Acidogenic digestion of effluents of the cheese industry in packed bed biofilm reactors

Dissertation for the Master degree in Biotechnology

Natural hydraulic lime mortars: influence of the aggregates

3rd Historic Mortars Conference, 11-14 September 2013, Glasgow, Scotland

Evaluation of air lime and clayish earth mortars for earthen wall renders

CIAV2013 – International Conference on Vernacular Architecture, 7º ATP, VerSus, 16-20 october 2013

The effect of hydraulic components on lime mortars

XXX IAHS World Congress on Housing - Housing Construction: An Interdisciplinary Task, September 9-13, 2002, Coimbra, Portugal

Adjusting to external imbalances within the EMU, the case of Portugal

From 1995 to 2010 Portugal has accumulated a negative international asset position of 110 percent of GDP. In a developed and aging economy the number is astonishing and any argument to consider it sustainable must rely on extremely favorable forecasts on growth. Portuguese policy options are reduced in number: no autonomous monetary policy, no currency to devaluate, and limited discretion in changing fiscal deficits and government debt. To start the necessary deleveraging a remaining possible policy is a budget-neutral change of the tax structure that increases private saving and net exports. An increase in the VAT and a decrease in the employer’s social security contribution tax can achieve the desired outcome in the short run if they are complemented with wage moderation. To obtain a substantial improvement in competitiveness and a large decrease in consumption, the changes in the tax rates have to be large. While a precise quantitative assessment is difficult, the initial increase in the effective VAT rate needed to allow the social security tax to decrease by 16 percentage points (pp) is approximately 10 pp. Such a large increase in the effective VAT rate could be obtained by raising most of the reduced VAT rates to the new general VAT rate of 23 percent. The empirical analysis shows that over time the suggested tax swap could generate surpluses and improve the trade balance. A temporary version of the suggested tax-swap has the attractiveness to achieve a sharper increase in the private saving rate maintaining the short run gains in competitiveness. Finally, the temporary version of the fiscal devaluation could be the basis for an automatic stabilizer to external imbalances within a monetary union.Portugal has been running large current account deficits every year since 1995. These deficits have accumulated to an astonishing 110 percent of GDP negative external asset position. The sustainability of such a large external position is questionable and must rely on fantastic productivity growth expectations. The recent global financial crisis appears to have anticipated the international investors reality check on those future expectations with the result of a large increase in the cost of external financing. Today the rebalancing of the current account through an increase in national savings and an improvement in competitiveness must be at the top of the Portuguese authorities “to do” list as the cost of a pull out from international investors is of the order of 10% of GDP. The external rebalancing is difficult as the degrees of freedom of the Portuguese authorities are limited in number: they have no autonomous monetary policy, no currency to devaluate, and little discretion in fiscal policy as deficit limits and debt targets are set by the Stability Growth Pact and the postcrisis consensus on medium-term fiscal consolidation. One possibility that remains is to change the fiscal policy mix for a given budget deficit. The purpose of this paper is to explore the effects of a “fiscal devaluation”1 obtained through a tax swap between employers’ social security contributions and taxes on consumption2. The paper begins by illustrating Portugal’s current account evolution during the euro period. The second section section lays out a model to offer a qualitative assessment of the dynamic outcomes of the the tax swap. I show that the suggested tax swap can in theory achieve the desired outcomes in terms of competitiveness and consumption if complemented with moderation (stickiness) in wages. I also study the effects of a temporary version of the tax swap and show that it achieves a sharper improvement in the current account that accelerate the rebalancing. The third section moves to the empirical analysis and estimates the likely effects of the tax swap for the Portuguese economy. The fourth section concludes.

Potential for ORC application in the Portuguese manufacturing industry

Dissertação para obtenção do Grau de Mestre em Engenharia do Ambiente, perfil Gestão e Sistemas Ambientais

Air lime-earth blended mortars - Assessment on fresh state and workability

International Conference on Vernacular Heritage, Sustainability and Earthen Architecture, VerSus 2014, 2nd MEDITERRA, 2nd ResTAPIA, 11-13 September, Valencia, Spain

Role of surfactants in filtration and fouling of colloidal silica

The EM3E Master is an Education Programme supported by the European Commission, the European Membrane Society (EMS), the European Membrane House (EMH), and a large international network of industrial companies, research centres and universities

