Assessment of CO2 adsorption capacity on activated carbons by a combination of batch and dynamic tests

In this work, batch and dynamic adsorption tests are coupled for an accurate evaluation of CO2 adsorption performance for three different activated carbons obtained from olives stones by chemical activation followed by physical activation with CO2 at varying times, i.e. 20, 40 and 60 h. Kinetic and thermodynamic CO2 adsorption tests from simulated flue-gas at different temperature and CO2 pressure are carried out both in batch (a manometric equipment operating with pure CO2) and dynamic (a lab-scale fixed-bed column operating with CO2/N2 mixture) conditions. The textural characterization of the activated carbon samples shows a direct dependence of both micropore and ultramicropore volume on the activation time, hence AC60 has the higher contribution. The adsorption tests conducted at 273 and 293 K showed that, when CO2 pressure is lower than 0.3 bar, the lower the activation time the higher CO2 adsorption capacity and a ranking ωeq(AC20)>ωeq(AC40)>ωeq(AC60) can be exactly defined when T= 293 K. This result can be likely ascribed to a narrower pore size distribution of the AC20 sample, whose smaller pores are more effective for CO2 capture at higher temperature and lower CO2 pressure, the latter representing operating conditions of major interest for decarbonation of a flue-gas effluent. Moreover, the experimental results obtained from dynamic tests confirm the results derived from the batch tests in terms of CO2 adsorption capacity. It is important to highlight that the adsorption of N2 on the synthesized AC samples can be considered negligible. Finally, the importance of a proper analysis of characterization data and adsorption experimental results is highlighted for a correct assessment of CO2 removal performances of activated carbons at different CO2 pressure and operating temperature.

Self-rated health and hospital services use in the Spanish National Health System: a longitudinal study

Background: Self-rated health is a subjective measure that has been related to indicators such as mortality, morbidity, functional capacity, and the use of health services. In Spain, there are few longitudinal studies associating self-rated health with hospital services use. The purpose of this study is to analyze the association between self-rated health and socioeconomic, demographic, and health variables, and the use of hospital services among the general population in the Region of Valencia, Spain. Methods: Longitudinal study of 5,275 adults who were included in the 2005 Region of Valencia Health Survey and linked to the Minimum Hospital Data Set between 2006 and 2009. Logistic regression models were used to calculate the odds ratios between use of hospital services and self-rated health, sex, age, educational level, employment status, income, country of birth, chronic conditions, disability and previous use of hospital services. Results: By the end of a 4-year follow-up period, 1,184 participants (22.4 %) had used hospital services. Use of hospital services was associated with poor self-rated health among both men and women. In men, it was also associated with unemployment, low income, and the presence of a chronic disease. In women, it was associated with low educational level, the presence of a disability, previous hospital services use, and the presence of chronic disease. Interactions were detected between self-rated health and chronic disease in men and between self-rated health and educational level in women. Conclusions: Self-rated health acts as a predictor of hospital services use. Various health and socioeconomic variables provide additional predictive capacity. Interactions were detected between self-rated health and other variables that may reflect different complex predictive models, by gender.

Ammonia removal using activated carbons: effect of the surface chemistry in dry and moist conditions

The effect of surface chemistry (nature and amount of oxygen groups) in the removal of ammonia was studied using a modified resin-based activated carbon. NH3 breakthrough column experiments show that the modification of the original activated carbon with nitric acid, that is, the incorporation of oxygen surface groups, highly improves the adsorption behavior at room temperature. Apparently, there is a linear relationship between the total adsorption capacity and the amount of the more acidic and less stable oxygen surface groups. Similar experiments using moist air clearly show that the effect of humidity highly depends on the surface chemistry of the carbon used. Moisture highly improves the adsorption behavior for samples with a low concentration of oxygen functionalities, probably due to the preferential adsorption of ammonia via dissolution into water. On the contrary, moisture exhibits a small effect on samples with a rich surface chemistry due to the preferential adsorption pathway via Brønsted and Lewis acid centers from the carbon surface. FTIR analyses of the exhausted oxidized samples confirm both the formation of NH4+ species interacting with the Brønsted acid sites, together with the presence of NH3 species coordinated, through the lone pair electron, to Lewis acid sites on the graphene layers.

An improved procedure for obtaining and maintaining well characterized partial water saturation states on concrete samples to be used for mass transport tests

A conditioning procedure is proposed allowing to install into the concrete specimens any selected value of water saturation degree with homogeneous moisture distribution. This is achieved within the least time and the minimum alteration of the concrete specimens. The protocol has the following steps: obtaining basic drying data at 50 °C (water absorption capacity and drying curves); unidirectional drying of the specimens at 50 °C until reaching the target saturation degree values; redistribution phase in closed containers at 50 °C (with measurement of the quasi-equilibrium relative humidities); storage into controlled environment chambers until and during mass transport tests, if necessary. A water transport model is used to derive transport parameters of the tested materials from the drying data, i.e., relative permeabilities and apparent water diffusion coefficients. The model also allows calculating moisture profiles during isothermal drying and redistribution phases, thus allowing optimization of the redistribution times for obtaining homogeneous moisture distributions.

Self-rated health and mortality: a follow-up study of a Spanish population

Objectives: Self-rated health (SRH) is known to be a valid indicator for the prediction of health outcomes. The aims of this study were to describe and analyse the associations between SRH and health status, socio-economic and demographic characteristics; and between SRH and mortality in a Spanish population. Study design: Longitudinal study. Methods: A sample of 5275 adults (age ≥21 years) residing in the Valencian Community (Spanish Mediterranean region) was surveyed in 2005 and followed for four years. SRH was categorized into good and poor health. The response variable was mortality (dead/alive), obtained from the local mortality register. Logistic regression models were adjusted in order to analyse the associations between SRH and health status, socio-economic and demographic characteristics; odds ratios were calculated to measure the associations. Poisson regression models were adjusted in order to analyse the associations between mortality and explanatory variables; the relative risk of death was calculated to measure the associations. Results: Poor SRH was reported by 25.9% of respondents, and the mortality rate after four years of follow-up was 3.6%. An association was found between SRH and the presence of chronic disease and disability in men and women. A perception of poor health vs good health led to a mortality risk of 3.0 in men and 2.7 in women. SRH was predictive of mortality, even after adjusting for all other variables. In men and women, the presence of disability provided additional predictive ability. Conclusions: SRH was predictive of mortality in both men and women, and acted as a mediator between socio-economic, demographic and health conditions and mortality.

Empoderamiento y discapacidad, factores moduladores del desarrollo de esta potencialidad

Introducción. El desarrollo del empoderamiento implica la posesión de múltiples habilidades que ayudan a las personas a afrontar la adversidad, por lo que el desarrollo de esta capacidad puede ser prioritario entre estas personas para mejorar su calidad de vida. Objetivos. Los objetivos del estudio analizan la capacidad de empoderamiento de un grupo de jóvenes con discapacidad en función de la tipología y etapa en la que se adquiere la discapacidad. Metodología. Participaron 98 jóvenes con diferentes tipos de discapacidad (física, intelectual, visual y auditiva). Contestaron la versión española adaptada de la Escala de Rogers, Chamberlin, Ellison y Crean (1997) diseñada para medir esta capacidad. Resultados. Los análisis indicaron altos niveles de esta capacidad entre los jóvenes observándose en mayor medida en las personas con discapacidad sobrevenida, así como en la discapacidad motora y visual. Conclusiones. Esto nos sugiere que esta capacidad puede variar y evolucionar, de ahí la importancia de fomentarla en programas de intervención-acción.