Atorvastatin versus Bezafibrate in Mixed Hyperlipidaemia : Randomised Clinical Trial of Efficacy and Safety (the ATOMIX Study)

OBJECTIVE: Combined hyperlipidaemia is a common and highly atherogenic lipid phenotype with multiple lipoprotein abnormalities that are difficult to normalise with single-drug therapy. The ATOMIX multicentre, controlled clinical trial compared the efficacy and safety of atorvastatin and bezafibrate in patients with diet-resistant combined hyperlipidaemia. PATIENTS AND STUDY DESIGN: Following a 6-week placebo run-in period, 138 patients received atorvastatin 10mg or bezafibrate 400mg once daily in a randomised, double-blind, placebo-controlled trial. To meet predefined low-density lipoprotein-cholesterol (LDL-C) target levels, atorvastatin dosages were increased to 20mg or 40mg once daily after 8 and 16 weeks, respectively. RESULTS: After 52 weeks, atorvastatin achieved greater reductions in LDL-C than bezafibrate (percentage decrease 35 vs 5; p < 0.0001), while bezafibrate achieved greater reductions in triglyceride than atorvastatin (percentage decrease 33 vs 21; p < 0.05) and greater increases in high-density lipoprotein-cholesterol (HDL-C) [percentage increase 28 vs 17; p < 0.01 ]. Target LDL-C levels (according to global risk) were attained in 62% of atorvastatin recipients and 6% of bezafibrate recipients, and triglyceride levels <200 mg/dL were achieved in 52% and 60% of patients, respectively. In patients with normal baseline HDL-C, bezafibrate was superior to atorvastatin for raising HDL-C, while in those with baseline HDL-C <35 mg/dL, the two drugs raised HDL-C to a similar extent after adjustment for baseline values. Both drugs were well tolerated. CONCLUSION: The results show that atorvastatin has an overall better efficacy than bezafibrate in concomitantly reaching LDL-C and triglyceride target levels in combined hyperlipidaemia, thus supporting its use as monotherapy in patients with this lipid phenotype.

Salvage Flexor Hallucis Longus Transfer for a Failed Achilles Repair: Endoscopic Technique

Flexor hallucis longus (FHL) transfer is a well-established treatment option in failed Achilles tendon (AT) repair and has been routinely performed as an open procedure. We detail the surgical steps needed to perform an arthroscopic transfer of the FHL for a chronic AT rupture. The FHL tendon is harvested as it enters in its tunnel beneath the sustentaculum tali; a tunnel is then drilled in the calcaneus as near to the AT footprint as possible. By use of a suture-passing device, the free end of the FHL is advanced to the plantar aspect of the foot. After adequate tension is applied to the construct, the tendon is fixed in place with an interference screw in an inside-out fashion. This minimally invasive approach is a safe and valid alternative to classic open procedures with the obvious advantages of preserving the soft-tissue envelope and using a biologically intact tendon.