Hierarchical Reinforcement Learning in Behavior and the Brain

Dissertation presented to obtain the Ph.D degree in Biology, Neuroscience

Optimisation and design of post-tensioning anchorage corner blisters in concrete box girder bidges

The design of anchorage blisters of internal continuity post-tensioning tendons of bridges built by the cantilever method, presents some peculiarities, not only because they are intermediate anchorages but also because these anchorages are located in blisters, so the prestressing force has to be transferred from the blister the bottom slab and web of the girder. The high density of steel reinforcement in anchorage blisters is the most common reason for problems with concrete cast in situ, resulting in zones with low concrete compacity, leading to concrete crushing failures under the anchor plates. A solution may involve improving the concrete compression and tensile strength. To meet these requirements a high-performance fibre reinforced self-compacting mix- ture (HPFRC) was used in anchorage corner blisters of post-tensioning tendons, reducing the concrete cross-section and decreasing the reinforcement needed. To assess the ultimate capacity and the adequate serviceability of the local anchorage zone after reducing the minimum concrete cross-section and the confining reinforcement, specified by the anchorage device supplier for the particular tendon, load transfer tests were performed. To investigate the behaviour of anchorage blisters regarding the transmission of stresses to the web and the bottom slab of the girder, and the feasibility of using high performance concrete only in the blister, two half scale models of the inferior corner of a box girder existing bridge were studied: a reference specimen of ordinary reinforced concrete and a HPFRC blister specimen. The design of the reinforcement was based in the tensile forces obtained on strut-and-tie models. An experimental program was carried out to assess the models used in design and to study the feasibility of using high performance concrete only in the blister, either with casting in situ, or with precast solutions. A non-linear finite element analysis of the tested specimens was also performed and the results compared.

Évolution géologique de la marge ouest-ibérique

This paper is a summary of the results of the authors recent researches about the Western Iberian continental margin. During the Mesozoic, the margin is affected by two consecutive extensional phases interpreted as the result from two episodes of rifting in the Atlantic. Then during Cenozoic, subsidence was interrupted by compression and related deformation, specially during Eocene time. Ante-mesozoic basement controls the structural and sedimentary evolution of the margin.

Synthesis of the Piacenzian onshore record between the Aveiro and Setubal parallels (Western portuguese margin)

Onshore, the Piacenzianof the Mondego and Lower Tagus Tertiary basins comprises siliciclastic sediments deposited in shallow marine to continental environments. The outcrops of the deposits are relatively widespread in the Aveiro and Seuibal region. A lithostratigraphic synthesis based on the correlation of geological sections, is presented for the two basins. In general, the Piacenzian sediments display a regressive sucession. The Late Tortonian-Zanclean (?) confined drainage pattern changed at the beginning of Piazencian, to fluvial systems draining to the Atlantic, and capturing the drainage of the inner parts of the Hesperic Meseta. The Piacenzian sedimentary sequence post-dates one of the uprising phases during Neogene compression, recorded by a strong regional unconformity. Some local active faulting - as in Lousa, Rio Maior and Senibal- Pinhal Novo - allowed the local thickening of the sedimentary record. Later compressive tectonism continues to generate reverse faulting and diapiric reactivation, affecting those sediments. Currently, the Piacenzian deposits culminates the marginal piedmonts, widely eroded by the Quaternary fluvial dissection.

Future gender relations in global restructuring processes case study evidence from knowledge-intensive, manufacturing and service occupations

Global restructuring processes have not only strong implications for European working and living realities, but also have specific outcomes with regard to gender relations. The following contribution analyses in which way global restructuring shapes current gender relations in order to identify important trends and developments for future gender (in)equalities at the workplace. On the basis of a large qualitative study on global restructuring and impacts on different occupational groups it argues that occupational belonging in line with skill and qualification levels are crucial factors to assess the further development of gender relations at work. Whereas global restructuring in knowledge-based occupations may provide new opportunities for female employees, current restructuring is going to deteriorate female labour participation in service occupations. In contrast, manufacturing occupations can be characterised by persistent gender relations, which do not change in spite of major restructuring processes at the work place. Taking the institutional perspective into account, it seems to be crucial to integrate the occupational perspective in order to apply adequate policy regulations to prevent the reinforcement of gender related working patterns in the near future.

