A current-mode interface circuit for a piezoresistive pressure sensor

An interfacing circuit for piezoresistive pressure sensors based on CMOS current conveyors is presented. The main advantages of the proposed interfacing circuit include the use of a single piezoresistor, the capability of offset compensation, and a versatile current-mode configuration, with current output and current or voltage input. Experimental tests confirm linear relation of output voltage versus piezoresistance variation.

Designing and testing of a sensor based on a magnetoresistive manganese perovskite thick film

In this paper we report on the growth of thick films of magnetoresistive La2/3Sr1/3MnO3 by using spray and screen printing techniques on various substrates (Al2O3 and ZrO2). The growth conditions are explored in order to optimize the microstructure of the films. The films display a room-temperature magnetoresistance of 0.0012%/Oe in the 1 kOe field region. A magnetic sensor is described and tested.

Properties of nitrogen doped silicon films deposited by low-pressure chemical vapor deposition from silane and ammonia

Nitrogen doped silicon (NIDOS) films have been deposited by low-pressure chemical vapor deposition from silane SiH4 and ammonia NH3 at high temperature (750°C) and the influences of the NH3/SiH4 gas ratio on the films deposition rate, refractive index, stoichiometry, microstructure, electrical conductivity, and thermomechanical stress are studied. The chemical species derived from silylene SiH2 into the gaseous phase are shown to be responsible for the deposition of NIDOS and/or (silicon rich) silicon nitride. The competition between these two deposition phenomena leads finally to very high deposition rates (100 nm/min) for low NH3/SiH4 gas ratio (R¿0.1). Moreover, complex variations of NIDOS film properties are evidenced and related to the dual behavior of the nitrogen atom into silicon, either n-type substitutional impurity or insulative intersticial impurity, according to the Si¿N atomic bound. Finally, the use of NIDOS deposition for the realization of microelectromechanical systems is investigated.

A fully automated hot-wall multiplasma-monochamber reactor for thin film deposition

We present a study on the development and the evaluation of a fully automated radio-frequency glow discharge system devoted to the deposition of amorphous thin film semiconductors and insulators. The following aspects were carefully addressed in the design of the reactor: (1) cross contamination by dopants and unstable gases, (2) capability of a fully automated operation, (3) precise control of the discharge parameters, particularly the substrate temperature, and (4) high chemical purity. The new reactor, named ARCAM, is a multiplasma-monochamber system consisting of three separated plasma chambers located inside the same isothermal vacuum vessel. Thus, the system benefits from the advantages of multichamber systems but keeps the simplicity and low cost of monochamber systems. The evaluation of the reactor performances showed that the oven-like structure combined with a differential dynamic pumping provides a high chemical purity in the deposition chamber. Moreover, the studies of the effects associated with the plasma recycling of material from the walls and of the thermal decomposition of diborane showed that the multiplasma-monochamber design is efficient for the production of abrupt interfaces in hydrogenated amorphous silicon (a-Si:H) based devices. Also, special attention was paid to the optimization of plasma conditions for the deposition of low density of states a-Si:H. Hence, we also present the results concerning the effects of the geometry, the substrate temperature, the radio frequency power and the silane pressure on the properties of the a-Si:H films. In particular, we found that a low density of states a-Si:H can be deposited at a wide range of substrate temperatures (100°C

Influence of pressure and radio frequency power on deposition rate and structural properties of hydrogenated amorphous silicon thin films prepared by plasma deposition

The influence of radio frequency (rf) power and pressure on deposition rate and structural properties of hydrogenated amorphous silicon (a-Si:H) thin films, prepared by rf glow discharge decomposition of silane, have been studied by phase modulated ellipsometry and Fourier transform infrared spectroscopy. It has been found two pressure regions separated by a threshold value around 20 Pa where the deposition rate increases suddenly. This behavior is more marked as rf power rises and reflects the transition between two rf discharges regimes. The best quality films have been obtained at low pressure and at low rf power but with deposition rates below 0.2 nm/s. In the high pressure region, the enhancement of deposition rate as rf power increases first gives rise to a reduction of film density and an increase of content of hydrogen bonded in polyhydride form because of plasma polymerization reactions. Further rise of rf power leads to a decrease of polyhydride bonding and the material density remains unchanged, thus allowing the growth of a-Si:H films at deposition rates above 1 nm/s without any important detriment of material quality. This overcoming of deposition rate limitation has been ascribed to the beneficial effects of ion bombardment on the a-Si:H growing surface by enhancing the surface mobility of adsorbed reactive species and by eliminating hydrogen bonded in polyhydride configurations.

Pressure groups and experts in environmental regulation

We study a problem of adverse selection in the context of environmental regulation, where the firm may suffer from a certain degree of ignorance about its own type. In a framework like the construction of a certain infrastructure project, the presence of ignorance about its impact on the environment, can play an important role in the determination of the regulatory policy. First, an optimal contract is constructed for any exogenous level of ignorance. Second, the presence of potentially informed third-parties is studied from the perspective of the regulator, which allows us to analyze the impact on the efficiency of the contract, of the presence of environmentalists and of experts. Then, we obtain some insights on how the problem differs when the degree of ignorance is a choice variable for the firm. We finally use our results to derive policy implications concerning the existing envoronmental regulation, and the potential role of interested parties as information providers.

