25 resultados para CDMA CAPACITY ANALYSIS

em University of Queensland eSpace - Australia


Relevância:

40.00% 40.00%

Publicador:

Resumo:

This letter presents an analytical model for evaluating the Bit Error Rate (BER) of a Direct Sequence Code Division Multiple Access (DS-CDMA) system, with M-ary orthogonal modulation and noncoherent detection, employing an array antenna operating in a Nakagami fading environment. An expression of the Signal to Interference plus Noise Ratio (SINR) at the output of the receiver is derived, which allows the BER to be evaluated using a closed form expression. The analytical model is validated by comparing the obtained results with simulation results.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Power system small signal stability analysis aims to explore different small signal stability conditions and controls, namely: (1) exploring the power system security domains and boundaries in the space of power system parameters of interest, including load flow feasibility, saddle node and Hopf bifurcation ones; (2) finding the maximum and minimum damping conditions; and (3) determining control actions to provide and increase small signal stability. These problems are presented in this paper as different modifications of a general optimization to a minimum/maximum, depending on the initial guesses of variables and numerical methods used. In the considered problems, all the extreme points are of interest. Additionally, there are difficulties with finding the derivatives of the objective functions with respect to parameters. Numerical computations of derivatives in traditional optimization procedures are time consuming. In this paper, we propose a new black-box genetic optimization technique for comprehensive small signal stability analysis, which can effectively cope with highly nonlinear objective functions with multiple minima and maxima, and derivatives that can not be expressed analytically. The optimization result can then be used to provide such important information such as system optimal control decision making, assessment of the maximum network's transmission capacity, etc. (C) 1998 Elsevier Science S.A. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Previous studies have shown that a negative relationship exists between transpiration efficiency (TE) and carbon isotope discrimination (Delta) and between TE and specific leaf area (SLA) in Stylosanthes scabra, A glasshouse experiment was conducted to confirm these relationships in an F-2 population and to study the causal nature of these relationships through quantitative trait loci (QTL) analysis, One hundred and twenty F-2 genotypes from a cross between two genotypes within S. scabra were used. Three replications for each genotype were maintained through vegetative propagation, Water stress was imposed by maintaining plants at 40% of field capacity for about 45 d. To facilitate QTL analysis, a genetic linkage map consisting of 151 RAPD markers was developed, Results from this study show that Delta was significantly and negatively correlated with TE and biomass production. Similarly, SLA showed significant negative correlation with TE and biomass production, Most of the QTL for TE and Delta were present on linkage groups 5 and 11. Similarly, QTL for SLA, transpiration and biomass productivity traits were clustered on linkage groups 13 and 24, One unlinked marker was also associated with these traits, There were several markers coincident between different traits, At all the coincident QTL, the direction of QTL effects was consistent with phenotypic data, At the coincident markers between TE and Delta, high alleles of TE were associated with low alleles of Delta. Similarly, low alleles of SLA were associated with high alleles of biomass productivity traits and transpiration. At the coincident markers between trans-4-hydroxy-N-methyl proline (MHP) and relative water content (RWC), low alleles of MHP were associated with high alleles of RWC, This study suggests the causal nature of the relationship between TE and Delta. Phenotypic data and QTL, data show that SLA was more closely associated with biomass production than with TE, This study also shows that a cause-effect relationship may exist between SLA and biomass production.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

A laboratory scale sequencing batch reactor (SBR) operating for enhanced biological phosphorus removal (EBPR) and fed with a mixture of volatile fatty acids (VFAs) showed stable and efficient EBPR capacity over a four-year-period. Phosphorus (P), poly-beta-hydroxyalkanoate (PHA) and glycogen cycling consistent with classical anaerobic/aerobic EBPR were demonstrated with the order of anaerobic VFA uptake being propionate, acetate then butyrate. The SBR was operated without pH control and 63.67+/-13.86 mg P l(-1) was released anaerobically. The P% of the sludge fluctuated between 6% and 10% over the operating period (average of 8.04+/-1.31%). Four main morphological types of floc-forming bacteria were observed in the sludge during one year of in-tensive microscopic observation. Two of them were mainly responsible for anaerobic/aerobic P and PHA transformations. Fluorescence in situ hybridization (FISH) and post-FISH chemical staining for intracellular polyphosphate and PHA were used to determine that 'Candidatus Accumulibacter phosphatis' was the most abundant polyphosphate accumulating organism (PAO), forming large clusters of coccobacilli (1.0-1.5 mum) and comprising 53% of the sludge bacteria. Also by these methods, large coccobacillus-shaped gammaproteobacteria (2.5-3.5 mum) from a recently described novel cluster were glycogen-accumulating organisms (GAOs) comprising 13% of the bacteria. Tetrad-forming organisms (TFOs) consistent with the 'G bacterium' morphotype were alphaproteobacteria , but not Amaricoccus spp., and comprised 25% of all bacteria. According to chemical staining, TFOs were occasionally able to store PHA anaerobically and utilize it aerobically.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

