Measurement of wide frequency range structural microvibrations with a pocket digital camera and sub-pixel techniques

Analysis of vibrations and displacements is a hot topic in structural engineering. Although there is a wide variety of methods for vibration analysis, direct measurement of displacements in the mid and high frequency range is not well solved and accurate devices tend to be very expensive. Low-cost systems can be achieved by applying adequate image processing algorithms. In this paper, we propose the use of a commercial pocket digital camera, which is able to register more than 420 frames per second (fps) at low resolution, for accurate measuring of small vibrations and displacements. The method is based on tracking elliptical targets with sub-pixel accuracy. Our proposal is demonstrated at a 10 m distance with a spatial resolution of 0.15 mm. A practical application over a simple structure is given, and the main parameters of an attenuated movement of a steel column after an impulsive impact are determined with a spatial accuracy of 4 µm.

Forensic analysis of buildings affected by mining subsidence based on Differential Interferometry (Part III)

This work presents a forensic analysis of buildings affected by mining subsidence, which is based on deformation data obtained by Differential Interferometry (DInSAR). The proposed test site is La Union village (Murcia, SE Spain) where subsidence was triggered in an industrial area due to the collapse of abandoned underground mining labours occurred in 1998. In the first part of this work the study area was introduced, describing the spatial and temporal evolution of ground subsidence, through the elaboration of a cracks map on the buildings located within the affected area. In the second part, the evolution of the most significant cracks found in the most damaged buildings was monitored using biaxial extensometric units and inclinometers. This article describes the work performed in the third part, where DInSAR processing of satellite radar data, available between 1998 and 2008, has permitted to determine the spatial and temporal evolution of the deformation of all the buildings of the study area in a period when no continuous in situ instrumental data is available. Additionally, the comparison of these results with the forensic data gathered in the 2005–2008 period, reveal that there is a coincidence between damaged buildings, buildings where extensometers register significant movements of cracks, and buildings deformation estimated from radar data. As a result, it has been demonstrated that the integration of DInSAR data into forensic analysis methodologies contributes to improve significantly the assessment of the damages of buildings affected by mining subsidence.

Temas de Química General para ITOP e ICCP

Libro de apuntes de Química (I) en Ing. de Obras Públicas.

El plan global frente al riesgo de inundación en la ribera del Júcar

El Plan Global del Júcar frente al riesgo de inundación pretende minimizar los daños causados por las avenidas que periódicamente afectan a la Ribera del Júcar. En el presente artículo se describen y analizan las actuaciones de este Plan, la génesis del mismo, el proceso de elaboración y sus resultados. La problemática es compleja, ya que el riesgo de inundación abarca un territorio muy poblado, con un importante desarrollo industrial y agrícola. Además, la existencia de espacios naturales de elevado valor ambiental, hace que las intervenciones derivadas del Plan consideren al mismo nivel la defensa frente a avenidas y las demandas sociales y ambientales, tras el consenso alcanzado en un proceso de participación pública. El Plan incorpora aspectos innovadores en ingeniería hidráulica, cuyo resultado es una actuación integrada y sostenible, que compatibiliza la protección frente a avenidas con la recuperación y mejora del ámbito fluvial, y su función como corredor vertebrador del territorio.

Temas de Química (II) para alumnos de ITOP e ICCP

Temas de Química (II) para ITOP e ICCP.

Resolution limits to object tracking with subpixel accuracy

Subpixel methods increase the accuracy and efficiency of image detectors, processing units, and algorithms and provide very cost-effective systems for object tracking. Published methods achieve resolution increases up to three orders of magnitude. In this Letter, we demonstrate that this limit can be theoretically improved by several orders of magnitude, permitting micropixel and submicropixel accuracies. The necessary condition for movement detection is that one single pixel changes its status. We show that an appropriate target design increases the probability of a pixel change for arbitrarily small shifts, thus increasing the detection accuracy of a tracking system. The proposal does not impose severe restriction on the target nor on the sensor, thus allowing easy experimental implementation.

Dynamic investigation of an ancient masonry bell tower with operational modal analysis: a non-destructive experimental technique to obtain the dynamic characteristics of a structure

This paper shows the results of an experimental analysis on the bell tower of “Chiesa della Maddalena” (Mola di Bari, Italy), to better understand the structural behavior of slender masonry structures. The research aims to calibrate a numerical model by means of the Operational Modal Analysis (OMA) method. In this way realistic conclusions about the dynamic behavior of the structure are obtained. The choice of using an OMA derives from the necessity to know the modal parameters of a structure with a non-destructive testing, especially in case of cultural-historical value structures. Therefore by means of an easy and accurate process, it is possible to acquire in-situ environmental vibrations. The data collected are very important to estimate the mode shapes, the natural frequencies and the damping ratios of the structure. To analyze the data obtained from the monitoring, the Peak Picking method has been applied to the Fast Fourier Transforms (FFT) of the signals in order to identify the values of the effective natural frequencies and damping factors of the structure. The main frequencies and the damping ratios have been determined from measurements at some relevant locations. The responses have been then extrapolated and extended to the entire tower through a 3-D Finite Element Model. In this way, knowing the modes of vibration, it has been possible to understand the overall dynamic behavior of the structure.

Apuntes de Hormigón Armado. Adaptados a la Instrucción EHE-08

Este libro de "Apuntes de Hormigón Armado" desarrolla los contenidos relacionados con el cálculo y comprobación de estructuras de edificación convencionales construidas en hormigón armado. Incluye los Estados Límite Últimos (piezas flectadas y flexo-comprimidas, cortante y punzonamiento, inestabilidad en pilares, redistribución limitada de momentos), Estados Límite de Servicio (fisuración y deformaciones instantáneas y diferidas), disposiciones constructivas de armaduras longitudinales y tangenciales y cálculo de elementos de cimentación y contención. La norma de referencia es la Instrucción Española de Hormigón Estructural, EHE-08, aunque también se reseña puntualmente el Eurocódigo 2.

Estructuras Metálicas. Presentaciones (curso 2012-2013)

Presentaciones de los temas que integran los contenidos de la asignatura "Estructuras Metálicas" impartidas en las titulaciones de Ing. Técnica de Obras Públicas y en el Grado en Ing. Civil.

Estructuras Metálicas. Material de apoyo (curso 2012-2013)

Material de apoyo de la asignatura "Estructuras Metálicas": prontuario de vigas y coeficientes de pandeo.

Estructuras Metálicas. Problemas (curso 2012-2013)

Colección de problemas de la asignatura "Estructuras Metálicas" correspondientes a los estudios de Ing. Técnica de Obras Públicas y Grado en Ingeniería Civil.

Hormigón Armado y Pretensado. Presentaciones (curso 2011-2012)

Presentaciones de los temas que integran los contenidos de la asignatura "Hormigón Armado y Pretensado", impartida en las titulaciones de Ingeniería Técnica de Obras Públicas, Ingeniería Geológica y Grado en Ing. Civil.

Estructuras de Hormigón Armado y Pretensado. Prácticas de autoevaluación (curso 2011-2012)

Supuestos prácticos de autoevaluación de la asignatura "Estructuras de Hormigón Armado y Pretensado".