Synthesis, characterization and DFT studies of the cobalt(III) complex of a tetrapodal pentadentate N4S donor ligand

The synthesis of the pentadentate ligand 2,6-bis(3,3-dimethyl-2,4-dioxocyclohexanyl)-4-thiaheptane (N(4)Samp) is described. The synthetic pathway involves the coupling of two 1,3-(dimethylenedioxy)-2-methyl-2-(methylene-p-toluenesulfonyl)propane moieties with sodium sulfide and subsequent synthetic elaboration to prepare the final N4S donor system. The cobalt(III) complex [Co(N(4)Samp)Cl](2+) has been prepared and subsequently crystallized as the tetrachlorozincate salt. The X-ray structure analysis confirms the pentadentate nature of the ligand and shows the thioether donor occupying one apex with four equivalent amine donors effectively occupying the equatorial plane of the molecule. The sixth coordination site is occupied by a chloro ligand. The electronic absorption and C-13 NMR spectra have been studied. DFT calculations have been employed to explore structural and mechanistic comparisons between [Co(N(4)Samp)Cl](2+) and an analogous pentaamine complex.

Functionalized macrocycles from functionalized tetra-amines: Pendent-arm macrocycles derived from dichloropivalic acid

Reaction between ethane-1,2-diamine and 3,3'-dichloropivalic acid results in different, isomeric tetra-amine derivatives, one a tetraamino carboxylic acid and the other a carboxamidotriamino alcohol, depending upon reaction conditions, Intended conversion of the Cu(II) complex of the former to a cyclam-like macrocycle through reaction with nitroethane and formaldehyde results in isolation of derivatives of both the former and the latter. This can be rationalized by assuming the intermediacy of an azetidinone, a species similar to that seen in simpler reactions of dichloropivalates. A single reaction thereby provides pendent-arm macrocycles where one has an electrophilic and the other a nucleophilic substituent. Parallel chemistry is not seen in the reaction between propane-1,3-diamine and 3,3'-dichloropivalate.

Effect of the preparation technique on the catalytic properties of mesoporous V-HMS for the oxidation of toluene

Various mesoporous catalysts with vanadium loadings between 0.5 and 6 V wt.% and surface areas around 1300 m(2)/g were synthesized using the isomorphous substitution (IS) and molecular designed dispersion (MDD) techniques. Their catalytic properties were tested using toluene as a model VOC in a fixed bed reactor at temperatures between 300 and 550 degrees C. It was found that during the oxidation of toluene, over V-HMS synthesized via IS, conversion of toluene mainly results in carbon oxides, benzene, benzaldehyde and water. Total conversion is greatly improved when the vanadium content is increased from around 1.5 to 3.0 wt.%, but an increase in the textural porosity (V-TEX/V-MESO) from 0.3 to 0.6 had no discernable effect on the conversion. This can be explained by the fact that a V-TEX/V-MESO as low as 0.3 is sufficient to facilitate the access of toluene into the framework confined mesopores without any molecular transport limitations. However, when using V-HMS synthesized by MDD, conversion of toluene is greatly improved when the V-TEX/ V-MESO ratio is increased from 0.1 to 0.6. This is because the diffusion limitations are minimized by this increase. V-HMS synthesized via MDD does not exhibit selectivity to benzaldehyde, favoring total oxidation to CO and CO2. This different oxidation mechanism can be explained in terms of location, accessibility and number of active species on the surface of the HMS support. (c) 2005 Elsevier Inc. All rights reserved.