An important feature of improving lattice gas models and classical isotherms is the incorporation of a pore size dependent capacity, which has hitherto been overlooked. In this paper, we develop a model for predicting the temperature dependent variation in capacity with pore size. The model is based on the analysis of a lattice gas model using a density functional theory approach at the close packed limit. Fluid-fluid and solid-fluid interactions are modeled by the Lennard-Jones 12-6 potential and Steele's 10-4-3, potential respectively. The capacity of methane in a slit-shaped carbon pore is calculated from the characteristic parameters of the unit cell, which are extracted by minimizing the grand potential of the unit cell. The capacities predicted by the proposed model are in good agreement with those obtained from grand canonical Monte Carlo simulation, for pores that can accommodate up to three adsorbed layers. Single particle and pair distributions exhibit characteristic features that correspond to the sequence of buckling and rhombic transitions that occur as the slit pore width is increased. The model provides a useful tool to model continuous variation in the microstructure of an adsorbed phase, namely buckling and rhombic transitions, with increasing pore width. (C) 2002 American Institute of Physics.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Life cycle models have become important in explaining the changing size structure of firms based on the carrying capacity of regions or industries. In particular, the population ecology model predicts stages of growth, maturity and eventually decline in the number of firms in an industry. There has been criticism of such models because of their focus on external variables as pre-determinants of the potential for enterprise development. This paper attempts to reconcile the external focus of the population ecology model with relevant internal management factors in enterprise development. A survey was conducted of Australian services exporters, and the results not only confirm the existence of four separate life cycle stages in the population ecology model, but also identify the external and internal variables that are strategically relevant at each of the stages. The findings provide potentially useful information in a range of contexts including the design of small business assistance as well a providing “guide posts” to entrepreneurs engaged in enterprise development.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

For most complex emergent technologies, product-market success depends on efficient linkages between changing lead innovators within the R&D process. In this paper, our unit of analysis is a complex high technology product and the system of alliance linkages formed to progress a product through R&D milestones. We present a model and evidence for advancing our understanding of how achieving early-to-market returns depends on systemic absorptive capacity. This systemic absorptive capacity is the cumulative efficiency in the use of absorptive capacity to link changing lead innovators across successive milestones in R&D product development. We advance propositions of how systemic absorptive capacity can explain performance differences between rival product development systems competing for early-to-market returns with similar products through accelerating speed to market, cost and quality advantages. These explanations are contrasted with the conclusions of previous studies that have focused on absorptive capacity of single firms or single alliances in RD.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

We present new simulation results for the packing of single-center and three-center models of carbon dioxide at high pressure in carbon slit pores. The former shows a series of packing transitions that are well described by our density functional theory model developed earlier. In contrast, these transitions are absent for the three-center model. Analysis of the simulation results shows that alternations of flat-lying molecules and rotated molecules can occur as the pore width is increased. The presence or absence of quadrupoles has negligible effect on these high-density structures.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

BACKGROUND: Recent studies have demonstrated that exercise capacity is an independent predictor of mortality in women. Normative values of exercise capacity for age in women have not been well established. Our objectives were to construct a nomogram to permit determination of predicted exercise capacity for age in women and to assess the predictive value of the nomogram with respect to survival. METHODS: A total of 5721 asymptomatic women underwent a symptom-limited, maximal stress test. Exercise capacity was measured in metabolic equivalents (MET). Linear regression was used to estimate the mean MET achieved for age. A nomogram was established to allow the percentage of predicted exercise capacity to be estimated on the basis of age and the exercise capacity achieved. The nomogram was then used to determine the percentage of predicted exercise capacity for both the original cohort and a referral population of 4471 women with cardiovascular symptoms who underwent a symptom-limited stress test. Survival data were obtained for both cohorts, and Cox survival analysis was used to estimate the rates of death from any cause and from cardiac causes in each group. RESULTS: The linear regression equation for predicted exercise capacity (in MET) on the basis of age in the cohort of asymptomatic women was as follows: predicted MET = 14.7 - (0.13 x age). The risk of death among asymptomatic women whose exercise capacity was less than 85 percent of the predicted value for age was twice that among women whose exercise capacity was at least 85 percent of the age-predicted value (P<0.001). Results were similar in the cohort of symptomatic women. CONCLUSIONS: We have established a nomogram for predicted exercise capacity on the basis of age that is predictive of survival among both asymptomatic and symptomatic women. These findings could be incorporated into the interpretation of exercise stress tests, providing additional prognostic information for risk stratification.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

The process of adsorption of two dissociating and two non-dissociating aromatic compounds from dilute aqueous solutions on an untreated commercially available activated carbon (B.D.H.) was investigated systematically. All adsorption experiments were carried out in pH controlled aqueous solutions. The experimental isotherms were fitted into four different models (Langmuir homogenous Models, Langmuir binary Model, Langmuir-Freundlich single model and Langmuir-Freundlich double model). Variation of the model parameters with the solution pH was studied and used to gain further insight into the adsorption process. The relationship between the model parameters and the solution pH and pK(a) was used to predict the adsorption capacity in molecular and ionic form of solutes in other solution. A relationship was sought to predict the effect of pH on the adsorption systems and for estimating the maximum adsorption capacity of carbon at any pH where the solute is ionized reasonably well. N-2 and CO2 adsorption were used to characterize the carbon. X-ray Photoelectron Spectroscopy (XPS) measurement was used for surface elemental analysis of the activated carbon.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

We present numerical results on the capacities of two-qubit unitary operations for performing communication and creating entanglement. The capacities for communication considered are based upon the increase in Holevo information of an ensemble. Our results indicate that the capacity may be accurately estimated using ensemble sizes and ancilla dimensions of 4. In addition, the calculated values of these capacities were close to, and in some cases equal to, the similarly defined entangling capacities; this result indicates connections between these capacities.