Regulation of antioxidant enzymes gene expression in the yeast Saccharomyces cerevisiae during stationary phase

Gene expression of three antioxidant enzymes, Mn superoxide dismutase (MnSOD), Cu,Zn superoxide dismutase (Cu,ZnSOD), and glutathione reductase (GR) was investigated in stationary phase Saccharomyces cerevisiae during menadione-induced oxidative stress. Both GR and Cu,ZnSOD mRNA steady state levels increased, reaching a plateau at about 90 min exposure to menadione. GR mRNA induction was higher than that of Cu,ZnSOD (about 14-fold and 9-fold after 90 min, respectively). A different pattern of response was obtained for MnSOD mRNA, with a peak at about 15 min (about 8-fold higher) followed by a decrease to a plateau approximately 4-fold higher than the control value. However, these increased mRNA levels did not result in increased protein levels and activities of these enzymes. Furthermore, exposure to menadione decreased MnSOD activity to half its value, indicating that the enzyme is partially inactivated due to oxidative damage. Cu,ZnSOD protein levels were increased 2-fold, but MnSOD protein levels were unchanged after exposure to menadione in the presence of the proteolysis inhibitor phenylmethylsulfonyl fluoride. These results indicate that the rates of Cu,ZnSOD synthesis and proteolysis are increased, while the rates of MnSOD synthesis and proteolysis are unchanged by exposure to menadione. Also, the translational efficiency for both enzymes is probably decreased, since increases in protein levels when proteolysis is inhibited do not reflect the increases in mRNA levels. Our results indicate that oxidative stress modifies MnSOD, Cu,ZnSOD, and GR gene expression in a complex way, not only at the transcription level but also at the post-transcriptional, translational, and post-translational levels.

Modification of MOR by desilication treatments: Structural, textural and acidic characterization

The effect of several desilication experimental parameters (base concentration, temperature and time) on the characteristics of MOR zeolite was studied. The samples were characterized by X-ray diffraction, Al-27 and Si-29 MAS-NMR, chemical analysis, and FTIR (framework vibration region). The textural characterization was made by N-2 adsorption and the acidity was evaluated by pyridine adsorption followed by FTIR and by the catalytic model reaction of n-heptane cracking. The alkaline treatments promoted the Si extraction from the zeolite framework, without considerable loss of crystallinity and, as it was envisaged, an important increase of the mesoporous structure was attained. A linear correlation between the number of framework Si per unit cell. N-Si and the asymmetric stretching wavenumber, nu(i), was observed. The acidity characterization shows that the desilicated samples exhibit practically the same acid properties than the parent HMOR zeolite. The optimum desilication conditions were those used to obtain sample M/0.2/85/2, i.e., sample treated with 0.2 M NaOH solution at 85 degrees C for 2 h.

IGRT com CBCT: o impacto na precisão em radioterapia

Mestrado em Radiações Aplicadas às Tecnologias da Saúde.

Do fatigue, physical activity, handgrip strength and quality of life change between pre and post liver transplant?

Analisar: níveis de fadiga, força de preensão, HRQoL, níveis de actividade física. Será que se alteram em doentes PAF após o transplante de fígado? Dado que os níveis de actividade física se encontram abaixo dos valores mínimos recomendados deveria ser encontrada uma estratégia de aumento do tempo dispendido na actividade física leve a moderada idealmente no PRÉ TRANSPLANTE.

Optimising protocol of acquisition and post-processing procedures in the assessment of coronary artery disease by computed tomography

Coronary artery disease (CAD) is currently one of the most prevalent diseases in the world population and calcium deposits in coronary arteries are one direct risk factor. These can be assessed by the calcium score (CS) application, available via a computed tomography (CT) scan, which gives an accurate indication of the development of the disease. However, the ionising radiation applied to patients is high. This study aimed to optimise the protocol acquisition in order to reduce the radiation dose and explain the flow of procedures to quantify CAD. The main differences in the clinical results, when automated or semiautomated post-processing is used, will be shown, and the epidemiology, imaging, risk factors and prognosis of the disease described. The software steps and the values that allow the risk of developingCADto be predicted will be presented. A64-row multidetector CT scan with dual source and two phantoms (pig hearts) were used to demonstrate the advantages and disadvantages of the Agatston method. The tube energy was balanced. Two measurements were obtained in each of the three experimental protocols (64, 128, 256 mAs). Considerable changes appeared between the values of CS relating to the protocol variation. The predefined standard protocol provided the lowest dose of radiation (0.43 mGy). This study found that the variation in the radiation dose between protocols, taking into consideration the dose control systems attached to the CT equipment and image quality, was not sufficient to justify changing the default protocol provided by the manufacturer.