Tomato response to a high light transmission greenhouse film

Increasing greenhouse light transmission has a positive effect not only in Northern latitudes but in Mediterranean countries as well. A greenhouse, H2, with a tetrafluoroethylene copolymer 60 microns film, (Asahi Glass company, Aflex) characterised by its high light transmission and durability was compared to another greenhouse with a co-extruded film considered as a control, H1. Tomato crop response to the increase in light during winter and summer with high temperature and light was evaluated. Light transmission in H2 remained very high in spite of the observed dust accumulation and the low angle of incidence of the winter solar radiation. Transmissivity was clearly higher for H2 (81 to 83 % throughout the season) than in the control (around 63 %). The rest of the climatic parameters were similar in both greenhouses, either in the winter or in the summer evaluations. In spite of the high solar radiation in H2, the summer temperature could be maintained at the desired levels by using evaporative cooling. Accumulated tomato yield and quality was better in the H2 greenhouse (15 % more for the winter crop and 27% more for the summer crop). Fruit size was bigger in the winter crop. As an overall conclusion, the use of high light transmissive films in Mediterranean areas is very convenient for many vegetable crops. This is valid not only in winter but in summer, provided the greenhouse has good ventilation or evaporative cooling to overcome the increase in sensible heat caused by this increase in light..

Effect of high pressure processing on the microbiology of skin-vacuum packaged sliced meat products: cooked pork ham, dry cured pork ham and marinated beef loin

High hydrostatic pressure is being increasingly investigated in food processing. It causes microbial inactivation and therefore extends the shelf life and enhances the safety of food products. Yeasts, molds, and vegetative cells of bacteria can be inactivated by pressures in the range of 200 to 700 MPa. Microorganisms are more or less sensitive to pressure depending on several factors such as type, strain and the phase or state of the cells. In general, Gram-positive organisms are usually more resistant than Gram-negative. High pressure processing modifies the permeability of the cell membrane, the ion exchange and causes changes in morphology and biochemical reactions, protein denaturations and inhibition of genetic mechanisms. High pressure has been used successfully to extend the shelf life of high-acid foods such as refrigerated fruit juices, jellies and jams. There is now an increasing interest in the use of this technology to extend the shelf life of low-acid foods such as different types of meat products.

Bioequivalence of meat products treated with high pressure processing

The effects of high pressure on the composition of food products have not been evaluated extensively. Since, it is necessary to take in consideration the possible effects in basis to the changes induced in the bio molecules by the application of high pressures. The main effect on protein is the denaturation, because the covalent bonds are not affected; however hydrogen bonding, hydrophobic and intermolecular interactions are modified or destroyed. 1 High pressure can modify the activity of some enzymes. If this is done the proteolysis and lipolysis could be more or less intense and the content of free amino acids and fatty acids will be different. This could be related to the bioavailability of these compounds. Low pressures (100 MPa) have been shown to activate some enzymes (monomeric enzymes). Higher pressures induce loss of the enzyme activity. However some enzymes are very stable (ex. Lipase ~ 600 - 1000 MPa). Lipoxygenase is less stable, and there is little information about the effects on antioxidant enzymes. Other important issue is the influence of high pressure on oxidation susceptibility. This could modify the composition of lipids if the degree of the oxidation would have been higher or lower than in the traditional product. Pressure produces the damage of cell membranes favouring the contact between substrates and enzymes, exposure to oxidation of membrane fatty acids and loos of the efficiency of vitamin E. These effects can also affect to protein oxidation. In this study different compounds were analysed to establish the differences between non-treated and high-pressure treated products.

Tourism and urban transport: holding demand pressure under supply constraints

Scholars and local planners are increasingly interested in tourism contribution to economic and social development. To this regard, several European cities lead the world rankings on tourist arrivals, and their governments have promoted tourism activity. Mobility is an essential service for tourists visiting large cities, since it is a crucial factor for their comfort. In addition, it facilitates the spread of benefits across the city. The aim of this study is to determine whether city planners respond to this additional urban transport demand pressure by extending supply services. We use an international database of European cities. Our results confirm that tourism intensity is a demand enhancing factor on urban transport. Contrarily, cities do not seem to address this pressure by increasing service supply. This suggests that tourism exerts a positive externality on public transport since it provides additional funding for these services, but it imposes as well external costs on resident users because of congestion given supply constraints.

