Peat as a natural solid-phase for copper preconcentration and determination in a multicommuted flow system coupled to flame atomic absorption spectrometry

The physical and chemical characteristics of peat were assessed through measurement of pH, percentage of organic matter, cationic exchange capacity (CEC), elemental analysis, infrared spectroscopy and quantitative analysis of metals by ICP OES. Despite the material showed to be very acid in view of the percentage of organic matter, its CEC was significant, showing potential for retention of metal ions. This characteristic was exploited by coupling a peat mini-column to a flow system based on the multicommutation approach for the in-line copper concentration prior to flame atomic absorption spectrometric determination. Cu(II) ions were adsorbed at pH 4.5 and eluted with 0.50 mol L(-1) HNO(3). The influence of chemical and hydrodynamic parameters, such as sample pH, buffer concentration, eluent type and concentration, sample flow-rate and preconcentration time were investigated. Under the optimized conditions, a linear response was observed between 16 and 100 mu g L(-1), with a detection limit estimated as 3 mu g L(-1) at the 99.7% confidence level and an enrichment factor of 16. The relative standard deviation was estimated as 3.3% (n = 20). The mini-column was used for at least 100 sampling cycles without significant variation in the analytical response. Recoveries from copper spiked to lake water or groundwater as well as concentrates used in hemodialysis were in the 97.3-111 % range. The results obtained for copper determination in these samples agreed with those achieved by graphite furnace atomic absorption spectrometry (GFAAS) at the 95% confidence level. (C) 2009 Elsevier B.V. All rights reserved.

Chemoprotective effect of the tetrahydrofuran lignan grandisin in the in-vivo rodent micronucleus assay

Objectives The chemoprotective effect of the tetrahydrofuran lignan grandisin against DNA damage induced by cyclophosphamide (200 mg/kg) has been evaluated using the in vitro rodent micronucleus assay. Methods The effects of a daily oral administration of grandisin (2, 4, or 8 mg/kg) for five days before exposure to cyclophosphamide on the frequency of micronucleus in the bone marrow of normal mice exposed and unexposed to cyclophosphamide were investigated (n = 5 per group). Electrochemical measurements were applied to investigate whether the antimutagenic effects of grandisin could be, at least in part, a consequence of its or its metabolite`s antioxidant properties. Key findings Grandisin did not show mutagenic effects on the bone marrow cells of exposed mice. On the other hand, the oral administration of grandisin (2, 4, or 8 mg/kg) per day reduced dose-dependently the frequency of micronucleus, induced by cyclophosphamide, in all groups studied. Cyclic voltammograms showed two peaks for a grandisin metabolite, which were absent for grandisin. Conclusions Under the conditions tested herein, this study has shown that mice treated with grandisin presented, in a dose-dependent manner, a protective effect against cyclophosphamide-induced mutagenicity. This effect could be, at least in part, associated to grandisin bioactivation. These data open new perspectives for further investigation into the toxicology and applied pharmacology of grandisin.

Removal of Zn(2+) from Electroplating Wastewater Using Modified Wood Sawdust and Sugarcane Bagasse

This paper describes the preparation of new adsorbents derived from sugarcane bagasse and wood sawdust (Manilkara sp.) to remove zinc (II) ions from electroplating wastewater. The first part deals with the chemical modification of sugarcane bagasse and wood sawdust, using succinic anhydride to introduce carboxylic acid functions into the material. The obtained materials (modified sugarcane bagasse MB2 and modified wood sawdust MS2) were then characterized by infrared spectroscopy (IR) and used in adsorption experiments. The adsorption experiments evaluates Zn(2+) removal from aqueous single metal solution and real electroplating wastewater on both batch and continuous experiments using fixed-bed columns prepared in laboratorial scale with the obtained adsorbents. Adsorption isotherms were then developed using Langmuir model and the Thomas kinetic model. The calculated Zn(2+) adsorption capacities were found to be 145 mg/g for MS2 and 125 mg/g for MB2 in single metal aqueous solution, whereas for the industrial wastewater these values were 61 mg/g for MS2 and 55 mg/g for MB2.