Beyond the sphere of the English facial approximation literature: Ramifications of German papers on western method concepts

In the English literature, facial approximation methods have been commonly classified into three types: Russian, American, or Combination. These categorizations are based on the protocols used, for example, whether methods use average soft-tissue depths (American methods) or require face muscle construction (Russian methods). However, literature searches outside the usual realm of English publications reveal key papers that demonstrate that the Russian category above has been founded on distorted views. In reality, Russian methods are based on limited face muscle construction, with heavy reliance on modified average soft-tissue depths. A closer inspection of the American method also reveals inconsistencies with the recognized classification scheme. This investigation thus demonstrates that all major methods of facial approximation depend on both face anatomy and average soft-tissue depths, rendering common method classification schemes redundant. The best way forward appears to be for practitioners to describe the methods they use (including the weight each one gives to average soft-tissue depths and deep face tissue construction) without placing them in any categorical classificatory group or giving them an ambiguous name. The state of this situation may need to be reviewed in the future in light of new research results and paradigms.

Aquatic passive sampling of herbicides on naked particle loaded membranes: Accelerated measurement and empirical estimation of kinetic parameters

Water-sampler equilibrium partitioning coefficients and aqueous boundary layer mass transfer coefficients for atrazine, diuron, hexazionone and fluometuron onto C18 and SDB-RPS Empore disk-based aquatic passive samplers have been determined experimentally under a laminar flow regime (Re = 5400). The method involved accelerating the time to equilibrium of the samplers by exposing them to three water concentrations, decreasing stepwise to 50% and then 25% of the original concentration. Assuming first-order Fickian kinetics across a rate-limiting aqueous boundary layer, both parameters are determined computationally by unconstrained nonlinear optimization. In addition, a method of estimation of mass transfer coefficients-therefore sampling rates-using the dimensionless Sherwood correlation developed for laminar flow over a flat plate is applied. For each of the herbicides, this correlation is validated to within 40% of the experimental data. The study demonstrates that for trace concentrations (sub 0.1 mu g/L) and these flow conditions, a naked Empore disk performs well as an integrative sampler over short deployments (up to 7 days) for the range of polar herbicides investigated. The SDB-RPS disk allows a longer integrative period than the C18 disk due to its higher sorbent mass and/or its more polar sorbent chemistry. This work also suggests that for certain passive sampler designs, empirical estimation of sampling rates may be possible using correlations that have been available in the chemical engineering literature for some time.

Selenium content of Australian foods: A review of literature values

The aim of this study was to review the published literature values for the selenium content of Australian foods. A secondary aim was to compare the results for Australian foods with food composition data from international sources to investigate the extent of geographical variation. Published food composition data sources for the selenium content in Australian foods were identified and assessed for data quality using established criteria. The selenium content is available for 148 individual food items. The highest values found are for fish (12.0-63.2 mug/100 g), meats (4.75-37.9 mug/100 g) and eggs (9.00-41.4 mug/100 g), followed by cereals (1.00-20.3 mug/100 g). Moderate levels are seen in dairy products (2.00-7.89 mug/100 g) while most fruits and vegetables have low levels (trace-3.27 mug/100 g). High selenium foods show the greatest level of geographical variation, with foods from the United States generally having higher selenium levels than Australian foods and foods from the United Kingdom and New Zealand having lower levels. This is the first attempt to review the available literature for selenium composition of Australian foods. These data serve as an interim measure for the assessment of selenium intake for use in epidemiological studies of diet-disease relationships. (C) 2002 Published by Elsevier Science Ltd.

International symposium on career development and public policy: Synthesis of country papers

During the conference, country teams were asked to select and address selection of six themes: human capital, labour supply, employability skills, carer development services for workforce development, older workers or evidence based research. This synthesis of country papers covers the conceptual links between these themes. It then goes on to cover three reframed themes focusing on career development policies and services, but distinguishing three levels of such policies and services: workforce preparation, workforce adaptability and workforce re-integration.

A bibliographic snapshot of the telemedicine citation literature

There appear to have been no previous literature-based or literature-oriented studies in telemedicine which have analysed raw citation data. Using a simple search strategy, the Web of Science was analysed up to the end of 2005 to give a snapshot of the field, and to identify matters which would need to be considered in larger scale bibliometric studies. Of the 3673 telemedicine documents retrieved, 2213 (60%) had been cited. Of 56,875 citation records, 32,460 unique citation formats were found. The most-cited paper, and the paper with the greatest annual citation rate, was Perednia and Allen's review article in JAMA, 1995. The two specialist telemedicine journals published 40% of all papers retrieved. In the general literature (i.e. excluding the two specialist journals) there were 1556 citations to their 1374 'citable' articles, apportioned in the ratio 76:24, almost exactly in accordance with the distribution of the articles themselves. However, each of the two specialist telemedicine journals cited itself in a proportion higher than its share of original articles, with an 'excess' of self-citations of 14% in the journal of Telemedicine and Telecare, and 19% in the Telemedicine journal and E-Health. Despite certain technical difficulties, there is considerable scope for bibliometric research in telemedicine.

