Amphibian Hotspots and Conservation Priorities in Eastern Cuba Identified by Species Distribution Modeling

The high rate of amphibian endemism and the severe habitat modification in the Caribbean islands make them an ideal place to test if the current protected areas network might protect this group. In this study, we model distribution and map species richness of the 40 amphibian species from eastern Cuba with the objectives of identify hotspots, detect gaps in species representation in protected areas, and select additional areas to fill these gaps. We used two modeling methods, Maxent and Habitat Suitability Models, to reach a consensus distribution map for each species, then calculate species richness by combining specific models and finally performed gap analyses for species and hotspots. Our results showed that the models were robust enough to predict species distributions and that most of the amphibian hotspots were represented in reserves, but 50 percent of the species were incompletely covered and Eleutherodactylus rivularis was totally uncovered by the protected areas. We identified 1441 additional km2 (9.9% of the study area) that could be added to the current protected areas, allowing the representation of every species and all hotspots. Our results are relevant for the conservation planning in other Caribbean islands, since studies like this could contribute to fill the gaps in the existing protected areas and to design a future network. Both cases would benefit from modeling amphibian species distribution using available data, even if they are incomplete, rather than relying only in the protection of known or suspected hotspots.

Temperature influence on the physical and mechanical properties of a porous rock: San Julian's calcarenite

This work discusses the results from tests which were performed in order to study the effect of high temperatures in the physical and mechanical properties of a calcarenite (San Julian's stone). Samples, previously heated at different temperatures (from 105 °C to 600 °C), were tested. Non-destructive tests (porosity and ultrasonic wave propagation) and destructive tests (uniaxial compressive strength and slake durability test) were performed over available samples. Furthermore, the tests were carried out under different conditions (i.e. air-cooled and water-cooled) in order to study the effect of the fire off method. The results show that uniaxial compressive strength and elastic parameters (i.e. elastic modulus and Poisson's ratio), decrease as the temperature increases for the tested range of temperatures. A reduction of the uniaxial compressive strength up to 35% and 50% is observed in air-cooled and water-cooled samples respectively when the samples are heated to 600 °C. Regarding the Young's modulus, a fall over 75% and 78% in air-cooled and water-cooled samples respectively is observed. Poisson's ratio also declines up to 44% and 68% with the temperature in air-cooled and water-cooled samples respectively. Slake durability index also exhibits a reduction with temperature. Other physical properties, closely related with the mechanical properties of the stone, are porosity, attenuation and propagation velocity of ultrasonic waves in the material. All exhibit considerable changes with temperature.

Social determinants of sexual satisfaction in Spain considered from the gender perspective

Aims: To describe gender- and social class-related inequalities in sexual satisfaction and analyze their relationship with self-perceived health status. Methods: This population-based, cross-sectional study included 7384 sexually active people aged 16 years and over residing in Spain in 2009 (3951 men and 3433 women). The explanatory variables were gender, age, social class, share in performing domestic tasks, spend time looking after oneself, collaborate economically in supporting the family, caring for children, self-perceived health status, and the desire to increase or decrease frequency of having sexual relations. Bivariate and multivariate logistic regression models were fitted. Results: Among women, sexual satisfaction declines progressively after age 45. Sexual satisfaction is 1.7 times higher among women who look after themselves and who feel good compared with those who do not. The odds of wanting to increase sex is 3.3 times higher for women who are satisfied compared with women who desire a lower frequency of sexual intercourses; and good perceived health was associated with sexual satisfaction. In satisfied men, the corresponding odds is 1.9 times that of men desiring to reduce their frequency of sex. Conclusions: Gender and social class inequalities are found in sexual satisfaction. This is associated with perceived health status, adding evidence in support of the World Health Organization definition of sexual health.

Isometric strength of the upper extremities in Czech men older than 18 years

The aim of this study was to compare isometric strength of the upper extremities in a sample of men from the Czech republic (n=638). Only the dominant upper limb was tested. The examined subjects were 18 years old or older. The measured values (in kilograms) were obtained via hand-held dynamometry testing (a digital hand-held dynamometer). The results of the hand-held dynamometry testing were compared across six age categories (18-29, 30-39, 40-49.... 70+ years). It was found that isometric strength of the dominant upper limb in men increases up to the age group 30-39 years and then declines. The highest average value (55.6 kg) was found in the age group 30-39 years, and expectably, the lowest values (34.4 kg) were documented in the age category 70+ years. The largest decline in isometric strength (-8.8 kg) was found between the age groups 60-69 years and 70+ years.

Regional subsidence modelling in Murcia city (SE Spain) using 1-D vertical finite element analysis and 2-D interpolation of ground surface displacements

Subsidence is a hazard that may have natural or anthropogenic origin causing important economic losses. The area of Murcia city (SE Spain) has been affected by subsidence due to groundwater overexploitation since the year 1992. The main observed historical piezometric level declines occurred in the periods 1982–1984, 1992–1995 and 2004–2008 and showed a close correlation with the temporal evolution of ground displacements. Since 2008, the pressure recovery in the aquifer has led to an uplift of the ground surface that has been detected by the extensometers. In the present work an elastic hydro-mechanical finite element code has been used to compute the subsidence time series for 24 geotechnical boreholes, prescribing the measured groundwater table evolution. The achieved results have been compared with the displacements estimated through an advanced DInSAR technique and measured by the extensometers. These spatio-temporal comparisons have showed that, in spite of the limited geomechanical data available, the model has turned out to satisfactorily reproduce the subsidence phenomenon affecting Murcia City. The model will allow the prediction of future induced deformations and the consequences of any piezometric level variation in the study area.