Gauge P-representations for quantum-dynamical problems: Removal of boundary terms

P-representation techniques, which have been very successful in quantum optics and in other fields, are also useful for general bosonic quantum-dynamical many-body calculations such as Bose-Einstein condensation. We introduce a representation called the gauge P representation, which greatly widens the range of tractable problems. Our treatment results in an infinite set of possible time evolution equations, depending on arbitrary gauge functions that can be optimized for a given quantum system. In some cases, previous methods can give erroneous results, due to the usual assumption of vanishing boundary conditions being invalid for those particular systems. Solutions are given to this boundary-term problem for all the cases where it is known to occur: two-photon absorption and the single-mode laser. We also provide some brief guidelines on how to apply the stochastic gauge method to other systems in general, quantify the freedom of choice in the resulting equations, and make a comparison to related recent developments.

VOC removal: Comparison of MCM-41 with hydrophobic zeolites and activated carbon

The recently discovered mesoporous molecular sieve MCM-41 was tested as an adsorbent for VOC removal. Its adsorption/desorption properties were evaluated and compared with other hydrophobic zeolites (silicalite-1 and zeolite Y) and a commercial activated carbon, BPL. The adsorption isotherms of some typical VOCs (benzene, carbon tetrachloride, and n-hexane) on MCM-41 are of type IV according to the IUPAC classification, drastically different from the other microporous adsorbents, indicating that VOCs, in the gas phase, have to be at high partial pressures in order to make the most of the new mesoporous material as an adsorbent for VOC removal. However, a proper modification of the pore openings of MCM-41 can change the isotherm types from type IV to type I without remarkable loss of the accessible pare volumes and, therefore, significantly enhance the adsorption performance at low partial pressures. Adsorption isotherms of water on these adsorbents are all of type V, demonstrating that they possess a similar hydrophobicity. Desorption of VOCs from MCM-41 could be achieved at lower temperatures (50-60 degrees C), while this had to be conducted at higher temperatures (100-120 degrees C) for microporous adsorbents, zeolites, and activated carbons.

Coronary events and exposure to environmental tobacco smoke: a case-control study from Australia and New Zealand

Objectives-To estimate the relative risk of coronary heart disease (CHD) associated with exposure to environmental tobacco smoke (ETS). Design-Population-based case-control study. Subjects-Cases were 953 people identified in a population register of coronary events, and controls were 3189 participants in independent community-based risk factor prevalence surveys from the same study populations. Setting-Newcastle, Australia and Auckland, New Zealand. Main outcome measures-Acute myocardial infarction or coronary death. Results-After adjusting for the effects of age, education, history of heart disease, and body mass index, women had a statistically significant increased risk of a coronary event associated with exposure to ETS (relative risk (RR) = 1.99; 95% confidence interval (CI)= 1.40-2.81). There was little statistical evidence of increased risk found in men (RR = 1.02, 95% CI = 0.81-1.28). Conclusion-Our study found evidence for the adverse effects of exposure to ETS on risk of coronary heart disease among women, especially at home. For men the issue is unclear according to the data from our study. Additional studies with detailed information on possible confounders and adequate statistical power are needed. Most importantly, they should use methods for measuring exposure to ETS that are sufficiently accurate to permit the investigation of dose-response relationships.

Effect of smoke-free policies on the behaviour of social smokers

Objective-To test the hypothesis that proposed amendments to the Occupational Safety and Health Act making all enclosed workplaces in Western Australia smoke free would result in a decrease in cigarette consumption by patrons at nightclubs, pubs, and restaurants without adversely affecting attendance. Design-Cross sectional structured interview survey. Participants and setting-Patrons of several inner city pubs and nightclubs in Perth were interviewed while queuing for admission to these venues. Outcome measures-Current social habits, smoking habits, and how these might be affected by the proposed regulations. Persons who did not smoke daily were classified as social smokers. Results-Half (50%) of the 374 patrons interviewed were male, 51% currently did not smoke at all, 34.3% smoked every day, and the remaining 15.7% smoked, brat not every day. A clear majority (62.5%) of all 374 respondents anticipated no change to the frequency of their patronage of hospitality venues if smoke-free policies became mandatory One in five (19.3%) indicated that they would,ao out more often, and 18.2% said they would go out less often. Half (52%) of daily smokers anticipated no change to their cigarette consumption, while 44.5% of daily smokers anticipated a reduction in consumption. A majority of social smokers (54%) predicted a reduction in their cigarette consumption, with 42% of these anticipating quitting. Conclusions-One in nine (11.5%) of smokers say that adoption of smoke-Pi ee policies would prompt them to quit smoking entirely without a significant decrease in attendance at pubs and nightclubs. There can be few other initiatives as simple, cheap, and popular that would achieve so much for public health.

