Thermogravimetric analysis of the pyrolysis of several materials used in the preparation of commercial cigarettes

Comunicación presentada en forma de póster en el "12th Mediterranean Congress of Chemical Engineering", Barcelona (Spain), November 15-18, 2011

Catalytic effect of MCM-41 in the pyrolysis of tobacco and several substances used as additives in the preparation of commercial cigarettes

Comunicación presentada en forma de póster en el "12th Mediterranean Congress of Chemical Engineering", Barcelona (Spain), November 15-18, 2011.

Ultrafast coherent spectroscopy of the Fermi edge singularity

Paper submitted to the XVI Sitges Conference on Statistical Mechanics, Sitges, Barcelona, Spain, 7-11 June 1999.

A neural network algorithm to simplify 2D meshes

In this paper we propose a neural network model to simplify and 2D meshes. This model is based on the Growing Neural Gas model and is able to simplify any mesh with different topologies and sizes. A triangulation process is included with the objective to reconstruct the mesh. This model is applied to some problems related to urban networks.

Fate and Transport of Naproxen in a Sandy Aquifer Material: Saturated Column Studies and Model Evaluation

Naproxen-C14H14O3 is a nonsteroidal anti-inflammatory drug which has been found at detectable concentrations in wastewater, surface water, and groundwater. Naproxen is relatively hydrophilic and is in anionic form at pH between 6 and 8. In this study, column experiments were performed using an unconsolidated aquifer material from an area near Barcelona (Spain) to assess transport and reaction mechanisms of Naproxen in the aquifer matrix under different pore water fluxes. Results were evaluated using HYDRUS-1D, which was used to estimate transport parameters. Batch sorption isotherms for Naproxen conformed with the linear model with a sorption coefficient of 0.42 (cm3 g−1), suggesting a low sorption affinity. Naproxen breakthrough curves (BTCs) measured in soil columns under steady-state, saturated water flow conditions displayed similar behavior, with no apparent hysteresis in sorption or dependence of retardation (R, 3.85-4.24) on pore water velocities. Soil sorption did not show any significant decrease for increasing flow rates, as observed from Naproxen recovery in the effluent. Sorption parameters estimated by the model suggest that Naproxen has a low sorption affinity to aquifer matrix. Most sorption of Naproxen occurred on the instantaneous sorption sites, with the kinetic sorption sites representing only about 10 to 40% of total sorption.

Willingness Towards Continuous Assessment

Among the factors that affect the convergence towards the European Higher Education Area, university teaching staff's motivation is fundamental, and consequently, it is crucial to empirically know what this motivation depends on. In this context, one of the most relevant changes in the teacher-student relationship is assessment. In fact, the transition from a static assessment -focused on only one temporal point (final exam)- to a dynamic assessment, will require changes in thought and action, both on the part of teachers and students. In this line, the objective of this paper is to analyze the determinants of teaching staff's predisposition to the continuous assessment method. Specifically, we consider the following explanatory dimensions: teaching method used (which measures their degree of involvement with the ongoing adaptation process), type of subject (core, compulsory and optional), and teacher's personal characteristics (professional status and gender). The empirical application carried out at the University of Alicante uses Logit Models with Random Coefficients to capture heterogeneity, and shows that "cooperative learning" is a clear-cut determinant of "continuous assessment" as well as "continuous assessment plus final examination". Also, a conspicuous result, which in turn becomes a thought-provoking finding, is that professional status is highly relevant as a teacher's engagement is closely related to prospects of stability. Consequently, the most relevant implications from the results revolve around the way academic institutions can propose and implement inducement for their teaching staff.