Authoritarian Responses to Foreign Pressure: Spending, Repression, and Sanctions

This paper explores how international sanctions affect authoritarian rulers’ decisions concerning repression and public spending composition, and how different authoritarian rulers respond to foreign pressure. If sanctions are assumed to increase the price of loyalty to the regime, then rulers whose budgets are not severely constrained by sanctions will tend to increase spending in those categories that most benefit their core support groups. In contrast, when constraints are severe due to reduced aid and trade, dictators are expected to greatly increase their levels of repression. Using data on regime types, public expenditures and spending composition (1970–2000) as well as on repression levels (1976–2001), we show that the empirical patterns conform well to our theoretical expectations. Single-party regimes, when targeted by sanctions, increase spending on subsidies and transfers which largely benefit more substantial sectors of the population and especially the urban classes. Likewise, military regimes increase their expenditures on goods and services, which include military equipment and soldiers’ and officers’ wages. Conversely, personalist regimes reduce spending in all categories, especially capital expenditures, while increasing repression much more than other regime types when targeted by sanctions.

Product differentiation, competitive pressure and the effects of innovation on the success and survivability of firms in oligopoly markets

In a recent paper Tishler and Milstein (2009) fi…nd that increased competition may increase aggregate R&D spending while market output decreases. Therefore, they obtain the surprising result that R&D spending is excessive when competition becomes intense. Their result is based on the standard linear demand function for differentiated products introduced by Bowley (1924) where decreased product differentiation is interpreted as more competitive pressure. In this paper I show that at an aggregate level this interpretation is problematic because equilibrium effects are dominated by a demand reduction effect. A slight modifi…cation of the standard demand function eliminates this effect. For the Tishler and Milstein (2009) setting it is shown that then increased competition increases both R&D spending and aggregate market output. Therefore, at least for consumers, more intense competition increases welfare. Journal of Economic Literature Classi…fication Numbers: D43, L1, O3. Keywords: Oligopoly markets, Product differentiation, Competitive pressure.

Innovation or Imitation? The effect of spillovers and competitive pressure on firms' R&D strategy choice

This article provides a theoretical and empirical analysis of a firm's optimal R&D strategy choice. In this paper a firm's R&D strategy is assumed to be endogenous and allowed to depend on both internal firms. characteristics and external factors. Firms choose between two strategies, either they engage in R&D or abstain from own R&D and imitate the outcomes of innovators. In the theoretical model this yields three types of equilibria in which either all firms innovate, some firms innovate and others imitate, or no firm innovates. Firms'equilibrium strategies crucially depend on external factors. We find that the efficiency of intellectual property rights protection positively affects firms'incentives to engage in R&D, while competitive pressure has a negative effect. In addition, smaller firms are found to be more likely to become imitators when the product is homogeneous and the level of spillovers is high. These results are supported by empirical evidence for German .rms from manufacturing and services sectors. Regarding social welfare our results indicate that strengthening intellectual property protection can have an ambiguous effect. In markets characterized by a high rate of innovation a reduction of intellectual property rights protection can discourage innovative performance substantially. However, a reduction of patent protection can also increase social welfare because it may induce imitation. This indicates that policy issues such as the optimal length and breadth of patent protection cannot be resolved without taking into account specific market and firm characteristics. Journal of Economic Literature Classification Numbers: C35, D43, L13, L22, O31. Keywords: Innovation; imitation; spillovers; product differentiation; market competition; intellectual property rights protection.

A new automated method versus continuous positive airway pressure method for measuring pressure-volume curves in patients with acute lung injury

Objective: To compare pressure–volume (P–V) curves obtained with the Galileo ventilator with those obtained with the CPAP method in patients with ALI or ARDS receiving mechanical ventilation. P–V curves were fitted to a sigmoidal equation with a mean R2 of 0.994 ± 0.003. Lower (LIP) and upper inflection (UIP), and deflation maximum curvature (PMC) points calculated from the fitted variables showed a good correlation between methods with high intraclass correlation coefficients. Bias and limits of agreement for LIP, UIP and PMC obtained with the two methods in the same patient were clinically acceptable.

Ús de Sensor Web Enablement per a gestió de dades marines i accés al servei d'observació de sensors a través de client Android

El present treball és un estudi de l'estat de Sensor Web Enablement (SWE) aplicat a l'àmbit marí d'investigació oceanogràfica. Per assolir aquest objectiu s'han avaluat les diferents solucions d'arquitectura de sistemes més adients a la problemàtica indicada i s'ha dissenyat un client de Sensor Observation Service (SOS) per plataforma mòbil Android que permeti consultar la descripció del sensor (SensorML) i conjunts d'observacions mitjançant estàndards oberts de SWE i peticions web (SOAP). Els dissenys anteriorment indicats han permès que quedés palès l'ampli ventall de possibilitats i avantatges que s'obtenen pel fet d'emprar SWE, ja que ens permet integrar fàcilment les dades proporcionades pels sensors i les pròpies descripcions dels sensors en diferents entorns, tal i com és el cas del disseny presentat en Android, a través d'estàndards oberts independents de les múltiples especificacions de cada fabricant, en un entorn, com és l'àmbit de la investigació marina on hi ha una gran heterogeneïtat de sensors i protocols.