Driven fragmentation of granular gases

The dynamics of homogeneously heated granular gases which fragment due to particle collisions is analyzed. We introduce a kinetic model which accounts for correlations induced at the grain collisions and analyze both the kinetics and relevant distribution functions these systems develop. The work combines analytical and numerical studies based on direct simulation Monte Carlo calculations. A broad family of fragmentation probabilities is considered, and its implications for the system kinetics are discussed. We show that generically these driven materials evolve asymptotically into a dynamical scaling regime. If the fragmentation probability tends to a constant, the grain number diverges at a finite time, leading to a shattering singularity. If the fragmentation probability vanishes, then the number of grains grows monotonously as a power law. We consider different homogeneous thermostats and show that the kinetics of these systems depends weakly on both the grain inelasticity and driving. We observe that fragmentation plays a relevant role in the shape of the velocity distribution of the particles. When the fragmentation is driven by local stochastic events, the longvelocity tail is essentially exponential independently of the heating frequency and the breaking rule. However, for a Lowe-Andersen thermostat, numerical evidence strongly supports the conjecture that the scaled velocity distribution follows a generalized exponential behavior f (c)~exp (−cⁿ), with n ≈1.2, regarding less the fragmentation mechanisms

Role of Particle Shape on the Stress Propagation in Granular Packings

We present an experimental and numerical study on the influence that particle aspect ratio has on the mechanical and structural properties of granular packings. For grains with maximal symmetry (squares), the stress propagation in the packing localizes forming chainlike forces analogous to the ones observed for spherical grains. This scenario can be understood in terms of stochastic models of aggregation and random multiplicative processes. As the grains elongate, the stress propagation is strongly affected. The interparticle normal force distribution tends toward a Gaussian, and, correspondingly, the force chains spread leading to a more uniform stress distribution reminiscent of the hydrostatic profiles known for standard liquids

High-SNR power offset in multiantenna communication

The analysis of the multiantenna capacity in the high-SNR regime has hitherto focused on the high-SNR slope (or maximum multiplexing gain), which quantifies the multiplicative increase as function of the number of antennas. This traditional characterization is unable to assess the impact of prominent channel features since, for a majority of channels, the slope equals the minimum of the number of transmit and receive antennas. Furthermore, a characterization based solely on the slope captures only the scaling but it has no notion of the power required for a certain capacity. This paper advocates a more refined characterization whereby, as function of SNRjdB, the high-SNR capacity is expanded as an affine function where the impact of channel features such as antenna correlation, unfaded components, etc, resides in the zero-order term or power offset. The power offset, for which we find insightful closed-form expressions, is shown to play a chief role for SNR levels of practical interest.

Job satisfaction and life satisfaction: Analysis of a reciprocal model with social demographic moderators

The general objective of the study was to empirically test a reciprocal model of job satisfaction and life satisfaction while controlling for some social demographic variables. 827 employees working in 34 car dealerships in Northern Quebec (56% responses rate) were surveyed. The multiple item questionnaires were analysed using correlation analysis, chi square and ANOVAs. Results show interesting patterns emerging for the relationships between job and life satisfaction of which 49.2% of all individuals have spillover, 43.5% compensation, and 7.3% segmentation type of relationships. Results, nonetheless, are far richer and the model becomes much more refined when social demographic indicators are taken into account. Globally, social demographic variables demonstrate some effects on each satisfaction individually but also on the interrelation (nature of the relations) between life and work satisfaction.

On Rothschild-Stiglitz as competitive pooling

Dubey and Geanakoplos [2002] have developed a theory of competitive pooling, which incorporates adverse selection and signaling into general equilibrium. By recasting the Rothschild-Stiglitz model of insurance in this framework, they find that a separating equilibrium always exists and is unique.We prove that their uniqueness result is not a consequence of the framework, but rather of their definition of refined equilibria. When other types of perturbations are used, the model allows for many pooling allocations to be supported as such: in particular, this is the case for pooling allocations that Pareto dominate the separating equilibrium.

Adaptive dynamics and the implementation problem with complete information

This paper studies the equilibrating process of several implementationmechanisms using naive adaptive dynamics. We show that the dynamics convergeand are stable, for the canonical mechanism of implementation in Nash equilibrium.In this way we cast some doubt on the criticism of ``complexity'' commonlyused against this mechanism. For mechanisms that use more refined equilibrium concepts,the dynamics converge but are not stable. Some papers in the literatureon implementation with refined equilibrium concepts have claimed that themechanisms they propose are ``simple'' and implement ``everything'' (incontrast with the canonical mechanism). The fact that some of these ``simple''mechanisms have unstable equilibria suggests that these statements shouldbe interpreted with some caution.

Screen printed La2/3Sr1/3MnO3 thick films on alumina substrates

We report here on the preparation of La2/3Sr1/3MnO3 magnetoresistive thick films on polycrystalline Al2O3 substrates by using the screen printing technique. It is shown that films can be obtained using high temperature sintering. While there is a reacted layer, this improves adhesion and is not too troublesome if the films are made thick enough. It is shown that PbO-B2O3-SiO2 glass additives allow sintering at lower temperatures and can be used to improve the mechanical stress of the films. However, it is found that glass concentrations large enough to significantly improve the film adherence result in a weak low field magnetoresistance probably because grains are coated with high resistivity material. Strategies to overcome these difficulties are discussed.

Structural characterization of laser-treated Cr3C2-NiCr coatings

The interconnected porosity of the Cr3C2-NiCr coatings obtained by high-velocity oxy fuel spraying is detrimental in corrosion and wear resistance applications. Laser treatments allow sealing of their surfaces through melting and resolidification of a thin superficial layer. A Nd:YAG laser beam was used to irradiate Cr3C2-NiCr coatings either in the continuous wave mode or at different repetition rates in the pulsed one. Results indicated that high peak and low mean laser irradiances are not good, since samples presented deep grooves and an extensive crack network. At low peak and higher mean laser irradiances the surface was molten, and only a few shallow cracks were observed. The interconnected porosity was completely eliminated in a layer up to 80 m thick, formed by large Cr7C3 grains imbedded in a NiCr matrix.

