Impact of carbon/nitrogen feeding strategy on polyhydroxyalkanoates production using mixed microbial cultures

Polyhydroxyalkanoates (PHA) production using mixed microbial cultures (MMC) requires a multi-stage process involving the microbial selection of PHA-storing microorganisms, typically operated in sequencing batch reactors (SBR), and an accumulation reactor. Since low-cost renewable feedstocks used as process feedstock are often nitrogen-deficient, nutrient supply in the selection stage is required to allow for microbial growth. In this context, the possibility to uncouple nitrogen supply from carbon feeding within the SBR cycle has been investigated in this study. Moreover, three different COD:N ratios (100:3.79, 100:3.03 and 100:2.43) were tested in three different runs which also allowed the study of COD:N ratio on the SBR performance. For each run, a synthetic mixture of acetic and propionic acids at an overall organic load rate of 8.5 gCOD L-1 d-1 was used as carbon feedstock, whereas ammonium sulfate was the nitrogen source in a lab-scale sequence batch reactor (SBR) with 1 L of working volume. Besides, a sludge retention time (SRT) of 1 d was used as well as a 6 h cycle length. The uncoupled feeding strategy significantly enhanced the selective pressure towards PHA-storing microorganisms, resulting in a two-fold increase in the PHA production (up to about 1.3 gCOD L-1). A high storage response was observed for the two runs with the COD:N ratios (gCOD:gN) of 100:3.79 and 100:3.03, whereas the lowest investigated nitrogen load resulted in very poor performance in terms of polymer production. In fact, strong nitrogen limitation caused fungi to grow and a very poor storage ability by microorganisms that thrived in those conditions. The COD:N ratio also affected the polymer composition, indeed the produced poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) showed a variable HV content (1-20 %, w/w) among the three runs, lessening as the COD:N increased. This clearly suggests the possibility to use the COD:N ratio as a tool for tuning polymer properties regardless the composition of the feedstock.

Improving the early diagnostic of prostate cancer by multiple biomarker detection with new biosensing devices

Prostate cancer (PCa) is the most common form of cancer in men, in Europe (World Health Organization data). The most recent statistics, in Portuguese territory, confirm this scenario, which states that about 50% of Portuguese men may suffer from prostate cancer and 15% of these will die from this condition. Its early detection is therefore fundamental. This is currently being done by Prostate Specific Antigen (PSA) screening in urine but false positive and negative results are quite often obtained and many patients are sent to unnecessary biopsy procedures. This early detection protocol may be improved, by the development of point-of-care cancer detection devices, not only to PSA but also to other biomarkers recently identified. Thus, the present work aims to screen several biomarkers in cultured human prostate cell lines, serum and urine samples, developing low cost sensors based on new synthetic biomaterials. Biomarkers considered in this study are the following: prostate specific antigen (PSA), annexin A3 (ANXA3), microseminoprotein-beta (MSMB) and sarcosine (SAR). The biomarker recognition may occurs by means of molecularly imprinted polymers (MIP), which are a kind of plastic antibodies, and enzymatic approaches. The growth of a rigid polymer, chemically stable, using the biomarker as a template allows the synthesis of the plastic antibody. MIPs show high sensitivity/selectivity and present much longer stability and much lower price than natural antibodies. This nanostructured material was prepared on a carbon solid. The interaction between the biomarker and the sensing-material produces electrical signals generating quantitative or semi-quantitative data. These devices allow inexpensive and portable detection in point-of-care testing.

The early metallurgy in Southwestern Iberia: metals from the Chalcolithic Settlement of São Pedro (Redondo)

Archaeological excavations carried out in the archaeological site of São Pedro (Southern Portugal) revealed a Chalcolithic settlement occupied in different moments of the 3rd millennium BC. The material culture recovered includes different types of materials, such as ceramics, lithics and metals. The later comprises about 30 artefacts with different typologies such as tools (e.g. awls, chisels and a saw) and weapons (e.g. daggers and arrowheads) mostly belonging to the 2nd and 3rd quarter of the 3rd millennium BC. In the present work the collection of chalcolithic metallic artefacts recovered in São Pedro was characterized. Analytical studies involved micro energy dispersive X-ray fluorescence spectrometry (micro-EDXRF) to determine elemental composition, together with optical microscopy and Vickers microhardness testing for microstructural characterisation and hardness determination. Main results show copper with variable amounts of arsenic and very low content of other impurities, such as iron. Moreover, nearly half of the collection is composed by arsenical copper alloys (As > 2 wt.%) and an association was found between arsenic content and typology since the weapons group (mostly daggers) present higher values than tools (mostly awls). These results suggest some criteria in the selection of arsenic-rich copper ores or smelting products. Furthermore, after casting an artefact would have been hammered, annealed and sometimes, finished with a hammering operation. Additionally, microstructural variations in this collection reveal somewhat different operational conditions during casting, annealing and forging, as expected in such a primitive metallurgy. Moreover the operational sequence seems to be used to achieve the required shape to the object, rather than to intentionally make the alloy harder. Overall, this study suggests that Chalcolithic metallurgists might have a poor control of the addition of arsenic and/or were unable to use this element to increase the hardness of tools and weapons. Finally, the compositions, manufacturing processes and hardness were compared to those from neighbouring regions and different chronological periods.

