The effect of salinity on plant available water

Salinity acts to inhibit plant access to soil water by increasing the osmotic strength of the soil solution. As the soil dries, the soil solution becomes increasingly concentrated, further limiting plant access to soil water. An experiment was conducted to examine the effect of salt on plant available water in a heavy clay soil, using a relatively salt tolerant species, wheat ‘Kennedy’, and a more salt sensitive species, chickpea ‘Jimbour’. Sodium chloride was applied to Red Ferrosol at 10 rates from 0 to 3 g/kg. Plants were initially maintained at field capacity. After 3 weeks, plants had become established and watering was ceased. The plants then grew using the water stored in the soil. Once permanent wilting point was reached plants were harvested, and soil water content was measured. The results showed that without salt stress, wheat and chickpea extracted approximately the same amount of water. However, as the salt concentration increased, the ability of chickpea to extract water was severely impaired, while wheat’s ability to extract water was not affected over the range of concentrations examined. Growth of both wheat and chickpea was reduced even from low salt concentrations. Possible explanations for this are that the effect on growth is due to Cl- toxicity and that this occurs at lower concentrations than the osmotic effect of salinity, or that the metabolic demands of maintaining plant water balance and extracting soil water under saline conditions result in reduced growth.

On the possibility of elastic strain localisation in a fault

The phenomenon of strain localisation is often observed in shear deformation of particulate materials, e.g., fault gouge. This phenomenon is usually attributed to special types of plastic behaviour of the material (e.g., strain softening or mismatch between dilatancy and pressure sensitivity or both). Observations of strain localisation in situ or in experiments are usually based on displacement measurements and subsequent computation of the displacement gradient. While in conventional continua the symmetric part of the displacement gradient is equal to the strain, it is no longer the case in the more realistic descriptions within the framework of generalised continua. In such models the rotations of the gouge particles are considered as independent degrees of freedom the values of which usually differ from the rotation of an infinitesimal volume element of the continuum, the latter being described for infinitesimal deformations by the non-symmetric part of the displacement gradient. As a model for gouge material we propose a continuum description for an assembly of spherical particles of equal radius in which the particle rotation is treated as an independent degree of freedom. Based on this model we consider simple shear deformations of the fault gouge. We show that there exist values of the model parameters for which the displacement gradient exhibits a pronounced localisation at the mid-layers of the fault, even in the absence of inelasticity. Inelastic effects are neglected in order to highlight the role of the independent rotations and the associated additional parameters. The localisation-like behaviour occurs if (a) the particle rotations on the boundary of the shear layer are constrained (this type of boundary condition does not exist in a standard continuum) and (b) the contact moment-or bending stiffness is much smaller than the product of the effective shear modulus of the granulate and the square of the width of the gouge layer. It should be noted however that the virtual work functional is positive definite over the range of physically meaningful parameters (here: contact stiffnesses, solid volume fraction and coordination number) so that strictly speaking we are not dealing with a material instability.

Play it again: did this melody occur more frequently or was it heard more recently? The role of stimulus familiarity in episodic recognition of music

Episodic recognition of novel and familiar melodies was examined by asking participants to make judgments about the recency and frequency of presentation of melodies over the course of two days of testing. For novel melodies, recency judgments were poor and participants often confused the number of presentations of a melody with its day of presentation; melodies heard frequently were judged as have been heard more recently than they actually were. For familiar melodies, recency judgments were much more accurate and the number of presentations of a melody helped rather than hindered performance. Frequency judgments were generally more accurate than recency judgments and did not demonstrate the same interaction with musical familiarity. Overall, these findings suggest that (1) episodic recognition of novel melodies is based more on a generalized feeling of familiarity than on a specific episodic memory, (2) frequency information contributes more strongly to this generalized memory than recency information, and (3) the formation of an episodic memory for a melody depends either on the overall familiarity of the stimulus or the availability of a verbal label. (C) 2004 Elsevier B.V. All rights reserved.

Application of central composite rotatable design to modelling the effect of some operating variables on the performance of the three-product cyclone

The central composite rotatable design (CCRD) was used to design an experimental program to model the effects of inlet pressure, feed density, and length and diameter of the inner vortex finder on the operational performance of a 150-min three-product cyclone. The ranges of values of the variables used in the design were: inlet pressure: 80-130 kPa, feed density: 30 60%; length of IVF below the OVF: 50-585 mm; diameter of IVF: 35-50 mm. A total of 30 tests were conducted, which is 51 less; an that required for a three-level full factorial design. Because the model allows confident performance prediction by interpolation over the range of data in the database, it was used to construct response surface graphs to describe the effects of the variables on the performance of the three-product cyclone. To obtain a simple and yet a realistic model, it was refitted using only the variable terms that are significant at greater than or equal to 90% confidence level. Considering the selected operating variables, the resultant model is significant and predicts the experimental data well. (c) 2005 Elsevier B.V. All rights reserved.