Incorporação de resíduos de cerâmica em argamassas de cal aérea

Sabe-se que aproximadamente 30% do material produzido pela indústria cerâmica é considerado desperdício e, frequentemente, depositado em aterro, com o impacto ambiental negativo que acarreta. Esta tem sido uma das grandes motivações para a crescente investigação que tem sido levada a cabo a fim de obter soluções viáveis para a sua reintrodução no processo produtivo. A viabilidade do uso de resíduos de material cerâmico tem vindo a ser avaliada, principalmente, na incorporação em betões ou em argamassas com base em cimento. Na antiguidade e na ausência de pozolanas naturais, eram frequentemente utilizados resíduos cerâmicos moídos, atuando como pozolanas artificiais e conferindo algumas características hidráulicas e de durabilidade às argamassas de cal aérea. Temse efetivamente constatado que alguns pós resultantes de desperdícios de cerâmica de barro vermelho, nomeadamente os que foram sujeitos a tratamento térmico a temperaturas inferiores a 900°C e moídos em granulometria fina, podem funcionar como pozolanas artificiais em argamassas. A introdução de resíduos de cerâmica em granulometria mais grossa nas argamassas, como agregado, pode também revelarse vantajoso, na medida em que permite substituir parcialmente a areia normalmente utilizada. Assim sendo, o recurso aos resíduos de cerâmica pode ser muito vantajoso em três vertentes principais: a redução de resíduos a depositar em aterro, a redução da extração de rochas para serem utilizadas na produção de ligantes e de areias e a produção de argamassas com comportamentos melhorados. Com o objetivo de analisar a viabilidade da introdução de resíduos de cerâmica em argamassas, que se pretendem sejam, essencialmente, adequadas como argamassas de substituição, tem vindo a ser desenvolvida investigação na Universidade de Coimbra em colaboração com a Universidade Nova de Lisboa. O trabalho que se apresenta neste artigo é uma pequena parte dessa investigação. Toda esta investigação tem tido o apoio de um projeto de investigação financiado pela FCT.

Evaporation from porous building materials and its cooling potential

Evaporative cooling is a traditional strategy to improve summer comfort, which has gained renewed relevance in the context of the transition to a greener economy. Here, the potential for evaporative cooling of two common porous building materials, natural stone and ceramic brick, was evaluated. The work has relevance also to the protection of built heritage becauseevaporation underlies the problems of dampness and salt crystallization, which are so harmful and frequent in this heritage. It was observed that the drying rate of the materials is, in some cases, higher than the evaporation rate of a free water surface. Surface area measurements by a three-dimensional optical technique suggested, as probable cause of this behavior, that surface irregularity gives rise to a large effective surface of evaporation in the material. Surface temperature measurements by infrared were performed afterward during evaporation experiments outside during a hot summer day in Lisbon. Their results indicate that ordinary building materials can be very efficient evaporative media and, thus, may help in achieving higher energy efficiency while maintaining a simultaneous constructive or architectural function.

40 K Neon liquid energy storage unit

Cryocoolers have been progressively replacing the use of the stored cryogens in cryogenic chains used for detector cooling, thanks to their higher and higher reliability. However, the mechanical vibrations, the electromagnetic interferences and the temperature fluctuations inherent to their functioning could reduce the sensor’s sensitivity. In order to minimize this problem, compact thermal energy storage units (ESU) are studied, devices able to store thermal energy without significant temperature increase. These devices can be used as a temporary cold source making it possible to turn the cryocooler OFF providing a proper environment for the sensor. A heat switch is responsible for the thermal decoupling of the ESU from the cryocooler’s temperature that increases when turned OFF. In this work, several prototypes working around 40 K were designed, built and characterized. They consist in a low temperature cell that contains the liquid neon connected to an expansion volume at room temperature for gas storage during the liquid evaporation phase. To turn this system insensitive to the gravity direction, the liquid is retained in the low temperature cell by capillary effect in a porous material. Thanks to pressure regulation of the liquid neon bath, 900 J were stored at 40K. The higher latent heat of the liquid and the inexistence of triple point transitions at 40 K turn the pressure control during the evaporation a versatile and compact alternative to an ESU working at the triple point transitions. A quite compact second prototype ESU directly connected to the cryocooler cold finger was tested as a temperature stabilizer. This device was able to stabilize the cryocooler temperature ((≈ 40K ±1 K) despite sudden heat bursts corresponding to twice the cooling power of the cryocooler. This thesis describes the construction of these devices as well as the tests performed. It is also shown that the thermal model developed to predict the thermal behaviour of these devices, implemented as a software,describes quite well the experimental results. Solutions to improve these devices are also proposed.