Polyhydroxyalkanoates production by photosynthetic mixed cultures

Polyhydroxyalkanoates (PHAs) are natural biologically synthesized polymers that have been the subject of much interest in the last decades due to their biodegradability. Thus far, its microbial production is associated with high operational costs, which increases PHA prices and limits its marketability. To address this situation, this thesis’ work proposes the utilization of photosynthetic mixed cultures (PMC) as a new PHA production system that may lead to a reduction in operational costs. In fact, the operational strategies developed in this work led to the selection of PHA accumulating PMCs that, unlike the traditional mixed microbial cultures, do not require aeration, thus permitting savings in this significant operational cost. In particular, the first PHA accumulating PMC tested in this work was selected under non-aerated illuminated conditions in a feast and famine regime, being obtained a consortium of bacteria and algae, where photosynthetic bacteria accumulated PHA during the feast phase and consumed it for growth during the famine phase, using the oxygen produced by algae. In this symbiotic system, a maximum PHA content of 20% cell dry weight (cdw) was reached, proving for the first time, the capacity of a PMC to accumulate PHA. During adaptation to dark/light alternating conditions, the culture decreased its algae content but maintained its viability, achieving a PHA content of 30% cdw. Also, the PMC was found to be able to utilize different volatile fatty acids for PHA production, accumulating up to 20% cdw of a PHA co-polymer composed of 3-hydroxybutyrate (3HB) and 3-hydroxyvalerate (HV) monomers. Finally, a new selective approach for the enrichment of PMCs in PHA accumulating bacteria was tested. Instead of imposing a feast and famine regime, a permanent feast regime was used, thus selecting a PMC that was capable of simultaneously growing and accumulating PHA, being attained a maximum PHA content of 60% cdw, the highest value reported for a PMC thus far. The results presented in this thesis prospect the utilization of cheap, VFA-rich fermented wastes as substrates for PHA production, which combined with this new photosynthetic technology opens up the possibility for direct sunlight illumination, leading to a more cost-effective and environmentally sustainable PHA production process.

Reinvigorating and redesigning early intervention in psychosis services for young people in Auckland

RESUMO: Auckland tem sido pioneira na implementação de modelos de Intervenção Precoce em Psicose. No entanto, esta organização do serviço não mudou nos últimos 19 anos. Segundo os dados obtidos da utilização do serviço, no período de 1996 -2012 foram atendidos 997 doentes, que tinham um número médio de 89 contactos (IQR: 36-184), com uma duração média de 62 horas de contactos (IQR: 24-136). Estes doentes passaram um número médio de 338 dias (IQR: 93-757) em contacto com o programa. 517 doentes (52%) não necessitaram de internamento no hospital, e os que foram internados, ficaram uma mediana de 124 dias no hospital (IQR: 40-380). Os doentes asiáticos tiveram um aumento de 50% de probabilidade de serem internados no hospital. Este relatório inclui 15 recomendações para orientar as reformas para o serviço e, nomeadamente, delinear a importância de uma visão organizacional e dos seus componentes-chave. As recomendações incluem o reforço da gestão e da liderança numa estrutura de equipe mais integrada, com recursos dedicados a melhorar a consciencialização da comunidade, a educação e deteção precoce, bem como a capacidade de receber referenciações diretas. Os Indicadores Chave de Desempenho devem ser estabelecidos, mas os Exames de Estado Mental em risco, devem ser removidos. Auckland deve manter a faixa etária alvo atual. A duração do serviço deve ser aumentada para um mínimo de três anos, com a opção de aumentá-la para cinco anos. A proporção de gestor de cuidados para os doentes deve ser preconizada em 1:15, enquanto o pessoal de apoio não-clínico deve ser aumentado. Os psiquiatras devem ter uma carga de trabalho de cerca de 80 doentes por equivalente de tempo completo. Um serviço local de prestação de cuidados deve ser desenvolvido com, nomeadamente, intervenções culturais para responder às necessidades da população multicultural de Auckland. A capacidade de investigação deve ser incorporada no Serviço de Intervenção Precoce em Psicoses. Qualquer alteração deverá envolver contacto com todas as partes interessadas, e a Administração Regional de Saúde deve comprometer-se em tempo, recursos humanos e políticos para apoiar e facilitar a mudança do sistema, investindo de forma significativa para melhor servir a comunidade Auckland.----------------------------------- ABSTRACT: Auckland has been pioneering in the adoption of Early Intervention in Psychosis models but the design of the service has not changed in 19 years. In service utilisation data from 997 patients seen from 1996 -2012, patients had a median number of 89 contacts (IQR: 36-184), with a median duration of 62 hours of contact (IQR: 24-136). Patients spent a median number of 338 days (IQR: 93-757) in contact with the program. 517 patients (52%) did not require admission to hospital, and those who did spent a median of 124 days in hospital (IQR: 40-380). Asian patients had a 50% increased chance of being admitted to hospital. This report includes 15 recommendations to guide reforms to the service, including outlining the importance of vision and key components. It recommends strengthened managerial leadership and a more integrated team structure with dedicated resources for improved community awareness, education and early detection as well as the capacity to take direct referrals. Key Performance Indicators (KPIs) should be established but At Risk Mental States should be excluded. Auckland should maintain the current target age range. The duration of service should be increased to a minimum of three years, with the option to extend this to five years. The ratio of care co-ordinator to patients should be capped at 1:15 whilst non-clinical supporting staff should be increased. Psychiatrists should have a caseload of about 80 per FTE. A local Service Delivery framework should be developed, as should cultural interventions to meet the needs of the multicultural population of Auckland. Research capacity should be incorporated into the fabric of Early Intervention in Psychosis Services. Any changes should involve consultation with all stakeholders, and the DHB should commit to investing time, human and political resources to support and facilitate meaningful system change to best serve the Auckland community.