Evaluation of nonlinear distortion in MIMO transmitters

In this paper, an evaluation of unwanted effects in Multiple Input Multiple Output (MIMO) transmitters is described. Complete 2×2 and 4×4 MIMO Orthogonal Frequency Division Multiplex (OFDM) transmitters are simulated for the purpose of quantifying all potential unwanted effects such as Power Amplifiers' (PAs) nonlinearity, linear and nonlinear crosstalk, and IQ modulator imperfections. An experimental analysis of a 2×2 MIMO transmitter using two-tones and WCDMA signal is presented.

Nonlinear distortion evaluation of reconfigurable RF circuits in wireless communication systems

A compact highly linear microstrip dual - mode optically switchable filter and a reconfigurable power amplifier are presented. The key characteristics of the dual - mode switchable filter are investigated and described. A second order filter design procedure is outlined to facilitate the realisation of Butterworth and Chebyshev functions. The proposed filter was built and tested with an optical switch, which comprised of a silicon dice acti vated using near infrared light. The measured and simulated results are in good agreement. The measured insertion loss in the ON state was 3.0 dB the isolation in the OFF state was 45 dB at the centre frequency. An evaluation of filter distortion is presen ted for digitally modulated M - QAM and M - QAM OFDM singals.

Compact high linearity switchable dual-mode microstrip bandpass filters

A compact highly linear microstrip dual-mode electronically switchable filter is presented. The key characteristics of the dual-mode switchable filter are investigated and described. A second order filter design procedure is outlined to facilitate the realisation of Butterworth and Chebyshev functions. The proposed filter was built and tested with NXP pin diode model BAP65-03. The measured and simulated results are in good agreement. The measured insertion loss in the ON state was 3.0 dB the isolation in the OFF state was 45 dB at the centre frequency. An evaluation of filter distortion is presented for digitally modulated 16 QAM and QPSK signals.

Compact tunable bandstop filters using defected microstrip structure for multi-standard wireless systems

A novel compact tunable bandstop filter using Defected Microstrip Structure (DMS) is presented in this paper. The structure utilizes a modified T shaped DMS which helps in miniaturization of the filter. To verify the concept, one such filter was simulated, designed, fabricated and tested. Measurements on a fabricated tunable filter confirm the accuracy of the design procedure. The tuning range of 20% is achieved, ranging from 2.26 GHz to 2.747 GHz. Tuning is achieved by using NXP BB179 varactor diode. A nonlinear distortion evaluation in a tunable filter was experimentally verified. Experimental verification shows the filter is highly linear.

Molecularly imprinted polymer based on MWCNTs-QDs as fluorescent biomimetic sensor for specific recognition of target protein

A novel molecularly imprinted optosensing material based on multi-walled carbon nanotube-quantum dots (MWCNT-QDs) has been designed and synthesized for its high selectivity, sensitivity and specificity in the recognition of a target protein bovine serum albumin (BSA). Molecularly imprinted polymer coated MWCNT-QDs using BSA as the template (BMIP-coated MWCNT-QDs) exhibits a fast mass-transfer speed with a response time of 25 min. It is found that the BSA as a target protein can significantly quench the luminescence of BMIP-coated MWCNT-QDs in a concentration-dependent manner that is best described by a Stem-Volmer equation. The K-SV for BSA is much higher than bovine hemoglobin and lysozyme, implying a highly selective recognition of the BMIP-coated MWCNT-QDs to BSA. Under optimal conditions, the relative fluorescence intensity of BMIP-coated MWCNT-QDs decreases linearly with the increasing target protein BSA in the concentration range of 5.0 x 10(-7)-35.0 x 10(-7) M with a detection limit of 80 nM.