Sources and transport of surface sediment and metals in B.C. fjord, Tahsis Inlet

Senior thesis written for Oceanography 445

Oxygen and hydrogen sulfide concentration of Nootka Sound bottom water

Senior thesis written for Oceanography 445

The Mineralogy and Strength Characteristics of Selected Glaciolacustrine Clays in the Puget Sound Region

The combination of rainy climate, glaciolacustrine clays, and steep topography of the Puget Lowland creates slope stability issues for the regional population. Several glaciolacustrine deposits of laminated silt and clay of different ages contribute to the likelihood of slope failure. The glaciolacustrine deposits are generally wet, range in thickness from absent to >30m, and consist of laminated silt and clay with sand interbeds at the tops and bottoms, sandy laminae throughout the deposits, occasional dropstones and shear zones. The glaciolacustrine deposits destabilize slopes by 1) impeding groundwater flow percolating through overlying glacial outwash sediments, 2) having sandy laminae that lower strength by increasing pore pressure during wet seasons, and 3) increasing the potential for block-style failure because of secondary groundwater pathways such as laminae and vertical fractures. Eight clay samples from six known landslide deposits were analyzed in this study for their mineralogy, clay fraction and strength characteristics. The mineralogy was determined using X-ray Diffractometry (XRD) which revealed an identical mineralogic suite among all eight samples consisting of chlorite, illite and smectite. Nonclay minerals appearing in the X-ray diffractogram include amphibole and plagioclase after removal of abundant quartz grains. Hydrometer tests yielded clay-size fraction percentages of the samples ranging from 10% to 90%, and ring shear tests showed that the angle of residual shear resistance (phi_r) ranged from 11° to 31°. Atterberg limits of the samples were found to have liquid limits ranging from 33 to 83, with plastic limits ranging from 25 to 35 and plasticity indices ranging from 6 to 48. The results of the hydrometer and residual shear strength tests suggest that phi_r varies inversely with the clay-size fraction, but that this relationship was not consistent among all eight samples. The nature of the XRD analysis only revealed the identity of the clay minerals present in the samples, and provided no quantitative information. Thus, the extent to which the mineralogy influenced the strength variability among the samples cannot be determined given that the mineral assemblages are identical. Additional samples from different locations within each deposit along with quantitative compositional analyses would be necessary to properly account for the observed strength variability.

Determining Spatial Distribution and Physical Properties of the Vashon Advance Outwash near Mountlake Terrace, Washington

This study is aimed at determining the spatial distribution, physical properties, and groundwater conditions of the Vashon advance outwash (Qva) in the Mountlake Terrace, WA area. The Qva is correlative with the Esperance Sand, as defined at its type section; however, local variations in the Qva are not well-characterized (Mullineaux, 1965). While the Qva is a dense glacial unit with low compressibility and high frictional shear strength (Gurtowski and Boirum, 1989), the strength of this unit can be reduced when it becomes saturated (Tubbs, 1974). This can lead to caving or flowing in excavations, and on a larger scale, can lead to slope failures and mass-wasting when intersected by steep slopes. By studying the Qva, we can better predict how it will behave under certain conditions, which will be beneficial to geologists, hydrogeologists, engineers, and environmental scientists during site assessments and early phases of project planning. In this study, I use data from 27 geotechnical borings from previous field investigations and C-Tech Corporation’s EnterVol software to create three-dimensional models of the subsurface geology in the study area. These models made it possible to visualize the spatial distribution of the Qva in relation to other geologic units. I also conducted a comparative study between data from the borings and generalized published data on the spatial distribution, relative density, soil classification, grain-size distribution, moisture content, groundwater conditions, and aquifer properties of the Qva. I found that the elevation of the top of the Qva ranges from 247 to 477 ft. I found that the Qva is thickest where the modern topography is high, and is thinnest where the topography is low. The thickness of the Qva ranges from absent to 242 ft. Along the northern, east-west trending transect, the Qva thins to the east as it rises above a ridge composed of Pre- Vashon glacial deposits. Along the southern, east-west trending transect, the Qva pinches out against a ridge composed of pre-Vashon interglacial deposits. Two plausible explanations for this ridge are paleotopography and active faulting associated with the Southern Whidbey Fault Zone. Further investigations should be done using geophysical methods and the modeling methods described in this study to determine the nature of this ridge. The relative density of the Qva in the study area ranges from loose to very dense, with the loose end of the spectrum probably relating to heave in saturated sands. I found subtle correlations between density and depth. Volumetric analysis of the soil groups listed in the boring logs indicate that the Qva in the study area is composed of approximately 9.5% gravel, 89.3% sand, and 1.2% silt and clay. The natural moisture content ranges from 3.0 to 35.4% in select samples from the Qva. The moisture content appears to increase with depth and fines content. The water table in the study area ranges in elevation from 231.9 to 458 ft, based on observations and measurements recorded in the boring logs. The results from rising-head and falling-head slug tests done at a single well in the study area indicate that the geometric mean of hydraulic conductivity is 15.93 ft/d (5.62 x 10-03 cm/s), the storativity is 3.28x10-03, and the estimated transmissivity is 738.58 ft2/d in the vicinity of this observation well. At this location, there was 1.73 ft of seasonal variation in groundwater elevation between August 2014 and March 2015.

