Molecular simulation of gas adsorption equilibria in nanoporous materials

This work is divided into two distinct parts. The first part consists of the study of the metal organic framework UiO-66Zr, where the aim was to determine the force field that best describes the adsorption equilibrium properties of two different gases, methane and carbon dioxide. The other part of the work focuses on the study of the single wall carbon nanotube topology for ethane adsorption; the aim was to simplify as much as possible the solid-fluid force field model to increase the computational efficiency of the Monte Carlo simulations. The choice of both adsorbents relies on their potential use in adsorption processes, such as the capture and storage of carbon dioxide, natural gas storage, separation of components of biogas, and olefin/paraffin separations. The adsorption studies on the two porous materials were performed by molecular simulation using the grand canonical Monte Carlo (μ,V,T) method, over the temperature range of 298-343 K and pressure range 0.06-70 bar. The calibration curves of pressure and density as a function of chemical potential and temperature for the three adsorbates under study, were obtained Monte Carlo simulation in the canonical ensemble (N,V,T); polynomial fit and interpolation of the obtained data allowed to determine the pressure and gas density at any chemical potential. The adsorption equilibria of methane and carbon dioxide in UiO-66Zr were simulated and compared with the experimental data obtained by Jasmina H. Cavka et al. The results show that the best force field for both gases is a chargeless united-atom force field based on the TraPPE model. Using this validated force field it was possible to estimate the isosteric heats of adsorption and the Henry constants. In the Grand-Canonical Monte Carlo simulations of carbon nanotubes, we conclude that the fastest type of run is obtained with a force field that approximates the nanotube as a smooth cylinder; this approximation gives execution times that are 1.6 times faster than the typical atomistic runs.

Compact SMB chromatography for binary separation

A thesis submitted for the degree of Doctor of Philosophy

Development of molecularly imprinted polymers using supercritical fluid technology

Dissertação para obtenção do Grau de Doutor em Química Sustentável

Municipal solid waste management system: decision support through systems analysis

Thesis submitted to the Universidade Nova de Lisboa, Faculdade de Ciências e Tecnologia for the degree of Doctor of Philosophy in Environmental Engineering

Development of integrated separation processes with green solvents

Dissertação para obtenção do Grau de Doutor em Química Sustentável

Valorization of olive pomace through combination of biocatalysis with supercritical fluid technology

A supercritical carbon dioxide (scCO2) based oil extraction method was implemented on olive pomace (alperujo), and an oil yield of 25,5 +/- 0,8% (goil/gdry residue) was obtained. By Soxhlet extraction with hexane, an oil extraction yield of 28,9 +/- 0,8 % was obtained, which corresponds to an efficiency of 88,4 +/- 4,8 % for the supercritical method. The scCO2 extraction process was optimized for operating conditions of 50 MPa and 348,15 K, for which an oil loading of 32,60 g oil/kg CO2 was calculated. As a proof of concept, olive pomace was used as feedstock for biodiesel production, in a process combining the use of lipase as a catalyst with the use of scCO2 as a solvent, and integrating the steps of oil extraction, oil to biodiesel transesterification and subsequent separation of the latter. In the conducted experiments, FAME (fatty acid methyl ester) purities of 90% were obtained, with the following operating parameters: an oil:methanol molar ratio of 1:24; a residence time of 7,33 and 11,6 mins; a pressure of 40 MPa; a temperature of 313,15 K; and Lipozyme (Mucor miehei; Sigma-Aldritch) as an enzyme. However, oscillations of FAME purity were registered throughout the experiments, which could possibly be due to methanol accumulation in the enzymatic reactor. Finally, the phenolic content of olive pomace, and the effect of the drying process – oven or freeze-drying – and the extraction methods – hydro-alcoholic method and supercritical method – on the phenolic content were analysed. It was verified that the oven-drying process on the olive pomace preserved 90,1 +/- 3,6 % of the total phenolic content. About 62,3 +/- 5,53% of the oven-dried pomace phenolic content was extracted using scCO2 at 60 MPa and 323,15 K. Seven individual phenols – hydroxytyrosol, tyrosol, oleuropein, quercetin, caffeic acid, ferulic acid and p-coumaric acid – were identified and quantified by HPLC.

