Electrochemical behaviour of different redox probes on single wall carbon nanotube buckypaper-modified electrodes

In the present work, the electrochemical properties of single-walled carbon nanotube buckypapers (BPs) were examined in terms of carbon nanotubes nature and preparation conditions. The performance of the different free-standing single wall carbon nanotube sheets was evaluated via cyclic voltammetry of several redox probes in aqueous electrolyte. Significant differences are observed in the electron transfer kinetics of the buckypaper-modified electrodes for both the outer- and inner-sphere redox systems. These differences can be ascribed to the nature of the carbon nanotubes (nanotube diameter, chirality and aspect ratio), surface oxidation degree and type of functionalities. In the case of dopamine, ferrocene/ferrocenium, and quinone/hydroquinone redox systems the voltammetric response should be thought as a complex contribution of different tips and sidewall domains which act as mediators for the electron transfer between the adsorbate species and the molecules in solution. In the other redox systems only nanotube ends are active sites for the electron transfer. It is also interesting to point out that a higher electroactive surface area not always lead to an improvement in the electron transfer rate of various redox systems. In addition, the current densities produced by the redox reactions studied here are high enough to ensure a proper electrochemical signal, which enables the use of BPs in sensing devices.

Single wall carbon nanotubes loaded with Pd and NiPd nanoparticles for H2 sensing at room temperature

Pd and bimetallic Ni50Pd50 nanoparticles protected by polyvinylpyrrolidone (PVP) have been synthesized by the reduction-by-solvent method and deposited on single wall carbon nanotubes (SWCNTs) to be tested as H2 sensors. The SWCNTs were deposited by drop casting from different suspensions. The Pd nanoparticles-based sensors show a very reproducible performance with good sensitivity and very low response times (few seconds) for different H2 concentrations, ranging from 0.2% to 5% vol. H2 in air at atmospheric pressure. The influence of the metal nanoparticle composition, the quality of SWCNTs suspension and the metal loading have been studied, observing that all these parameters play an important role in the H2 sensor performance. Evidence for water formation during the H2 detection on Pd nanoparticles has been found, and its repercussion on the behaviour of the assembled sensors is discussed. The sensor preparation procedure detailed in this work has proven to be simple and reproducible to prepare cost-effective and highly efficient H2 sensors that perform very well under real application conditions.

Growing Neural Gas approach for obtaining homogeneous maps by restricting the insertion of new nodes

The Growing Neural Gas model is used widely in artificial neural networks. However, its application is limited in some contexts by the proliferation of nodes in dense areas of the input space. In this study, we introduce some modifications to address this problem by imposing three restrictions on the insertion of new nodes. Each restriction aims to maintain the homogeneous values of selected criteria. One criterion is related to the square error of classification and an alternative approach is proposed for avoiding additional computational costs. Three parameters are added that allow the regulation of the restriction criteria. The resulting algorithm allows models to be obtained that suit specific needs by specifying meaningful parameters.

Electrospinning of silica sub-microtubes mats with platinum nanoparticles for NO catalytic reduction

Silica sub-microtubes loaded with platinum nanoparticles have been prepared in flexible non-woven mats using co-axial electrospinning technique. A partially gelated sol made from tetraethyl orthosilicate was used as the silica precursor, and oil was used as the sacrificial template for the hollow channel generation. Platinum has been supported on the wall of the tubes just adding the metallic precursor to the sol–gel, thus obtaining the supported catalyst by one-pot method. The silica tubes have a high aspect ratio with external/internal diameters of 400/200 nm and well-dispersed platinum nanoparticles of around 2 nm. This catalyst showed a high NO conversion with very high selectivity to N2 at mild conditions in the presence of excess oxygen when using C3H6 as reducing agent. This relevant result reveals the potential of this technique to produce nanostructured catalysts onto easy to handle conformations.

Technologies for Seduction: The “Espacio Doméstico” VideoArt Center in Blanca [EDOM]

Sustainability, understood in its beginnings as a common horizon for multiple practices and fields of study, has gradually given way to the development of increasingly sophisticated tools, with distinct dominant meanings established for each discipline. Within the field of material technologies for architectural production, sustainability seems to have found its most fertile ground in topics such as recycling, the use of "bio" materials, or energetic efficiency. However, to improve the understanding of the impact of technology on our ways of living, it appears increasingly necessary to move from the deterministic logic of sustainability into the relational domain of ecology, where the use and deployment of technologies can be observed through the multiplicity of its effects and the diversity of actors involved. In this paper we will address the case of the rehabilitation of several traditional houses located in the Murcian town of Blanca to host the “Espacio Doméstico” VideoArt Center (EDOM). In this action the selection and implementation of technologies have been aimed at impacting on diverse aspects including local communities, digital manufacturing, recycling, and policies regarding the rehabilitation of heritage buildings. While the initial approach was to address housing recovery as a heterogeneous accumulation of stories, technologies or material deployments of the domestic, our intervention strategies ascribed to the different technologies the role of mediating with existing elements through the incorporation of the very different visions of sustainability. Thus, we displayed artifacts produced by digitally manufactured methacrylate assembled on IKEA structures, fluorescent power lines supported by insulators on the wall, fluorescent tattoos on walls and ceilings that guide and extend the configuration of existing flooring, esparto furniture and fabrics produced by the esparto women workers’ and village women’s associations, re-appropriations of old furniture through the implementation of new media technologies, etc. If we can see seduction as the process of converting affinities and disagreements into affirmative communication, then the EDOM proposal can be seen as an active seduction process between technologies and users who approach this kind of cultural artifacts. Through these permanently active processes, art technologies will refer the viewer to complex sensory experiences, where a combination of parody, memory and sound pushes the user to the limit of mere comprehension of works of art. This more relational approach to the issue of heritage rehabilitation, technology or art institutions is offered as an area of controversy and debate on the scope of political ecology and its potential impact on the architect’s professional practice.