Species diversity of Leishmania (Viannia) parasites circulating in an endemic area for cutaneous leishmaniasis located in the Atlantic rainforest region of northeastern Brazil

OBJECTIVES To identify the aetiological agents of cutaneous leishmaniasis and to investigate the genetic polymorphism of Leishmania (Viannia) parasites circulating in an area with endemic cutaneous leishmaniasis (CL) in the Atlantic rainforest region of northeastern Brazil. METHODS Leishmania spp. isolates came from three sources: (i) patients diagnosed clinically and parasitologically with CL based on primary lesions, secondary lesions, clinical recidiva, mucocutaneous leishmaniasis and scars; (ii) sentinel hamsters, sylvatic or synanthropic small rodents; and (iii) the sand fly species Lutzomyia whitmani. Isolates were characterised using monoclonal antibodies, multilocus enzyme electrophoresis (MLEE) and polymerase chain reaction-restriction fragment length polymorphism of the internal transcribed spacer region rDNA locus. RESULTS Seventy-seven isolates were obtained and characterised. All isolates were identified as Leishmania (Viannia) braziliensis serodeme 1 based on reactivity to monoclonal antibodies. MLEE identified 10 zymodemes circulating in the study region. Most isolates were classified as zymodemes closely related to L. (V.) braziliensis, but five isolates were classified as Leishmania (Viannia) shawi. All but three of the identified zymodemes have so far been observed only in the study region. Enzootic transmission and multiclonal infection were observed. CONCLUSIONS Our results confirm that transmission cycle complexity and the co-existence of two or more species in the same area can affect the level of genetic polymorphism in a natural Leishmania population. Although it is not possible to make inferences as to the modes of genetic exchange, one can speculate that some of the zymodemes specific to the region are hybrids of L. (V.) braziliensis and L. (V.) shawi.

Perpendicular exchange bias in IrMn/Pt/[Co/Pt](3) multilayers with cone magnetization

The perpendicular exchange bias and magnetic anisotropy were investigated in IrMn/Pt/[Co/Pt](3) multilayers through the analysis of in-plane and out-of-plane magnetization hysteresis loops. A phenomenological model was used to simulate the in-plane curves and the effective perpendicular anisotropies were obtained employing the area method. The canted state anisotropy was introduced by taking into account the first and second uniaxial anisotropy terms of the ferromagnet with the corresponding uniaxial anisotropy direction allowed to make a nonzero angle with the film`s normal. This angle, obtained from the fittings, was of approximately 15 degrees for IrMn/[Co/Pt](3) film and decreases with the introduction of Pt in the IrMn/Pt/[Co/Pt](3) system, indicating that the Pt interlayer leads to a predominant perpendicular anisotropy. A maximum of the out-of-plane anisotropy was found between 0.5 and 0.6 nm of Pt, whereas a maximum of the perpendicular exchange bias was found at 0.3 nm. These results are very similar to those obtained for IrMn/Cu/[Co/Pt](3) system; however, the decrease of the exchange bias with the spacer thickness is more abrupt and the enhacement of the perpendicular anisotropy is higher for the case of Cu spacer as compared with that of Pt spacer. The existence of a maximum in the perpendicular exchange bias as a function of the Pt layer thickness was attributed to the predominance of the enhancement of exchange bias due to more perpendicular Co moment orientation over the exponential decrease of the ferromagnetic/antiferromagnetic exchange coupling and, consequently, of the exchange-bias field. (C) 2011 Elsevier B.V. All rights reserved.