Study of the Saldanha Massif (MAR, 36 degrees 34 ' N): Constrains from rock magnetic and geophysical data

We present a study of the magnetic properties of a group of basalt samples from the Saldanha Massif (Mid-Atlantic Ridge - MAR - 36degrees 33' 54" N, 33degrees 26' W), and we set out to interpret these properties in the tectono-magmatic framework of this sector of the MAR. Most samples have low magnetic anisotropy and magnetic minerals of single domain grain size, typical of rapid cooling. The thermomagnetic study mostly shows two different susceptibility peaks. The high temperature peak is related to mineralogical alteration due to heating. The low temperature peak shows a distinction between three different stages of low temperature oxidation: the presence of titanomagnetite, titanomagnetite and titanomaghemite, and exclusively of titanomaghemite. Based on established empirical relationships between Curie temperature and degree of oxidation, the latter is tentatively deduced for all samples. Finally, swath bathymetry and sidescan sonar data combined with dive observations show that the Saldanha Massif is located over an exposed section of upper mantle rocks interpreted to be the result of detachment tectonics. Basalt samples inside the detachment zone often have higher than expected oxidation rates; this effect can be explained by the higher permeability caused by the detachment fault activity.

C3G - A portuguese collaboration for geology, geodesy and geophysics

Portugal joined the effort to create the EPOS infrastructure in 2008, and it became immediately apparent that a national network of Earth Sciences infrastructures was required to participate in the initiative. At that time, FCT was promoting the creation of a national infrastructure called RNG - Rede Nacional de Geofísica (National Geophysics Network). A memorandum of understanding had been agreed upon, and it seemed therefore straightforward to use RNG (enlarged to include relevant participants that were not RNG members) as the Portuguese partner to EPOS-PP. However, at the time of signature of the EPOS-PP contract with the European Commission (November 2010), RNG had not gained formal identity yet, and IST (one of the participants) signed the grant agreement on behalf of the Portuguese consortium. During 2011 no progress was made towards the formal creation of RNG, and the composition of the network – based on proposals submitted to a call issued in 2002 – had by then become obsolete. On February 2012, the EPOS national contact point was mandated by the representatives of the participating national infrastructures to request from FCT the recognition of a new consortium - C3G, Collaboratory for Geology, Geodesy and Geophysics - as the Portuguese partner to EPOS-PP. This request was supported by formal letters from the following institutions: ‐ LNEG. Laboratório Nacional de Energia e Geologia (National Geological Survey); ‐ IGP ‐ Instituto Geográfico Português (National Geographic Institute); ‐ IDL, Instituto Dom Luiz – Laboratório Associado ‐ CGE, Centro de Geofísica de Évora; ‐ FCTUC, Faculdade de Ciências e Tecnologia da Universidade de Coimbra; ‐ Instituto Superior de Engenharia de Lisboa; ‐ Instituto Superior Técnico; ‐ Universidade da Beira Interior. While Instituto de Meteorologia (Meteorological Institute, in charge of the national seismographic network) actively supports the national participation in EPOS, a letter of support was not feasible in view of the organic changes underway at the time. C3G aims at the integration and coordination, at national level, of existing Earth Sciences infrastructures, namely: ‐ seismic and geodetic networks (IM, IST, IDL, CGE); ‐ rock physics laboratories (ISEL); ‐ geophysical laboratories dedicated to natural resources and environmental studies; ‐ geological and geophysical data repositories; ‐ facilities for data storage and computing resources. The C3G - Collaboratory for Geology, Geodesy and Geophysics will be coordinated by Universidade da Beira Interior, whose Department of Informatics will host the C3G infrastructure.

Geological and geotechnical surveys in tectonically active rock masses

The economic development of a region depends on the speed that people and goods can travel. The reduction of people and goods travel time can be achieved by planning smooth road layouts, which are obtained by crossing natural obstacles such as hills, by tunneling at great depths, and allowing the reduction of the road alignment length. The stress state in rock masses at such depths, either because of the overburden or due to the tectonic conditions of the rock mass induces high convergences of the tunnel walls. These high convergence values are incompatible with the supports structural performance installed in the excavation stabilization. In this article it is intended to evaluate and analyze some of the solutions already implemented in several similar geological and geotechnical situations, in order to establish a methodological principle for the design of the tunnels included in a highway section under construction in the region influenced by the Himalayas, in the state of Himachal Pradesh (India) and referenced by "four laning of Kiratpur to Ner Chowk section".

Design and construction of tunnels in zones subjected to high convergences

The economic development of a region depends on the speed that people and goods can travel. The reduction of people and goods travel time can be achieved by planning smooth road layouts, which are obtained by crossing natural obstacles such as hills, by tunneling at great depths, and allowing the reduction of the road alignment length. The stress state in rock masses at such depths, either because of the overburden or due to the tectonic conditions of the rock mass induces high convergences of the tunnel walls. These high convergence values are incompatible with the supports structural performance installed in the excavation stabilization. In this article it is intended to evaluate and analyze some of the solutions already implemented in several similar geological and geotechnical situations, in order to establish a methodological principle for the design of the tunnels included in a highway section under construction in the region influenced by the Himalayas, in the state of Himachal Pradesh (India) and referenced by "four laning of Kiratpur to Ner Chowk section".

Deep structure of the Santos basin-São Paulo plateau system, SE Brazil

The structure and nature of the crust underlying the Santos Basin-São Paulo Plateau System (SSPS), in the SE Brazilian margin, are discussed based on five wide-angle seismic profiles acquired during the Santos Basin (SanBa) experiment in 2011. Velocity models allow us to precisely divide the SSPS in six domains from unthinned continental crust (Domain CC) to normal oceanic crust (Domain OC). A seventh domain (Domain D), a triangular shape region in the SE of the SSPS, is discussed by Klingelhoefer et al. (2014). Beneath the continental shelf, a similar to 100km wide necking zone (Domain N) is imaged where the continental crust thins abruptly from similar to 40km to less than 15km. Toward the ocean, most of the SSPS (Domains A and C) shows velocity ranges, velocity gradients, and a Moho interface characteristic of the thinned continental crust. The central domain (Domain B) has, however, a very heterogeneous structure. While its southwestern part still exhibits extremely thinned (7km) continental crust, its northeastern part depicts a 2-4km thick upper layer (6.0-6.5km/s) overlying an anomalous velocity layer (7.0-7.8km/s) and no evidence of a Moho interface. This structure is interpreted as atypical oceanic crust, exhumed lower crust, or upper continental crust intruded by mafic material, overlying either altered mantle in the first two cases or intruded lower continental crust in the last case. The deep structure and v-shaped segmentation of the SSPS confirm that an initial episode of rifting occurred there obliquely to the general opening direction of the South Atlantic Central Segment.