Mapping intertidal habitats and an evaluation of their conservation status in Queensland, Australia

The goal of biodiversity conservation has been described as the conservation of diversity at three levels: ecosystem, species and genetic diversity. Developing a representative system of marine protected areas (MPAs) is considered an effective way to achieve this goal in the marine environment. In the absence of detailed information relating to biological distributions there has been increasing use of biodiversity surrogates to determine MPA priorities at regional levels. The development of biodiversity surrogates at fine scales (i.e. habitats) will have an increasingly important role in the identification of sites that will contribute to a representative system of MPAs. This is because it will increase the likelihood that the system will adequately achieve biodiversity objectives by ensuring protection of a greater range of habitats and species. This article provides an explanation of an intertidal shoreline habitat surrogate used to describe 24,216km of Queensland's coastline. The protective status of intertidal habitats was evaluated to assist with designing a representative system of intertidal MPAs. (C) 2002 Elsevier Science Ltd. All rights reserved.

Evaluation of individual protein errors in silver-stained two-dimensional gels

The relationship between spot volume and variation for all protein spots observed on large format 2D gels when utilising silver stain technology and a model system based on mammalian NSO cell extracts is reported. By running multiple gels we have shown that the reproducibility of data generated in this way is dependent on individual protein spot volumes, which in turn are directly correlated with the coefficient of variation. The coefficients of variation across all observed protein spots were highest for low abundant proteins which are the primary contributors to process error, and lowest for more abundant proteins. Using the relationship between spot volume and coefficient of variation we show it is necessary to calculate variation for individual protein spot volumes. The inherent limitations of silver staining therefore mean that errors in individual protein spot volumes must be considered when assessing significant changes in protein spot volume and not global error. (C) 2003 Elsevier Science (USA). All rights reserved.

Evaluation of IDDM8 susceptibility locus in a Russian simplex family data set

Type 1 diabetes (TID) susceptibility locus, IDDM8, has been accurately mapped to 200 kilobases at the terminal end of chromosome 6q27. This is within the region which harbours a cluster of three genes encoding proteasome subunit beta 1 (PMSB1), TATA-box binding protein (TBP) and a homologue of mouse programming cell death activator 2 (PDCD2). In this study, we evaluated whether these genes contribute to TID susceptibility using the transmission disequilibrium test of the data set from 114 affected Russian simplex families. The A allele of the G/A1180 single nucleotide polymorphism (SNP) at the PDCD2 gene, which was significant in its preferential transfer from parents to diabetic children (75 transmissions vs. 47 non-transmissionS, x(2) = 12.85, P corrected = 0.0038), was found to be associated with T1D. G/A1180 dimorphism and two other SNPs, C/T771 TBP and G/T(-271) PDCD2, were shown to share three common haplotypes, two of which (A-T-G and A-T-T) have been associated with higher development risk of TID. The third haplotype (G-T-G) was related to having a lower risk of disease. These findings suggest that the PDCD2 gene is a likely susceptibility gene for TID within IDDM8. However, it was not possible to exclude the TBP gene from being another putative susceptibility gene in this region. (c) 2005 Elsevier Ltd. All rights reserved.

Project to investigate improving literacy and numeracy outcomes of distance education students in the early years of schooling

The project was commissioned to investigate and analyse the issue of effective support for distance education students in the early years of school to maximise literacy and numeracy outcomes. The scope of this project was limited to students living in rural and remote areas who are undertaking education at home and who are in their early years of schooling. For the purpose of this project, the early years are conceptualised as the first three years of formal compulsory schooling in each of the States and Territories. There were a number of key tasks for the project which included: 1. Examining of the role of home tutors/supervisors This included interviewing personnel from the State and Territory distance education providers as well as the principals, teachers, home tutors and children. 2. Describing literacy and numeracy teaching and learning, and the use of information and communication technologies (ICT) in distance education This aspect of the project involved a critical review and analysis of relevant literature and reports in the last five years, and a consideration of the new initiatives that had been implemented in the States and Territories in the last two years. 3. The development of resources Through examination of the role of home tutors/supervisors, and an examination of literacy and numeracy and the use of technology in distance education, three resources were developed: ● A guide for home tutors/supervisors and schools of distance education about effective intervention and assessment strategies to support students’ learning and to assist the home tutors/supervisors in implementing ICT to support the development of literacy and numeracy in the early years. ● A calendar of activities for literacy and numeracy that would act as a stimulus for integrated and authentic activity for young children. ● An embryonic website of resources for the stakeholders in rural and distance education that might act as a catalyst for future resource building and sharing. In this way the final key task of the project, which was to create a context for a strategic dissemination plan, was realised when a strategy to address effective dissemination of the findings of the project so as to maximise their usefulness for the relevant groups was achieved.

A comparison of dissected follicle numbers and follicle counts on the ovarian surface for the evaluation of ovarian follicular populations in Bos indicus cows

