25 resultados para HALIDE-IONS
Resumo:
Haloesterification of diverse diols with various carboxylic acids was achieved using potassium halides (KX) as the only halide source in ionic liquids. The best yield was obtained in [BMIM][PF6] when 1,2-octanediol, palmitic acid and KBr were used. This yield was 85% and the regioisomer with the bromine in primary position was present in a 75:25 ratio. The regioisomeric ratio could be improved using either KCl or some phenylcarboxylic acids. [BMIM][PF6] acts as both reaction media and catalyst of the reaction. To the best of our knowledge, this type of combined reaction using an ionic liquid is unprecedented. The other solvents tested did not lead either to the same yield or to the same regioisomeric ratio.
Resumo:
We have studied the current transport and electroluminescence properties of metal oxide semiconductor MOS devices in which the oxide layer, which is codoped with silicon nanoclusters and erbium ions, is made by magnetron sputtering. Electrical measurements have allowed us to identify a Poole-Frenkel conduction mechanism. We observe an important contribution of the Si nanoclusters to the conduction in silicon oxide films, and no evidence of Fowler-Nordheim tunneling. The results suggest that the electroluminescence of the erbium ions in these layers is generated by energy transfer from the Si nanoparticles. Finally, we report an electroluminescence power efficiency above 10−3%. © 2009 American Institute of Physics. doi:10.1063/1.3213386
Resumo:
We present an analysis of factors influencing carrier transport and electroluminescence (EL) at 1.5 µm from erbium-doped silicon-rich silica (SiOx) layers. The effects of both the active layer thickness and the Si excess content on the electrical excitation of erbium are studied. We demonstrate that when the thickness is decreased from a few hundred to tens of nanometers the conductivity is greatly enhanced. Carrier transport is well described in all cases by a Poole-Frenkel mechanism, while the thickness-dependent current density suggests an evolution of both density and distribution of trapping states induced by Si nanoinclusions. We ascribe this observation to stress-induced effects prevailing in thin films, which inhibit the agglomeration of Si atoms, resulting in a high density of sub-nm Si inclusions that induce traps much shallower than those generated by Si nanoclusters (Si-ncs) formed in thicker films. There is no direct correlation between high conductivity and optimized EL intensity at 1.5 µm. Our results suggest that the main excitation mechanism governing the EL signal is impact excitation, which gradually becomes more efficient as film thickness increases, thanks to the increased segregation of Si-ncs, which in turn allows more efficient injection of hot electrons into the oxide matrix. Optimization of the EL signal is thus found to be a compromise between conductivity and both number and degree of segregation of Si-ncs, all of which are governed by a combination of excess Si content and sample thickness. This material study has strong implications for many electrically driven devices using Si-ncs or Si-excess mediated EL.
Resumo:
A scheme to generate long-range spin-spin interactions between three-level ions in a chain is presented, providing a feasible experimental route to the rich physics of well-known SU(3) models. In particular, we demonstrate different signatures of quantum chaos which can be controlled and observed in experiments with trapped ions.
Resumo:
By exciting at 940 nm, we have characterized the 1.84 m near infrared emission of trivalent thulium ions in Yb3+, Tm3+:KGd WO4 2 single crystals as a function of the dopant concentration and temperature, from 10 K to room temperature. An overall 3H6 Stark splitting of 470 cm−1 for the Tm3+ ions in the Yb3+, Tm3+:KGd WO4 2 was obtained. We also studied the blue emission at 476 nm Tm3+ and the near infrared emissions at 1.48 m Tm3+ and 1 m Yb3+ as a function of the dopant concentration. Experimental decay times of the 1G4, 3H4, and 3F4 Tm3+ and 2F5/2 Yb3+ excited states have been measured as a function of Yb3+ and Tm3+ ion concentrations. For the 3F4 →3H6 transition of Tm3+ ions, we used the reciprocity method to calculate the maximum emission cross section of 3.07 10−20 cm2 at 1.84 m for the polarization parallel to the Nm principal optical direction.
Resumo:
El present treball, com a projecte final de carrera, té com objectiu estudiar la viabilitat del suro com a material alternatiu a compostos sintètics, com per exemple bescanviadors iònics convencionals. Està centrat al cas particular de la recuperació de Pal·ladi i Platí, metalls nobles d’alt valor econòmic i per tant amb un alt interès per la seva recuperació un cop usats.