Age constraints on the late cretaceous alkaline magmatism on the West Iberian margin

Cretaceous Research 30 (2009) 575–586

Aspectos gerais da tectónica alpina no Algarve

The study of the tectonic strutures affecting the mesozoic and cenozoic deposits of Algarve's basin allows us to recognize the following phases of the Alpine orogeny: Jurassic (Upper Triassic at least)-Lower Cretaceous N-S distension; N-S compression during the setting-up of the Monchique syenite dome at the uppermost Cretaceous; Paleogene compression (?) (only locally? - at the Albufeira salt dome); Lower Miocene N-S distension; Upper Burdigalian to Lower Langhian N-S and E-W distension; N-S or NNW-SSE compression after the Middle Miocene; E-W compression after the Upper Tortonian; N-S compression during the Quaternary. NE-SW fractures affecting the Paleozoic basement are related with the first distension phases. The mesozoic N-S distension are the main cause of the two E-W flexures so far recognized. A tectonic inversion event did occur after the setting up of the Monchique syenite. If, the Lower Cretaceous Lower Miocene Albufeira's unconformity, is a local effect of halokinesis then, the true tectonic inversion of the Algarve basin, did occur in the Middle Miocene. These events correlate well with those knewn at Southern Spain and Morocco.

Synthesis of the Piacenzian onshore record between the Aveiro and Setúbal parallels (Western portuguese margin)

Onshore, the Piacenzian of the Mondego and Lower Tagus Tertiary basins comprises siliciclastic sediments deposited in shallow marine to continental environments. The outcrops of the deposits are relatively widespread in the Aveiro and Setúbal region. A lithostratigraphic synthesis based on the correlation of geological sections, is presented for the two basins. In general, the Piacenzian sediments display a regressive sucession. The Late Tortonian-Zanclean (?) confined drainage pattern changed at the beginning of Piazencian, to fluvial systems draining to the Atlantic, and capturing the drainage of the inner parts of the Hesperic Meseta. The Piacenzian sedimentary sequence post-dates one of the uprising phases during Neogene compression, recorded by a strong regional unconformity. Some local active faulting - as in Lousa, Rio Maior and Senibal- Pinhal Novo - allowed the local thickening of the sedimentary record. Later compressive tectonism continues to generate reverse faulting and diapiric reactivation, affecting those sediments. Currently, the Piacenzian deposits culminates the marginal piedmonts, widely eroded by the Quaternary fluvial dissection.

Evolution of Iberia during the Cenozoic with special emphasis on the formation of the Betic Cordillera and its relation with the western Mediterranean

The extensional process affecting Iberia during the Triassic and Jurassic times change from the end of the Cretaceous and, throughout the Palaeocene, the displacement between the African and European plates was clearly convergent and part of the future Internal Zone of the Betic Cordillera was affected. To the west, the Atlantic continued to open as a passive margin and, to the north, no significant deformation occurred. During the Eocene, the entire Iberian plate was subjected to compression. which caused major deformations in the Pyrenees and also in the Alpujarride and Nevado-Filabride, Internal Betic, complexes. In the Oligocene continued this situation, but in addition, the new extensional process ocurring in the western Mediterranean area, together with the constant eastward drift of Iberia due to Atlantic opening, compressed the eastern sector of Iberia, giving rise to the structuring of the Iberian Cordillera. The Neogene was the time when the Betic Cordillera reached its fundamental features with the westward displacement of the Betic-Rif Internal Zone, expelled by the progressive opening of the Algerian Basin, opening prolonged till the Alboran Sea. From the late Miocene onwards, all Iberia was affected by a N-S to NNW-SSE compression, combined in many points by a near perpendicular extension. Specially in eastern and southern Iberia a radial extension superposed these compression and extension.

