Kinetics of propranolol uptake in muscle, skin, and fat of the isolated perfused rat hindlimb

The tissue distribution kinetics of a highly bound solute, propranolol, was investigated in a heterogeneous organ, the isolated perfused limb, using the impulse-response technique and destructive sampling. The propranolol concentration in muscle, skin, and fat as well as in outflow perfusate was measured up to 30 min after injection. The resulting data were analysed assuming (1) vascular, muscle, skin and fat compartments as well mixed (compartmental model) and (2) using a distributed-in-space model which accounts for the noninstantaneous intravascular mixing and tissue distribution processes but consists only of a vascular and extravascular phase (two-phase model). The compartmental model adequately described propranolol concentration-time data in the three tissue compartments and the outflow concentration-time curve (except of the early mixing phase). In contrast, the two-phase model better described the outflow concentration-time curve but is limited in accounting only for the distribution kinetics in the dominant tissue, the muscle. The two-phase model well described the time course of propranolol concentration in muscle tissue, with parameter estimates similar to those obtained with the compartmental model. The results suggest, first that the uptake kinetics of propranolol into skin and fat cannot be analysed on the basis of outflow data alone and, second that the assumption of well-mixed compartments is a valid approximation from a practical point of view las, e.g., in physiological based pharmacokinetic modelling). The steady-state distribution volumes of skin and fat were only 16 and 4%, respectively, of that of muscle tissue (16.7 ml), with higher partition coefficient in fat (6.36) than in skin (2.64) and muscle (2.79. (C) 2000 Elsevier Science B.V. All rights reserved.

Genetic and non-genetic factors affecting birth-weight and adult body mass index

Birthweight affects neonatal mortality and morbidity and has been used as a marker of foetal undernutrition in studies of prenatal effects on adult characteristics. It is potentially influenced by genetic and environmental influences on the mother, and effects of foetal genotype, which is partially derived from the maternal genotype. Interpretations of variation in birthweight and associated characteristics as being due to prenatal environment ignore other possible modes of materno-foetal transmission. Subjects were adult twins recruited through the Australian Twin Registry, aged 17 to 87 years, and the sample comprised 1820 men and 4048 women. Twins reported their own birthweight as part of a health questionnaire. Body Mass Index (BMI) was calculated from self-reports of height and weight. Correlations between co-twins' birthweights were high for both monozygotic (r = 0.77) and dizygotic (r = 0.67) pairs, leading to substantial estimates of shared environmental effects (56% of variance) with significant additive genetic (23%) and non-shared environmental (21%) components. Adult BMI was mainly influenced by genetic factors, both additive (36% of variance) and nonadditive (35%). The correlation between birthweight and BMI was positive, in that heavier babies became on average more obese adults. A bivariate model of birthweight and adult BMI showed significant positive genetic (rg = 0.16, p = 0.005) and environmental (re = 0.08, p = 0.000011) correlations. Intra-uterine environmental or perinatal influences shared by cotwins exercise a strong influence on birthweight, but the factors which affect both birthweight and adult BMI are partly genetic and partly non-shared environmental.

Timing and magnitude of peak height velocity and peak tissue velocities for early, average, and late maturing boys and girls

Height, weight, and tissue accrual were determined in 60 male and 53 female adolescents measured annually over six years using standard anthropometry and dual-energy X-ray absorptiometry (DXA). Annual velocities were derived, and the ages and magnitudes of peak height and peak tissue velocities were determined using a cubic spline fit to individual data. Individuals were rank ordered on the basis of sex and age at peak height velocity (PHV) and then divided into quartiles: early (lowest quartile), average (middle two quartiles), and late (highest quartile) maturers. Sex- and maturity-related comparisons in ages and magnitudes of peak height and peak tissue velocities were made. Males reached peak velocities significantly later than females for all tissues and had significantly greater magnitudes at peak. The age at PHV was negatively correlated with the magnitude of PHV in both sexes. At a similar maturity point (age at PHV) there were no differences in weight or fat mass among maturity groups in both sexes. Late maturing males, however, accrued more bone mineral and lean mass and were taller at the age of PHV compared to early maturers. Thus, maturational status (early, average, or late maturity) as indicated by age at PHV is inversely related to the magnitude and late maturers for weight and fat mass in boys and girls. Am. J. Hum. Biol. 13:1-8, 2001. (C) 2001 Wiley-Liss, Inc.