Revision of Telotrema Ozaki, 1933 (Digenea : Gyliauchenidae Fukui, 1929), including the description of a new species from an acanthurid fish from the Great Barrier Reef, Queensland, Australia

We describe one new species of Telotrema Ozaki, 1933 from the intestine of an acanthurid fish of the Great Barrier Reef. Telotrema brevicaudatum n. sp. is described from 2 mature specimens from the yellowfin surgeonfish, Acanthurus xanthopterus Valenciennes, 1835 ( Acanthuridae), from waters off Lizard Island, Queensland, Australia. This species is distinguished from the type-species, Telotrema caudatum Ozaki, 1933, by the smaller excretory papilla, the massive pars prostatica, the unipartite, globular seminal vesicle, and the intertesticular position of the ovary. The proposal of a new species of Telotrema necessitates re-examination of the generic diagnosis, and the genus is here redefined in light of the morphology of T. brevicaudatum. Telotrema is distinguished from Gyliauchen Nicoll, 1915 by the possession of a ventral sucker which is larger than the pharynx, a straight or sigmoid oesophagus, an extensive and dense vitellarium, and a distinct excretory papilla. We here recognise 3 species and distinguish them in a key. The biogeographical range for species of Telotrema now includes acanthurid and pomacentrid fishes of the western Pacific Ocean.

Light alloy castings for automotive applications: The case of Al vs Mg

The economical and environmental effects of mass reduction through Al and Mg primary alloys substitutions for cast iron and steel in automotive components are discussed using MF. Ashby's penalty functions method The viability of Mg alloy substitutions for existing Al alloy cast components is also considered. The cost analysis shows that direct, equal-volume, Al alloy substitutions for cast iron and steel are the most feasible in terms of the CAFE liability, followed by substitutions involving flat panels of prescribed stiffness. When the creation of CO2 associated to the production of Al and Mg is considered, the potential gasoline savings over the lifespan of the car compensate for the intrinsic environmental burden of Al in all applications, while electrolytic Mg substitutions for cast iron and steel are feasible for equal volume and panels only. Magnesium produced by the Pidgeon thermal process appears to be too primary energy intensive to be competitive in structural applications. Magnesium substitutions for existing Al alloy beams and panels are generally unviable. The current higher recycling efficiency of Al casting alloys confers Al a significant advantage over Mg alloys.

Modelling the conversion of Colombian lowland ecosystems since 1940: Drivers, patterns and rates

In biologically mega-diverse countries that are undergoing rapid human landscape transformation, it is important to understand and model the patterns of land cover change. This problem is particularly acute in Colombia, where lowland forests are being rapidly cleared for cropping and ranching. We apply a conceptual model with a nested set of a priori predictions to analyse the spatial and temporal patterns of land cover change for six 50-100 km(2) case study areas in lowland ecosystems of Colombia. Our analysis included soil fertility, a cost-distance function, and neighbourhood of forest and secondary vegetation cover as independent variables. Deforestation and forest regrowth are tested using logistic regression analysis and an information criterion approach to rank the models and predictor variables. The results show that: (a) overall the process of deforestation is better predicted by the full model containing all variables, while for regrowth the model containing only the auto-correlated neighbourhood terms is a better predictor; (b) overall consistent patterns emerge, although there are variations across regions and time; and (c) during the transformation process, both the order of importance and significance of the drivers change. Forest cover follows a consistent logistic decline pattern across regions, with introduced pastures being the major replacement land cover type. Forest stabilizes at 2-10% of the original cover, with an average patch size of 15.4 (+/- 9.2) ha. We discuss the implications of the observed patterns and rates of land cover change for conservation planning in countries with high rates of deforestation. (c) 2005 Elsevier Ltd. All rights reserved.

Changes in social identity when joining a new group: The role of individual-level and group-level adaptation processes

While classic intergroup theories have specified the processes explaining situational shifts in social identification, the processes whereby social identities change more profoundly and become integrated within the self have to be proposed. To this aim, the present studies investigate the processes by which group members integrate a new social identity as they are joining a new group. Combining a social identity approach and stress and coping models, this research tests if social factors (i.e., needs satisfied by fellow group members, social support), have an impact on the adaptation strategies group members use to deal with the novelty of the situation and to fit into their new group (seeking information & adopting group norms vs. disengaging). These strategies, in turn, should predict changes in level of identification with the new social group over time, as well as enhanced psychological adjustment. These associations are tested among university students over the course of their first academic year (Study 1), and among online gamers joining a newly established online community (Study 2). Path analyses provide support for the hypothesised associations. The results are discussed in light of recent theoretical developments pertaining to intraindividual changes in social identities and their integration in the self.

The role of team identification in the dissimilarity-conflict relationship

This study examined the role of team identification in the dissimilarity and conflict relationship. We tested competing predictions that team identification would either mediate or moderate the positive associations between visible (age, gender and ethnic background), professional (background) and value dissimilarity and task and relationship conflict. Data was collected from 27 MBA student teams twice during a semester. Multilevel modelling and a longitudinal design were used. Results showed that value dissimilarity was positively associated with task and relationship conflict at Time 2. Its effects on relationship conflict at Time 1 were moderated by team identification. Team identification also moderated the effects of gender, age and ethnic dissimilarity on task conflict at Time 2, and the effects of gender and professional dissimilarity on relationship conflict at Time 2. No support was obtained for the mediating role of team identification on the associations between dissimilarity and conflict, or for changes in the effects of dissimilarity over time.