Assinatura tectono-sedimentar do auge da compressão bética em Portugal: a descontinuidade sedimentar Valesiano terminal-Turoliano

An Upper Miocene important sedimentary break can be accurately recognised in the Portuguese basins and is reflected by a drastic palaeogeographic change in relation to a large-scale tectonic event of probable uppermost Vallesian-Turolian (9,5 Ma; middle Tortonian) age. The characterisation of the sedimentary record of this tectonic event, as well as its relations with interpreted active faults is made for different situations: Douro (NW border), Mondego, Lower-Tagus and Sado Tertiary basins. The sedimentary record, considered upper Tortonian-Messinian ? (uppermost Vallesian-Turolian ?) is interpreted mainly as endorheic alluvial fans (internal drainage), developed along active NNE-SSW indent-linked strike-slip faults and NE-SW reverse faults. At NE Portugal, proximal fluvial systems of an endorheic hydrographic network drained eastwards to the Spanish Duero interior Basin. The main evidences of the betic compression clímax in Portugal mainland are presented; the interpreted active tectonic structures are in accordance with an intense NNW-SSE crustal shortening, but some regional differences are also documented.

The three main marine depositional cycles of the Neogene of Portugal

The present work follows a stratigraphic model for the marine Neogene of Portugal based on the definition of three main marine sedimentary cycles. Conceptually the I, II and III Neogene Cycles can be defined as 2nd order sedimentary sequences with duration ranging from 5 to 8 Ma. The I Neogene Cycle is fully represented only in the Lower Tagus Basin. Ranging from the Early Aquitanian to the Late Burdigalian the I Neogene Cycle testify a transgressive episode in the region of Lisbon and Setúbal Peninsula. Rapid lateral facies variations suggest a shallowmarine basin. This cycle ends with an important Late Burdigalian tectonic compressive event expressed by uplift of the surrounding areas and deformation affecting the Early Miocene deposits of the Arrábida Chain. The II Neogene Cycle includes thick sedimentary sequences covering Paleozoic and Mesozoic formations in the Algarve and Alvalade-Melides regions and it extends as far north as Santarém in the Lower Tagus Basin. Mainly controlled by global eustasy, it was generated by the important positive eustatic trend that characterized the Middle Miocene worldwide to which the Portuguese continental margin acted more or less passively. This cycle ended with a second and the most important compression event starting after the end of the Serravallian affecting the entire Portuguese onshore and shelf areas. This led to an important depositional hiatus of marine sediments for more than 2.5 Ma. During the Early and the Middle Tortonian occurred the clockwise rotation of the Guadalquivir Basin. The thickmarine units deposited afterwards in this basin produced a litostatic load, which seems to have induced subsidence farther west resuming the Neogene marine sedimentation in the Cacela region (Eastern Algarve), during the Late Tortonian. This marks the beginning of the III Neogene Cycle. To the north, in the Sado Basin (Alvalade-Melides region), a similar depositional sequence starts its sedimentation during the Messinian. Further north, in the Pombal-Caldas da Rainha region, marine sedimentation started during the Late Pliocene (Piacenzian). The migration in time, from south to north for the beginning of the marine sedimentation of this cycle is interpreted as reflecting a visco-elastic propagation of the deformation from the Betic chain northwards.

Preliminary study on the production of functionally graded materials by friction stir processing

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do grau de Mestre em Engenharia Mecânica

Integration of forest fire management with SDI: user requirements.

Dissertation submitted in partial fulfilment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Robustness of corroded reinforced concrete structures. A structural performance approach

Structure and Infrastructure Engineering, 1-17

Reforço à flexão de vigas de betão armado com compósitos de CFRP

Dissertação para obtenção do Grau de Mestre em Engenharia Civil – Estruturas e Geotecnia pela Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa