framework for gauging the efficiency of portfolio management using nonparametric frontier envelopment methods based on quadratic optimisation.

Composition of Greenhouse Gas Emissions in Spain: an Input-Output Analysis

Extending the traditional input-output model to account for the environmental impacts of production processes reveals the channels by which environmental burdens are transmitted throughout the economy. In particular, the environmental input-output approach is a useful technique for quantifying the changes in the levels of greenhouse emissions caused by changes in the final demand for production activities. The inputoutput model can also be used to determine the changes in the relative composition of greenhouse gas emissions due to exogenous inflows. In this paper we describe a method for evaluating how the exogenous changes in sectorial demand, such as changes in private consumption, public consumption, investment and exports, affect the relative contribution of the six major greenhouse gases regulated by the Kyoto Protocol to total greenhouse emissions. The empirical application is for Spain, and the economic and environmental data are for the year 2000. Our results show that there are significant differences in the effects of different sectors on the composition of greenhouse emissions. Therefore, the final impact on the relative contribution of pollutants will basically depend on the activity that receives the exogenous shock in final demand, because there are considerable differences in the way, and the extent to which, individual activities affect the relative composition of greenhouse gas emissions. Keywords: Greenhouse emissions, composition of emissions, sectorial demand, exogenous shock.

Ecological and Economic Impacts within the Environmental Input-Output Framework

The environmental input-output approach reveals the channels through which the environmental burdens of production activities are transmitted throughout the economy. This paper uses the input-output framework and analyses the changes in Spanish emission multipliers during the period 1995-2000. By decomposing the global changes in multipliers into different components, it is possible to evaluate separately the economic and ecological impacts captured by the environmental input-output model. Specifically, in this study we distinguish between the effects on multipliers caused by changes in emission coefficients (the ecological impacts) and the effects on multipliers caused by changes in technical coefficients (the economic impacts). Our results show a significant improvement in the ecological impacts of production activities, which contributed negatively to changes in emission multipliers. They also show a deterioration in the economic impacts, which contributed positively to changes in emission multipliers. Together, these two effects lead to a small reduction in global multipliers during the period of analysis. Our results also show significant differences in the individual behaviour of different sectors in terms of their contribution to multiplier changes. Since there are considerable differences in the way individual sectors affect the changes in emission levels, and in the intensity of these effects, this means that the final effects will basically depend on the activity considered. Keywords: emission multipliers, multipliers' changes, ecological impacts, economic impacts.

A Characterization of single-peaked preferences

We identify in this paper two conditions that characterize the domain of single-peaked preferences on the line in the following sense: a preference profile satisfies these two properties if and only if there exists a linear order $L$ over the set of alternatives such that these preferences are single-peaked with respect L. The first property states that for any subset of alternatives the set of alternatives considered as the worst by all agents cannot contains more than 2 elements. The second property states that two agents cannot disagree on the relative ranking of two alternatives with respect to a third alternative but agree on the (relative) ranking of a fourth one. Classification-JEL: D71, C78

A note on the separability principle in economies with single-peaked

We consider the problem of allocating an infinitely divisible commodity among a group of agents with single-peaked preferences. A rule that has played a central role in the analysis of the problem is the so-called uniform rule. Chun (2001) proves that the uniform rule is the only rule satisfying Pareto optimality, no-envy, separability, and continuity (with respect to the social endowment). We obtain an alternative characterization by using a weak replication-invariance condition, called duplication-invariance, instead of continuity. Furthermore, we prove that Pareto optimality, equal division lower bound, and separability imply no-envy. Using this result, we strengthen one of Chun's (2001) characterizations of the uniform rule by showing that the uniform rule is the only rule satisfying Pareto optimality, equal división lower bound, separability, and either continuity or duplication-invariance.

An input-output analysis of the "key" sectors in CO2 emissions from a production perspective: an application to the spanish economy

Here we present an approach that allows the identification of the "key" productive sectors responsible for CO2 emission. For this purpose, we develop an input–output methodology from a supply perspective. We focus on the impact of an increase in the value-added of the different productive sectors on total CO2 emissions and we identify the productive sectors responsible for the increase in CO2 emissions when there is an increase in the income of the economy. The approach shows the contribution of the various sectors to CO2 emission from a production perspective and allows us to identify the sectors that deserve more consideration for mitigation policies. This analysis is complementary to the input–output analysis from a demand perspective. The methodology is applied to the Spanish economy.

