Fast calculation of the CAC convolution algorithm using the multinomial distribution function

The authors focus on one of the methods for connection acceptance control (CAC) in an ATM network: the convolution approach. With the aim of reducing the cost in terms of calculation and storage requirements, they propose the use of the multinomial distribution function. This permits direct computation of the associated probabilities of the instantaneous bandwidth requirements. This in turn makes possible a simple deconvolution process. Moreover, under certain conditions additional improvements may be achieved

Application of discriminant function analysis and change-point problem in dating volcanic ashes

The application of Discriminant function analysis (DFA) is not a new idea in the studyof tephrochrology. In this paper, DFA is applied to compositional datasets of twodifferent types of tephras from Mountain Ruapehu in New Zealand and MountainRainier in USA. The canonical variables from the analysis are further investigated witha statistical methodology of change-point problems in order to gain a betterunderstanding of the change in compositional pattern over time. Finally, a special caseof segmented regression has been proposed to model both the time of change and thechange in pattern. This model can be used to estimate the age for the unknown tephrasusing Bayesian statistical calibration

Electron localization function at the correlated level

The electron localization function (ELF) has been proven so far a valuable tool to determine the location of electron pairs. Because of that, the ELF has been widely used to understand the nature of the chemical bonding and to discuss the mechanism of chemical reactions. Up to now, most applications of the ELF have been performed with monodeterminantal methods and only few attempts to calculate this function for correlated wave functions have been carried out. Here, a formulation of ELF valid for mono- and multiconfigurational wave functions is given and compared with previous recently reported approaches. The method described does not require the use of the homogeneous electron gas to define the ELF, at variance with the ELF definition given by Becke. The effect of the electron correlation in the ELF, introduced by means of configuration interaction with singles and doubles calculations, is discussed in the light of the results derived from a set of atomic and molecular systems

Inter-rater agreement and reliability of the COSMIN (COnsensus-based Standards for the selection of health status Measurement Instruments) Checklist

Background: The COSMIN checklist is a tool for evaluating the methodological quality of studies on measurement properties of health-related patient-reported outcomes. The aim of this study is to determine the inter-rater agreement and reliability of each item score of the COSMIN checklist (n = 114). Methods: 75 articles evaluating measurement properties were randomly selected from the bibliographic database compiled by the Patient-Reported Outcome Measurement Group, Oxford, UK. Raters were asked to assess the methodological quality of three articles, using the COSMIN checklist. In a one-way design, percentage agreement and intraclass kappa coefficients or quadratic-weighted kappa coefficients were calculated for each item. Results: 88 raters participated. Of the 75 selected articles, 26 articles were rated by four to six participants, and 49 by two or three participants. Overall, percentage agreement was appropriate (68% was above 80% agreement), and the kappa coefficients for the COSMIN items were low (61% was below 0.40, 6% was above 0.75). Reasons for low inter-rater agreement were need for subjective judgement, and accustom to different standards, terminology and definitions.Conclusions: Results indicated that raters often choose the same response option, but that it is difficult on item level to distinguish between articles. When using the COSMIN checklist in a systematic review, we recommend getting some training and experience, completing it by two independent raters, and reaching consensus on one final rating. Instructions for using the checklist are improved.

Protocol of the COSMIN study: consensus-based standards for the selection of health measurement instruments

Background: Choosing an adequate measurement instrument depends on the proposed use of the instrument, the concept to be measured, the measurement properties (e.g. internal consistency, reproducibility, content and construct validity, responsiveness, and interpretability), the requirements, the burden for subjects, and costs of the available instruments. As far as measurement properties are concerned, there are no sufficiently specific standards for the evaluation of measurement properties of instruments to measure health status, and also no explicit criteria for what constitutes good measurement properties. In this paper we describe the protocol for the COSMIN study, the objective of which is to develop a checklist that contains COnsensus-based Standards for the selection of health Measurement INstruments, including explicit criteria for satisfying these standards. We will focus on evaluative health related patient-reported outcomes (HR-PROs), i.e. patient-reported health measurement instruments used in a longitudinal design as an outcome measure, excluding health care related PROs, such as satisfaction with care or adherence. The COSMIN standards will be made available in the form of an easily applicable checklist.Method: An international Delphi study will be performed to reach consensus on which and how measurement properties should be assessed, and on criteria for good measurement properties. Two sources of input will be used for the Delphi study: (1) a systematic review of properties, standards and criteria of measurement properties found in systematic reviews of measurement instruments, and (2) an additional literature search of methodological articles presenting a comprehensive checklist of standards and criteria. The Delphi study will consist of four (written) Delphi rounds, with approximately 30 expert panel members with different backgrounds in clinical medicine, biostatistics, psychology, and epidemiology. The final checklist will subsequently be field-tested by assessing the inter-rater reproducibility of the checklist.Discussion: Since the study will mainly be anonymous, problems that are commonly encountered in face-to-face group meetings, such as the dominance of certain persons in the communication process, will be avoided. By performing a Delphi study and involving many experts, the likelihood that the checklist will have sufficient credibility to be accepted and implemented will increase.

Prediction of enzyme function by combining sequence similarity and protein interactions

Background: A number of studies have used protein interaction data alone for protein function prediction. Here, we introduce a computational approach for annotation of enzymes, based on the observation that similar protein sequences are more likely to perform the same function if they share similar interacting partners. Results: The method has been tested against the PSI-BLAST program using a set of 3,890 protein sequences from which interaction data was available. For protein sequences that align with at least 40% sequence identity to a known enzyme, the specificity of our method in predicting the first three EC digits increased from 80% to 90% at 80% coverage when compared to PSI-BLAST. Conclusion: Our method can also be used in proteins for which homologous sequences with known interacting partners can be detected. Thus, our method could increase 10% the specificity of genome-wide enzyme predictions based on sequence matching by PSI-BLAST alone.

