Behavioural responses of heifers to ACTH injections

The objective of this study was to investigate behavioural changes in Holstein heifers caused by exogenous adrenocorticotropic hormone (ACTH) administration. Twelve 11-month-old heifers were submitted to either a single saline or ACTH injection and then the treatments were switched after 3 days (n = 12 heifers/treatment). Heifers were in full view throughout the experimental period and recordings started immediately after ACTH and saline administration (injection corresponded to time 0 min), with general activity patterns of each heifer recorded on videotape for 24 h. Behavioural results during the first two experimental hours showed that heifers were less active and spent more time lying following ACTH than after saline treatment (P = 0.04). Also, heifers spent significantly less time ruminating immediately following ACTH injection (P = 0.05). However, feed intake measured after 4 and 24 h was similar between treatments (P > 0.05). Overall, there was no significant influence of ACTH treatment on frequency or duration of behaviours during the 4- and 24-h periods following injection (P > 0.05). The rapid and minimal effect of ACTH injection on behaviour suggests that peripheral administration of ACTH can be used to measure reactivity of the adrenal cortex without inducing biologically significant consequences. (C) 2010 Elsevier B.V. All rights reserved.

A critical view on biaxial and short-beam uniaxial flexural strength tests applied to resin composites using Weibull, fractographic and finite element analyses

Objective. To evaluate the biaxial and short-beam uniaxial strength tests applied to resin composites based upon their Weibull parameters, fractographic features and stress distribution. Methods. Disk- (15 mm x 1 mm) and beam-shaped specimens (10 mm x 2 mm x 1 mm) of three commercial composites (Concept/Vigodent, CA; Heliomolar/Ivoclar-Vivadent, HE; Z250/3M ESPE, FZ) were prepared. After 48h dry storage at 37 degrees C, disks and beams were submitted to piston-on-three-balls (BI) and three-point bending (UNI) tests, respectively. Data were analyzed by Weibull statistics. Fractured surfaces were observed under stereomicroscope and scanning electron microscope. Maximum principal stress (sigma(1)) distribution was determined by finite element analysis (FEA). Maximum sigma(1-BI) and sigma(1-UNI) were compared to FZ strengths calculated by applying the average failure loads to the analytical equations (sigma(a-BI) and sigma(a-UNI)). Results. For BI, characteristic strengths were: 169.9a (FZ), 122.4b (CA) and 104.8c (HE), and for UNI were: 160.3a (FZ), 98.2b (CA) and 91.6b (HE). Weibull moduli ( m) were similar within the same test. CA and HE presented statistically higher m for BI. Surface pores ( BI) and edge flaws ( UNI) were the most frequent fracture origins. sigma(1-BI) was 14% lower than sigma(a-BI.) sigma(1-UNI) was 43% higher than sigma(a-UNI). Significance. Compared to the short-beam uniaxial test, the biaxial test detected more differences among composites and displayed less data scattering for two of the tested materials. Also, biaxial strength was closer to the material`s strength estimated by FEA. (C) 2009 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.