Evaluation of three indices for biofilm accumulation on complete dentures

Objectives: The objective of this study was to evaluate the accuracy and reproducibility of three complete denture biofilm indices (Prosthesis Hygiene Index; Jeganathan et al. Index; Budtz-J circle divide rgensen Index) by means of a computerised comparison method. Background: Clinical studies into denture hygiene have employed a large number of biofilm indices among their outcome variables. However, the knowledge about the validity of these indices is still scarce. Materials and methods: Sixty-two complete denture wearers were selected. The internal surfaces of the upper complete dentures were stained (5% erythrosine) and photographed. The slides were projected on paper, and the biofilm indices were applied over the photos by means of a scoring method. For the computerised method, the areas (total and biofilm-covered) were measured by dedicated software (Image Tool). In addition, to compare the results of the computerised method and Prosthetic Hygiene Index, a new scoring scale (including four and five graded) was introduced. For the Jeganathan et al. and Budtz-J circle divide rgensen indices, the original scales were used. Values for each index were compared with the computerised method by the Friedman test. Their reproducibility was measured by means of weighed kappa. Significance for both tests was set at 0.05. Results: The indices tested provided similar mean measures but they tended to overestimate biofilm coverage when compared with the computerised method (p < 0.001). Agreement between the Prosthesis Hygiene Index and the computerised method was not significant, regardless of the scale used. Jeghanathan et al. Index showed weak agreement, and consistent results were found for Budtz-Jorgensen Index (kappa = 0.19 and 0.39 respectively). Conclusion: Assessment of accuracy for the biofilm indices showed instrument bias that was similar among the tested methods. Weak inter-instrument reproducibility was found for the indices, except for the Budtz-J circle divide rgensen Index. This should be the method of choice for clinical studies when more sophisticated approaches are not possible.

Narrowing socioeconomic inequality in child stunting: the Brazilian experience, 1974-2007

Objective To assess trends in the prevalence and social distribution of child stunting in Brazil to evaluate the effect of income and basic service redistribution policies implemented in that country in the recent past. Methods The prevalence of stunting (height-for-age z score below 2 using the Child Growth Standards of the World Health Organization) among children aged less than 5 years was estimated from data collected during national household surveys carried out in Brazil in 1974-75 (n = 34 409), 1989 (n = 7374), 1996 (n = 4149) and 2006-07 (n = 4414). Absolute and relative socioeconomic inequality in stunting was measured by means of the slope index and the concentration index of inequality, respectively. Findings Over a 33-year period, we documented a steady decline in the national prevalence of stunting from 37.1% to 7.1%. Prevalence dropped from 59.0% to 11.2% in the poorest quintile and from 12.1% to 3.3% among the wealthiest quintile. The decline was particularly steep in the last 10 years of the period (1996 to 2007), when the gaps between poor and wealthy families with children under 5 were also reduced in terms of purchasing power; access to education, health care and water and sanitation services; and reproductive health indicators. Conclusion In Brazil, socioeconomic development coupled with equity-oriented public policies have been accompanied by marked improvements in living conditions and a substantial decline in child undernutrition, as well as a reduction of the gap in nutritional status between children in the highest and lowest socioeconomic quintiles. Future studies will show whether these gains will be maintained under the current global economic crisis.

Are Reanalysis Data Useful for Calculating Climate Indices over South America?

Precipitation and temperature climate indices are calculated using the National Centers for Environmental Prediction/National Center for Atmospheric Research (NCEP/NCAR) reanalysis and validated against observational data from some stations over Brazil and other data sources. The spatial patterns of the climate indices trends are analyzed for the period 1961-1990 over South America. In addition, the correlation and linear regression coefficients for some specific stations were also obtained in order to compare with the reanalysis data. In general, the results suggest that NCEP/NCAR reanalysis can provide useful information about minimum temperature and consecutive dry days indices at individual grid cells in Brazil. However, some regional differences in the climate indices trends are observed when different data sets are compared. For instance, the NCEP/NCAR reanalysis shows a reversal signal for all rainfall annual indices and the cold night index over Argentina. Despite these differences, maps of the trends for most of the annual climate indices obtained from the NCEP/NCAR reanalysis and BRANT analysis are generally in good agreement with other available data sources and previous findings in the literature for large areas of southern South America. The pattern of trends for the precipitation annual indices over the 30 years analyzed indicates a change to wetter conditions over southern and southeastern parts of Brazil, Paraguay, Uruguay, central and northern Argentina, and parts of Chile and a decrease over southwestern South America. All over South America, the climate indices related to the minimum temperature (warm or cold nights) have clearly shown a warming tendency; however, no consistent changes in maximum temperature extremes (warm and cold days) have been observed. Therefore, one must be careful before suggesting an), trends for warm or cold days.

