Maternal alcohol use disorder and offspring ADHD: disentangling genetic and environmental effects using a children-of-twins design

Background. Children of alcoholics are significantly more likely to experience high-risk environmental exposures, including prenatal substance exposure, and are more likely to exhibit externalizing problems [e.g. attention deficit hyperactivity disorder (ADHD)]. While there is evidence that genetic influences and prenatal nicotine and/or alcohol exposure play separate roles in determining risk of ADHD, little has been done on determining the joint roles that genetic risk associated with maternal alcohol use disorder (AUD) and prenatal risk factors play in determining risk of ADHD. Method. Using a children-of-twins design, diagnostic telephone interview data from high-risk families (female monozygotic and dizygotic twins concordant or discordant for AUD as parents) and control families targeted from a large Australian twin cohort were analyzed using logistic regression models. Results. Offspring of twins with a history of AUD, as well as offspring of non-AUD monozygotic twins whose co-twin had AUD, were significantly more likely to exhibit ADHD than offspring of controls. This pattern is consistent with a genetic explanation for the association between maternal AUD and increased offspring risk of ADHD. Adjustment for prenatal smoking, which remained significantly predictive, did not remove the significant genetic association between maternal AUD and offspring ADHD. Conclusions. While maternal smoking during pregnancy probably contributes to the association between maternal AUD and offspring ADHD risk, the evidence for a significant genetic correlation suggests: (i) pleiotropic genetic effects, with some genes that influence risk of AUD also influencing vulnerability to ADHD; or (ii) ADHD is a direct risk-factor for AUD.

Design of complementary UWB printed monopole antennas using simple formulas

Simple design formulas for designing ultra wideband (UWB) antennas in the form of complementary planar monopoles are described and their validity is tested using full electromagnetic wave simulations and measurements. Assuming dielectric substrate with relative permittivity of 10.2, the designed antennas feature a small size of 13 mmtimes26 mm. They exhibit a 10 dB return loss bandwidth from 3 to more than 15 GHz accompanied by near omnidirectional characteristics and good radiation efficiency throughout this band

Sketch design drawing, Hill House, Chapel Hill, Brisbane

Sketch floor plan and diagrams.

Sketch design drawing, Hill House, Chapel Hill, Brisbane

Three-dimensional projection sketch showing roof forms and wall finishes.

Hydraulic Design of Stepped Spillways and Downstream Energy Dissipators for Embankment Dams

In recent years, the design flows of many dams were re-evaluated, often resulting in discharges larger than the original design. In many cases, the occurrence of the revised flows could result in dam overtopping because of insufficient storage and spillway capacity. An experimental study was conducted herein to gain a better understanding of the flow properties in stepped chutes with slopes typical of embankment dams. The work was based upon a Froude similitude in large-size experimental facilities. A total of 10 configurations were tested including smooth steps, steps equipped with devices to enhance energy dissipation and rough steps. The present results yield a new design procedure. The design method includes some key issues not foreseen in prior studies : e.g., gradually varied flow, type of flow regime, flow resistance. It is believed that the outcomes are valid for a wide range of chute geometry and flow conditions typical of embankment chutes.

Design, Science and Conceptual Analysis

Philosophers expend considerable effort on the analysis of concepts, but the value of such work is not widely appreciated. This paper principally analyses some arguments, beliefs, and presuppositions about the nature of design and the relations between design and science common in the literature to illustrate this point, and to contribute to the foundations of design theory.

Research, knowledge and design

The discussion about relations between research and design has a number of strands, and presumably motivations. Putting aside the question whether or not design or “creative endeavour” should be counted as research, for reasons to do with institutional recognition or reward, the question remains how, if at all, is design research? This question is unlikely to have attracted much interest but for matters external to Architecture within the modern university. But Architecture as a discipline now needs to understand research much better than in the past when ‘research’ was whatever went on in building science, history or people/environment studies. In this paper, I begin with some common assumptions about design, considered in relation to research, and suggest how the former can constitute or be a mode of the latter. Central to this consideration is an understanding of research as the production of publicly available knowledge. The method is that of conceptual analysis which is much more fruitful than is usually appreciated. This work is part of a larger project in philosophy of design, in roughly the analytical tradition.

Measurement Function Design for Visual Tracking Applications

Extracting human postural information from video sequences has proved a difficult research question. The most successful approaches to date have been based on particle filtering, whereby the underlying probability distribution is approximated by a set of particles. The shape of the underlying observational probability distribution plays a significant role in determining the success, both accuracy and efficiency, of any visual tracker. In this paper we compare approaches used by other authors and present a cost path approach which is commonly used in image segmentation problems, however is currently not widely used in tracking applications.

The determination of the design strength of granite used as external cladding for buildings

This chapter is concerned with acquisition and analysis of test data for determining whether or not the flexural strength of granite cladding under extreme conditions is adequate to assure that reliability requirements are satisfied.