Fruit weight and shoot diameter relationship in early ripening peaches

Data were collected in early ripening peach [Prunus persica (L.) Batsch] varieties trained to a vase system to determine if a relationship exists between fruit weight and shoot diameter. The experiment was conducted with 3 varieties at Gainesville, FL with detailed pruning and with 3 other varieties at Atapulgus, GA with minimum pruning. All the varieties were similar in fruit development period (FDP) and fruit size. The largest shoot diameter was generally found in the upper canopy in all varieties. There was no correlation between shoot diameter and fruit weight for 'TropicBeauty', 'TropicSnow' and 'UF2000' at Gainesville under detailed pruning. There was a significant (p = 0.01) correlation for 'Flordacrest' in the lower (r = 0.53) canopy and for 'White Robin' in both the upper (r = 0.38) and lower (r = 0.40) canopy at Attapulgus, GA under minimal pruning. In these situations, large stems were associated with large fruit. 'Delta', grown at Attapulgus with minimal pruning, showed no correlation between shoot diameter and fruit weight, probably because it is male sterile and produced large fruit due to a reduced crop load.

Effect of Rosiglitazone on Insulin Sensitivity and Body Composition in Type 2 Diabetic Patients

Objective: To investigate the effects of rosiglitazone (RSG) on insulin sensitivity and regional adiposity (including intrahepatic fat) in patients with type 2 diabetes. Research Methods and Procedures: We examined the effect of RSG (8 mg/day, 2 divided doses) compared with placebo on insulin sensitivity and body composition in 33 type 2 diabetic patients. Measurements of insulin sensitivity (euglycemic hyperinsulinemic clamp), body fat (abdominal magnetic resonance imaging and DXA), and liver fat (magnetic resonance spectroscopy) were taken at baseline and repeated after 16 weeks of treatment. Results: There was a significant improvement in glycemic control (glycosylated hemoglobin -0.7 +/- 0.7%, p less than or equal to 0.05) and an 86% increase in insulin sensitivity in the RSG group (glucose-disposal rate change from baseline: 17.5 +/- 14.5 mumol glucose/min/kg free fat mass, P < 0.05), but no significant change in the placebo group compared with baseline. Total body weight and fat mass increased (p &LE; 0.05) with RSG (2.1 +/- 2.0 kg and 1.4 +/- 1.6 kg, respectively) with 95% of the increase in adiposity occurring in nonabdominal regions. In the abdominal region, RSG increased subcutaneous fat area by 8% (25.0 +/- 28.7 cm(2), p = 0.02), did not alter intra-abdominal fat area, and reduced intrahepatic fat levels by 45% (-6.7 +/- 9.7%, concentration relative to water). Discussion: Our data indicate that RSG greatly improves insulin sensitivity in patients with type 2 diabetes and is associated with an increase in adiposity in subcutaneous but not visceral body regions.

Design strategies for controlling the molecular weight and rate using reversible addition-fragmentation chain transfer mediated living radical polymerization

Living radical polymerization has allowed complex polymer architectures to be synthesized in bulk, solution, and water. The most versatile of these techniques is reversible addition-fragmentation chain transfer (RAFT), which allows a wide range of functional and nonfunctional polymers to be made with predictable molecular weight distributions (MWDs), ranging from very narrow to quite broad. The great complexity of the RAFT mechanism and how the kinetic parameters affect the rate of polymerization and MWD are not obvious. Therefore, the aim of this article is to provide useful insights into the important kinetic parameters that control the rate of polymerization and the evolution of the MWD with conversion. We discuss how a change in the chain-transfer constant can affect the evolution of the MWD. It is shown how we can, in principle, use only one RAFT agent to obtain a poly-mer with any MWD. Retardation and inhibition are discussed in terms of (1) the leaving R group reactivity and (2) the intermediate radical termination model versus the slow fragmentation model. (c) 2005 Wiley Periodicals, Inc.

