Molecular modelling of ABC transporters: from ATP hydrolysis to substrate transport

Dissertação para a obtenção de grau de doutor em Bioquímica pelo Instituto de Tecnologia Química e Biológica da Universidade Nova de Lisboa

Modelling HIV/AIDS length of stay in Portugal

Tese apresentada como requisito parcial para obtenção do grau de Doutor em Estatística e Gestão de Informação pelo Instituto Superior de Estatística e Gestão de Informação da Universidade Nova de Lisboa

Design and development of a microfluidic platform for use with colorimetric gold nanoprobe assays

Due to the importance and wide applications of the DNA analysis, there is a need to make genetic analysis more available and more affordable. As such, the aim of this PhD thesis is to optimize a colorimetric DNA biosensor based on gold nanoprobes developed in CEMOP by reducing its price and the needed volume of solution without compromising the device sensitivity and reliability, towards the point of care use. Firstly, the price of the biosensor was decreased by replacing the silicon photodetector by a low cost, solution processed TiO2 photodetector. To further reduce the photodetector price, a novel fabrication method was developed: a cost-effective inkjet printing technology that enabled to increase TiO2 surface area. Secondly, the DNA biosensor was optimized by means of microfluidics that offer advantages of miniaturization, much lower sample/reagents consumption, enhanced system performance and functionality by integrating different components. In the developed microfluidic platform, the optical path length was extended by detecting along the channel and the light was transmitted by optical fibres enabling to guide the light very close to the analysed solution. Microfluidic chip of high aspect ratio (~13), smooth and nearly vertical sidewalls was fabricated in PDMS using a SU-8 mould for patterning. The platform coupled to the gold nanoprobe assay enabled detection of Mycobacterium tuberculosis using 3 8l on DNA solution, i.e. 20 times less than in the previous state-of-the-art. Subsequently, the bio-microfluidic platform was optimized in terms of cost, electrical signal processing and sensitivity to colour variation, yielding 160% improvement of colorimetric AuNPs analysis. Planar microlenses were incorporated to converge light into the sample and then to the output fibre core increasing 6 times the signal-to-losses ratio. The optimized platform enabled detection of single nucleotide polymorphism related with obesity risk (FTO) using target DNA concentration below the limit of detection of the conventionally used microplate reader (i.e. 15 ng/μl) with 10 times lower solution volume (3 μl). The combination of the unique optical properties of gold nanoprobes with microfluidic platform resulted in sensitive and accurate sensor for single nucleotide polymorphism detection operating using small volumes of solutions and without the need for substrate functionalization or sophisticated instrumentation. Simultaneously, to enable on chip reagents mixing, a PDMS micromixer was developed and optimized for the highest efficiency, low pressure drop and short mixing length. The optimized device shows 80% of mixing efficiency at Re = 0.1 in 2.5 mm long mixer with the pressure drop of 6 Pa, satisfying requirements for the application in the microfluidic platform for DNA analysis.