Resumo:
Estudi elaborat a partir dâuna estada a la School of Life Sciences de la University of Dundee, Gran Bretanya, entre gener i març del 2007.L'estrès osmòtic causa rà pidament l'activació de la quinasa WNK1, que fosforila i activa a continuació les quinases SPAK i OSR1, que alhora regulen canals i transportadors dâions preexistents a la membrana celâ¢lular. El factor de transcripció NFAT5 és el principal regulador de la resposta celâ¢lular transcripcional secundà ria a hipertonicitat i sâha descrit que les quinases p38, Fyn, PKA, ERK/MEK i ATM estan involucrades en la seva regulació post-traduccional. No obstant, com que la funció dâaquestes quinases no explica totalment els mecanismes d'activació de NFAT5, sâha estudiat si lâactivitat transcripcional de NFAT5 pot estar regulada per WNK1, SPAK o OSR1. Aixà doncs, es va observar que lâactivitat dâun reporter dependent de NFAT5 no es veu afectada per la presència de cap de les quinases anteriors, en la seva forma wild-type o dominant negatiu. Dâaltra banda, es va estudiar quin domini de WNK1 és necessari per a que pugui respondre a hipertonicitat i quines quinases poden estar involucrades en la fosforilació de la serina 382 de WNK1. En conclusió, les dades obtingudes apunten que lâactivació de WNK1 en resposta a estrès osmòtic requereix la seva fosforilació en la serina 382 per quinases upstream com PAK2 o RSK i que també és necessari un dels seus dominis coiled-coil, almenys els aminoà cids 558 i 561. Aquests processos, però, semblen ser independents de lâactivació de NFAT5 en resposta a hipertonicitat. ââ
Resumo:
Treball de recerca realitzat per un alumne d’ensenyament secundari i guardonat amb un Premi CIRIT per fomentar l'esperit científic del Jovent l’any 2008. La nanobiotecnologia és una branca de la nanociència i/o nanotecnologia que previsiblement tindrà un gran creixement i impacte durant els propers anys en molts camps i especialment en el de la diagnosi i tractament de malalties. Això requereix disposar de biosensors a escala nanomètrica que siguin molt sensibles i selectius enfront d’agents químics i biològics, a fi de poder obtenir dades en temps real “in situ” a nivell cel•lular i facilitar tractaments específics i personalitzats. Un petit pas previ als nanobiosensors són els microsensors químics, que poden ser fàcilment implantats en teixits humans sense lesionar-los i proporcionar mesures freqüents o contínues del pH o de la concentració de diversos ions que són dades importants per determinar l’estat de salut d’una persona. Els sensors ISFET tenen una configuració que els permet detectar i mesurar les concentracions de ions H+, per tant mesuren el pH. Entre les seves aplicacions hi destaca la gran eficàcia en la detecció del ió H+ en petites concentracions, que, entre altres usos com els biomèdics, és de gran importància en la mesura de la qualitat dels terrenys de cultiu. Si el sensor tipus ISFET és modificat mitjançant una membrana, com es fa en el present treball, pot desenvolupar moltes aplicacions en el camp de la salut, com és el cas de la detecció de cèl•lules mortes dins el cos humà, i per tant detectar de manera precoç la necrosi.
Resumo:
Projecte de recerca elaborat a partir d’una estada al Max Born Institute for Nonlinear Optics and Short Pulse Spectroscopy entre setembre i desembre 2007. Els materials monocristal•lins tungstats dobles de potassi i terra rara, KRE(WO4)2, a partir d'ara KREW, són en l'actualitat un material competitiu com a material actiu per sistemes de làser d'estat sòlid. Aquests materials monoclínics són fàcils de dopar amb altres densitats de ions lantànid, Ln3+, i a més presenten unes seccions eficaces d'absorció i d'emissió, molt elevades. Dins d’aquesta família, destaca el KLuW; degut als seus millors resultats com a material làser. Durant aquesta estada d’un mes al laboratori Max Born de Berlin, s’han realitzat les mesures de conductivitat tèrmica d’aquest material, per tal de obtenir el seu tensor de segon ordre de conductivitat tèrmica. El bombeig òptic dels materials làser d’estat sòlid genera calor com a resultat de la termalització en els multiplets, de les relaxacions no-radiatives i de les absorcions residuals (defectes, impureses). Per tant, el coneixement de les propietats tèrmiques de qualsevol material actiu és essencial pel disseny de la cavitat làser i l’avaluació de la funció làser, especialment en règims d’altes potències(...)
Resumo:
The 1st chapter of this work presents the different experiments and collaborations in which I am involved during my PhD studies of Physics. Following those descriptions, the 2nd chapter is dedicated to how the radiation affects the silicon sensors, as well as some experimental measurements carried out at CERN (Geneve, Schwitzerland) and IFIC (Valencia, Spain) laboratories. Besides the previous investigation results, this chapter includes the most recent scientific papers appeared in the latest RD50 (Research & Development #50) Status Report, published in January 2007, as well as some others published this year. The 3rd and 4th are dedicated to the simulation of the electrical behavior of solid state detectors. In chapter 3 are reported the results obtained for the illumination of edgeless detectors irradiated at different fluences, in the framework of the TOSTER Collaboration. The 4th chapter reports about simulation design, simulation and fabrication of a novel 3D detector developed at CNM for ions detection in the future ITER fusion reactor. This chapter will be extended with irradiation simulations and experimental measurements in my PhD Thesis.