Ovaries (n = 140) from 70 mixed-age multiparous, lactating Brahman cross (3/4-7/8 Bos indicus) cows were used to examine the hypothesis that counts of follicles visible on the surface of the ovaries of Bos indicus cows and their classification into diameter size classes, are closely correlated with numbers of follicles in those size classes found by complete dissection of the ovary. immediately after ovariectomy, mean diameters (long and short axes averaged) of all follicles greater than or equal to 2 mm visible on the surface of each ovary were measured. All follicles greater than or equal to 2 mm were dissected from the ovaries, excess stroma removed and follicle diameters measured under a stereomicroscope using an ocular graticule. For each ovary, follicles were classified in either small (8 mm) categories based on either diameters of surface or dissected follicles. Data for numbers of surface and dissected follicles (mean +/- SE) in small, medium, large categories and total follicle numbers, respectively, were 24.4 +/- 1.6 vs. 28.0 +/- 1.9, 1.6 +/- + 0.2 vs. 11.6 +/- 1.0, 0.5 +/- 0.1 vs. 0.7 +/- 0.1 and 26.4 +/- 1.6 vs. 40.4 +/- 2.5. Correlation coefficients (r) for counts of surface and dissected follicles in small, medium, large and total follicle numbers were 0.76, 0.40, 0.69 and 0.79, respectively. Medium size follicles presented only a small translucent area on the surface of the ovary, leading to an underestimate of numbers when categorised by surface evaluation. Counts of follicles visible on the surface of the ovaries of Bos indicus cows and their classification into size classes based on estimated diameter, are closely correlated with numbers of follicles in those size classes found at dissection of the ovary for small (8 mm) and total follicles but not for medium sized (4-8 mm) follicles. (C) 1997 Elsevier Science B.V.

Analysis of the gate capacitance measurement technique and its application for the evaluation of hot-carrier degradation in submicrometer MOSFETs

The use of gate-to-drain capacitance (C-gd) measurement as a tool to characterize hot-carrier-induced charge centers in submicron n- and p-MOSFET's has been reviewed and demonstrated. By analyzing the change in C-gd measured at room and cryogenic temperature before and after high gate-to-drain transverse field (high field) and maximum substrate current (I-bmax) stress, it is concluded that the degradation was found to be mostly due to trapping of majority carriers and generation of interface states. These interface states were found to be acceptor states at top half of band gap for n-MOSFETs and donor states at bottom half of band gap for p-MOSFETs. In general, hot electrons are more likely to be trapped in gate oxide as compared to hot holes while the presence of hot holes generates more interface states. Also, we have demonstrated a new method for extracting the spatial distribution of oxide trapped charge, Q(ot), through gate-to-substrate capacitance (C-gb) measurement. This method is simple to implement and does not require additional information from simulation or detailed knowledge of the device's structure. (C) 2001 Elsevier Science Ltd. All rights reserved.

Numerical evaluation of three dimensional effects in planar flow birefringence

The influence of three dimensional effects on isochromatic birefringence is evaluated for planar flows by means of numerical simulation. Two fluid models are investigated in channel and abrupt contraction geometries. In practice, the flows are confined by viewing windows, which alter the stresses along the optical path. The observed optical properties differ therefore from their counterpart in an ideal two-dimensional flow. To investigate the influence of these effects, the stress optical rule and the differential propagation Mueller matrix are used. The material parameters are selected so that a retardation of multiple orders is achieved, as is typical for highly birefringent melts. Errors due to three dimensional effects are mainly found on the symmetry plane, and increase significantly with the flow rate. Increasing the geometric aspect ratio improve the accuracy provided that the error on the retardation is less than one order. (C) 2004 Elsevier B.V. All rights reserved.

Evaluation of clinically relevant changes in patient reported outcomes in knee and hip osteoarthritis: the minimal clinically important improvement

Background: In clinical trials, at the group level, results are usually reported as mean and standard deviation of the change in score, which is not meaningful for most readers. Objective: To determine the minimal clinically important improvement (MCII) of pain, patient's global assessment of disease activity, and functional impairment in patients with knee and hip osteoarthritis (OA). Methods: A prospective multicentre 4 week cohort study involving 1362 outpatients with knee or hip OA was carried out. Data on assessment of pain and patient's global assessment, measured on visual analogue scales, and functional impairment, measured on the Western Ontario McMaster Universities Osteoarthritis Index (WOMAC) function subscale, were collected at baseline and final visits. Patients assessed their response to treatment on a five point Likert scale at the final visit. An anchoring method based on the patient's opinion was used. The MCII was estimated in a subgroup of 814 patients ( 603 with knee OA, 211 with hip OA). Results: For knee and hip OA, MCII for absolute ( and relative) changes were, respectively, ( a) -19.9 mm (-40.8%) and -15.3 mm (-32.0%) for pain; ( b) -18.3 mm ( - 39.0%) and -15.2 mm ( -32.6%) for patient's global assessment; ( c) -9.1 ( -26.0%) and -7.9 ( -21.1%) for WOMAC function subscale score. The MCII is affected by the initial degree of severity of the symptoms but not by age, disease duration, or sex. Conclusion: Using criteria such as MCII in clinical trials would provide meaningful information which would help in interpreting the results by expressing them as a proportion of improved patients.

Evaluation of clinically relevant states in patient reported outcomes in knee and hip osteoarthritis: the patient acceptable symptom state

Background: The patient acceptable symptom state ( PASS) is the value beyond which patients can consider themselves well. This concept can help in interpreting results of clinical trials. Objective: To determine the PASS estimate for patients with knee and hip osteoarthritis (OA) by assessing pain, patient's global assessment of disease activity, and functional impairment. Methods: A 4 week prospective multicentre cohort study of 1362 outpatients with knee or hip OA was carried out. Data on assessment of pain and patient's global assessment of disease, measured on visual analogue scales, and functional impairment, measured on the Western Ontario McMaster Universities Osteoarthritis Index (WOMAC) function subscale, were collected at baseline and final visits. The patients assessed their satisfaction with their current state at the final visit. An anchoring method based on the patient's opinion was used. Results: For patients with knee and hip OA, the estimates of PASS were, respectively, 32.3 and 35.0 mm for pain, 32.0 and 34.6 mm for patient global assessment of disease activity, and 31.0 and 34.4 points for WOMAC function score. The PASS varied moderately across the tertiles of baseline scores but not across age, disease duration, or sex. Conclusion: The use of PASS in clinical trials would provide more meaningful results expressed as a proportion of patients in an acceptable symptom state.