Production of polyhydroxyalkanoates from oil-containing substrates

Different oil-containing substrates, namely, used cooking oil (UCO), fatty acids-byproduct from biodiesel production (FAB) and olive oil deodorizer distillate (OODD) were tested as inexpensive carbon sources for the production of polyhydroxyalkanoates (PHA) using twelve bacterial strains, in batch experiments. The OODD and FAB were exploited for the first time as alternative substrates for PHA production. Among the tested bacterial strains, Cupriavidus necator and Pseudomonas resinovorans exhibited the most promising results, producing poly-3-hydroxybutyrate, P(3HB), form UCO and OODD and mcl-PHA mainly composed of 3-hydroxyoctanoate (3HO) and 3-hydroxydecanoate (3HD) monomers from OODD, respectively. Afterwards, these bacterial strains were cultivated in bioreactor. C. necator were cultivated in bioreactor using UCO as carbon source. Different feeding strategies were tested for the bioreactor cultivation of C. necator, namely, batch, exponential feeding and DO-stat mode. The highest overall PHA productivity (12.6±0.78 g L-1 day-1) was obtained using DO-stat mode. Apparently, the different feeding regimes had no impact on polymer thermal properties. However, differences in polymer‟s molecular mass distribution were observed. C. necator was also tested in batch and fed-batch modes using a different type of oil-containing substrate, extracted from spent coffee grounds (SCG) by super critical carbon dioxide (sc-CO2). Under fed-batch mode (DO-stat), the overall PHA productivity were 4.7 g L-1 day-1 with a storage yield of 0.77 g g-1. Results showed that SCG can be a bioresource for production of PHA with interesting properties. Furthermore, P. resinovorans was cultivated using OODD as substrate in bioreactor under fed-batch mode (pulse feeding regime). The polymer was highly amorphous, as shown by its low crystallinity of 6±0.2%, with low melting and glass transition temperatures of 36±1.2 and -16±0.8 ºC, respectively. Due to its sticky behavior at room temperature, adhesiveness and mechanical properties were also studied. Its shear bond strength for wood (67±9.4 kPa) and glass (65±7.3 kPa) suggests it may be used for the development of biobased glues. Bioreactor operation and monitoring with oil-containing substrates is very challenging, since this substrate is water immiscible. Thus, near-infrared spectroscopy (NIR) was implemented for online monitoring of the C. necator cultivation with UCO, using a transflectance probe. Partial least squares (PLS) regression was applied to relate NIR spectra with biomass, UCO and PHA concentrations in the broth. The NIR predictions were compared with values obtained by offline reference methods. Prediction errors to these parameters were 1.18 g L-1, 2.37 g L-1 and 1.58 g L-1 for biomass, UCO and PHA, respectively, which indicates the suitability of the NIR spectroscopy method for online monitoring and as a method to assist bioreactor control. UCO and OODD are low cost substrates with potential to be used in PHA batch and fed-batch production. The use of NIR in this bioprocess also opened an opportunity for optimization and control of PHA production process.

Coupling organic substrate removal to methane production in a fully biological microbial electrolysis cell

Microbial electrolysis cells (MECs) are an innovative and emerging technique based on the use of solid-state electrodes to stimulate microbial metabolism for wastewater treatment and simultaneous production of value-added compounds (such as methane). This research studied the performance of a two-chamber MEC in terms of organic matter oxidation (at the anode) and methane production (at the cathode). MEC‟s anode had been previously inoculated with an activated sludge, whereas the cathode chamber inoculum was an anaerobic sludge (containing methanogenic microorganisms). During the experimentation, the bioanode was continuously fed with synthetic solutions in anaerobic basal medium, at an organic load rate (OLR) of around 1 g L-1 d-1, referred to the chemical oxygen demand (COD). At the beginning (Run I), the feeding solution contained acetate and subsequently (Run II) it was replaced with a more complex solution containing soluble organic compounds other than acetate. For both conditions, the anode potential was controlled at -0.1 V vs. standard hydrogen electrode, by means of a potentiostat. During Run I, over 80% of the influent acetate was anaerobically oxidized at the anode, and the resulting electric current was recovered as methane at the cathode (with a cathode capture efficiency, CCE, accounting around 115 %). The average energy efficiency of the system (i.e., the energy captured into methane relative to the electrical energy input) under these conditions was over 170%. However, reactor‟s performance decreased over time during this run. Throughout Run II, a substrate oxidation over 60% (on COD basis) was observed. The electric current produced (57% of coulombic efficiency) was also recovered as methane, with a CCE of 90%. For this run the MEC‟s average energy efficiency accounted for almost 170 %. During all the experimentation, a very low biomass growth was observed at the anode whereas ammonium was transferred through the cationic membrane and concentrated at the cathode. Tracer experiments and scanning electron microscopy analyses were also carried out to gain a deeper insight into the reactor performance and also to investigate the possible reasons for partial loss of performance. In conclusion, this research suggests the great potential of MEC to successfully treat low-strength wastewaters, with high energy efficiency and very low sludge production.