Drop formation and breakup of low viscosity elastic fluids: Effects of molecular weight and concentration

The dynamics of drop formation and pinch-off have been investigated for a series of low viscosity elastic fluids possessing similar shear viscosities, but differing substantially in elastic properties. On initial approach to the pinch region, the viscoelastic fluids all exhibit the same global necking behavior that is observed for a Newtonian fluid of equivalent shear viscosity. For these low viscosity dilute polymer solutions, inertial and capillary forces form the dominant balance in this potential flow regime, with the viscous force being negligible. The approach to the pinch point, which corresponds to the point of rupture for a Newtonian fluid, is extremely rapid in such solutions, with the sudden increase in curvature producing very large extension rates at this location. In this region the polymer molecules are significantly extended, causing a localized increase in the elastic stresses, which grow to balance the capillary pressure. This prevents the necked fluid from breaking off, as would occur in the equivalent Newtonian fluid. Alternatively, a cylindrical filament forms in which elastic stresses and capillary pressure balance, and the radius decreases exponentially with time. A (0+1)-dimensional finitely extensible nonlinear elastic dumbbell theory incorporating inertial, capillary, and elastic stresses is able to capture the basic features of the experimental observations. Before the critical "pinch time" t(p), an inertial-capillary balance leads to the expected 2/3-power scaling of the minimum radius with time: R-min similar to(t(p)-t)(2/3). However, the diverging deformation rate results in large molecular deformations and rapid crossover to an elastocapillary balance for times t>t(p). In this region, the filament radius decreases exponentially with time R-min similar to exp[(t(p)-t)/lambda(1)], where lambda(1) is the characteristic time constant of the polymer molecules. Measurements of the relaxation times of polyethylene oxide solutions of varying concentrations and molecular weights obtained from high speed imaging of the rate of change of filament radius are significantly higher than the relaxation times estimated from Rouse-Zimm theory, even though the solutions are within the dilute concentration region as determined using intrinsic viscosity measurements. The effective relaxation times exhibit the expected scaling with molecular weight but with an additional dependence on the concentration of the polymer in solution. This is consistent with the expectation that the polymer molecules are in fact highly extended during the approach to the pinch region (i.e., prior to the elastocapillary filament thinning regime) and subsequently as the filament is formed they are further extended by filament stretching at a constant rate until full extension of the polymer coil is achieved. In this highly extended state, intermolecular interactions become significant, producing relaxation times far above theoretical predictions for dilute polymer solutions under equilibrium conditions. (C) 2006 American Institute of Physics

Birth weight and age at menopause in Australian female twin pairs: exploration of the fetal origin hypothesis

In a twin sample where duration of gestation can be controlled, a specific example of the fetal origins hypothesis concerning association between low birth weight and early age at menopause is explored. The hypothesis is based on the physiologically plausible path from intrauterine growth retardation and reduced numbers of primary follicles to an earlier menopause. The sample comprised 323 Australian female twin pairs where both co-twins had reached menopause naturally and reported on their weight at birth. Regression analysis showed no linear association between the two variables (P = 0.371, r(2) = 0.0009). Intra-pair differences in age at menopause were investigated in the context of relative birth weight of co-twins. In 265 pairs an intra-pair birth a eight difference was reported. In monozygotic (MZ) pairs (n = 168) this allowed for control of genetic effects as well as gestation duration. No significant differences dependent on birth weight relative to co-twin were found for age at natural menopause in either MZ or dizygotic (DZ) twin pairs, even in pairs whose birth weights differed markedly. There was some indication that twins with premature ovarian failure were heavier at birth than twins with normal or later menopausal age. We conclude that the hypothesis that lower birth weight is associated with earlier menopause is not supported by our data.