Water speech: energy, power and inequality in Brazil

The documentary is available in Portuguese at the following link: http://hdl.handle.net/10045/17580

Beyond megaprojects?. Water alternatives for mass tourism in coastal Mediterranean Spain

Water availability in adequate quantities and qualities is a fundamental requirement for tourism. In the Mediterranean, one of the world’s leading tourist destinations, water availability is subject to modest and erratic precipitation figures which may decline with climate change. The tourist industry therefore may have to assure future supplies by either recurring to new technologies such as desalination or increasing efficiency in water use. A third and yet little explored alternative would be to seek for complementary of uses with irrigation, the traditional user in many coastal Mediterranean areas and holder of substantial amounts of water. In this paper we present the example of the Consorcio de Aguas de la Marina Baja to show how Benidorm, in Mediterranean Spain and one of the most important tourist centers of the Mediterranean, obtains part of its water through agreements with farmers by which these trade their water with Benidorm and other towns’ treated wastewater of enough quality to be used for irrigation, and obtain several compensations in return. The advantages and disadvantages of the water trade between farmers and tourist interests in the Benidorm area are discussed and we argue that solutions to the pending water crisis of many coastal Mediterranean tourist areas may not need to rely uniquely on expensive technologies to generate new resources but may attempt other alternatives.

Novel Ti/Ta2O5-SnO2 electrodes for water electrolysis and electrocatalytic oxidation of organics

Mixed metal oxide (MMO) electrodes have been applied to different technologies including chlorine production, organic compounds oxidation, water electrolysis, electroplating, etc. due to their catalytic, optical and electronic properties. Most of the existing MMO electrodes contain either toxic metals or precious metals of the platinum group. The aim of this study was to develop environmentally friendly and cost-effective MMO electrodes for water and organic compounds oxidation. Ti/Ta2O5-SnO2 electrodes of different nominal composition were prepared, and electrochemically and physically characterized. For water oxidation, Ti/SnO2 electrode with 5 at.% of Ta produced the highest electroactivity. Ti/SnO2 electrode with 7.5 at.% of Ta showed the best performance for the oxidation of methylene blue (MB). The electrocatalytic activity of the Ti/Ta2O5-SnO2 electrodes increased with the number of active layers. The maximum current of water oxidation reached 3.5 mA at 2.5 V when the electrode was covered with ten layers of Ta2O5. In case of the oxidation of 0.1 mM MB, eight and ten active layers of Ta2O5 significantly increased the electrode activity. The prepared electrodes have been found applicable for both water electrolysis and organic compounds oxidation.

An improved procedure for obtaining and maintaining well characterized partial water saturation states on concrete samples to be used for mass transport tests

A conditioning procedure is proposed allowing to install into the concrete specimens any selected value of water saturation degree with homogeneous moisture distribution. This is achieved within the least time and the minimum alteration of the concrete specimens. The protocol has the following steps: obtaining basic drying data at 50 °C (water absorption capacity and drying curves); unidirectional drying of the specimens at 50 °C until reaching the target saturation degree values; redistribution phase in closed containers at 50 °C (with measurement of the quasi-equilibrium relative humidities); storage into controlled environment chambers until and during mass transport tests, if necessary. A water transport model is used to derive transport parameters of the tested materials from the drying data, i.e., relative permeabilities and apparent water diffusion coefficients. The model also allows calculating moisture profiles during isothermal drying and redistribution phases, thus allowing optimization of the redistribution times for obtaining homogeneous moisture distributions.