Effect of the compact Ti layer on the efficiency of dye-sensitized solar cells assembled using stainless steel sheets

Titanium films have been deposited on stainless steel metal sheets using dc magnetron sputtering technique at different substrate temperatures. The structure of the titanium films strongly depend on the substrate temperature. The titanium film deposited at the substrate temperature lower than 300 ◦C has a loose flat sheet grains structure and the titanium film prepared at the substrate temperature higher than 500 ◦C has a dense nubby grains structure. The DSSC assembled using stainless steel sheet coated with titanium film deposited at high substrate temperature has a low charge transfer resistance in the TiO2/Ti interface and results in a high conversion efficiency. The DSSC assembled using stainless steel sheet coated with titanium film deposited at temperature higher than 500 ◦C has higher conversion efficiency than that assembled using titanium metal sheet as the substrate. The maximum conversion efficiency, 2.26% is obtained for DSSC assembled using stainless steel sheet coated with titanium film deposited at 700 ◦C substrate temperature, which is about 70% of the conversion efficiency of the FTO reference cell used in this study.

On the capacity of cluster-tree ZigBee networks

Modeling the fundamental performance limits of Wireless Sensor Networks (WSNs) is of paramount importance to understand their behavior under worst-case conditions and to make the appropriate design choices. In that direction this paper contributes with an analytical methodology for modeling cluster-tree WSNs where the data sink can either be static or mobile. We assess the validity and pessimism of analytical model by comparing the worst-case results with the values measured through an experimental test-bed based on Commercial-Off- The-Shelf (COTS) technologies, namely TelosB motes running TinyOS.

The impact of the implementation of the Basel III recommendations on the capital of portuguese banks

This paper analyses the impact of the implementation of the Basel III recommendations, using the standard method, in Portugal. For our study, we used the annual reports of 31st of December of 2012, and found out that out of the fourteen banks that published annual reports, only six satisfied the minimum ratios laid out by BCBS. Till 2012, Portuguese banks used an internal ratings method based on the Basel II recommendations known as notice 6/2010 of the Portuguese central bank, Banco de Portugal. As the implementation of the recommendations of Basel III in the EU via the Credit Review Directive IV is scheduled for 2014 and later years, Portuguese banks may severely contract credit upon implementation, as that is the easiest, fastest and cheapest way for banks to satisfy the minimum ratio requirements as compared to an increase of capital or credit spreads.