Peanut resistance to Sclerotinia minor and S-sclerotiorum

The fungi Sclerotinia minor and S. sclerotiorum are the causal agents of two similar diseases of peanut (Arachis hypogaea L.). Both diseases cause significant losses in the Australian peanut industry. Development of cultivars with resistance to Sclerotinia will be an important component of integrated control. The aims of this project are to generate information that will assist in breeding for Sclerotinia resistance in peanut: to identify Sclerotinia-resistant peanut germplasm, to understand the inheritance and estimate heritability of resistance, and to test the effectiveness of identified sources of resistance against both S. minor and S. sclerotiorum. This study has clearly established that material that shows resistance to S. minor in the USA is resistant to S. minor and likely to be resistant to S. sclerotiorum in Australia. The high level of resistance to both S. minor and S. sclerotiorum in germplasm from Texas, particularly TxAG-4, was confirmed. VA 93B showed good resistance in the field, which is primarily due to the open bush type rather than physiological resistance. Physiological resistance to S. minor was also identified in a cultivar and a landrace from Indonesia and a rust-resistant line from Queensland. All germplasm found to have high physiological resistance to S. minor belonged to the Spanish type. Inheritance of physiological resistance to S. minor was studied using a Generation Means Analysis (GMA) of the cross TxAG-4/VA 93B and its reciprocal. The broad-sense heritability of physiological resistance on a single plant basis was estimated at 47%, much higher than earlier estimates obtained in field studies. The average gene action of Sclerotinia resistance genes from TxAG-4 was found to be additive. No dominance effects were detected in the GMA. A small but significant reciprocal effect between TxAG-4 and VA 93B indicated that VA 93B passed on some physiological resistance maternally. An experiment was conducted to confirm the value of resistance against both S. minor and S. sclerotiorum. TxAG-4 was found to have physiological resistance to both S. minor and S. sclerotiorum. This resistance was expressed against both Sclerotinia species by progeny that were selected for resistance to S. minor. On the basis of the information obtained, the comparative advantages of 3 strategies for Sclerotinia-resistant cultivar development are discussed: (1) introduction of germplasm; (2) recurrent backcrossing with screening and crossing in the BCnF1 generation; and (3) pedigree selection. At present, introduction and backcrossing are recommended as the preferred strategies.

Molecular motors-based micro- and nano-biocomputation devices

Protein molecular motors, which are natural nano-machines that convert the chemical energy into mechanical work for cellular motion, muscle contraction and cell division, have been integrated in the last decade in primitive nanodevices based on the motility of nano-biological objects in micro- and nano-fabricated structures. However, the motility of microorganisms powered by molecular motors has not been similarly exploited. Moreover, among the proposed devices based on molecular motors, i.e., nanosensors, nano-mechanical devices and nano-imaging devices, biocomputation devices are conspicuously missing. The present contribution discusses, based on the present state of the art nano- and micro-fabrication, the comparative advantages and disadvantages of using nano- and micro-biological objects in future computation devices. (c) 2006 Elsevier B.V. All rights reserved.

Estimating nutrient intake in comparative studies of animals: an example using dietary carotenoid content in birds

Many different methods of reporting animal diets have been used in ecological research. These vary greatly in level of accuracy and precision and therefore complicate attempts to measure and compare diets, and quantitites of nutrients in those diets, across a wide range of taxa. For most birds, the carotenoid content of the diet has not been directly measured. Here, therefore, I use an avian example to show how different methods of measuring the quantities of various foods in the diet affect the relative rankings of higher taxa (families, subfamilies, and tribes), and species within these taxa, with regard to the carotenoid contents of their diets. This is a timely example, as much recent avian literature has focused on the way dietary carotenoids may be traded off among aspects of survival, fitness and signalling. I assessed the mean dietary carotenoid contents of representatives of thirty higher taxa of birds using four different carotenoid intake indices varying in precision, including trophic levels, a coarse-scale and a fine-scale categorical index, and quantitative estimates of dietary carotenoids. This last method was used as the benchmark. For comparisons among taxa, all but the trophic level index were significantly correlated with each other. However, for comparisons of species within taxa, the fine-scale index outperformed the coarse-scale index, which in turn outperformed the trophic level index. In addition, each method has advantages and disadvantages, as well as underlying assumptions that must be considered. Examination and comparison of several possible methods of diet assessment appears to highlight these so that the best possible index is used given available data, and it is recommended that such a step be taken prior to the inclusion of estimated nutrient intake in any statistical analysis. Although applied to avian carotenoids here, this method could readily be applied to other taxa and types of nutrients.