3D teaching: the ideal complement for professionals in design and construction

Today, the requirement of professional skills to university students is constantly increasing in our society. In our opinion, the content offered in official degrees need to be nourished with different variables, enriching their global professional knowledge in a parallel way; that is why, in recent years, there is a great multiplicity of complementary courses at university. One of the most socially demanded technical requirements within the architectural, design or engineering field is the management of 3D drawing software, becoming an indispensable reality in these sectors. Thus, this specific training becomes essential over two-dimension traditional design, because the inclusion of great possibilities of spatial development that go beyond conventional orthographic projections (plans, sections or elevations), allowing modelling and rotation of the selected items from multiple angles and perspectives. Therefore, this paper analyzes the teaching methodology of a complementary course for those technicians in the construction industry interested in computer-aided design, using modelling (SketchupMake) and rendering programs (Kerkythea). The course is developed from the technician point of view, by learning computer management and its application to professional development from a more general to a more specific view through practical examples. The proposed methodology is based on the development of real examples in different professional environments such as rehabilitation, new constructions, opening projects or architectural design. This multidisciplinary contribution improves criticism of students in different areas, encouraging new learning strategies and the independent development of three-dimensional solutions. Thus, the practical implementation of new situations, even suggested by the students themselves, ensures active participation, saving time during the design process and the increase of effectiveness when generating elements which may be represented, moved or virtually tested. In conclusion, this teaching-learning methodology improves the skills and competencies of students to face the growing professional demands of society. After finishing the course, technicians not only improved their expertise in the field of drawing but they also enhanced their capacity for spatial vision; both essential qualities in these sectors that can be applied to their professional development with great success.

Controversy between curriculum design and curriculum development of online "highly specialized" education in the field of construction

Nowadays, on a global level, the Higher Education System has a complex and broad horizon of curricular tools to use in the teaching and learning process. In addition to these new educational instruments, full of possibilities, we face specific socio-economic conditions that affect in a significantly way the Curriculum Development in certain knowledge areas (areas traditionally built on a methodology based on a physical presence of students in the classroom). Some areas such as Restoration, Rehabilitation or Construction Pathologies, and the construction sector in general, require very defined and particular knowledge that only a small number of experts claim as specialized training. All these aspects condition the teaching methodology performed in a physical classroom at a university campus (the only option used until recent years) and made us consider the integration of online teaching in these areas too. The present work shows the teaching methodology used for the development of two online courses, where we offer distance learning for "highly specialized" formation in the Edification area (an area where traditionally there was only classroom training). At the beginning, both courses were designed by classroom training, but got a really small number of applications due to the specialized topic proposed. Later, we proposed a "Curriculum Redesign" of the contents, offering an online modality, which implied a significant demand both within and outside the university area. A notable feature of this educational experience is the great spectrum opened for attendees of both courses in the online version. This situation improved significantly the "Curriculum Development" for the student and implied an interesting new proposal on the offered contents and materials (what would have been really difficult to get in a face to face classroom). In conclusion, the absence of certain types of specialized contents in the academic university curricula makes essential to raise new methodologies to save the gap in this area through additional training courses as those analyzed in this paper. Thus, our experience opens a debate on the appropriateness of implementing online training in relation to the face to face training in constructive content subjects and, especially, presents a new scheme, not without controversy, for the curriculum design.

Teaching-learning process of historical heritage: a Journey as a beginning, path and end

The implantation of new university degrees within the European Higher Education Area implies the need of innovative methodologies in teaching and learning to improve the skills and competencies of students and to answer the growing needs that society continuously demands to heritage management experts. The present work shows an application of the teaching methodology proposed during the international workshop entitled “I International Planning Preservation Workshop. Learning from Al Andalus”, which included the participation of the University of Alicante and Granada, Università Politecnico di Milano and Hunter College City University of New York; where we tried to dissolve traditional boundaries derived of interuniversity cooperation programs. The main objective of the workshop was to discuss and debate the role of urban Historical Centers within the Global Heritage by the integrated work through multidisciplinary teams and the creation of a permanent international working group between these universities to both teach and research. The methodology of this workshop was very participatory and considered the idea of a new learning process generated by "a journey experience." A trip from global to local (from the big city to the small village) but also a trip from the local (historical) part of a big city to the global dimension of contemporary historical villages identified by the students through a system of exhibition panels in affinity groups, specific projects proposed by lecturers and teachers or the generation of publications in various areas (texts, photographs, videos, etc.). So, the participation of the students in this multidisciplinary meeting has enhanced their capacity for self-criticism in several disciplines and has promoted their ability to perform learning and research strategies in an autonomous way. As a result, it has been established a permanent international work structure for the development of projects of the Historical City. This relationship has generated the publication of several books whose contents have reflected the conclusions developed in the workshop and several teaching proposals shared between those institutions. All these aspects have generated a new way of understanding the teaching process through a journey, in order to study the representative role of university in the historical heritage and to make students (from planning, heritage management, architecture, geography, sociology, history or engineering areas) be compromised on searching strategies for sustainable development in the Contemporary City.