The role of arl13b in cilia length regulation and in zebrafish development

RESUMO: Arl13b é uma importante proteína ciliar, presente em cílios primários e cílios móveis. Ratinhos mutantes para Arl13b têm comprimento dos cílios reduzido e defeitos nos B-túbulos dos cílios. Como consequência destes fenótipos, deficiências na Arl13b originam, em modelos animais, várias doenças congénitas, incluindo problemas no estabelecimento do eixo esquerda-direita, malformações cerebrais e deformações corporais. Nos seres humanos, deficiências na Arl13b levam a uma doença crónica congénita chamada Síndrome de Joubert. Por outro lado, a sobreexpressão de Arl13b origina cílios mais longos, no entanto existe uma ausência da caracterização dos fenótipos celulares e durante o desenvolvimento embrionário. Neste trabalho, quisemos explorar o efeito da sobre-expressão de Arl13b em embriões de peixezebra. Descobrimos que, ao nível ciliar, a sobre-expressão de Arl13b nas células aumenta o comprimento ciliar em cílios primários e móveis, no entanto, a esses cílios falta adequada acetilação da alfa-tubulina no citoesqueleto feito por microtúbulos. Os nossos resultados mostraram que esse efeito é específico de Arl13b sobre-expressão e quando se manipularam as enzimas responsáveis pela acetilação (Mec17) e pela de-acetilação (HDAC6) encontrámos uma sinergia potencial com ambas. Testámos ainda, que o aumento no comprimento ciliar não estava causalmente relacionado com a falta de acetilação, ou seja, os cílios com menos acetilação não eram necessariamente os mais longos. Também mostrámos que a sobre-expressão de Arl13b é capaz de restaurar o comprimento dos cílios em mutantes com cílios curtos e como isso pode ser explorado para um futuro potencial papel terapêutico para Arl13b. Em seguida, foi avaliado o impacto do aumento da quantidade de Arl13b no desenvolvimento embrionário do peixe-zebra. Observou-se que a sobre-expressão de Arl13b apresentava fenótipos muito fracos, quando comparados com a perda de função dos mutantes de Arl13b. Focados no inesperado fenótipo leve no estabelecimento do eixo esquerda-direita abordámos a questão através do estabelecimento de uma colaboração com matemáticos, descobrimos que os cílios mais longos que potencialmente têm a capacidade de movimentar mais fluido são atenuados por amplitudes de batimento menores, e, como resultado, estes longos cílios não prejudicam o movimento do fluido e consequentemente não afetam o estabelecimento dos padrões de esquerda-direita. Sugerimos assim que a Arl13b é um regulador chave, do comprimento ciliar. Descobrimos uma nova interação com as enzimas de acetilação/de-acetilação e levantamos novas hipóteses quanto aos mecanismos moleculares da função da Arl13b. Propomos um novo modelo para o mecanismo molecular da Arl13b na regulação do comprimento dos cílios onde podemos integrar os nossos resultados com os relatados na literatura. Este trabalho adiciona mais conhecimento para o mecanismo de ação da Arl13b e, portanto, fornece uma importante contribuição para o campo da investigação em cílios.---------------------------------------------------------------------------------------------------------------------- ABSTRACT: Arl13b is an important ciliary protein, present in primary and motile cilia. arl13b-/- mouse mutants have reduced cilia length and cilia B-tubule defects. As a consequence of these phenotypes, Arl13b loss of function animal models suffer from several congenital disorders including left-right problems, brain malformations and body deformations. In humans Arl13b depletion leads to a congenital chronic disease called Joubert Syndrome. On the other hand, overexpressing Arl13b leads to longer cilia but the characterization of the cellular and developmental phenotypes was missing. In this work we explore the effect of Arl13b overexpression in zebrafish embryos. We found that, at the ciliary level, Arl13b overexpression from 1 cell stage produces longer primary and motile cilia, but these cilia lack proper alpha tubulin acetylation of their microtubule cytoskeleton. Our results showed that this effect is specific from Arl13b overexpression and when we manipulated the enzymes responsible for acetylation, Mec17, and de-acetylation, HDAC6, we found a potential synergy of both mec17 knockdown and HDAC6 activity with Arl13b overexpression. We tested that the ciliary increase in length was not causally related to the lack of acetylation, meaning the more de-acetylated cilia were not necessarily the longer ones. We also showed that Arl13b overexpression is able to restore cilia length in short cilia mutants and how that may be explored to a potential future therapeutic role for Arl13b. Next, we evaluated the impact of increasing the amount of Arl13b in zebrafish embryonic development. We observed that Arl13b overexpression presented very mild phenotypes when compared to the loss of function mutants. We focused on the unexpected left-right mild phenotype and by establishing a mathematical modeling collaboration, we found out that the longer cilia generated force was attenuated by smaller beating amplitudes, and as a result, these long cilia were not impairing the cilia generated flow and the establishment of left-right patterning. We suggest that Arl13b is one key cilia length regulator. We disclosed a novel interaction with the acetylation / de-acetylation enzymes and raised new hypothesis as to the mechanisms of Arl13b function. We propose a new model for the Arl13b molecular mechanism of cilia length regulation where we integrate our findings with those reported in the literature. This work adds more knowledge to the Arl13b mechanism of action and therefore provides an important contribution to the cilia research field.