Concepts and tools for comprehensive sustainability assessments for tourism destinations: a comparative review

This paper reviews a wide range of tools for comprehensive sustainability assessments at whole tourism destinations, covering socio-cultural, economic and environmental issues. It considers their strengths, weaknesses and site specific applicability. It is intended to facilitate their selection (and combination where necessary). Tools covered include Sustainability Indicators, Environmental Impact Assessment, Life Cycle Assessment, Environmental Audits, Ecological Footprints, Multi-Criteria Analysis and Adaptive Environmental Assessment. Guidelines for evaluating their suitability for specific sites and situations are given as well as examples of their use.

Recreational fishing and fishing policies in the Netherlands and Australia: A comparative review

This article compares fisheries management, environmental problems and policies of the Netherlands and Australia. From this comparison lessons can be learned for countries that experience economic growth and on increase of leisure activity. In both countries, conflicts between the user groups, e.g. commercial and recreational fishers, are identified and the ways in which policymakers deal with these problems are outlined. Often suggested tools to address these problems are decision-making procedures based on a holistic framework in which economic, sociocultural, political/institutional, ecological aspects are included in the decision framework. Recreational fishing is today often the dominant factor in the resolution of these matters because of the relative economic, social and political power of recreational fishers as a group.

Comparative public support for conserving reptile species is high: Australian evidence and its implications

This paper investigates factors influencing the public’s support for conservation of tropical reptile species in a focal group drawing on Australian data and an experiment involving a sample of the Australian public. The influences of the likeability of the species, their degree of endangerment, ethical considerations as well as knowledge are examined and found to be important. Likeability is found to be much less important than the existing literature suggests. This is highlighted by comparing the likeability of the focal group of reptiles with that for a group of birds and a group of mammals with differences in willingness to pay for their conservation.

The deep-sea teleost cornea: a comparative study of gadiform fishes

The corneal structure of three deep-sea species of teleosts (Gadiformes, Teleostei) from different depths (250-4000 m) and photic zones are examined at the level of the light and electron microscopes. Each species shows a similar but complex arrangement of layers with a cornea split into dermal and scleral components. The dermal cornea comprises an epithelium overlying a basement membrane and a dermal stroma with sutures and occasional keratocytes. Nezumia aequalis is the only species to possess a Bowman's layer, although it is not well-developed. The scleral cornea is separated from the dermal cornea by a mucoid layer and, in contrast to shallow-water species, is divided into three main layers; an anterior scleral stroma, a middle or iridescent layer and a posterior scleral stroma. The iridescent layer of collagen and intercalated cells or cellular processes is bounded by a layer of cells and the posterior scleral stroma overlies a Descemet's membrane and an endothelium. In the relatively shallow-water Microgadus proximus, the keratocytes of the dermal stroma, the cells of the iridescent layer and the endothelial cells all contain aligned endoplasmic reticulum, which may elicit an iridescent reflex. No alignment of the endoplasmic reticulum was found in N. aequalis or Coryphanoides (Nematonurus) armatus. The relative differences between shallow-water and deep-sea corneas are discussed in relation to the constraints of light, depth and temperature.

Incorporating cognitive-behavioral therapy with occupational therapy: A comparative study with patients with low back pain

This paper reports on the implementation of a psychoeducational program utilizing cognitive-behavioral principles. The efficacy of this psychoeducational treatment program in modifying dysfunctional attitudes in patients with chronic low back pain was examined using a two-group pretest posttest design with a follow-lip at 3 months Thirty patients (average age = 44.37 SD = 13.71) participated in the study, with 15 in the psychoeducational treatment group and 15 in the placebo control group. These two conditions were added on to an existing eclectic inpatient pain management program. After assessment on the IPAM (The Integrated Psychosocial Assessment Model), scores were reduced to multivariate composite scores on the factors of illness behavior depressed and negative cognitions, and acute pain strategies. Results of a group x time repeated measures analysis of variance for the three pain factors revealed a significant main effect for group (F(23,1) = 5.00 p < .04), tempered by a significant interaction between group and rime on the 'depressed and negative' pain factor (F(23,1) = 4.77 p < .04). Patients in the treatment group improved significantly over time and significantly more than the placebo control group patients at posttreatment. Results provide support for the program in increasing patients' feelings of control over their pain and the use of positive coping strategies, while reducing perceived helplessness, depression, disability, and pain intensity.

