Direct modulation of electroluminescence from silicon nanocrystals beyond radiative recombination rates

We propose a light emitting transistor based on silicon nanocrystals provided with 200 Mbits/ s built-in modulation. Suppression of electroluminescence from silicon nanocrystals embedded into the gate oxide of a field effect transistor is achieved by fast Auger quenching. In this process, a modulating drain signal causes heating of carriers in the channel and facilitates the charge injection into the nanocrystals. This excess of charge enables fast nonradiative processes that are used to obtain 100% modulation depths at modulating voltages of 1 V.

Si nanocrystal-based LEDs fabricated by ionimplantation and plasma-enhanced chemical vapourdeposition

Dept. Electrònica

The First World War and coal trade geography in Latin America and the Caribbean (1890-1930)

This paper aims to illustrate the dynamics of coal trade between Latin America and its main trade partners, i.e. the USA, Great Britain and Germany, before and after the enormous disruption caused by the First World War. The coal trade was used as an indicator of modernization for Latin American countries, given that oil was at that time of secondary importance. Energy imports have determined the possibilities of each Latin American country in its process of development. Here we address this question and place special emphasis on supply channels, concluding that the trade link with main suppliers was of key significance. Although this was very clear by the end of the period, the process had started well before the First World War, at least for the majority of LA&C countries. These points are developed through a gravity model applied to the bilateral coal trade. The importance of the market supplier share is addressed through cluster methodologies.

Influence of RF power on the properties of sputtered ZnO:Al thin films

Transparent conducting, aluminium doped zinc oxide thin films (ZnO:Al) were deposited by radio frequency (RF) magnetron sputtering. The RF power was varied from 60 to 350Wwhereas the substrate temperature was kept at 160 °C. The structural, electrical and optical properties of the as-deposited films were found to be influenced by the deposition power. The X-ray diffraction analysis showed that all the films have a strong preferred orientation along the [001] direction. The crystallite size was varied from 14 to 36 nm, however no significant change was observed in the case of lattice constant. The optical band gap varied in the range 3.44-3.58 eV. The lowest resistivity of 1.2×10 -3Vcm was shown by the films deposited at 250 W. The mobility of the films was found to increase with the deposition power.

Transparent conducting thin films by the co-sputtering of ZnO-ITO targets

Transparent and conductive Zn-In-Sn-O (ZITO) amorphous thin films have been deposited at room temperature by the rf magnetron co-sputtering of ITO and ZnO targets. Co-sputtering gives the possibility to deposit multicomponent oxide thin films with different compositions by varying the power to one of the targets. In order to make ZITO films with different Zn content, a constant rf power of 50 W was used for the ITO target, where as the rf power to ZnO target was varied from 25 W to 150 W. The as deposited films showed an increase in Zn content ratio from 17 to 67 % as the power to ZnO target was increased from 25 to 150 W. The structural, electrical and optical properties of the as deposited films are reported. The films showed an average transmittance over 80% in the visible wavelength range. The electrical resistivity and optical band gap of the ZITO films were found to depend on the Zn content in the film. The ZITO films deposited at room temperature with lower Zn content ratios showed better optical transmission and electrical properties compared to ITO film.

Electrical and optical properties of Zn-In-Sn-O transparent conducting thin films

Indium tin oxide (ITO) is one of the widely used transparent conductive oxides (TCO) for application as transparent electrode in thin film silicon solar cells or thin film transistors owing to its low resistivity and high transparency. Nevertheless, indium is a scarce and expensive element and ITO films require high deposition temperature to achieve good electrical and optical properties. On the other hand, although not competing as ITO, doped Zinc Oxide (ZnO) is a promising and cheaper alternative. Therefore, our strategy has been to deposit ITO and ZnO multicomponent thin films at room temperature by radiofrequency (RF) magnetron co-sputtering in order to achieve TCOs with reduced indium content. Thin films of the quaternary system Zn-In-Sn-O (ZITO) with improved electrical and optical properties have been achieved. The samples were deposited by applying different RF powers to ZnO target while keeping a constant RF power to ITO target. This led to ZITO films with zinc content ratio varying between 0 and 67%. The optical, electrical and morphological properties have been thoroughly studied. The film composition was analysed by X-ray Photoelectron Spectroscopy. The films with 17% zinc content ratio showed the lowest resistivity (6.6 × 10 - 4 Ω cm) and the highest transmittance (above 80% in the visible range). Though X-ray Diffraction studies showed amorphous nature for the films, using High Resolution Transmission Electron Microscopy we found that the microstructure of the films consisted of nanometric crystals embedded in a compact amorphous matrix. The effect of post deposition annealing on the films in both reducing and oxidizing atmospheres were studied. The changes were found to strongly depend on the zinc content ratio in the films.

