Transitional justice in the judiciary: lessons from the portuguese democratisation

The nature of the Portuguese transition to democracy and the following state crises (1974-1975) created a ‘window of opportunity’ in which the ‘reaction to the past’ was much stronger than in the other Southern or even of Central and Eastern European transitions. In Portugal, initiatives of symbolic rupture with the past began soon after the April 25, 1974, coup d’état and transitional justice policies assumed mainly three formulas. First, the institutional reforms directed primarily to abusive state institutions such as the political police (PIDE-DGS) and political courts (Plenary courts) in order to dismantle the repressive apparatus and prevent further human rights abuses and impunity. Secondly, the criminal prosecutions addressed to perpetrators considered as being the most responsible for repression and abuses. Finally, lustration or political purges (saneamentos, the term used in Portugal to designate political purges) which were, in fact, the most common form of political justice in Portuguese transition to democracy. This paper deals with the peculiarities of transitional justice in Portugal devoting a particular attention to the judicial, a key sector to understand the way the Portuguese dealt with their authoritarian past.

New Steel Alloys for the Design of Heat Recovery Steam Generator Components of Combined Cycle Gas Plants

Demand for power is growing every day, mainly due to emerging economies in countries such as China, Russia, India, and Brazil. During the last 50 years steam pressure and temperature in power plants have been continuously raised to improve thermal efficiency. Recent efforts to improve efficiency leads to the development of a new generation of heat recovery steam generator, where the Benson once-through technology is applied to improve the thermal efficiency. The main purpose of this paper is to analyze the mechanical behavior of a high pressure superheater manifold by applying finite element modeling and a finite element analysis with the objective of analyzing stress propagation, leading to the study of damage mechanism, e.g., uniaxial fatigue, uniaxial creep for life prediction. The objective of this paper is also to analyze the mechanical properties of the new high temperature resistant materials in the market such as 2Cr Bainitic steels (T/P23 and T/P24) and also the 9-12Cr Martensitic steels (T/P91, T/P92, E911, and P/T122). For this study the design rules for construction of power boilers to define the geometry of the HPSH manifold were applied.

Solid-State Bipolar Marx Converter with Output Transformer and Energy Recovery

The purpose of this paper is to present and discuss a general HV topology of the solid-state Marx modulator, for unipolar or bipolar generation connected with a step-up transformer to increase the output voltage applied to a resistive load. Due to the use of an output transformer, discussion about the reset of the transformer is made to guarantee zero average voltage applied to the primary. It is also discussed the transformer magnetizing energy recovering back to the energy storage capacitors. Simulation results for a circuit that generates 100 kV pulses using 1000 V semiconductors are presented and discussed regarding the voltage and current stress on the semiconductors and result obtained.

Modular high-current generator for electromagnetic forming with energy recovery

A 10 kJ electromagnetic forming (EMF) modulator with energy recovery based on two resonant power modules, each containing a 4.5 kV/30-kA silicon controlled rectifier, a 1.11-mF capacitor bank and an energy recovery circuit, working in parallel to allow a maximum actuator discharge current amplitude and rate of 50 kA and 2 kA/mu s was successfully developed and tested. It can be plugged in standard single phase 230 V/16 A mains socket and the circuit is able to recover up to 32% of its initial energy, reducing the charging time of conventional EMF systems by up to 68%.