158 resultados para Theater. Corporeal mimesis. Rural maracatu. Actor. Composition
em University of Queensland eSpace - Australia
Resumo:
The prevalence of idiopathic Parkinson’s disease (IPD) in Australia is unclear. We estimated the prevalence of IPD, and other forms of parkinsonism, through the study of typical caseloads in general practice. A random sample of general practitioners (GPs) throughout Queensland (401 responses from 528 validated practice addresses) was asked to estimate the numbers of patients with IPD and parkinsonism seen in the preceding year. The estimated prevalence of diagnosed IPD in Queensland was 146 per 100 000 (95% CI = 136–155). A further 51 per 100 000 in the population were suspected by doctors to have IPD without formal diagnosis, whereas another 51 per 100 000 people may have non-idiopathic parkinsonism. Idiopathic Parkinson’s disease was more common in rural than metropolitan areas. Although most GPs were confident in making diagnoses of IPD, the majority had little or no confidence in their ability to treat the disease, especially in its later stages. Support from neurologists was perceived by GPs to be very good in cities, but poor in remote areas.
Resumo:
Background: Concerns of a decrease in physical activity levels (PALs) of children and a concurrent increase in childhood obesity exist worldwide. The exact relation between these two parameters however has as yet to be fully defined in children. Objective: This study examined the relation in 47 children, aged 5–10.5 y (mean age 8.4plusminus0.9 y) between habitual physical activity, minutes spent in moderate, vigorous and hard intensity activity and body composition parameters. Design: Total energy expenditure (TEE) was calculated using the doubly labelled water technique and basal metabolic rate (BMR) was predicted from Schofield's equations. PAL was determined by PAL=TEE/BMR. Time spent in moderate, vigorous and hard intensity activity was determined by accelerometry, using the Tritrac-R3D. Body fatness and body mass index (BMI) were used as the two measures of body composition. Results: Body fat and BMI were significantly inversely correlated with PAL (r=-0.43, P=0.002 and r=-0.45, P=0.001). Times spent in vigorous activity and hard activity were significantly correlated to percentage body fat (r=-0.44, P=0.004 and r=-0.39, P=0.014), but not BMI. Children who were in the top tertiles for both vigorous activity and hard activity had significantly lower body fat percentages than those in the middle and lowest tertiles. Moderate intensity activity was not correlated with measures of body composition. Conclusions: As well as showing a significant relation between PAL and body composition, these data intimate that there may be a threshold of intensity of physical activity that is influential on body fatness. In light of world trends showing increasing childhood obesity, this study supports the need to further investigate the importance of physical activity for children.
Resumo:
Background: The University of Queensland has through an Australian Government initiative, established a Rural Clinical Division (RCD) at four regional sites in the southern and central Queensland. Over the fi rst four years of the existence of the RCD, an integrated package of innovative medical education has been developed. Method: The integrated aspects of the RCD program include: The Rural Medical Rotation: Every medical student undertakes an eight week rural rotation in Year 3. Year 3 and 4 MBBS - 100 students are currently spending one to two years in the rural school and demand is increasing. Interprofessional Education - Medical and Allied Health students attend lectures, seminars and workshops together and often share the same rural clinical placement. Rural health projects - allow students to undertake a project of benefi t to the rural community. Information Technology (IT) - the Clinical Discussion Board (CDB) and Personal Digital Assistants (PDA) demonstrate the importance of IT to medical students in the 21st century. Changing the Model of Medical Education - The Leichhardt Community Attachment Placement (LCAP), is a pilot study that resulted in the addition of three interns to the rural workforce. All aspects of the RCD are evaluated with surveys using both qualitative and quantitative free response questions, completed by all students regularly throughout the academic year. Results: Measures of impact include: Student satisfaction and quality of teaching surveys – 86-91% of students improved their clinical skills and understanding across all rotations. Academic results and progress – RCD students out-perform their urban colleagues. Intent to work in rural areas – 90% of students reported a greater interest in rural medicine. Intern numbers – rural / regional intern placements are increasing. Conclusions: The RCD proves to be a site for innovations all designed to help reach our primary goal of fostering increased recruitment of a rural medical workforce.
Resumo:
Examines the status and well being of wives in rural India using results from interviews. Surveys were conducted in three villages in the southwest of West Bengal and in three villages in the west of Orissa. The survey in West Bengal contained a large proportion of Santal tribals and the Oriyan survey was dominated by Kondh tribals. The relationships between variables representing economic, social and cultural factors are compared with ‘dependent’ variables representing the status of wives within their family and their wellbeing. Wellbeing is indicated by whether the basic needs of wives for food and medical care are met. Status of wives is indicated by their ‘control’ over family resources, whether or not they are restricted in joining social groups and in working outside their home, and the extent of their involvement in family decision-making. Cultural factors are found to be the dominant influence on the status of wives. Family income and other economic factors are found to be associated cross sectionally with greater restrictions on wives within their family. Nevertheless, the higher in the economic status of the household, the more likely are the basic needs of wives to be met.
