Living and dealing with RF impairments in communication transceivers

This paper provides an overview of the sources and effects of the RF impairments limiting and rendering the performance of the future wireless communication transceivers costly as well as hindering their wide-spread use in commercial products. As transmission bandwidths and carrier frequencies increase effect of these impairments worsen. This paper studies and presents analytical evaluations of the performance degradation due to the RF impairments in terms of bit-error-rate and image rejection ratio. The paper also give highlights of the various aspects of the research carried out in mitigating the effects of these impairments primarily in the digital signal processing domain at the baseband as well as providing low-complexity hardware implementations of such algorithms incorporating a number of power and area saving techniques.

Analysis and compensation of RF impairments for next generation multimode GNSS receivers

Global navigation satellite system (GNSS) receivers require solutions that are compact, cheap and low-power, in order to enable their widespread proliferation into consumer products. Furthermore, interoperability of GNSS with non-navigation systems, especially communication systems will gain importance in providing the value added services in a variety of sectors, providing seamless quality of service for users. An important step into the market for Galileo is the timely availability of these hybrid multi-mode terminals for consumer applications. However, receiver architectures that are amenable to high-levels of integration will inevitably suffer from RF impairments hindering their easy widespread use in commercial products. This paper studies and presents analytical evaluations of the performance degradation due to the RF impairments and develops algorithms that can compensate for them in the DSP domain at the base band with complexity-reduced hardware overheads, hence, paving the way for low-power, highly integrated multi-mode GNSS receivers.

Nonlinear distortion evaluation of reconfigurable RF circuits in wireless communication systems

A compact highly linear microstrip dual - mode optically switchable filter and a reconfigurable power amplifier are presented. The key characteristics of the dual - mode switchable filter are investigated and described. A second order filter design procedure is outlined to facilitate the realisation of Butterworth and Chebyshev functions. The proposed filter was built and tested with an optical switch, which comprised of a silicon dice acti vated using near infrared light. The measured and simulated results are in good agreement. The measured insertion loss in the ON state was 3.0 dB the isolation in the OFF state was 45 dB at the centre frequency. An evaluation of filter distortion is presen ted for digitally modulated M - QAM and M - QAM OFDM singals.

NFC RF Analog Challenge and Enhanced High Speed Transmitter Design

This paper investigates the inherent radio frequency analog challenges associated with near field communication systems. Furthermore, the paper presents a digital based sigma-delta modulator for near field communication transmitter implementations. The proposed digital transmitter architecture is designed to best support data intensive applications requiring higher data rates and complex modulation schemes. An NFC transmitter based on a single-bit sigma-delta DAC is introduced, and then the multi-bit extension with necessary simulation results are presented to confirm the suitability of the architecture for near field communication high speed applications.

Reconfigurable Matching Networks for RF Amplifiers

This article presents applications of reconfigurable matching networks for RF amplifier design. Two possible solutions are given, one where the switching element is a PIN diode, and the other is based on graphene. Due to the fact that its conductivity depends on applied bias voltage, the graphene-based circuits can be used in microwave circuits as controllable elements. The structure of the proposed switch is very simple and it is particularly convenient for microstrip-based circuits. Because of that, a design of reconfigurable amplifier with the graphene-based switch is presented together with the one which has the PIN diode switch. Both amplifiers have the same specifications, and the one with the PIN diode switch is fabricated. The amplifier utilizing the PIN switch was used as a reference to make a comparison the two types of switches. Results of both amplifiers are very similar which indicates possible future applications of the graphene-based switch.