Modifications of MCM-22 zeolite through sequential post-synthesis treatments. Implications on the acidic and catalytic behaviour

Desilication and a combination of alkaline followed by acid treatment were applied to MCM-22 zeolite using two different base concentrations. The samples were characterised by powder X-ray diffraction, Al-27 and Si-29 MAS-NMR spectroscopy, SEM, TEM and low temperature N-2 adsorption. The acidity of the samples was study through pyridine adsorption followed by FTIR spectroscopy and by the analyses of the hydroxyl region. The catalytic behaviour, anticipated by the effect of post-synthesis treatments on the acidity and space available inside the two internal pore systems was evaluated by using the model reaction of m-xylene transformation. The generation of mesoporosity was achieved upon alkaline treatment with 0.05 M NaOH solution and practically no additional gain was obtained when the more concentrate solution, 0.1 M, was used. Instead, Al extraction takes place along with Si, as shown by Si-29 and Al-27 MAS-NMR data, followed by Al deposition as extraframework species. Samples submitted to alkaline plus acid treatments present distinct behaviour. When the lowest NaOH solution was used no relevant effect was observed on the textural characteristics. Additionally, when the acid treatment was performed on an already fragilized MCM-22 structure, due to previous desilication with 0.1 M NaOH solution, the extraction of Al from both internal pore systems promotes their interconnection, evolving from a 2-D to a 3-D porous structure. This transformation has a marked effect in the catalytic behaviour, allowing an increase of m-xylene conversion as a consequence of an easier and faster molecular traffic in the 3-D structure. On the other hand, the continuous deposition of extraframework Al species inside the pores leads to a shape selective effect that privileges the formation of the more valuable isomer p-xylene.

Somewhere near reality: artistic portrayal of violence in post WWII British realistic drama

ABSTRACT - I will explore and present the portrayal of violence in some British plays that were staged between 1951 and 1965, in order to discuss the role, impact and aim of its representation. Thus, I will consider John Whiting’s Saint’s Day (1951), Ann Jelicoe’s The Sport of my Mad Mother (1956), Arnold Wesker (Chicken Soup with Barley (1958), Harold Pinter’s Birthday Party (1958), David Rudkin’s Afore Night Come (1962) and Edward Bond’s Saved (1965). My aim is to discuss the way how theatre in the post WWII changed the traditional ways of representing violence. On one hand, violence and reality became more and more familiar and domestic, permitting a representation of multiple and non-agonic violence; and, on the other hand, the violence that was depicted often changed the way one perceived reality itself, being part of a socially engaged artistic attitude.

Formación de profesores post Bolonia: los desafíos de un proceso en dos etapas

En los últimos años, las políticas de formación de profesores se han convertido en un foco de interés para gobernantes, investigadores y profesionales de la educación. En Portugal, como en otros países europeos, la reestructuración de la formación de profesores estuvo marcada por las políticas, directrices y tendencias de la Comisión Europea, adecuándolas a las especificidades propias de la cultura e historia nacionales. Actualmente, la formación de profesores para los primeros años (0-12) se realiza en instituciones de enseñanza superior, bajo una estructura de dos etapas, constituida por el primer ciclo (licenciatura en Educación Básica) y el segundo ciclo (maestros en educación de infancia y/o ciclo de Enseñanza Básica), con una duración de 4,5 a 5 años. Esta organización en dos etapas ha traído nuevos desafíos a la coherencia y consistencia de los cursos de formación, sobre todo, por lo que respecta a la articulación de la formación académica con la formación práctica. Los problemas generados se vuelven especialmente relevantes en el 6º semestre de la licenciatura en Educación Básica, periodo de transición entre la conclusión de una etapa y el inicio de otra. En este artículo, relatamos el recorrido realizado en la organización de la formación en Educación Básica en una escuela superior de educación en Portugal. El proyecto duró 4 años e incidió en la orientación, organización y procesos de apoyo a la iniciación a la práctica profesional en el 6º semestre del curso. En este proceso, la participación e implicación de los estudiantes, a través de la evaluación de la formación, fue el rasgo fundamental y distintivo.