Perinatal salt restriction: A new pathway to programming adiposity indices in adult female Wistar rats

Low birth weight has been associated with increased obesity in adulthood. It has been shown that dietary salt restriction during intrauterine life induces low birth weight and insulin resistance in adult Wistar rats. The present study had a two-fold objective: to evaluate the effects that low salt intake during pregnancy and lactation has on the amount and distribution of adipose tissue; and to determine whether the phenotypic changes in fat mass in this model are associated with alterations in the activity of the renin-angiotensin system. Maternal salt restriction was found to reduce birth weight in male and female offspring. In adulthood, the female offspring of dams fed the low-salt diet presented higher adiposity indices than those seen in the offspring of dams fed a normal-salt diet. This was attributed to the fact that adipose tissue mass (retroperitoneal but not gonadal, mesenteric or inguinal) was greater in those rats than in the offspring of dams fed a normal diet. The adult offspring of dams fed the low-salt diet, compared to those dams fed a normal-salt diet, presented the following: plasma leptin levels higher in males and lower in females; plasma renin activity higher in males but not in females; and no differences in body weight, mean arterial blood pressure or serum angiotensin-converting enzyme activity. Therefore, low salt intake during pregnancy might lead to the programming of obesity in adult female offspring. (c) 2009 Elsevier Inc. All rights reserved.

A Framework for Exploring Multidimensional Data with 3D Projections

Visualization of high-dimensional data requires a mapping to a visual space. Whenever the goal is to preserve similarity relations a frequent strategy is to use 2D projections, which afford intuitive interactive exploration, e. g., by users locating and selecting groups and gradually drilling down to individual objects. In this paper, we propose a framework for projecting high-dimensional data to 3D visual spaces, based on a generalization of the Least-Square Projection (LSP). We compare projections to 2D and 3D visual spaces both quantitatively and through a user study considering certain exploration tasks. The quantitative analysis confirms that 3D projections outperform 2D projections in terms of precision. The user study indicates that certain tasks can be more reliably and confidently answered with 3D projections. Nonetheless, as 3D projections are displayed on 2D screens, interaction is more difficult. Therefore, we incorporate suitable interaction functionalities into a framework that supports 3D transformations, predefined optimal 2D views, coordinated 2D and 3D views, and hierarchical 3D cluster definition and exploration. For visually encoding data clusters in a 3D setup, we employ color coding of projected data points as well as four types of surface renderings. A second user study evaluates the suitability of these visual encodings. Several examples illustrate the framework`s applicability for both visual exploration of multidimensional abstract (non-spatial) data as well as the feature space of multi-variate spatial data.

Quality indices for (practical) clustering evaluation

Clustering quality or validation indices allow the evaluation of the quality of clustering in order to support the selection of a specific partition or clustering structure in its natural unsupervised environment, where the real solution is unknown or not available. In this paper, we investigate the use of quality indices mostly based on the concepts of clusters` compactness and separation, for the evaluation of clustering results (partitions in particular). This work intends to offer a general perspective regarding the appropriate use of quality indices for the purpose of clustering evaluation. After presenting some commonly used indices, as well as indices recently proposed in the literature, key issues regarding the practical use of quality indices are addressed. A general methodological approach is presented which considers the identification of appropriate indices thresholds. This general approach is compared with the simple use of quality indices for evaluating a clustering solution.

Least square projection: A fast high-precision multidimensional projection technique and its application to document mapping

The problem of projecting multidimensional data into lower dimensions has been pursued by many researchers due to its potential application to data analyses of various kinds. This paper presents a novel multidimensional projection technique based on least square approximations. The approximations compute the coordinates of a set of projected points based on the coordinates of a reduced number of control points with defined geometry. We name the technique Least Square Projections ( LSP). From an initial projection of the control points, LSP defines the positioning of their neighboring points through a numerical solution that aims at preserving a similarity relationship between the points given by a metric in mD. In order to perform the projection, a small number of distance calculations are necessary, and no repositioning of the points is required to obtain a final solution with satisfactory precision. The results show the capability of the technique to form groups of points by degree of similarity in 2D. We illustrate that capability through its application to mapping collections of textual documents from varied sources, a strategic yet difficult application. LSP is faster and more accurate than other existing high-quality methods, particularly where it was mostly tested, that is, for mapping text sets.