Characterization of the volatile fraction emitted by phloems of four pinus species by solid-phase microextraction and gas chromatography–mass spectrometry

Pine forests constitute some of the most important renewable resources supplying timber, paper and chemical industries, among other functions. Characterization of the volatiles emitted by different Pinus species has proven to be an important tool to decode the process of host tree selection by herbivore insects, some of which cause serious economic damage to pines. Variations in the relative composition of the bouquet of semiochemicals are responsible for the outcome of different biological processes, such as mate finding, egg-laying site recognition and host selection. The volatiles present in phloem samples of four pine species, P. halepensis, P. sylvestris, P. pinaster and P. pinea, were identified and characterized with the aim of finding possible host-plant attractants for native pests, such as the bark beetle Tomicus piniperda. The volatile compounds emitted by phloem samples of pines were extracted by headspace solid-phase micro extraction, using a 2 cm 50/30 mm divinylbenzene/carboxen/polydimethylsiloxane table flex solid-phase microextraction fiber and its contents analyzed by high-resolution gas chromatography, using flame ionization and a non polar and chiral column phases. The components of the volatile fraction emitted by the phloem samples were identified by mass spectrometry using time-of-flight and quadrupole mass analyzers. The estimated relative composition was used to perform a discriminant analysis among pine species, by means of cluster and principal component analysis. It can be concluded that it is possible to discriminate pine species based on the monoterpenes emissions of phloem samples.

Factores favoráveis e desfavoráveis à adesão dos cidadãos à separação selectiva de resíduos sólidos urbanos, na cidade do seixal, enquanto cidade saudável

RESUMO - A cidade do Seixal, enquanto Cidade Saudável tem como missão a implementação dos princípios e estratégias do Projecto Cidades Saudáveis da OMS. Para tal, desenvolve programas e acções, conjuntamente com parceiros intersectoriais, com vista à melhoria da saúde e da qualidade de vida dos cidadãos residentes na cidade do Seixal, e que promova em simultâneo a participação da comunidade. A separação selectiva dos resíduos depende da participação dos cidadãos, pelo que esta investigação propõe-se estudar quais os factores favoráveis e desfavoráveis à adesão dos cidadãos à separação selectiva de resíduos sólidos urbanos, na cidade do Seixal, enquanto Cidade Saudável. O paradigma quantitativo foi o escolhido para guiar o desenvolvimento deste estudo, através do método survey (descrição numérica de uma fracção da população – amostra – através do processo de aplicação de questionários à população). O questionário desenvolvido para esta investigação será aplicado no Fórum Municipal do Seixal a uma amostra de 250 cidadãos residentes na cidade do Seixal. Para obter os resultados finais, será realizada, numa primeira fase, uma análise descritiva de todas as variáveis, que deverá incluir medidas de localização e variabilidade adequadas a cada variável. Numa segunda fase será realizada uma análise inferencial recorrendo a testes não paramétricos e paramétricos. ----------------ABSTRAT - The city of Seixal, while Healthy City, takes as a mission the implementation of the beginnings and strategies of the WHO Healthy Cities Project. Programs and actions are being developed for that purpose, jointly with intersectorial partners, with sight to the improvement of the health and of the quality of life of the resident citizens in the city of Seixal, and that it promotes in simultaneous the participation of the community. Because the selective waste separation depends on the participation of the citizens, the purpose of this investigation is to study the favorable and unfavorable factors which leads participation or not of the citizens to the selective separation of urbane solid wastes, in the city of Seixal, while Healthy City. The quantitative paradigm was the chosen one to guide the development of this study, through the survey method (numerical description of a fraction of the population – sample – through the process of questionnaires to the population). The questionnaire developed for this investigation will be applied in the Fórum Municipal do Seixal, to a sample of 250 resident citizens in the city of Seixal. To obtain the final results, we will carry out, in a first phase, a descriptive analysis of all the variables, which will include measures of location and variability appropriate to each one. In a second phase will be carried out an inferential analysis resorting to non parametric and parametric tests.

Modelling of the kinetics of municipal solid waste composting in full-scale mechanical-biological treatment plants

A thesis submitted in fulfilment of the requirements for the Degree of Doctor of Philosophy in Sanitary Engineering in the Faculty of Sciences and Technology of the New University of Lisbon

Characterization of Pinus spp. needles by gas chromatography and mass spectrometry: Application to plant-insect interactions

Dissertação apresentada para obtenção do Grau de Doutor em Ciências do Ambiente pela Universidade Nova de Lisboa, Faculdade de Ciências e Tecn

Development and implementation of strategies for the incorporation of reinforcing elements in aluminium alloys by solid state processing

Dissertação para obtenção do Grau de Mestre em Engenharia Mecânica

Alternative solvents in separation processes

Dissertation presented to obtain the Ph.D degree in Sustainable Chemistry

A proof system for lock-free concurrency

Dissertação para obtenção do Grau de Mestre em Engenharia Informática

Separation of bioactive peptides by electrodialysis with ultrafiltration membranes: membrane characteristics, ex-situ and in-situ digestion and their impact on peptide migration

Dissertation presented to Faculdade de Ciências e Tecnologia, Universidade Nova de Lisboa for obtaining the master degree in Membrane Engineering

One-pot enzymatic resolution/separation of enantiomers using green solvents

Dissertação para obtenção do Grau de Mestre em Biotecnologia