Estudio de la concentración de elementos traza tóxicos de los depósitos de lodos, los suelos y las plantas en Mina La Solana, Almería (España)

En ese trabajo se estudia la concentración de elementos traza tóxicos en los depósitos de lodos (relaves) abandonados por la industria minera en Almería (España), los suelos del entorno próximo y las plantas que los colonizan y representan una vía de incorporación de dichos elementos en la cadena trófica. La industria minera antigua dejó toda una serie de instalaciones abandonadas en diferentes zonas de Andalucía, entre las que destacan por presentar altos contenidos en metales, los depósitos de residuos en forma de lodos generados en el proceso de flotación. En este estudio se trata el caso concreto de los depósitos de lodos de Mina La Solana (Almócita, Almería), donde se ha realizado una caracterización geoquímica de los depósitos y de los suelos de su entorno, en función al contenido en algunos elementos traza. Se han caracterizado muestras de las plantas que enraízan en dichos residuos para determinar la concentración que presentan en los mismos elementos traza. Los resultados muestran que los lodos presentan altos contenidos en Pb (concentración media 6800 ppm) y Zn (concentración media 22 000 ppm). Estos elementos no aparecen en forma soluble en agua, los test de lixiviación dan valores de concentración muy bajos (≤10 ppm de Pb y ≤ 2 ppm de Zn). De la misma forma se ha determinado una concentración alta de los mismos elementos en los restos vegetales, con un valor del Pb hasta los 210 ppm y 1300 ppm de Zn. Este hecho pone de manifiesto la capacidad de las plantas para alterar la movilidad de los elementos presentes en el sustrato donde enraízan estableciéndose una transferencia hacia la cadena trófica.

Comparison among monitoring strategies to assess water flow dynamic and soil hydraulic properties in agricultural soils

Irrigated agriculture is usually performed in semi-arid regions despite scarcity of water resources. Therefore, optimal irrigation management by monitoring the soil is essential, and assessing soil hydraulic properties and water flow dynamics is presented as a first measure. For this purpose, the control of volumetric water content, θ, and pressure head, h, is required. This study adopted two types of monitoring strategies in the same experimental plot to control θ and h in the vadose zone: i) non-automatic and more time-consuming; ii) automatic connected to a datalogger. Water flux was modelled with Hydrus-1D using the data collected from both acquisition strategies independently (3820 daily values for the automatic; less than 1000 for the non-automatic). Goodness-of-fit results reported a better adjustment in case of automatic sensors. Both model outputs adequately predicted the general trend of θ and h, but with slight differences in computed annual drainage (711 mm and 774 mm). Soil hydraulic properties were inversely estimated from both data acquisition systems. Major differences were obtained in the saturated volumetric water content, θs, and the n and α van Genuchten model shape parameters. Saturated hydraulic conductivity, Ks, shown lower variability with a coefficient of variation range from 0.13 to 0.24 for the soil layers defined. Soil hydraulic properties were better assessed through automatic data acquisition as data variability was lower and accuracy was higher.

A simple method to predict elastic settlements in foundations resting on two soils of differing deformability

This paper shows the analysis results obtained from more than 200 finite element method (FEM) models used to calculate the settlement of a foundation resting on two soils of differing deformability. The analysis considers such different parameters as the foundation geometry, the percentage of each soil in contact with the foundation base and the ratio of the soils’ elastic moduli. From the described analysis, it is concluded that the maximum settlement of the foundation, calculated by assuming that the foundation is completely resting on the most deformable soil, can be correlated with the settlement calculated by FEM models through a correction coefficient named “settlement reduction factor” (α). As a consequence, a novel expression is proposed for calculating the real settlement of a foundation resting on two soils of different deformability with maximum errors lower than 1.57%, as demonstrated by the statistical analysis carried out. A guide for the application of the proposed simple method is also explained in the paper. Finally, the proposed methodology has been validated using settlement data from an instrumented foundation, indicating that this is a simple, reliable and quick method which allows the computation of the maximum elastic settlement of a raft foundation, evaluates its suitability and optimises its selection process.