Economic impacts of alternative water policy scenarios in the Spanish production system: an input-output analysis

The objective of this paper is to analyse the economic impacts of alternative water policies implemented in the Spanish production system. The methodology uses two versions of the input-output price model: a competitive formulation and a mark-up formulation. The input-output framework evaluates the impact of water policy measures on production prices, consumption prices, intermediate water demand and private welfare. Our results show that a tax on the water used by sectors considerably reduces the intermediate water demand, and increases the production and consumption prices. On the other hand, according to Jevons' paradox, an improvement in technical efficiency, which leads to a reduction in the water requirements of all sectors and an increase in water production, increases the amount of water consumed. The combination of a tax on water and improved technical efficiency takes the pressure off prices and significantly reduces intermediate water demand. JEL Classification: C67 ; D57 ; Q25. Keywords: Production prices; Consumption prices; Water uses; Water policy; Water taxation.

Income growth and atmospheric pollution in Spain: an input-output approach

The relationships between economic growth and environmental pressures are complex. Since the early nineties, the debate on these relationships has been strongly influenced by the Environmental Kuznets Curve hypothesis, which states that during the first stage of economic development environmental pressures increase as per capita income increases, but once a critical turning-point has been reached these pressures diminish as income levels continue to increase. However, to date such a delinking between economic growth and emission levels has not happened for most atmospheric pollutants in Spain. The aim of this paper is to analyse the relationship between income growth and nine atmospheric pollutants in Spain. In order to obtain empirical outcomes for this analysis, we adopt an input-output approach and use NAMEA data for the nine pollutants. First, we undertake a structural decomposition analysis for the period 1995-2000 to estimate the contribution of various factors to changes in the levels of atmospheric emissions. And second, we estimate the emissions associated with the consumption patterns of different groups of households classified according to their level of expenditure

Subsistemas input-output y contaminación: una aplicación al sector servicions y las emisiones de CO2 en España

El análisis de subsistemas input-output nos proporciona una herramienta de gran utilidad para estudiar la estructura productiva de los diferentes sectores que componen una economía. En el presente trabajo se ha desarrollado este análisis para estudiar las emisiones de CO2 relacionadas con el conjunto de ramas productivas que conforman el sector servicios. La descomposición de la producción total del subsistema servicios nos permite obtener las emisiones de CO2 relacionadas con diferentes efectos (escala, propio, feed-back y spill over). De los resultados obtenidos, destaca el diferente papel de las distintas ramas productivas de servicios. Las actividades de transporte serían las responsables de las mayores emisiones generadas directamente en el sector. Estas actividades son demandadas por el resto de sectores de la economía en mayor grado que su propia demanda final, teniendo mayor responsabilidad la producción vendida a otros sectores que la propia demanda final. No obstante, para el resto de actividades las emisiones directas e indirectas asociadas a la demanda final son mucho más importantes, por el fuerte efecto de arrastre sobre otras ramas de la economía que ejercen las actividades de servicios. A este respecto, destacan los servicios de Comercio, Hostelería, Inmobiliarias y servicios empresariales y la Administración pública, actividades que reciben escasa atención en el diseño de políticas orientadas a reducir las emisiones, pero que tienen una responsabilidad muy destacable en el fuerte aumento de emisiones experimentado en los últimos años.

Actividad económica, consumo final de energía y requerimientos de energía primaria en Cataluña, 1990-2005. Análisis mediante el uso de los balances energéticos desde una perspectiva input-output

Este trabajo analiza la evolución de los consumos finales de energía en Cataluña durante el periodo 1990-2005. En conjunto, los consumos finales de energía crecen por encima del crecimiento del PIB en términos reales. La disponibilidad actual de datos permite una desagregación en cinco actividades: sector primario; sector industrial; sector servicios; transporte; y sector doméstico. Los aumentos relativos más importantes se dan en los sectores servicios, doméstico y transporte. Es esta última actividad (que incluye el transporte privado y comercial) la que experimenta un mayor aumento en términos absolutos, hasta llegar a representar un consumo final de energía.

Actividad económica y emisiones de CO2 derivadas del consumo de energía en Cataluña, 1990-2005. Análisis mediante el uso de los balances energéticos desde una perspectiva input-output

A lo largo del trabajo hemos analizado, tanto desde una perspectiva agregada, como posteriormente con todo el detalle posible, la evolución experimentada por estas emisiones, teniendo en cuenta las limitaciones de información . Para hacerlo se han utilizado conceptos y precisiones metodológicas ampliamente utilizadas en la literatura científica sobre el tema. Del estudio realizado en la primera parte del trabajo resulta evidente que el importante crecimiento de las emisiones en Cataluña durante el periodo considerado, de un 60.1%, muy superior a la media española (50,5%), se explica como principal factor por el aumento en el PIB per cápita, con un crecimiento del 33,35% . El crecimiento demográfico también habría contribuido de forma importante al incremento en las emisiones totales, con un aumento del 10,5% de la población; sobre todo a partir de 1999, ya que en la década de los noventa la población se mantuvo estable con pocas.