A comparison of landslide inventories along the shoreline of Steamboat Island Peninsula, Thurston County, WA: office based protocol vs. field based protocol

The mountain ranges and coastlines of Washington State have steep slopes, and they are susceptible to landslides triggered by intense rainstorms, rapid snow melts, earthquakes, and rivers and waves removing slope stability. Over a 30-year timespan (1984-2014 and includes State Route (SR) 530), a total of 28 deep-seated landslides caused 300 million dollars of damage and 45 deaths (DGER, 2015). During that same timeframe, ten storm events triggered shallow landslides and debris flows across the state, resulting in nine deaths (DGER, 2015). The loss of 43 people, due to the SR 530 complex reactivating and moving at a rate and distance unexpected to residents, highlighted the need for an inventory of the stateís landslides. With only 13% of the state mapped (Lombardo et al., 2015), the intention of this statewide inventory is to communicate hazards to citizens and decision makers. In order to compile an accurate and consistent landslide inventory, Washington needs to adopt a graphic information system (GIS) based mapping protocol. A mapping protocol provides consistency for measuring and recording information about landslides, including such information as the type of landslide, the material involved, and the size of the movement. The state of Oregon shares similar landslide problems as Washington, and it created a GIS-based mapping protocol designed to inform its residents, while also saving money and reducing costly hours in the field (Burns and Madin, 2009). In order to determine if the Oregon Department of Geology and Mineral Industries (DOGAMI) protocol, developed by Burns and Madin (2009), could serve as the basis for establishing Washingtonís protocol, I used the office-based DOGAMI protocol to map landslides along a 40-50 km (25-30 mile) shoreline in Thurston County, Washington. I then compared my results to the field-based landslide inventory created in 2009 by the Washington Division of Geology and Earth Resources (DGER) along this same shoreline. If the landslide area I mapped reasonably equaled the area of the DGER (2009) inventory, I would consider the DOGAMI protocol useful for Washington, too. Utilizing 1m resolution lidar flown for Thurston County in 2011 and a GIS platform, I mapped 36 landslide deposits and scarp flanks, covering a total area of 879,530 m2 (9,467,160 ft2). I also found 48 recent events within these deposits. With an exception of two slides, all of the movements occurred within the last fifty years. Along this same coastline, the DGER (2009) recorded 159 individual landslides and complexes, for a total area of 3,256,570 m2 (35,053,400 ft2). At a first glance it appears the DGER (2009) effort found a larger total number and total area of landslides. However, in addition to their field inventory, they digitized landslides previously mapped by other researchers, and they did not field confirm these landslides, which cover a total area of 2,093,860 m2 (22,538,150 ft2) (DGER, 2009). With this questionable landslide area removed and the toes and underwater landslides accounted for because I did not have a bathymetry dataset, my results are within 6,580 m2 (70,840 ft2) of the DGERís results. This similarity shows that the DOGAMI protocol provides a consistent and accurate approach to creating a landslide inventory. With a few additional modifications, I recommend that Washington State adopts the DOGAMI protocol. Acquiring additional 1m lidar and adopting a modified DOGAMI protocol poises the DGER to map the remaining 87% of the state, with an ultimate goal of informing citizens and decision makers of the locations and frequencies of landslide hazards on a user-friendly GIS platform.

Under the Bridge: Utilizing Covered Liminal Spaces for Sanctioned Homeless Encampments in the City of Seattle

Thesis (Master's)--University of Washington, 2016-06

Using the R package Shiny to create web applications that facilitate quantitative gene expression analysis

Thesis (Master's)--University of Washington, 2016-06

The Little Galaxies That Could Reionize the Universe

Thesis (Ph.D.)--University of Washington, 2016-08