Construction of Structures I in Moodle: a new teaching methodology in the Degree of Building Engineer

The subject of Construction of Structures I studies, from a constructive point of view and taking into account current legislation, reinforced concrete structures used in buildings, through the acquisition of knowledge and construction criteria required in the profession of a Technical Architect. The contents acquired in this course are essential for further professional development of technicians and are closely related to many of the subjects taught in the same or other courses of the Degree in Technical Architecture at the University of Alicante. The aim of this paper is to present, analyze and discuss the development of a new methodology proposed in the mentioned subject, as it supposed an important change in the traditional way of teaching Construction and Structures I. In order to incorporate new teaching tools in 2013-2014, the course has been implemented by using a Moodle software tool to promote blended learning with online exercises. Our Moodle community allows collaborative work within an open-source platform where teachers and students share a new and personalized learning environment. Students are easily used to the interface and the platform, value the constant connection with teachers or other fellows and completely agree with the possibility of making questions or share documents 24 hours a day. The proposed methodology consists of lectures and practical classes. In the lectures, the basics of each topic are discussed; class attendance, daily study and conducting scheduled exercises are indispensable. Practical classes allow to consolidate the knowledge gained in theory classes by solving professional exercises and actual construction problems related to structures, that shall be compulsorily delivered online. So, after the correction of the teacher and the subsequent feedback of students, practical exercises ensure lifelong learning of the student, who can download any kind of material at any time (constructive details, practical exercises and even corrected exams). Regarding the general evaluation system, goals achievement is assessed on an ongoing basis (65% of the final mark) along the course through written and graphic evidences in person and online, as well as a individual development of a workbook. In all cases, the acquisition of skills, the ability to synthesize, the capacity of logical and critical thinking are assessed. The other 35 % of the mark is evaluated by a complementary graphic exam. Participation in the computing platform is essential and the student is required to do and present, at least 90% of the practices proposed. Those who do not comply with the practices in each specific date could not be assessed continuously and may only choose the final exam. In conclusion, the subject of Construction of Structures I is essential in the development of the regulated profession of Technical Architect as they are considered, among other professional profiles, as specialists in construction of building structures. The use of a new communication platform and online teaching allows the acquisition of knowledge and constructive approaches in a continuous way, with a more direct and personal monitoring by the teacher that has been highly appreciated by almost 100% of the students. Ultimately, it is important to say that the use of Moodle in this subject is a very interesting tool, which was really well welcome by students in one of the densest and important subjects of the Degree of Technical Architecture.

Efectos del cambio climático y usos del suelo sobre los recursos hídricos de la cuenca del río Tordera (Barcelona, España)

Se presentan los efectos del cambio global en la cuenca del río Tordera (España) para el periodo 2000-2050, escenarios climáticos A2 (medio-alto) definidos por el Panel Intergubernamental del Cambio Climático (IPCC, 200) y escenarios socioeconómicos (cambios previstos en la cuenca) denominados estable y tendencial. Los efectos sobre los recursos hídricos se han analizado de forma conjunta superficial-subterránea mediante una metodológica de tipo acoplado. Para establecer los impactos futuros sobre los recursos hídricos se ha seleccionado el Modelo de Circulación Global ECHAM5 (Max Planck Institute). Los resultados obtenidos indican una disminución de la precipitación del 11.3% y un aumento de la temperatura de 1ºC, respecto a los valores históricos de la zona. De acuerdo a la proyección futura (2050) sobre cambios en los recursos hídricos, la escorrentía superficial obtenida mediante simulación con el código HEC-HMS 3.4 experimenta una reducción del 31.8% respecto al valor histórico y la recarga natural, estimada mediante VISUAL-Balan, se reduce en un 11.7%. El balance en el acuífero deltaico simulado mediante MODFLOW 2009.1 Pro muestra igualmente una disminución de los parámetros del balance. Los cambios del uso del suelo previstos de acuerdo a la legislación vigente (escenarios socioeconómicos) no conducen a la generación de un impacto apreciable en los recursos hídricos; según los escenarios definidos la variación de precipitación y temperatura son los parámetros fundamentales del cambio previsto.