4 resultados para nonpoint source pollution
em Galway Mayo Institute of Technology, Ireland
Resumo:
The aim of this study was to investigate the effects of biosurfactants and organic matter amendments on the bioremediation of diesel contaminated soil. Two strains of Pseudomonas aeruginosa with the ability to produce biosurfactant were isolated from a water and soil sample in Co. Sligo. The first strain, Isolate A, produced a biosurfactant which contained four rhamnose containing compounds, when grown in proteose peptone glucose ammonium salts medium with glucose as the carbon source. Two of the components were identified as rhamnolipid 1 and 2 whilst the other two components were unidentified. The second strain, Isolate GO, when grown in similar conditions produced a biosurfactant which contained only rhamnolipid 2. The type of aeration system used had a significant effect on the abiotic removal of diesel from soil. Forced aeration at a rate of 120L 02/kg soil/ hour resulted in the greatest removal. Over a 112 day incubation period this type o f aeration resulted in the removal o f 48% o f total hexane extractable material. In relation to bioremediation of the diesel contaminated sandy soil, amending the soil with two inorganic nutrients, KH2PO4 and NÜ4N03, significantly enhanced the removal of diesel, especially the «- alkanes, when compared to an unamended control. The biosurfactant from Isolate A and a biosurfactant produced by Pseudomonas aeruginosa NCIMB 8628 (a known biosurfactant producer), when applied at a concentration of three times their critical micelle concentration, had a neutral effect on the biodégradation o f diesel contaminated sandy soil, even in the presence o f inorganic nutrients. It was deduced that the main reason for this neutral effect was because they were both readily biodegraded by the indigenous microorganisms. The most significant removal of diesel occurred when the soils were amended with two organic materials plus the inorganic nutrients. Amendment of the diesel contaminated soil with spent brewery grain (SBG) removed significantly more diesel than amendment with dried molassed sugar beet pulp (DMSBP). After a 108 day incubation period, amendment of the diesel contaminated soil with DMSBP plus inorganic nutrients and SBG plus inorganic nutrients resulted in 72 and 89% removal of diesel range organics (DRO), in comparison to 41% removal of DRO in an inorganic nutrient amended control. The first order kinetic model described the degradation of the different diesel components with high correlation and was used to calculate Vi lives. The V2 life, of the total «-alkanes in the diesel was reduced from 40 days in the control to 8.5 and 5.1 days in the presence of DMSBP and SBG, respectively. The V2 life o f the unresolved complex mixture (UCM) in the diesel contaminated soil was also significantly reduced in the presence o f the two organics. DMSBP and SBG addition reduced UCM V2 life to 86 and 43 days, respectively, compared to 153 days in the control. The component of diesel whose removal was enhanced the greatest through the organic material amendments was the isoprenoid, pristane, a compound which until recently was thought to be nonbiodegradable and was used as an inert biomarker in oil degradation studies. The V2 life of pristane was reduced from 533 days in the nutrient amended control to 49.5 and 19.5 days in DMSBP and SBG amended soils. These results indicate that the addition o f the DMSBP and SBG to diesel contaminated soil stimulated diesel biodégradation, probably by enhancing the indigenous diesel degrading microbial population to degrade diesel hydrocarbons, whilst the addition o f biosurfactants had no enhanced effect on the bioremediation process.
Resumo:
Recent studies have shown that septic tank systems are a major source of groundwater pollution. Many public health workers feel that the most cri^cal aspect of the use of septic tanks as a means of sewage disposal is the contamination of private water wells with attendant human health hazards. In this study the movement and attenuation of septic tank effluents in a range of soil/overburden types and hydrogeological situations was investigated. The suitability of a number of chemical and biological tracer materials to monitor the movement of septic tank effluent constituents to groundwater sources was also examined. The investigation was divided into three separate but inteiTelated sections. In the first section of the study the movement of septic tank effluent from two soil treatment systems was investigated by direct measurements of soil nutrient concentrations and enteric bacterial numbers in the soil beneath and downgradient of the test systems. Two sites with different soil types and hydrogeological characteristics were used. The results indicated that the attenuation of the effluent in both of the treatment systems was incomplete. Migration of nitrate, ammonium, phosphate and fecal bacteria to a depth of 50 cm beneath the inverts of the distribution tiles was demonstrated on all sampling occasions. The lateral migration of the pollutants was less pronounced, although on occasions high nutrients levels and fecal bacterial numbers were detected at a lateral distance of 4.0 m downgradient of the test systems. There was evidence that the degree and extent of effluent migration was increased after periods of heavy or prolonged rainfall when the attenuating properties of the treatment systems were reduced as a result of saturation of the soil. The second part of the study examined the contamination of groundwaters downgradient of septic tank soil treatment systems. Three test sites were used in the investigation. The sites were chosen because of differences in the thicknesses and nature of the unsaturated zone available for effluent attenuation at each of the locations. A series of groundwater monitoring boreholes were installed downgradient of the test systems at each of the sites and these were sampled regularly to assess the efficiency of the overburden material in reducing the polluting potential of the wastewater. Effluent attenuation in the septic tank treatment systems was shown to be incomplete, resulting in chemical and microbiological contamination of the groundwaters downgradient of the systems. The nature and severity of groundwater contamination was dependent on the composition and thickness of the unsaturated zone and the extent of weathering in the underlying saturated bedrock. The movement of septic tank effluent through soil/overburdens to groundwater sources was investigated by adding a range of chemical and biological tracer materials to the three septic tank systems used in section two of the study. The results demonstrated that a single tracer type cannot be used to accurately monitor the movement of all effluent constituents through soils to groundwater. The combined use of lithium bromide and endospores of Bacillus globigii was found to give an accurate indication of the movement of both the chemical and biological effluent constituents.
