Physical Characteristics and Estimated Hydraulic Conductivity from Grain-Size Distribution for Vashon Till, South-Central Puget Lowland, Washington

Population growth, urban development, and increased commercial and industrial activity in the south-central Puget Lowlands of Washington State has led to an increased demand for groundwater. The Vashon till is a glacially consolidated, low-permeability unit comprising unstratified clay, silt, cobbles and boulders with ubiquitous coarse-grained lenses and is an extensive surficial unit throughout the south-central Puget Lowland. Thus, understanding the physical and hydrological characteristics – specifically, the hydraulic conductivity – of this unit is a necessary component of a groundwater model. This study provides (1) a record of the physical characteristics of Vashon till deposits within the study area; and (2) an estimate of the highest, lowest, and average value of saturated hydraulic conductivity based on the grain-size distribution of Vashon till samples collected from six field sites in the Puyallup River Watershed. Analysis shows that the average moisture content ranges between about 1 and 6%, average dry bulk density is about 2.20 g/cm3, and average porosity is about 17%. Grain-size distributions show that half of the samples analyzed are well graded, while the other half is poorly graded. Grain-size distributions also show an average d10 value of about 0.20 mm, and average ff values ≤ 16%, which are key values in estimating the saturated hydraulic conductivity of over-consolidated glacial deposits. Based on these observed values, the estimates of hydraulic conductivity range from a minimum of 0.02 m/d to a maximum of 1.38 m/d in within the general Vashon till.

Geomorphic Impacts of the 2013 Colorado Front Range Flood on Black Canyon Creek and North Fork Big Thompson River

In September 2013, the Colorado Front Range experienced a five-day storm that brought record-breaking precipitation to the region. As a consequence, many Front Range streams experienced flooding, leading to erosion, debris flows, bank failures and channel incision. I compare the effects that debris flows and flooding have on the channel bar frequency, frequency and location of wood accumulation, and on the shape and size of the channel along two flood impacted reaches located near Estes Park and Glen Haven, Colorado within Rocky Mountain National Park and Arapaho-Roosevelt National Forest: Black Canyon Creek (BCC) and North Fork Big Thompson River (NFBT). The primary difference between the two study areas is that BCC was inundated by multiple debris flows, whereas NFBT only experienced flooding. Fieldwork consisted of recording location and size of large wood and channel bars and surveying reaches to produce cross-sections. Additional observations were made on bank failures in NFBT and the presence of boulders in channel bars in BCC to determine sediment source. The debris flow acted to scour and incise BCC causing long-term alteration. The post-flood channel cross-sectional area is as much as 7 to 23 times larger than the pre-flood channel, caused by the erosion of the channel bed to bedrock and the elimination of riparian vegetation. Large wood was forced out of the stream channel and deposited outside of the bankfull channel. Flooding in NFBT caused bank erosion and widening that contributed sediment to channel bars, but accomplished little stream-bed scour. As a result, there was relatively little damage to mid-channel and riparian vegetation, and most large wood remained within the wetted channel.