Resumo:
Bioelectrical impedance analysis (BIA) was used to assess body composition in rats fed on either standard laboratory diet or on a high-fat diet designed to induce obesity. Bioelectrical impedance analysis predictions of total body water and thus fat-free mass (FFM) for the group mean values were generally within 5% of the measured values by tritiated water ((H2O)-H-3) dilution. The limits of agreement for the procedure were, however, large, approximately +/-25%, limiting the applicability of the technique for measurement of body composition in individual animals.
Resumo:
Multi-frequency bioimpedance analysis (MFBIA) was used to determine the impedance, reactance and resistance of 103 lamb carcasses (17.1-34.2 kg) immediately after slaughter and evisceration. Carcasses were halved, frozen and one half subsequently homogenized and analysed for water, crude protein and fat content. Three measures of carcass length were obtained. Diagonal length between the electrodes (right side biceps femoris to left side of neck) explained a greater proportion of the variance in water mass than did estimates of spinal length and was selected for use in the index L-2/Z to predict the mass of chemical components in the carcass. Use of impedance (Z) measured at the characteristic frequency (Z(c)) instead of 50 kHz (Z(50)) did not improve the power of the model to predict the mass of water, protein or fat in the carcass. While L-2/Z(50) explained a significant proportion of variation in the masses of body water (r(2) 0.64), protein (r(2) 0.34) and fat (r(2) 0.35), its inclusion in multi-variate indices offered small or no increases in predictive capacity when hot carcass weight (HCW) and a measure of rib fat-depth (GR) were present in the model. Optimized equations were able to account for 65-90 % of the variance observed in the weight of chemical components in the carcass. It is concluded that single frequency impedance data do not provide better prediction of carcass composition than can be obtained from measures of HCW and GR. Indices of intracellular water mass derived from impedance at zero frequency and the characteristic frequency explained a similar proportion of the variance in carcass protein mass as did the index L-2/Z(50).
Resumo:
Gas sorption by coal is closely related to its physical and chemical properties, which are, in turn, governed by coal type and rank. The role of coal type (sensu maceral composition) is not fully established but it is clear that coal type may affect both adsorption capacity and desorption rate. Adsorption capacity is closely related to micropore (pores <2 nm) development, which is rank and maceral dependent. Adsorption isotherms indicate that in most cases bright (vitrinite-rich) coals have a greater adsorption capacity than their dull (often inertinite-rich) equivalents. However, no differences, or even the opposing trend, may be observed in relation to coal type. Desorption rate investigations have been performed using selected bright and dull coal samples in a high pressure microbalance. Interpretation of results using unipore spherical and bidisperse pore models indicate the importance of the pore structure. Bright, vitrinite-rich coals usually have the slowest desorption rates which is associated with their highly microporous structure. However, rapid desorption in bright coals may be related to development of extensive, unmineralised fracture systems. Both macro-and micro-pore systems are implicated in the more rapidly desorbing dull coals. Some dull, inertinite-rich coals may rapidly desorb due to a predominance of large, open cell lumina. Mineral matter is essentially nonadsorbent to coal gases and acts as a simple diluent. However, mineral-rich coals may be associated with more rapid desorption. Coal rank and type (maceral composition) per se do not appear to be the critical factors in controlling gas sorption, but rather the influence they exert over pore structure development. (C) 1998 Elsevier Science B.V.
Resumo:
Surveys of commercial soybean fields, disease nurseries, and trial plots of soybean were conducted throughout eastern Australia between 1979 and 1996, and 694 isolates of Phytophthora sojae were collected and classified into races. Fourteen races, 1, 2, 4, 10, 15, and 25, and eight new races, 46 to 53, were identified, but only races 1, 4, 15, 25, 46, and 53 were found in commercial fields. Races 1 and 15 were the only races found in commercial fields in the soybean-growing areas of Australia up until 1989, with race 1 being the dominant race. Race 4 was found in central New South Wales in 1989 on cultivars with the Rps1a gene, and it is now the dominant race in central and southern New South Wales. Races 46 and 53 have only been found once, in southern New South Wales, and race 25 was identified in the same region in 1994 on a cultivar with the Rps1k gene. Only races 1 and 15 have been found in the northern soybean-growing regions, with the latter dominating, which coincides with the widespread use of cultivars with the Rps2 gene. Changes in the race structure of the P. sojae population from commercial fields in Australia follow the deployment of specific resistance genes.
Resumo:
Analytical electron microscopy was used to measure the composition of grain boundaries (GBs) and interconstituent boundaries (IBs) of X52 pipeline steel using specimens about 40-60 nm in thickness. All elements of interest were examined with the exception of carbon. With this caveat; there was no segregation at proeutectoid ferrite GBs. This indicated that the commonly expected species S and P are not responsible for preferential corrosion of GBs during intergranular stress corrosion cracking of pipeline steels. Manganese was the only species measured to segregate at the IBs. Manganese segregated to the IBs between proeutectoid ferrite and pearlitic cementite, and desegregated from IBs between proeutectoid ferrite and pearlitic ferrite. The pearlitic cementite was Mn rich. There was no Mn segregation at the IBs between pearlitic ferrite and pearlitic cementite. The pattern of Mn segregation could be explained in terms of diffusion in the process zone ahead of the pearlite during the austenite to pearlite transformation and diffusion in the IBs between the proeutectoid ferrite and pearlite. (C) 1998 Acta Metallurgica Inc. Published by Elsevier Science Ltd. All rights reserved.