Resumo:
The vulnerability to pollution and hydrochemical variation of groundwater in the mid-west karstic lowlands of Ireland were investigated from October 1992 to September 1993, as part of an EU STRIDE project at Sligo Regional Technical College. Eleven springs were studied in the three local authority areas of Co. Galway, Co. Mayo, and Co. Roscommon. Nine of the springs drain locally or regionally important karstic aquifers and two drain locally important sand and gravel aquifers. The maximum average daily discharge of any of the springs was 16,000 m3/day. Determination of the vulnerability of groundwater to pollution relies heavily on an examination of subsoil deposits in an area since they can act as a protecting or filtering layer over groundwater. Within aquifers/spring catchments, chemical reactions such as adsorption, solution-precipitation or acid-base reactions occur and modify the hydrochemistry of groundwater (Lloyd and Heathcote, 1985). The hydrochemical processes) that predominate depend cm the mineralogy of the aquifer, the hydrogeological environment, the overlying subsoils, and the history of groundwater movement. The aim of this MSc research thesis was to investigate the hydrochemical variation of spring outflow and to assess the relationship between these variations and the intrinsic vulnerability of the springs and their catchments. If such a relationship can be quantified, then it is hoped that the hydrochemical variation of a spring may indicate the vulnerability of a spring catchment without the need for determining it by field mapping. Such a method would be invaluable to any of the three local authorities since they would be able to prioritise sources that are most at risk from pollution, using simple techniques of chemical sampling, and statistical analysis. For each spring a detailed geological, hydrogeological and hydrochemical study was carried out. Individual catchment areas were determined with a water balance/budget and groundwater tracing. The subsoils geology for each spring catchment were mapped at the 1:10,560 scale and digitised to the 1:25,000 scale with AutoCad™ and Arclnfo™. The vulnerability of each spring was determined using the Geological Survey's vulnerability guidelines. Field measurements and laboratory based chemistry analyses of the springs were undertaken by personnel from both the EPA Regional Laboratory in Castlebar, Co. Mayo, and the Environment Section of Roscommon Co. Council. Electrical conductivity and temperature (°C) were sampled fortnightly, in the field, using a WTW microprocessor conductivity meter. A percentage (%) vulnerability was applied to each spring in order to indicate the areal extent of the four main classes of vulnerability (Extreme, High, Moderate, and Low) which occurred within the confines of each spring catchment. Hydrochemical variation for the springs were presented as the coefficient of variation of electrical conductivity. The results of this study show that a clear relationship exists between the degree of vulnerability of each catchment area as defined by the subsoil cover and the coefficient of variation of EC, with the coefficient of variation increasing as the vulnerability increases. The coefficient of variation of electrical conductivity is considered to be a parameter that gives a good general reflection of the degree of vulnerability occurring in a spring catchment in Ireland's karstic lowlands.
Resumo:
This study utilised recent developments in forensic aromatic hydrocarbon fingerprint analysis to characterise and identify specific biogenic, pyrogenic and petrogenic contamination. The fingerprinting and data interpretation techniques discussed include the recognition of: The distribution patterns of hydrocarbons (alkylated naphthalene, phenanthrene, dibenzothiophene, fluorene, chrysene and phenol isomers), • Analysis of “source-specific marker” compounds (individual saturated hydrocarbons, including n-alkanes (n-C5 through 0-C40) • Selected benzene, toluene, ethylbenzene and xylene isomers (BTEX), • The recalcitrant isoprenoids; pristane and phytane and • The determination of diagnostic ratios of specific petroleum / non-petroleum constituents, and the application of various statistical and numerical analysis tools. An unknown sample from the Irish Environmental Protection Agency (EPA) for origin characterisation was subjected to analysis by gas chromatography utilising both flame ionisation and mass spectral detection techniques in comparison to known reference materials. The percentage of the individual Polycyclic Aromatic Hydrocarbons (PAIIs) and biomarker concentrations in the unknown sample were normalised to the sum of the analytes and the results were compared with the corresponding results with a range of reference materials. In addition, to the determination of conventional diagnostic PAH and biomarker ratios, a number of “source-specific markers” isomeric PAHs within the same alkylation levels were determined, and their relative abundance ratios were computed in order to definitively identify and differentiate the various sources. Statistical logarithmic star plots were generated from both sets of data to give a pictorial representation of the comparison between the unknown sample and reference products. The study successfully characterised the unknown sample as being contaminated with a “coal tar” and clearly demonstrates the future role of compound ratio analysis (CORAT) in the identification of possible source contaminants.