New fluorescence parameters for monitoring photosynthesis in plants - 1. The effect of illumination on the fluorescence parameters of the JIP-test

Chlorophyll fluorescence measurements have a wide range of applications from basic understanding of photosynthesis functioning to plant environmental stress responses and direct assessments of plant health. The measured signal is the fluorescence intensity (expressed in relative units) and the most meaningful data are derived from the time dependent increase in fluorescence intensity achieved upon application of continuous bright light to a previously dark adapted sample. The fluorescence response changes over time and is termed the Kautsky curve or chlorophyll fluorescence transient. Recently, Strasser and Strasser (1995) formulated a group of fluorescence parameters, called the JIP-test, that quantify the stepwise flow of energy through Photosystem II, using input data from the fluorescence transient. The purpose of this study was to establish relationships between the biochemical reactions occurring in PS II and specific JIP-test parameters. This was approached using isolated systems that facilitated the addition of modifying agents, a PS II electron transport inhibitor, an electron acceptor and an uncoupler, whose effects on PS II activity are well documented in the literature. The alteration to PS II activity caused by each of these compounds could then be monitored through the JIP-test parameters and compared and contrasted with the literature. The known alteration in PS II activity of Chenopodium album atrazine resistant and sensitive biotypes was also used to gauge the effectiveness and sensitivity of the JIP-test. The information gained from the in vitro study was successfully applied to an in situ study. This is the first in a series of four papers. It shows that the trapping parameters of the JIP-test were most affected by illumination and that the reduction in trapping had a run-on effect to inhibit electron transport. When irradiance exposure proceeded to photoinhibition, the electron transport probability parameter was greatly reduced and dissipation significantly increased. These results illustrate the advantage of monitoring a number of fluorescence parameters over the use of just one, which is often the case when the F-V/F-M ratio is used.

Sampling phylogenetic tree space with the generalized Gibbs sampler

The generalized Gibbs sampler (GGS) is a recently developed Markov chain Monte Carlo (MCMC) technique that enables Gibbs-like sampling of state spaces that lack a convenient representation in terms of a fixed coordinate system. This paper describes a new sampler, called the tree sampler, which uses the GGS to sample from a state space consisting of phylogenetic trees. The tree sampler is useful for a wide range of phylogenetic applications, including Bayesian, maximum likelihood, and maximum parsimony methods. A fast new algorithm to search for a maximum parsimony phylogeny is presented, using the tree sampler in the context of simulated annealing. The mathematics underlying the algorithm is explained and its time complexity is analyzed. The method is tested on two large data sets consisting of 123 sequences and 500 sequences, respectively. The new algorithm is shown to compare very favorably in terms of speed and accuracy to the program DNAPARS from the PHYLIP package.

Bacteria in shrimp pond sediments: their role in mineralizing nutrients and some suggested sampling strategies

Strategies for sampling sediment bacteria were examined in intensive shrimp, Penaeus monodon (Fabricius), ponds in tropical Australia. Stratified sampling of bacteria at the end of the production season showed that the pond centre, containing flocculated sludge, had significantly higher bacterial counts (15.5 X 10(9) g(-1) dw) than the pond periphery (8.1 X 10(9) g(-1) dw), where the action of aerators had swept the pond floor. The variation in bacterial counts between these two zones within a pond was higher than that between sites within each zone or between ponds. Therefore, sampling effort should be focused within these zones: for example, sampling two ponds at six locations within each of the two zones resulted in a coefficient of variation of approximate to 5%. Bacterial numbers in the sediment were highly correlated with sediment grain size, probably because eroded soil particles and organic waste both accumulated in the centre of the pond. Despite high inputs of organic matter added to the ponds, principally as pelleted feeds, the mean bacterial numbers and nutrient concentrations (i.e. organic carbon, nitrogen and phosphorus) in the sediment were similar to those found in mangrove sediments. This suggests that bacteria are rapidly remineralizing particulates into soluble compounds. Bacterial numbers were highly correlated with organic carbon and total kjeldahl nitrogen in the sediment, suggesting that these were limiting factors to bacterial growth.