40 K neon liquid energy storage unit

Cryocoolers have been progressively replacing the use of the stored cryogens in cryogenic chains used for detector cooling, thanks to their higher and higher reliability. However, the mechanical vibrations, the electromagnetic interferences and the temperature fluctuations inherent to their functioning could reduce the sensor’s sensitivity. In order to minimize this problem, compact thermal energy storage units (ESU) are studied, devices able to store thermal energy without significant temperature increase. These devices can be used as a temporary cold source making it possible to turn the cryocooler OFF providing a proper environment for the sensor. A heat switch is responsible for the thermal decoupling of the ESU from the cryocooler’s temperature that increases when turned OFF. In this work, several prototypes working around 40 K were designed, built and characterized. They consist in a low temperature cell that contains the liquid neon connected to an expansion volume at room temperature for gas storage during the liquid evaporation phase. To turn this system insensitive to the gravity direction, the liquid is retained in the low temperature cell by capillary effect in a porous material. Thanks to pressure regulation of the liquid neon bath, 900 J were stored at 40K. The higher latent heat of the liquid and the inexistence of triple point transitions at 40 K turn the pressure control during the evaporation a versatile and compact alternative to an ESU working at the triple point transitions. A quite compact second prototype ESU directly connected to the cryocooler cold finger was tested as a temperature stabilizer. This device was able to stabilize the cryocooler temperature ((≈ 40K ±1 K) despite sudden heat bursts corresponding to twice the cooling power of the cryocooler. This thesis describes the construction of these devices as well as the tests performed. It is also shown that the thermal model developed to predict the thermal behaviour of these devices,implemented as a software, describes quite well the experimental results. Solutions to improve these devices are also proposed.

Numerical prediction of diffusion and electric field-induced iron nanoparticle transport

Zero valent iron nanoparticles (nZVI) are considered very promising for the remediation of contaminated soils and groundwaters. However, an important issue related to their limited mobility remains unsolved. Direct current can be used to enhance the nanoparticles transport, based on the same principles of electrokinetic remediation. In this work, a generalized physicochemical model was developed and solved numerically to describe the nZVI transport through porous media under electric field, and with different electrolytes (with different ionic strengths). The model consists of the Nernst–Planck coupled system of equations, which accounts for the mass balance of ionic species in a fluid medium, when both the diffusion and electromigration of the ions are considered. The diffusion and electrophoretic transport of the negatively charged nZVI particles were also considered in the system. The contribution of electroosmotic flow to the overall mass transport was included in the model for all cases. The nZVI effective mobility values in the porous medium are very low (10−7–10−4 cm2 V−1 s−1), due to the counterbalance between the positive electroosmotic flow and the electrophoretic transport of the negatively charged nanoparticles. The higher the nZVI concentration is in the matrix, the higher the aggregation; therefore, low concentration of nZVI suspensions must be used for successful field application.

Biological colonization on majolica glazed tiles: biodeterioration, bioreceptivity and mitigation strategies

The impact of microbial activity on the deterioration of cultural heritage is a well-recognized global problem. Glazed wall tiles constitute an important part of the worldwide cultural heritage. When exposed outdoors, biological colonization and consequently biodeterioration may occur. Few studies have dealt with this issue, as shown in the literature review on biodiversity, biodeterioration and bioreceptivity of architectural ceramic materials. Due to the lack of knowledge on the biodeteriogens affecting these assets, the characterization of microbial communities growing on Portuguese majolica glazed tiles, from Pena National Palace (Sintra, Portugal) and another from Casa da Pesca (Oeiras, Portugal) was carried out by culture and molecular biology techniques. Microbial communities were composed of microalgae, cyanobacteria, bacteria and fungi, including a new fungal species (Devriesia imbrexigena) described for the first time. Laboratory-based colonization experiments were performed to assess the biodeterioration patterns and bioreceptivity of glazed wall tiles produced in laboratory. Microorganisms previously identified on glazed tiles were inoculated on pristine and artificially aged tile models and incubated under laboratory conditions for 12 months. Phototrophic microorganisms were able to grow into glaze fissures and the tested fungus was able to form oxalates over the glaze. The bioreceptivity of artificially aged tiles was higher for phototrophic microorganisms than pristine tile models. A preliminary approach on mitigation strategies based on in situ application of commercial biocides and titanium dioxide (TiO2) nanoparticles on glazed tiles demonstrated that commercial biocides did not provide long term protection. In contrast, TiO2 treatment caused biofilm detachment. In addition, the use of TiO2 thin films on glazed wall tiles as a protective coating to prevent biological colonization was analysed under laboratorial conditions. Finally, conservation notes on tiles exposed to biological colonization were presented.

Arqueologia Urbana em Lisboa: o Convento do Carmo entre os séculos XIV e XIX

No estágio desenvolvido na intervenção arqueológica em curso na área envolvente ao Convento do Carmo, em Lisboa, foi possível recolher abundante espólio que ajuda a compreender a sua ocupação desde o período medieval aos nossos dias. O relatório que aqui se apresenta pretende abordar, numa fase prévia e de âmbito generalizado, a problemática das intervenções preventivas em contexto urbano, partindo para o caso específico do Convento do Carmo. As observações feitas na zona tardoz do convento durante os trabalhos de escavação lançaram as bases para a escolha de um conjunto cerâmico como objecto de estudo. A existência, na fachada Este, de algumas marcas de canteiro com vestígios de pigmento vermelho permitiu teorizar sobre a hipótese de parte da fachada ter sido aterrada não muito tempo após a sua construção. Foi com base nessa hipótese que se optou por estudar a cerâmica recolhida no depósito [1298]/[705], sedimento que assentava parcialmente no alicerce do monumento.