Metamorphism on Chromite Ores from the Dobromirtsi ultramafic massif, Rhodope Mountains (SE Bulgaria)

Podiform chromitite bodies occur in highly serpentinized peridotites at Dobromirtsi Ultramafic Massif (Rhodope Mountains, southeastern Bulgaria). The ultramafic body is believed to represent a fragment of Palaeozoic ophiolite mantle. The ophiolite sequence is associated with greenschist - lower-temperature amphibolite facies metamorphosed rocks (biotitic gneisses hosting amphibolite). This association suggests that peridotites, chromitites and metamorphic rocks underwent a common metamorphic evolution. Chromitites at Dobromirtsi have been strongly altered. Their degree of alteration depends on the chromite/silicate ratio and to a lesser extent, on the size of chromitite bodies. Alteration is recorded in individual chromite grains in the form of optical and chemical zoning. Core to rim chemical trends are expressed by MgO- and Al2O3- impoverishment, mainly compensated by FeO and/or Fe2O3 increases. Such chemical variations correspond with three main alteration events. The first one was associated with ocean-floor metamorphism and was characterized by a lizardite replacement of olivine and the absence of chromite alteration. The second event took place during greenchist facies metamorphism. During this event, MgO- and SiO2-rich fluids (derived from low temperature serpentinization of olivine and pyroxenes) reacted with chromite to form chlorite; as a consequence, chromite became altered to a FeO- and Cr2O3-rich, Al2O3-poor chromite. The third event, mainly developed during lower temperature amphibolite facies metamorphism, caused the replacement of the primary and previously altered chromite by Fe2O3-rich chromite (ferritchromite).

Max-convex decompositions for cooperative TU games

We show that any cooperative TU game is the maximum of a finite collection of convex games. This max-convex decomposition can be refined by using convex games with non-negative dividends for all coalitions of at least two players. As a consequence of the above results we show that the class of modular games is a set of generators of the distributive lattice of all cooperative TU games. Finally, we characterize zero-monotonic games using a strong max-convex decomposition

Generic finite-size enhancement of pairing in mesoscopic Fermi systems

The finite-size-dependent enhancement of pairing in mesoscopic Fermi systems is studied under the assumption that the BCS approach is valid and that the two-body force is size independent. Different systems are investigated such as superconducting metallic grains and films as well as atomic nuclei. It is shown that the finite size enhancement of pairing in these systems is in part due to the presence of a surface which accounts quite well for the data of nuclei and explains a good fraction of the enhancement in Al grains.

Seasonal dependence in the solar neutrino flux

Mikheyev-Smirnov-Wolfenstein (MSW) solutions of the solar neutrino problem predict a seasonal dependence of the zenith angle distribution of the event rates, due to the nonzero latitude at the Super-Kamiokande site. We calculate this seasonal dependence and compare it with the expectations in the no-oscillation case as well as just-so scenario, in the light of the latest Super-Kamiokande 708-day data. The seasonal dependence can be sizable in the large mixing angle MSW solution and would be correlated with the day-night effect. This may be used to discriminate between MSW and just-so scenarios and should be taken into account in refined fits of the data.

Magnetic hardening mechanisms in Nd-Fe-B nanocrystalline material

Microstructural and magnetic measurements of the evolution by heat treatment of initially amorphous Nd16Fe76B8 alloys prepared by melt spinning are presented. Evidence of magnetic hardening above a threshold temperature induced by magnetic isolation of the Nd2Fe14B grains is provided. A thermodynamic and kinetic explanation of local melting of the intergranular nanostructured Nd¿rich eutectic phase at temperatures below 900 K based on capillary effects is presented. A subsequent Ostwald ripening process moves Nd to wet intimately the hard magnetic grains, becoming, on cooling, a real paramagnetic isolating thin film (~2.5 nm). By using a simple analogy, it is shown that the switching magnetization field in a single¿domain crystal can be drastically affected through the exchange coupling to neighboring grains with different orientation of the easy axis. This effect should be important enough to reinforce the coercive field of polycrystalline hard magnetic materials and explains the observed enhancement from 0.9 to 1.9 T.

Structural characterization of laser-treated Cr3C2-NiCr coatings

The interconnected porosity of the Cr3C2-NiCr coatings obtained by high-velocity oxy fuel spraying is detrimental in corrosion and wear resistance applications. Laser treatments allow sealing of their surfaces through melting and resolidification of a thin superficial layer. A Nd:YAG laser beam was used to irradiate Cr3C2-NiCr coatings either in the continuous wave mode or at different repetition rates in the pulsed one. Results indicated that high peak and low mean laser irradiances are not good, since samples presented deep grooves and an extensive crack network. At low peak and higher mean laser irradiances the surface was molten, and only a few shallow cracks were observed. The interconnected porosity was completely eliminated in a layer up to 80 m thick, formed by large Cr7C3 grains imbedded in a NiCr matrix.

Long-tailed trapping times and Lévy flights in a self-organized critical granular system

We present a continuous time random walk model for the scale-invariant transport found in a self-organized critical rice pile [K. Christensen et al., Phys. Rev. Lett. 77, 107 (1996)]. From our analytical results it is shown that the dynamics of the experiment can be explained in terms of Lvy flights for the grains and a long-tailed distribution of trapping times. Scaling relations for the exponents of these distributions are obtained. The predicted microscopic behavior is confirmed by means of a cellular automaton model.