Capacity-approaching rate function for layered multiantenna architectures

The simultaneous use of multiple transmit and receive antennas can unleash very large capacity increases in rich multipath environments. Although such capacities can be approached by layered multi-antenna architectures with per-antenna rate control, the need for short-term feedback arises as a potential impediment, in particular as the number of antennas—and thus the number of rates to be controlled—increases. What we show, however, is that the need for short-term feedback in fact vanishes as the number of antennas and/or the diversity order increases. Specifically, the rate supported by each transmit antenna becomes deterministic and a sole function of the signal-to-noise, the ratio of transmit and receive antennas, and the decoding order, all of which are either fixed or slowly varying. More generally, we illustrate -through this specific derivation— the relevance of some established random CDMA results to the single-user multi-antenna problem.

The externalisation of the asylum function in the European Union

This paper aims to identify and assess the main items in the strategy followed by the EU and its member states on the externalisation of their asylum function. First, it analyses the European harmonisation of the return to safe third countries and to countries of first asylum, which is carried out by means of readmission agreements. Second, it refers to the strategies defined by the Hague and the Stockholm programs concerning the External Aspects of the European Union Asylum Policy, on the detention centres for illegal immigrants abroad, and on the proposals for delocalisation of asylum applications processing centres beyond the EU borders. Finally, this paper considers whether the strategy of externalisation of the function of asylum sometimes lacks legitimacy, and to what extent there is a fair balance between the interests of the states and the protection of the human rights of refugees and asylum seekers.

Solving higher-dimensional continuous time stochastic control problems by value function regression

The paper develops a method to solve higher-dimensional stochasticcontrol problems in continuous time. A finite difference typeapproximation scheme is used on a coarse grid of low discrepancypoints, while the value function at intermediate points is obtainedby regression. The stability properties of the method are discussed,and applications are given to test problems of up to 10 dimensions.Accurate solutions to these problems can be obtained on a personalcomputer.

A singular function and its relation with the number systems involved in its definition

Minkowski's ?(x) function can be seen as the confrontation of two number systems: regular continued fractions and the alternated dyadic system. This way of looking at it permits us to prove that its derivative, as it also happens for many other non-decreasing singular functions from [0,1] to [0,1], when it exists can only attain two values: zero and infinity. It is also proved that if the average of the partial quotients in the continued fraction expansion of x is greater than k* =5.31972, and ?'(x) exists then ?'(x)=0. In the same way, if the same average is less than k**=2 log2(F), where F is the golden ratio, then ?'(x)=infinity. Finally some results are presented concerning metric properties of continued fraction and alternated dyadic expansions.

Satisfaction in choice as a function of the number of alternatives: When "goods satiate" but "bads escalate"

Whereas people are typically thought to be better off with more choices, studiesshow that they often prefer to choose from small as opposed to large sets of alternatives.We propose that satisfaction from choice is an inverted U-shaped function of thenumber of alternatives. This proposition is derived theoretically by considering thebenefits and costs of different numbers of alternatives and is supported by fourexperimental studies. We also manipulate the perceptual costs of information processingand demonstrate how this affects the resulting satisfaction function. We furtherindicate that satisfaction when choosing from a given set is diminished if people aremade aware of the existence of other choice sets. The role of individual differences insatisfaction from choice is documented by noting effects due to gender and culture. Weconclude by emphasizing the need to have an explicit rationale for knowing how muchchoice is enough.

Cost efficiency in primary care contracting: A stochastic frontier cost function approach

The principal aim of this paper is to estimate a stochastic frontier costfunction and an inefficiency effects model in the analysis of the primaryhealth care services purchased by the public authority and supplied by 180providers in 1996 in Catalonia. The evidence from our sample does not supportthe premise that contracting out has helped improve purchasing costefficiency in primary care. Inefficient purchasing cost was observed in thecomponent of this purchasing cost explicitly included in the contract betweenpurchaser and provider. There are no observable incentives for thecontracted-out primary health care teams to minimise prescription costs, whichare not explicitly included in the present contracting system.

A new light on Minkowski's? $(x)$ function

The well--known Minkowski's? $(x)$ function is presented as the asymptotic distribution function of an enumeration of the rationals in (0,1] based on their continued fraction representation. Besides, the singularity of ?$(x)$ is clearly proved in two ways: by exhibiting a set of measure one in which ?ï$(x)$ = 0; and again by actually finding a set of measure one which is mapped onto a set of measure zero and viceversa. These sets are described by means of metrical properties of different systems for real number representation.

Labor market heterogeneity and the aggregate matching function

The matching function -a key building block in models of labor market frictions- impliesthat the job finding rate depends only on labor market tightness. We estimate such amatching function and find that the relation, although remarkably stable over 1967-2007,broke down spectacularly after 2007. We argue that labor market heterogeneities are notfully captured by the standard matching function, but that a generalized matching functionthat explicitly takes into account worker heterogeneity and market segmentation is fullyconsistent with the behavior of the job finding rate. The standard matching function canbreak down when, as in the Great Recession, the average characteristics of the unemployedchange too much, or when dispersion in labor market conditions -the extent to which somelabor markets fare worse than others- increases too much.