Removal of a cysteine ligand from rubredoxin: assembly of Fe2S2 and Fe(S-Cys)(3)(OH) centres

The electron transfer protein rubredoxin from Clostridium pasteurianum contains an Fe(S-Cys)(4) active site. Mutant proteins C9G, C9A, C42G and C42A, in which cysteine ligands are replaced by non-ligating Gly or Ala residues, have been expressed in Escherichia coli. The C42A protein expresses with a (Fe2S2)-S-III cluster in place. In contrast, the other proteins are isolated in colourless forms, although a (Fe2S2)-S-III cluster may be assembled in the C42G protein via incubation with Fe-III and sulfide. The four mutant proteins were isolated as stable mononuclear Hg-II forms which were converted to unstable mononuclear Fe-III preparations that contain both holo and apo protein. The Fe-III systems were characterized by metal analysis and mass spectrometry and by electronic, electron paramagnetic resonance, X-ray absorption and resonance Raman spectroscopies. The dominant Fe-III form in the C9A preparation is a Fe(S-Cys)(3)(OH) centre, similar to that observed previously in the C6S mutant protein. Related centres are present in the proteins NifU and IscU responsible for assembly and repair of iron-sulfur clusters in both prokaryotic and eukaryotic cells. In addition to Fe(S-Cys)(3)(OH) centres, the C9G, C42G and C42A preparations contain a second four-coordinate Fe-III form in which a ligand appears to be supplied by the protein chain. Electronic supplementary material to this paper can be obtained by using the Springer Link server located at http://dx.doi.org/10.1007/s00775-0020355-1.

High speed versus conventional grinding in high removal rate machining of alumina and alumina-titania

High removal rate (up to 16.6 mm(3)/s per mm) grinding of alumina and alumina-titania was investigated with respect to material removal and basic grinding parameters using a resin-bond 160 mu m grit diamond wheel at the speeds of 40 and 160 m/s, respectively. The results show that the material removal for the single-phase polycrystalline alumina and the two-phase alumina-titania composite revealed identical mechanisms of microfracture and grain dislodgement under the grinding conditioned selected. There were no distinct differences in surface roughness and morphology for both materials ground at either conventional or high speed. An increase in material removal rate did not necessarily worsen the surface toughness for the two materials at both speeds. Also the grinding forces for the two ceramics demonstrated similar characteristics at any grinding speeds and specific removal rates. Both normal and tangential grinding forces and their force ratios at the high speed were lower than those at the conventional speed, regardless of removal rates. An increase in specific removal rate caused more rapid increases in normal and tangential forces obtained at the conventional grinding speed than those at the high speed. Furthermore, it is found that the high speed grinding at all the removal rates exerted a great amount of coolant-induced normal forces in grinding zone, which were 4-6 times higher than the pure normal grinding forces. (c) 2004 Elsevier Ltd. All rights reserved.

Dormancy release in Australian fire ephemeral seeds during burial increases germination response to smoke water or heat

Fire ephemerals are short-lived plants that primarily germinate after fire. Fresh and laboratory-stored seeds are difficult to germinate ex situ, even in response to fire-related cues such as heat and smoke. Seeds of eight Australian fire ephemeral species were buried in unburnt and recently burnt sites of natural bushland during autumn. Seeds were exhumed after 6 and 12 months and incubated in water and smoke water, either with or without a heat treatment at 70 degrees C for 1 h. Generally, germination did not increase after 6 months of burial, but after 12 months of burial germination was enhanced in seven of the eight species. Actinotus leucocephalus produced higher germination following 12 months of burial without any further treatment, and smoke water and heat further improved germination. The four Gyrostemonaceae species, Codonocarpus cotinifolius, Gyrostemon racemiger, Gyrostemon ramulosus and Tersonia cyathiflora, only germinated in the presence of smoke water, and their germination was enhanced by burial. Burial improved germination in response to a heat treatment in Grevillea scapigera and Alyogyne huegelii seeds, but did not enhance Alyogyne hakeifolia germination. During concurrent dry laboratory storage of seeds at 15 degrees C, only Actinotus leucocephalus produced increased germination in response to smoke water and heat over time. In summary, soil burial can alter the dormancy status of a number of Australian fire ephemeral seeds, rendering them more responsive to germination cues such as smoke water and heat. The requirement for a period of burial before seeds become responsive to smoke and/or heat would ensure that seeds persist in the soil until a subsequent fire, when there is an increase in nutrients available for growth and reduced competition from other plants.