Comparative in vitro effects of closantel and selected beta-ketoamide anthelmintics on a gastrointestinal nematode and vertebrate liver cells

PNU-87407 and PrNU-88509, beta-ketoamide anthelmintics that are structurally related to each other and to the salicylanilide anthelmintic closantel, exhibit different anthelmintic spectra and apparent toxicity in mammals, The basis for this differential pharmacology was examined in experiments that measured motility and adenosine triphosphate (ATP) levels in larval and adult stages of the gastrointestinal nematode, Haemonchus contortus, and in a vertebrate liver cell line and mitochondria, PNU-87407 and PNU-88509 both exhibited functional cross-resistance with closantel in larval migration assays using closantel-resistant and -sensitive isolates of H, contortus. Each compound reduced motility and,ATP levels in cultured adult H. contortus in a concentration- and time-dependent manner: however, motility was reduced more rapidly by PNU-88509, and ATP levels were reduced by lower concentrations of closantel than the beta-ketoamides. Tension recordings from segments of adult H, contortus showed that PNU-88509 induces spastic paralysis, while PNU-87407 and closantel induce flaccid paralysis of the somatic musculature. Marked differences in the actions of these compounds were also observed in the mammalian preparations. In Chang liver cells, ATP levels were reduced after 3 h exposures to greater than or equal to 0.25 mu M PNU-87407 1 mu M closantel or 10 mu M PNU-88509, Reductions in ATP caused by PNU-88509 were completely reversible, while the effects of closantel and PNU-87407; were irreversible. PNU-87407, closantel and PNU-88509 uncoupled oxidative phosphorylation in isolated rat liver mitochondria, inhibiting the respiratory control index (with glutamate or succinate as substrate) by 50% at concentrations of 0.14, 0.9 and 7.6 mu M respectively.

Comparative labor market performance of visaed and non-visaed migrants: Pacific islanders in Sydney

Using survey data for Tongan and Samoan migrants in Sydney the effects of visa restrictions on labor market performance of migrants are assessed. Univariate analysis suggests a positive association between unemployment and the unrestricted entry of Samoan step-migrants from New Zealand. A probit model of the determinants of unemployment is estimated with controls for human capital and demographic variables. While human capital endowments are important, visa restrictions do not have a significant effect on either group's employability. Implications for policy are discussed highlighting the complementarities between host country immigration policies and foreign aid programs.

A comparative study of the fluidized-bed coating of cylindrical metal surfaces with various thermoplastic polymer powders

This paper reports the results of an experimental investigation into the fluidized-bed coating of cylindrical metal specimens using two types of thermoplastic powders, Rilsan(R) PA11, a nylon-11 powder produced by Elf Atochem, France and Cotene(TM) 4612, a linear low density polyethylene powder produced by J.R Courtenay (New Zealand). The effects of dipping time, preheat temperature and particle size distribution on coating thickness and surface finish were investigated. Consistent trends in coating thickness growth with dipping time were obtained for both nylon-11 and polyethylene powders with increases in coating thickness with preheat temperature. For the same preheat temperature, the lower melting point of polyethylene results in thicker coatings compared to those of nylon-11. There is a negligible change in the coating thickness for sieved powders compared to that for unsieved powders. A pre-heat temperatures of between 240 degrees C and 300 degrees C is necessary to achieve an acceptable surface finish with both nylon-11 and polyethylene powders. To minimize errors in achieving the desired coating thickness, dipping times shorter than 2 s are not recommended. The use of graphs of coating thickness versus dipping time in combination with the coating surface roughness plots presented in this paper enable the optimal choice of pre-heat temperature and dipping time to achieve acceptable surface finish. (C) 1999 Elsevier Science S.A. All rights reserved.

A comparative study of N2O conversion to N-2 over Co/AC and Cu/AC catalysts

Catalytic conversion of N2O to N-2 over Cu- and Co-impregnated activated carbon catalysts (Cu/AC and Co/AC) was investigated. Catalytic activity measurements were carried out in a fixed-bed flow reactor at atmospheric pressure. The catalysts were characterized by N-2 adsorption, X-ray diffraction (XRD) and thermogravimetric analysis (TGA). This study aimed to provide insights into the following aspects: the metal dispersion, changes in pore structure, influence of catalyst loading on reaction, and reaction mechanism. Increasing loading of Co or Cu led to decreasing dispersion, but 20 wt % loading was an upper limit for optimal activities in both cases, with too high loading causing sintering of metal. Co exhibited a relatively better dispersion than Cu. Impregnation of metal led to a large decrease in surface area and pore volume, especially for 30 wt % of loading. 20 wt % of loading has proved to be the optimum for both Cu and Co, which shows the highest activity. Both N2O-Co/AC and -Cu/AC reactions are based upon a redox mechanism, but the former is limited by the oxygen transfer from catalysts to carbon, while N2O chemisorption on the surface of Cu catalyst controls the latter. The removal of oxygen from cobalt promotes the activity of Co/AC, but it is beneficial for Cu/AC to keep plenty of oxygen to maintain the intermediate oxidation of copper-Cu1+. The different nature of the two catalysts and their catalytic reaction mechanisms are closely related to their different electronegativities.