Reduction of tobacco smoke components yield in commercial cigarette brands by addition of HUSY, NaY and Al-MCM-41 to the cigarette rod

The effect of two zeolites, HUSY, NaY and a mesoporous synthesized Al-MCM-41 material on the smoke composition of ten commercial cigarettes brands has been studied. Cigarettes were prepared by mixing the tobacco with the three powdered materials, and the smoke obtained under the ISO conditions was analyzed. Up to 32 compounds were identified and quantified in the gas fraction and 80 in the total particulate matter (TPM) condensed in the cigarettes filters and in the traps located after the mouth end of the cigarettes. Al-MCM-41 is by far the best additive, providing the highest reductions of the yield for most compounds and brands analyzed. A positive correlation was observed among the TPM and nicotine yields with the reduction obtained in nicotine, CO, and most compounds with the three additives. The amount of ashes in additive free basis increases due to the coke deposited on the solids, especially with Al-MCM-41. Nicotine is reduced with Al-MCM-41 by an average of 34.4% for the brands studied (49.5% for the brand where the major reduction was obtained and 18.5 for the brand behaving the worst). CO is reduced by an average of 18.6% (ranging from 10.3 to 35.2% in the different brands).

Comparison between the mainstream smoke of eleven RYO tobacco brands and the reference tobacco 3R4F

In this study 11 commercial roll-your-own (RYO) tobacco brands sold in Spain and the reference tobacco 3R4F have been smoked and several components of the mainstream tobacco smoke have been analyzed. Cigarettes were prepared using commercial tubes, and were smoked under smoking conditions based on the ISO 3308. The gaseous and condensed fractions of the smoke from RYO brands and 3R4F have been analyzed and compared. RYO tobaccos, as opposed to 3R4F, present lower amounts of condensed products in the traps than in the filters. In general, RYO tobaccos also provide lower yields of most of the compounds detected in the gas fraction. The yield of CO is between 15.4 and 20.4 mg/cigarette. In most of the cases studied, RYO tobaccos deliver higher amounts of nicotine than the 3R4F tobacco. On average, the yield of the different chemical families of compounds appearing in the particulate matter retained in the cigarette filters tends to be around three times higher than those obtained from 3R4F, whereas similar values have been obtained in the particulate matter retained in the traps located after the filters. It can be concluded that RYO tobaccos are not less hazardous than the reference tobacco, which may be contrary to popular belief.

Effect of the Concentration of Siliceous Materials Added to Tobacco Cigarettes on the Composition of the Smoke Generated during Smoking

Two as-synthesized meso- and macro-porous siliceous materials (MPSMs), i.e., Al-MCM-41 and SBA-15, were mixed with tobacco to study their effect on tobacco smoke chemistry. A reference cigarette, 3R4F, and a commercial cigarette, Fortuna, containing different percentages of MPSM were smoked in a smoking machine, and the mainstream smoke was analyzed. SBA-15 showed the highest reductions of nicotine; close to 90% when it was added at 8 mass %. The superb behavior of these materials may be related to their high particulate matter filtering efficiency in combination with their catalytic activity. The selectivity of these materials with respect to nicotine was also analyzed. Al-MCM-41 presents higher selectivity for condensed compounds than for gases, whereas SBA-15 presents similar ratios for both fractions. The highest selectivity was obtained for the liquid fraction when smoking 3R4F cigarettes mixed with Al-MCM-41.

Thermogravimetric analysis of the pyrolysis of several materials used in the preparation of commercial cigarettes

Comunicación presentada en forma de póster en el "12th Mediterranean Congress of Chemical Engineering", Barcelona (Spain), November 15-18, 2011

Catalytic effect of MCM-41 in the pyrolysis of tobacco and several substances used as additives in the preparation of commercial cigarettes

Comunicación presentada en forma de póster en el "12th Mediterranean Congress of Chemical Engineering", Barcelona (Spain), November 15-18, 2011.

TGA/FTIR study of the pyrolysis of diammonium hydrogen phosphate–tobacco mixtures

Diammonium hydrogen phosphate (DAP) is commonly used as a flavor ingredient of commercial cigarettes. In addition, among its other uses, it is employed to expand the tobacco volume, to manufacture reconstituted tobacco sheet, and to denicotinize tobacco. However, the use of DAP as a cigarette ingredient is a controversial issue. Some authors have stated that ammonium compounds added to tobacco increase smoke ammonia and “smoke pH”, resulting in more free nicotine available in the smoke. On the other hand, other researchers have reported that the larger ammonium content of a cigarette blend due to the presence of DAP was not reflected in increased smoke ammonia. In this work, the thermal behavior of DAP, tobacco and DAP-tobacco mixtures has been studied by TGA/FTIR. The chemical processes involved in the different pyrolysis steps of DAP have been suggested. Marked changes in the pyrolytic behavior of both, tobacco and DAP have been detected when analyzing the behavior of the mixtures. A displacement of the decomposition steps mainly related to the glycerol and lignin from tobacco toward lower temperatures has been observed, whereas that associated with cellulose is displaced toward higher temperature. Additionally, no peak corresponding to the phosphorous oxides decomposition has been detected in the curves relating to the DAP-tobacco mixtures. All these features are indicative of the strong interactions between DAP and tobacco. The FTIR spectra show no significant qualitative differences between the qualitative overall composition of the gases evolved from the pyrolysis of tobacco in the absence and in the presence of DAP. Nevertheless, depending on the temperature considered, the addition of DAP contributes to a decrease in the generation of hydrocarbons and an increase in the formation of CO, CO2 and oxygenated compounds in terms of amount generated per mass of pyrolysed tobacco.