Uniformity Study of Amorphous and Microcrystalline Silicon Thin Films Deposited on 10cmx10cm Glass Substrate using Hot Wire CVD Technique

The scaling up of the Hot Wire Chemical Vapor Deposition (HW-CVD) technique to large deposition area can be done using a catalytic net of equal spaced parallel filaments. The large area deposition limit is defined as the limit whenever a further increment of the catalytic net area does not affect the properties of the deposited film. This is the case when a dense catalytic net is spread on a surface considerably larger than that of the film substrate. To study this limit, a system able to hold a net of twelve wires covering a surface of about 20 cm x 20 cm was used to deposit amorphous (a-Si:H) and microcrystalline (μc-Si:H) silicon over a substrate of 10 cm x 10 cm placed at a filament-substrate distance ranging from 1 to 2 cm. The uniformity of the film thickness d and optical constants, n(x, λ) and α(x,¯hω), was studied via transmission measurements. The thin film uniformity as a function of the filament-substrate distance was studied. The experimental thickness profile was compared with the theoretical result obtained solving the diffusion equations. The optimization of the filament-substrate distance allowed obtaining films with inhomogeneities lower than ±2.5% and deposition rates higher than 1 nm/s and 4.5 nm/s for (μc-Si:H) and (a-Si:H), respectively.

A review of the Tripterygion tripteronotus (Risso, 1810) complex, with a description of a new species from the Mediterranean Sea (Teleostei: Tripterygiidae)

We compared specimens of Tripterygion tripteronotus from 52 localities of the Mediterranean Sea and adjacent waters, using four gene sequences (12S rRNA, tRNA-valine, 16S rRNA and COI) and morphological characters. Two well-differentiated clades with a mean genetic divergence of 6.89±0.73% were found with molecular data, indicating the existence of two different species. These two species have disjunctive geographic distribution areas without any molecular hybrid populations. Subtle but diagnostic morphological differences were also present between the two species. T. tripteronotus is restricted to the northern Mediterranean basin, from the NE coast of Spain to Greece and Turkey, including the islands of Malta and Cyprus. T. tartessicum n. sp. is geographically distributed along the southern coast of Spain, from Cape of La Nao to the Gulf of Cadiz, the Balearic Islands and northern Africa, from Morocco to Tunisia. According to molecular data, these two species could have diverged during the Pliocene glaciations 2.7-3.6 Mya.

Corpus Oral Dialectal (COD). Caràtula

Aquest document conté la imatge de la caràtula del CD "COD. Corpus Oral Dialectal". El COD és un component del Corpus de Català Contemporani de la Universitat de Barcelona (CCCUB), un arxiu de corpus de llengua catalana oral contemporània que ha estat confegit pel grup de recerca Grup d'Estudi de la Variació (GEV) amb la finalitat de contribuir a l'estudi de la variació dialectal, social i funcional en la llengua catalana. Aquest i altres materials del CCCUB són accessibles directament al Dipòsit Digital de la UB (http://diposit.ub.edu) o a través del web del CCCUB (http://www.ub.edu/cccub).

The First World War and coal trade geography in Latin America and the Caribbean (1890-1930)

This paper aims to illustrate the dynamics of coal trade between Latin America and its main trade partners, i.e. the USA, Great Britain and Germany, before and after the enormous disruption caused by the First World War. The coal trade was used as an indicator of modernization for Latin American countries, given that oil was at that time of secondary importance. Energy imports have determined the possibilities of each Latin American country in its process of development. Here we address this question and place special emphasis on supply channels, concluding that the trade link with main suppliers was of key significance. Although this was very clear by the end of the period, the process had started well before the First World War, at least for the majority of LA&C countries. These points are developed through a gravity model applied to the bilateral coal trade. The importance of the market supplier share is addressed through cluster methodologies.

Hexaclorobenceno: 1as jornadas nacionales : Barcelona, 23-24 de mayo de 1988: libro de actas

El volum recull les 20 comunicacions presentades durant la cel·lebració d'aquestes jornades.L'objectiu d'aquestes jornades era reunir en un fòrum comú tots els investigadors i grups que estudien a Espanya l'hexaclorobenzè des dels diferents punts de vista possibles.

Studia Ramazziniana mediterranea. Vol, 2, 1992

Aquest segon volum de la revista Studia Ramazziniana mediterranea recull les Actes del Primer Congrés Català de Medicina del Treball, cel·lebrat a Barcelona del 4 al 7 d'abril de 1984.Les actes s'ordenen en quatre grups segons la temàtica tractada: Asbestosi, Invalideses, Dermatologia Laboral i Hepatitis.

Cirugía forense o Arte de hacer las relaciones chirúrgico-legales

L'obra consta de dues parts. La primera és un estudi previ fet pel doctor Jacint Corbella i que consisteix en una petita biografia del doctor Vidal i una anàlisi de la seva obra i la seva rellevància posterior en el desenvolupament de la medicina legal.La segona part és la pròpia obra de Vidal, datada del 1783 i que constitueix el primer llibre fet a Espanya dedicat estrictament a la medicina legal.

L'Obra mèdica catalana de dos cirurgians del 1700: Anton de Borja i Carles Pallejà

En aquest llibre trobem l'obra de 1672 "Principios de cirugía útiles y provechosos, para que puedan aprovecharse los principiantes en esta facultad" del cirurgià espanyol Jerónimo de Ayala. És una còpia editada per Carles Pallejà a partir d'una traducció d'Anton de Borja.Tot plegat ve presentat i acompanyat d'un estudi de l'autor, Pere Vallribera, així com d'una crítica històrica del text original i el seu context.