Smoke derived from burnt vegetation stimulates germination of arable weeds

A commercially available smoke-water solution (Seed Starter (R)) stimulated the germination of caryopses and intact florets of Avena fatua L. The solution was most effective when diluted (5-50%) and presented to intact or dehulled grain that had received a short period of dry after-ripening. It was less effective when applied at full strength or to grains that had been freshly harvested. The same stimulatory effect was observed in par-fly after-ripened caryopses of nine different wild oat biotypes obtained from three different cropping regions of the world. When freshly harvested caryopses were re-tested with the commercial solution (100%) for just 7 days prior to placement on to distilled water, a much higher germination percentage was possible than seen with continuous smoke-water incubation. The stimulatory ability of smoke water was more closely matched to that of gibberellic acid than to potassium nitrate, which had little or no effect on freshly harvested caryopses. The smoke-water solution (5-100%) was tested on the germination of 18 other cool temperate arable weed species. All monocotyledonous species tested (viz. Avena sterilis ssp. ludoviciana L., Alopecurus myosuroides, Sorghum halepense, Phalaris paradoxa) responded positively, while those of the dicotyledonous species were either strongly stimulated (greater than or equal to 40% stimulation Malva neglecta), moderately stimulated (greater than or equal to 20% stimulation Galium aparine, Veronica persica), slightly stimulated (Polygonum persicaria, P pennsylvanicum, Fallopia convolvulus), unaffected (P. aviculare, Sinapis arvensis, Heracleum sphondylium, Angelica sylvestris, Mercurialis annua, Veronica hederifolia) or inhibited (Lamium purpureum). The optimal concentrations required to stimulate germination of the monocotyledonous species were similar to those observed for A. fatua (5-10%). However, for the dicotyledonous species slightly stronger solutions were required (10-20%). When the unaffected species were retested using a 10-day pre-chilling treatment, smoke water showed a small promotive response in three (S. arvensis, P. aviculare and V hederifolia) of the six species. When four different smoke-water solutions (Seed Starter (R), Regen 2000 (R), charred-wood solution and wheat-straw solution) were tested on two representative species (A. fatua and M. neglecta), three formulations were effective in promoting the germination of both species, while the fourth (charred-wood solution) was only active on A. fatua. The active concentrations were different for the four solutions. Three solutions were active in the 2-20% dilution range, while the fourth (Regen 2000 (R)) was only active in the 1-2% dilution range and was inhibitory at higher concentrations. These observations are discussed in the context that smoke may play an important ecological role in the management and control of introduced weeds in native and arable communities.

Adsorption kinetics for the removal of chromium(VI) from aqueous solution by adsorbents derived from used tyres and sawdust

The batch removal of hexavalent chromium (Cr(Vl)) from wastewater under different experimental conditions using economic adsorbents was investigated in this study. These adsorbents were produced from the pyrolysis and activation of the waste tyres (TAC) and from the pyrolysis of sawdust (SPC). The performance of these adsorbents against commercial activated carbon F400 (CAC) has also been carried out. The removal was favoured at low pH, with maximum removal at pH = 2 for all types of carbon. The effects of concentration, temperature and particle size have been reported. All sorbents were found to efficiently remove Cr(VI) from solution. The batch sorption kinetics have been tested for a first-order reversible reaction, a first-order and second-order reaction. The rate constants of adsorption for all these kinetic models have been calculated. The applicability of the Langmuir isotherm for the present system has been tested at different temperatures. The thermodynamic parameters (AGO, K,) obtained indicate the endothermic nature of Cr(Vl) adsorption on TAC, SPC and CAC. (C) 2001 Elsevier Science B.V. All rights reserved.